© 2026 Aqora Quantum S.A.S.

Terms Privacy Legal Notice

IEEE Journal of Quantum Electronics

Theoretical Analysis of Noise in Erbium Doped Fiber Amplifier

Alexander William Setiawan Putra, Minoru Yamada, Hiroyuki Tsuda, Sumiaty Ambran

Published Jun 20, 2017• 18 citations

Abstract

Characteristics of noise in erbium doped fiber amplifier (EDFA) are theoretically analyzed and experimentally verified. Four discreet energy models are used for erbium ion transition. Spatially varying photon number for traveling optical field was defined in a spatially divided segment with finite length, whose length is decided by property of the spontaneous emission. Quantitative evaluation of the Langevin noise sources becomes possible by this model. The amplified spontaneous emission was included in terms of discrete longitudinal mode, which is defined for whole length of the EDFA. It was found that the relative intensity noise (RIN) in the EDFA hardly changes with noise frequency in the region higher than several kHz. The phase noise in EDFA also hardly changes with the noise frequency. The frequency noise of the signal light in the EDFA increases proportional to squared value of the noise frequency. The amount of RIN and the phase noise decrease in higher input optical power. Good correspondence between theoretical and experimental results was obtained.

DOI: 10.1109/jqe.2017.2717703

Related papers

Output Photon Number Distribution of Erbium-Doped Fiber Amplifiers

G. Saplakoglu, M. CELIK

Erbium-doped fiber amplifiers (EDFA) are gaining increasing importance in the lightwave communications arena due mainly to their low insertion loss and easy manufacturability. Consequently there is significant motivation in obtaining the photon number distribution at the output of an EDFA taking finite bandwith and line shape of the signal lasers into account. In this paper the photon number distribution at the output of an EDFA resulting from an input wave packet having an arbitrary photon number distribution is evaluated. Previously the output photon number distribution was derived [1] for input fields having Poisson photon number distributions, i.e. for coherent sate input fields. Our treatment is more general in the sense that the input field can be in an arbitrary quantum sate. This generality will enable researchers to evaluate EDFA photon number distributions resulting from non-monochromatic incident fields [for example laser sources with phase and/or intensity noise] simply by using the appropriate input photon number distributions in the equations that will be derived below [see for example [2] for several photon number distributions corresponding to various laser line shapes].

Optical Amplifiers and Their Applications•Jan 1, 1992•2 citations

"Analytical Model of Pulse Amplification in Erbium Doped Fiber Amplifier "

Nour. A. Naser, Muhammed. R. Harb, Hassan Abid Yasser

"Doping a part of the optical fiber core by (Er3+ ) ions in presence of external pumping power will lead to form the erbium-doped fiber amplifier (EDFA).The performance of this optical amplifier depends on (the power and the wavelength of the pumping laser, the power and wavelength of the input signal, amplifier length, ion concentration). These parameters will affect the characteristics of EDFA such as amplifier gain, gain saturation, noise figure and output power. However, these characteristics can be determined by solving the EDFA propagation and rate equations. The solution of these equations of two-level laser medium can be done numerically. In this paper, we are proposed a novel method to solve these equations. The reconstructed results are perfectly coincided the well known numerical results.

Muthanna Journal of Pure Science•Oct 14, 2020•0 citations

The Gain Characteristics and the Optimum Fiber Length of Erbium-doped Fiber Amplifiers

Huang De, Li Zai

An apporoximative theoretical of an erbium-doped fiber amplifier (EDFA) has been proposed in this paper by the rate equation of three-level system. The optimum fiber length is obtained with different pump wavelength by considering the excited-stated-absorption(ESA) in EDFA. The relations between the gain and signal light intensity and pump light intensity are analyzed. It is found that the gain spectrum shape can be changed with the fiber length, which provides the evidence that EDFA is of great potential use in wavelength division multiplexed telecommunication systems.

Optical Communication Technology•Jan 1, 1994•0 citations

Analytical Model of Pulse Amplification inErbium Doped Fiber Amplifier

Muhammed. R. Harb

Doping a part of the optical fiber core by (Er3+ ) ions in presence of external pumping power will lead to form the erbium-doped fiber amplifier (EDFA).The performance of this optical amplifier depends on (the power and the wavelength of the pumping laser, the power and wavelength of the input signal, amplifier length, ion concentration). These parameters will affect the characteristics of EDFA such as amplifier gain, gain saturation, noise figure and output power. However, these characteristics can be determined by solving the EDFA propagation and rate equations. The solution of these equations of two-level laser medium can be done numerically. In this paper, we are proposed a novel method to solve these equations. The reconstructed results are perfectly coincided the well known numerical results.

Muthanna Journal of Pure Science•Dec 30, 2020•0 citations

EDFAs gain and noise figure dependence on the fiber length: comparison between L and C bands

Andrés Anibal Rieznik, W.A. Arellano, Gustavo S. Wiederhecker +2 more

In this paper we perform a theoretical study via simulations of both, Cand L-EDFAs dependence on the fiber length. The model used in all the simulations results here introduced is the well-known modeling of erbium ions as a two level homogeneously broadened system. The propagation equations for the light, coupled with the rate equation for the excited state population of the erbium ions, are solved in both possible directions into the fiber. Numerical simulations give the gain and NF of the amplifier for any input signal and pump powers configuration.

SBMO/IEEE MTT-S International Microwave and Optoelectronics Conference (IMOC)•Mar 1, 2004•3 citations

The effect of upconversion on erbium-doped fiber amplifiers (EDFA)

Zhou Meng

Erbium-doped fiber amplifier(EDFA)efficiency strongly depends on erbium concentration.Highly doped erbium devices show degraded performance when compared with low concentration ones.The mechanism of upconversion is studied and the effect of it on the performance of an EDFA is analyzed numerically,by means of a set of rate equations model.Approximate analytical solutions,for the rate equations,which include the effect of the upconversion,are presented,when the amplified spontaneous emission can be neglected,compared to the pump and signal powers.Results show that the pump and signal powers all bear degradation due to upconversion.,and the effect can't be neglected when the Er3+ concentration is larger than 2.95×1025 m-3.

Optical Technique•Jan 1, 2006•0 citations

Characteristics of noise in erbium doped fiber amplifier (EDFA) are theoretically analyzed and experimentally verified. Four discreet energy models are used for erbium ion transition. Spatially varying photon number for traveling optical field was defined in a spatially divided segment with finite length, whose length is decided by property of the spontaneous emission. Quantitative evaluation of the Langevin noise sources becomes possible by this model. The amplified spontaneous emission was included in terms of discrete longitudinal mode, which is defined for whole length of the EDFA. It was found that the relative intensity noise (RIN) in the EDFA hardly changes with noise frequency in the region higher than several kHz. The phase noise in EDFA also hardly changes with the noise frequency. The frequency noise of the signal light in the EDFA increases proportional to squared value of the noise frequency. The amount of RIN and the phase noise decrease in higher input optical power. Good correspondence between theoretical and experimental results was obtained.

Erbium-doped fiber amplifiers (EDFA) are gaining increasing importance in the lightwave communications arena due mainly to their low insertion loss and easy manufacturability. Consequently there is significant motivation in obtaining the photon number distribution at the output of an EDFA taking finite bandwith and line shape of the signal lasers into account. In this paper the photon number distribution at the output of an EDFA resulting from an input wave packet having an arbitrary photon number distribution is evaluated. Previously the output photon number distribution was derived [1] for input fields having Poisson photon number distributions, i.e. for coherent sate input fields. Our treatment is more general in the sense that the input field can be in an arbitrary quantum sate. This generality will enable researchers to evaluate EDFA photon number distributions resulting from non-monochromatic incident fields [for example laser sources with phase and/or intensity noise] simply by using the appropriate input photon number distributions in the equations that will be derived below [see for example [2] for several photon number distributions corresponding to various laser line shapes].

"Doping a part of the optical fiber core by (Er3+ ) ions in presence of external pumping power will lead to form the erbium-doped fiber amplifier (EDFA).The performance of this optical amplifier depends on (the power and the wavelength of the pumping laser, the power and wavelength of the input signal, amplifier length, ion concentration). These parameters will affect the characteristics of EDFA such as amplifier gain, gain saturation, noise figure and output power. However, these characteristics can be determined by solving the EDFA propagation and rate equations. The solution of these equations of two-level laser medium can be done numerically. In this paper, we are proposed a novel method to solve these equations. The reconstructed results are perfectly coincided the well known numerical results.

An apporoximative theoretical of an erbium-doped fiber amplifier (EDFA) has been proposed in this paper by the rate equation of three-level system. The optimum fiber length is obtained with different pump wavelength by considering the excited-stated-absorption(ESA) in EDFA. The relations between the gain and signal light intensity and pump light intensity are analyzed. It is found that the gain spectrum shape can be changed with the fiber length, which provides the evidence that EDFA is of great potential use in wavelength division multiplexed telecommunication systems.

Doping a part of the optical fiber core by (Er3+ ) ions in presence of external pumping power will lead to form the erbium-doped fiber amplifier (EDFA).The performance of this optical amplifier depends on (the power and the wavelength of the pumping laser, the power and wavelength of the input signal, amplifier length, ion concentration). These parameters will affect the characteristics of EDFA such as amplifier gain, gain saturation, noise figure and output power. However, these characteristics can be determined by solving the EDFA propagation and rate equations. The solution of these equations of two-level laser medium can be done numerically. In this paper, we are proposed a novel method to solve these equations. The reconstructed results are perfectly coincided the well known numerical results.

In this paper we perform a theoretical study via simulations of both, Cand L-EDFAs dependence on the fiber length. The model used in all the simulations results here introduced is the well-known modeling of erbium ions as a two level homogeneously broadened system. The propagation equations for the light, coupled with the rate equation for the excited state population of the erbium ions, are solved in both possible directions into the fiber. Numerical simulations give the gain and NF of the amplifier for any input signal and pump powers configuration.

Erbium-doped fiber amplifier(EDFA)efficiency strongly depends on erbium concentration.Highly doped erbium devices show degraded performance when compared with low concentration ones.The mechanism of upconversion is studied and the effect of it on the performance of an EDFA is analyzed numerically,by means of a set of rate equations model.Approximate analytical solutions,for the rate equations,which include the effect of the upconversion,are presented,when the amplified spontaneous emission can be neglected,compared to the pump and signal powers.Results show that the pump and signal powers all bear degradation due to upconversion.,and the effect can't be neglected when the Er3+ concentration is larger than 2.95×1025 m-3.