Challenges
Datasets
Workspaces
Papers
Discussions
Leaderboard
Log inSign up
Challenges
Datasets
Workspaces
Papers
Discussions
Leaderboard
Blog
Job Board
Q3AS

© 2026 Aqora Quantum S.A.S.

TermsPrivacyLegal Notice

IEEE Photonics Technology Letters

Using a Passive Fiber Ring Cavity to Generate Shot-Noise-Limited Laser Light for Low-Power Quantum Optics Applications

Malcolm B. Gray, J. H. Chow, Kirk McKenzie, David E. McClelland

Published Jun 28, 2007• 8 citations
Publisher

Abstract

High-stability single-frequency fiber lasers typically exhibit relative intensity noise that is far in excess of shot noise across a broad frequency range extending from dc to many tens of megahertz. This excess noise precludes the use of these fiber lasers in a range of precision interferometry and quantum optics applications. We present experimental results using a passive, highQ, fiber ring resonator to filter out up to 26 dB of excess laser intensity noise, resulting in a stabilized laser output that reaches the shot-noise limit over most of its signal spectrum.

DOI
10.1109/lpt.2007.899466

Related papers

A Shot-Noise Limited Fiber Laser Source by Cascaded Passive Optical Filtering

T. Nguyen, J. H. Chow, Conor M Mow-Lowry +2 more

We present a technique for suppressing relative intensity noise in a fiber laser, which uses two Pound-Drever-Hall feedback control loops to lock two optical fiber ring resonators in series. The resonators act as cascaded passive optical filters to remove high frequency intensity noise. We describe and discuss the control scheme for holding the cavities on resonance, and present the experimental result, demonstrating shot noise limited performance for intensity fluctuations above 2.5 MHz.

IEEE Journal of Quantum Electronics•Mar 12, 2010•2 citations

Passive filtering of fiber laser intensity noise by active frequency locking to a fiber resonators

J. H. Chow, Ian C. M. Littler, David E. McClelland +1 more

We demonstrate passive filtering of laser relative intensity noise by active frequency locking a laser to a cavity, thereby producing a shot-noise limited optical source suitable for quantum cryptographic communications.

European Conference on Optical Communication•Jan 1, 2008•0 citations

Ultrabroadband Passive Laser Noise Suppression to Quantum Noise Limit through on-chip Second Harmonic Generation

Geun Ho Ahn, Ziyu Wang, Devin J. Dean +5 more

Laser intensity noise limits performance in quantum sensing, metrology, and computing. Existing stabilization methods face a trade-off between bandwidth and complexity: electronic feedback loops are speed-limited, while optical resonators are constrained by narrow linewidths and locking requirements. Here, we demonstrate an all-optical "noise eater" that passively suppresses intensity fluctuations from DC to >10 gigahertz. By leveraging high-efficiency second-harmonic generation in nanophotonic lithium niobate waveguides, we operate at a pump-depletion stationary point where input fluctuations are decoupled from the output to first order. This passive and nonresonant nanophotonic device suppresses relative intensity noise by 25 to 60 dB over the full measurement bandwidth and stabilizes a noisy fiber amplifier output to the shot-noise limit. Our results establish a scalable, wide-bandwidth paradigm for laser stabilization essential for high-throughput quantum technologies and deployable photonic sensing systems.

physics.opticsCross-listedarXiv:2603.25801•Mar 30, 2026•0 citations

Fiber laser-pumped Ti:sapphire laser with ultra-low-intensity noise and frequency stabilization for quantum precision measurement applications

Yingjie Ma, Yutong Wang, Xinxiu Zhou +2 more

We developed a fiber-laser-pumped Ti:sapphire laser system designed for quantum precision measurement applications. By employing a 35 W single-frequency 532 nm fiber laser as the pump source, the system delivered continuous-wave output powers of 4.12 W at 770.108 nm (D 1 line, K), 4.72 W at 780.244 nm (D 2 line, Rb), and 5.29 W at 794.982 nm (D 1 line, Rb), thereby fulfilling the requirements for optical pumping and probing of alkali atoms. To enhance frequency stability, saturated absorption spectroscopy was used to lock the laser frequency, resulting in frequency drifts below 1 MHz over two hours. Furthermore, since low-frequency intensity noise (DC-100 Hz) critically affects spin-relaxation-free quantum sensing, we carried out a theoretical analysis which identified the pump laser as the dominant noise source. By implementing feedback control to the pump source as well as an external noise suppression, both methods achieved over 30 dB of intensity noise suppression within the DC-4kHz frequency range. In addition, improved beam pointing stability further reduced noise below 3 Hz. These results collectively demonstrate the system’s strong potential for quantum sensing applications.

Optics Express•Aug 19, 2025•4 citations

Ultrabroadband Passive Laser Noise Suppression to Quantum Noise Limit via on-chip Second Harmonic Generation

Amir H. Safavi‐Naeini, Geun Ho Ahn, Ziyu Wang +5 more

Abstract Laser intensity noise limits performance in quantum sensing, metrology, and computing. Existing stabilization methods face a trade-off between bandwidth and complexity: electronic feedback loops are speed-limited, while optical resonators are constrained by narrow linewidths and locking requirements. Here, we demonstrate an all-optical "noise eater" that passively suppresses intensity fluctuations from DC to > 10 gigahertz. By leveraging high-efficiency second-harmonic generation in nanophotonic lithium niobate waveguides, we operate at a pump-depletion stationary point where input fluctuations are decoupled from the output to first order. This passive and nonresonant nanophotonic device suppresses relative intensity noise by 25 to 60 dB over the full measurement bandwidth and stabilizes a noisy fiber amplifier output to the shot-noise limit. Our results establish a scalable, wide-bandwidth paradigm for laser stabilization essential for high-throughput quantum technologies and deployable photonic sensing systems.

•Mar 25, 2026•0 citations

Broadband near-to-shot-noise suppression of arbitrary cw-laser excess intensity noise in the gigahertz range

Ernest A. Michael, Laurent Pallanca

Broadband near-to-shot-noise suppression of the intensity noise from a continuous-wave (cw) fiber laser at 1550 nm is demonstrated at GHz-frequencies using feed-forward phase-matched destructive noise interference impressed onto the optical signal with a fiber electro-optic power modulator. The scheme is independent of the laser frequency and therefore is suitable for tunable lasers. It can be used with some modifications after an optical fiber-amplifier boosting a cw laser signal. A noise residual of down to 2 dB above the shot-noise was measured, which is about 2 dB below the prediction with a rigorous noise model. While the total laser noise can be removed, inclusive shot noise, because the latter is still 10 dB above the thermal noise, the power splitter introduces some partition noise above the shot level. In that case, a sub-shot-noise suppression scheme should be possible by replacing the photon anti-correlation of the power splitter by the co-correlation obtained from a paired photon or twin beam source.

Optics Letters•Mar 20, 2015•9 citations
High-stability single-frequency fiber lasers typically exhibit relative intensity noise that is far in excess of shot noise across a broad frequency range extending from dc to many tens of megahertz. This excess noise precludes the use of these fiber lasers in a range of precision interferometry and quantum optics applications. We present experimental results using a passive, highQ, fiber ring resonator to filter out up to 26 dB of excess laser intensity noise, resulting in a stabilized laser output that reaches the shot-noise limit over most of its signal spectrum.
Laser intensity noise limits performance in quantum sensing, metrology, and computing. Existing stabilization methods face a trade-off between bandwidth and complexity: electronic feedback loops are speed-limited, while optical resonators are constrained by narrow linewidths and locking requirements. Here, we demonstrate an all-optical "noise eater" that passively suppresses intensity fluctuations from DC to >10 gigahertz. By leveraging high-efficiency second-harmonic generation in nanophotonic lithium niobate waveguides, we operate at a pump-depletion stationary point where input fluctuations are decoupled from the output to first order. This passive and nonresonant nanophotonic device suppresses relative intensity noise by 25 to 60 dB over the full measurement bandwidth and stabilizes a noisy fiber amplifier output to the shot-noise limit. Our results establish a scalable, wide-bandwidth paradigm for laser stabilization essential for high-throughput quantum technologies and deployable photonic sensing systems.
We developed a fiber-laser-pumped Ti:sapphire laser system designed for quantum precision measurement applications. By employing a 35 W single-frequency 532 nm fiber laser as the pump source, the system delivered continuous-wave output powers of 4.12 W at 770.108 nm (D 1 line, K), 4.72 W at 780.244 nm (D 2 line, Rb), and 5.29 W at 794.982 nm (D 1 line, Rb), thereby fulfilling the requirements for optical pumping and probing of alkali atoms. To enhance frequency stability, saturated absorption spectroscopy was used to lock the laser frequency, resulting in frequency drifts below 1 MHz over two hours. Furthermore, since low-frequency intensity noise (DC-100 Hz) critically affects spin-relaxation-free quantum sensing, we carried out a theoretical analysis which identified the pump laser as the dominant noise source. By implementing feedback control to the pump source as well as an external noise suppression, both methods achieved over 30 dB of intensity noise suppression within the DC-4kHz frequency range. In addition, improved beam pointing stability further reduced noise below 3 Hz. These results collectively demonstrate the system’s strong potential for quantum sensing applications.
Abstract Laser intensity noise limits performance in quantum sensing, metrology, and computing. Existing stabilization methods face a trade-off between bandwidth and complexity: electronic feedback loops are speed-limited, while optical resonators are constrained by narrow linewidths and locking requirements. Here, we demonstrate an all-optical "noise eater" that passively suppresses intensity fluctuations from DC to > 10 gigahertz. By leveraging high-efficiency second-harmonic generation in nanophotonic lithium niobate waveguides, we operate at a pump-depletion stationary point where input fluctuations are decoupled from the output to first order. This passive and nonresonant nanophotonic device suppresses relative intensity noise by 25 to 60 dB over the full measurement bandwidth and stabilizes a noisy fiber amplifier output to the shot-noise limit. Our results establish a scalable, wide-bandwidth paradigm for laser stabilization essential for high-throughput quantum technologies and deployable photonic sensing systems.
Broadband near-to-shot-noise suppression of the intensity noise from a continuous-wave (cw) fiber laser at 1550 nm is demonstrated at GHz-frequencies using feed-forward phase-matched destructive noise interference impressed onto the optical signal with a fiber electro-optic power modulator. The scheme is independent of the laser frequency and therefore is suitable for tunable lasers. It can be used with some modifications after an optical fiber-amplifier boosting a cw laser signal. A noise residual of down to 2 dB above the shot-noise was measured, which is about 2 dB below the prediction with a rigorous noise model. While the total laser noise can be removed, inclusive shot noise, because the latter is still 10 dB above the thermal noise, the power splitter introduces some partition noise above the shot level. In that case, a sub-shot-noise suppression scheme should be possible by replacing the photon anti-correlation of the power splitter by the co-correlation obtained from a paired photon or twin beam source.