Challenges
Datasets
Workspaces
Papers
Discussions
Leaderboard
Log inSign up
Challenges
Datasets
Workspaces
Papers
Discussions
Leaderboard
Blog
Job Board
Q3AS

© 2026 Aqora Quantum S.A.S.

TermsPrivacyLegal Notice

Technical Physics Letters

Excess noise of an Er/Yb fiber superfluorescent radiation source

É. I. Alekseev, E. N. Bazarov, Yu. A. Barannikov, Valentin P. Gapontsev, V. P. Gubin, Igor E. Samartsev, Nikolay I. Starostin

Published Dec 1, 1997• 4 citations
Publisher

Abstract

A study is made of the noise in the output intensity of a high-power superfluorescent fiber radiation source generating 20 mW in the 1.55 μ m region of the spectrum. The source is constructed in an all-fiber technology from a quartz fiber activated with ytterbium and erbium. It is found that the spectral density of the noise in the frequency range 100–500 kHz is uniform and corresponds to the excess noise of “thermal” sources. It is shown that the noise in the output intensity of the source can be compensated (decreased by an order of magnitude) in a two-channel scheme of photodetection, where it approaches a level close to the photon shot noise.

DOI
10.1134/1.1261925

Related papers

Using a Passive Fiber Ring Cavity to Generate Shot-Noise-Limited Laser Light for Low-Power Quantum Optics Applications

Malcolm B. Gray, J. H. Chow, Kirk McKenzie +1 more

High-stability single-frequency fiber lasers typically exhibit relative intensity noise that is far in excess of shot noise across a broad frequency range extending from dc to many tens of megahertz. This excess noise precludes the use of these fiber lasers in a range of precision interferometry and quantum optics applications. We present experimental results using a passive, highQ, fiber ring resonator to filter out up to 26 dB of excess laser intensity noise, resulting in a stabilized laser output that reaches the shot-noise limit over most of its signal spectrum.

IEEE Photonics Technology Letters•Jun 28, 2007•8 citations

Intensity noise of erbium-doped fiber laser based on full quantum theory

Wenjun Yue, YunXiang Wang, Cai-Dong Xiong +2 more

Traditionally, by means of full quantum theory, we present the intensity noise transfer function of an Er-doped fiber laser, on the basis of which we analyze the spectrum of the intensity noise. Our theoretical results are in agreement with the existing experiment results. This model explains not only how the noise is produced, but also how the spontaneous emission and dipole fluctuations have an effect on the output noise, which cannot be explained via rate equation theory. We analyze the physical sources of various contributions to the noise spectrum as well. The simulation results show that the noise of the Er-doped fiber laser mainly consists of the vacuum noise resulting from the output coupling, dipole fluctuation noise, the pump source intensity noise, and the spontaneous emission from the upper level to the ground level, which provides the theoretical basis for noise suppression. Compared to the solid laser, the Er-doped fiber laser shows lower resonant relaxation oscillation frequency.

Journal of the Optical Society of America B•Jan 7, 2013•28 citations

Broadband near-to-shot-noise suppression of arbitrary cw-laser excess intensity noise in the gigahertz range

Ernest A. Michael, Laurent Pallanca

Broadband near-to-shot-noise suppression of the intensity noise from a continuous-wave (cw) fiber laser at 1550 nm is demonstrated at GHz-frequencies using feed-forward phase-matched destructive noise interference impressed onto the optical signal with a fiber electro-optic power modulator. The scheme is independent of the laser frequency and therefore is suitable for tunable lasers. It can be used with some modifications after an optical fiber-amplifier boosting a cw laser signal. A noise residual of down to 2 dB above the shot-noise was measured, which is about 2 dB below the prediction with a rigorous noise model. While the total laser noise can be removed, inclusive shot noise, because the latter is still 10 dB above the thermal noise, the power splitter introduces some partition noise above the shot level. In that case, a sub-shot-noise suppression scheme should be possible by replacing the photon anti-correlation of the power splitter by the co-correlation obtained from a paired photon or twin beam source.

Optics Letters•Mar 20, 2015•9 citations

Noise optimization of an Er-doped superfluorescent fiber source

Frands B. Pedersen, Jørn Hedegaard Povlsen, Anders Bjarklev +2 more

A theoretical analysis of the noise properties of an Er-doped superfluorescent fiber source is presented. The optimum fiber design with respect to the signal-to-noise ratio and output power is found.

Optics Letters•Oct 15, 1993•1 citation

Theoretical Analysis of Noise in Erbium Doped Fiber Amplifier

Alexander William Setiawan Putra, Minoru Yamada, Hiroyuki Tsuda +1 more

Characteristics of noise in erbium doped fiber amplifier (EDFA) are theoretically analyzed and experimentally verified. Four discreet energy models are used for erbium ion transition. Spatially varying photon number for traveling optical field was defined in a spatially divided segment with finite length, whose length is decided by property of the spontaneous emission. Quantitative evaluation of the Langevin noise sources becomes possible by this model. The amplified spontaneous emission was included in terms of discrete longitudinal mode, which is defined for whole length of the EDFA. It was found that the relative intensity noise (RIN) in the EDFA hardly changes with noise frequency in the region higher than several kHz. The phase noise in EDFA also hardly changes with the noise frequency. The frequency noise of the signal light in the EDFA increases proportional to squared value of the noise frequency. The amount of RIN and the phase noise decrease in higher input optical power. Good correspondence between theoretical and experimental results was obtained.

IEEE Journal of Quantum Electronics•Jun 20, 2017•18 citations

Coherence length of a Yb fibre superfluorescent source with an adjustable linewidth

E J Park, D. J. Kim, Hoon Jeong +1 more

Abstract Characterization of coherence for superfluorescent light emitted from a diode-pumped Yb-doped fiber source is reported. We have constructed a superfluorescent light source with an adjustable linewidth employing a Yb-doped fiber master oscillator and two power-amplifier stages and measured its coherence length as a function of a linewidth in a Michelson interferometer. The experimental values are in good agreement with the numerically calculated values using the given spectral intensity distribution. The results indicate that the mechanism for linewidth broadening of the fiber superfluorescent output can be attributed to inhomogeneous line broadening of an atomic transition. The prospect of the fiber superfluorescent source with a tailored coherence length will be discussed.

Laser Physics Letters•Aug 28, 2018•8 citations
A study is made of the noise in the output intensity of a high-power superfluorescent fiber radiation source generating 20 mW in the 1.55 μ m region of the spectrum. The source is constructed in an all-fiber technology from a quartz fiber activated with ytterbium and erbium. It is found that the spectral density of the noise in the frequency range 100–500 kHz is uniform and corresponds to the excess noise of “thermal” sources. It is shown that the noise in the output intensity of the source can be compensated (decreased by an order of magnitude) in a two-channel scheme of photodetection, where it approaches a level close to the photon shot noise.
High-stability single-frequency fiber lasers typically exhibit relative intensity noise that is far in excess of shot noise across a broad frequency range extending from dc to many tens of megahertz. This excess noise precludes the use of these fiber lasers in a range of precision interferometry and quantum optics applications. We present experimental results using a passive, highQ, fiber ring resonator to filter out up to 26 dB of excess laser intensity noise, resulting in a stabilized laser output that reaches the shot-noise limit over most of its signal spectrum.
Traditionally, by means of full quantum theory, we present the intensity noise transfer function of an Er-doped fiber laser, on the basis of which we analyze the spectrum of the intensity noise. Our theoretical results are in agreement with the existing experiment results. This model explains not only how the noise is produced, but also how the spontaneous emission and dipole fluctuations have an effect on the output noise, which cannot be explained via rate equation theory. We analyze the physical sources of various contributions to the noise spectrum as well. The simulation results show that the noise of the Er-doped fiber laser mainly consists of the vacuum noise resulting from the output coupling, dipole fluctuation noise, the pump source intensity noise, and the spontaneous emission from the upper level to the ground level, which provides the theoretical basis for noise suppression. Compared to the solid laser, the Er-doped fiber laser shows lower resonant relaxation oscillation frequency.
Broadband near-to-shot-noise suppression of the intensity noise from a continuous-wave (cw) fiber laser at 1550 nm is demonstrated at GHz-frequencies using feed-forward phase-matched destructive noise interference impressed onto the optical signal with a fiber electro-optic power modulator. The scheme is independent of the laser frequency and therefore is suitable for tunable lasers. It can be used with some modifications after an optical fiber-amplifier boosting a cw laser signal. A noise residual of down to 2 dB above the shot-noise was measured, which is about 2 dB below the prediction with a rigorous noise model. While the total laser noise can be removed, inclusive shot noise, because the latter is still 10 dB above the thermal noise, the power splitter introduces some partition noise above the shot level. In that case, a sub-shot-noise suppression scheme should be possible by replacing the photon anti-correlation of the power splitter by the co-correlation obtained from a paired photon or twin beam source.
Characteristics of noise in erbium doped fiber amplifier (EDFA) are theoretically analyzed and experimentally verified. Four discreet energy models are used for erbium ion transition. Spatially varying photon number for traveling optical field was defined in a spatially divided segment with finite length, whose length is decided by property of the spontaneous emission. Quantitative evaluation of the Langevin noise sources becomes possible by this model. The amplified spontaneous emission was included in terms of discrete longitudinal mode, which is defined for whole length of the EDFA. It was found that the relative intensity noise (RIN) in the EDFA hardly changes with noise frequency in the region higher than several kHz. The phase noise in EDFA also hardly changes with the noise frequency. The frequency noise of the signal light in the EDFA increases proportional to squared value of the noise frequency. The amount of RIN and the phase noise decrease in higher input optical power. Good correspondence between theoretical and experimental results was obtained.
Abstract Characterization of coherence for superfluorescent light emitted from a diode-pumped Yb-doped fiber source is reported. We have constructed a superfluorescent light source with an adjustable linewidth employing a Yb-doped fiber master oscillator and two power-amplifier stages and measured its coherence length as a function of a linewidth in a Michelson interferometer. The experimental values are in good agreement with the numerically calculated values using the given spectral intensity distribution. The results indicate that the mechanism for linewidth broadening of the fiber superfluorescent output can be attributed to inhomogeneous line broadening of an atomic transition. The prospect of the fiber superfluorescent source with a tailored coherence length will be discussed.