Challenges
Datasets
Workspaces
Papers
Discussions
Leaderboard
Log inSign up
Challenges
Datasets
Workspaces
Papers
Discussions
Leaderboard
Blog
Job Board
Q3AS

© 2026 Aqora Quantum S.A.S.

TermsPrivacyLegal Notice

Muthanna Journal of Pure Science

"Analytical Model of Pulse Amplification in Erbium Doped Fiber Amplifier "

Nour. A. Naser, Muhammed. R. Harb, Hassan Abid Yasser

Published Oct 14, 2020• 0 citations
Publisher

Abstract

"Doping a part of the optical fiber core by (Er3+ ) ions in presence of external pumping power will lead to form the erbium-doped fiber amplifier (EDFA).The performance of this optical amplifier depends on (the power and the wavelength of the pumping laser, the power and wavelength of the input signal, amplifier length, ion concentration). These parameters will affect the characteristics of EDFA such as amplifier gain, gain saturation, noise figure and output power. However, these characteristics can be determined by solving the EDFA propagation and rate equations. The solution of these equations of two-level laser medium can be done numerically. In this paper, we are proposed a novel method to solve these equations. The reconstructed results are perfectly coincided the well known numerical results.

DOI
10.52113/2/07.02.2020/38-48

Related papers

Analytical Model of Pulse Amplification inErbium Doped Fiber Amplifier

Muhammed. R. Harb

Doping a part of the optical fiber core by (Er3+ ) ions in presence of external pumping power will lead to form the erbium-doped fiber amplifier (EDFA).The performance of this optical amplifier depends on (the power and the wavelength of the pumping laser, the power and wavelength of the input signal, amplifier length, ion concentration). These parameters will affect the characteristics of EDFA such as amplifier gain, gain saturation, noise figure and output power. However, these characteristics can be determined by solving the EDFA propagation and rate equations. The solution of these equations of two-level laser medium can be done numerically. In this paper, we are proposed a novel method to solve these equations. The reconstructed results are perfectly coincided the well known numerical results.

Muthanna Journal of Pure Science•Dec 30, 2020•0 citations

Analysis of the effect of upconversion on signal amplification in erbium-doped fiber amplifiers (EDFAs)

Inna Nusinsky, Amos A. Hardy

The effect of homogeneous upconversion on the performance of an erbium-doped fiber amplifier (EDFA) is analyzed numerically, by means of a set of rate equations model. In particular, the influence of pump power, signal power, and Er/sup 3+/ concentration on the degradation, due to upconversion, is examined. Forward pumping is considered and amplified spontaneous emission, as well as scattering loss are taken into account. In addition, approximate analytical solutions, for the rate equations, which include the effect of the cooperative upconversion, are presented. It is shown that under the considered conditions, these analytical solutions provide a good approximation to the exact numerical solution and thus may be used for the design of such amplifiers.

IEEE Journal of Quantum Electronics•Mar 26, 2003•14 citations

The effect of upconversion on erbium-doped fiber amplifiers (EDFA)

Zhou Meng

Erbium-doped fiber amplifier(EDFA)efficiency strongly depends on erbium concentration.Highly doped erbium devices show degraded performance when compared with low concentration ones.The mechanism of upconversion is studied and the effect of it on the performance of an EDFA is analyzed numerically,by means of a set of rate equations model.Approximate analytical solutions,for the rate equations,which include the effect of the upconversion,are presented,when the amplified spontaneous emission can be neglected,compared to the pump and signal powers.Results show that the pump and signal powers all bear degradation due to upconversion.,and the effect can't be neglected when the Er3+ concentration is larger than 2.95×1025 m-3.

Optical Technique•Jan 1, 2006•0 citations

EDFAs gain and noise figure dependence on the fiber length: comparison between L and C bands

Andrés Anibal Rieznik, W.A. Arellano, Gustavo S. Wiederhecker +2 more

In this paper we perform a theoretical study via simulations of both, Cand L-EDFAs dependence on the fiber length. The model used in all the simulations results here introduced is the well-known modeling of erbium ions as a two level homogeneously broadened system. The propagation equations for the light, coupled with the rate equation for the excited state population of the erbium ions, are solved in both possible directions into the fiber. Numerical simulations give the gain and NF of the amplifier for any input signal and pump powers configuration.

SBMO/IEEE MTT-S International Microwave and Optoelectronics Conference (IMOC)•Mar 1, 2004•3 citations

The Gain Characteristics and the Optimum Fiber Length of Erbium-doped Fiber Amplifiers

Huang De, Li Zai

An apporoximative theoretical of an erbium-doped fiber amplifier (EDFA) has been proposed in this paper by the rate equation of three-level system. The optimum fiber length is obtained with different pump wavelength by considering the excited-stated-absorption(ESA) in EDFA. The relations between the gain and signal light intensity and pump light intensity are analyzed. It is found that the gain spectrum shape can be changed with the fiber length, which provides the evidence that EDFA is of great potential use in wavelength division multiplexed telecommunication systems.

Optical Communication Technology•Jan 1, 1994•0 citations

Effects of concentration on the performance of erbium-doped fiber amplifiers

Piotr Myslinski, Dan Trung Nguyen, Jacek Chrostowski

The dependence of erbium-doped fiber amplifier (EDFA) performance on the erbium ion concentration is studied experimentally and theoretically. The quantum efficiency of the amplifier is found to he strongly dependent on the erbium ion concentration, the signal wavelength, and the relative propagation direction of the pump and signal beams. This dependence is fully explained by the presence of an upconversion mechanism between ions residing in pairs or larger clusters and suggests that other sources of amplifier performance degradation (back-ground loss, excited state absorption, homogenous upconversion) are negligible. The experimental data show that in the present EDFA designs with over 80% quantum/conversion efficiency, the aluminum co-doped fibers with erbium ion concentration less than 20/spl times/10/sup 24/ m/sup -3/ (900 molar ppm Er/sup 3+/) are most suitable.

Journal of Lightwave Technology•Jan 1, 1997•221 citations
"Doping a part of the optical fiber core by (Er3+ ) ions in presence of external pumping power will lead to form the erbium-doped fiber amplifier (EDFA).The performance of this optical amplifier depends on (the power and the wavelength of the pumping laser, the power and wavelength of the input signal, amplifier length, ion concentration). These parameters will affect the characteristics of EDFA such as amplifier gain, gain saturation, noise figure and output power. However, these characteristics can be determined by solving the EDFA propagation and rate equations. The solution of these equations of two-level laser medium can be done numerically. In this paper, we are proposed a novel method to solve these equations. The reconstructed results are perfectly coincided the well known numerical results.
Doping a part of the optical fiber core by (Er3+ ) ions in presence of external pumping power will lead to form the erbium-doped fiber amplifier (EDFA).The performance of this optical amplifier depends on (the power and the wavelength of the pumping laser, the power and wavelength of the input signal, amplifier length, ion concentration). These parameters will affect the characteristics of EDFA such as amplifier gain, gain saturation, noise figure and output power. However, these characteristics can be determined by solving the EDFA propagation and rate equations. The solution of these equations of two-level laser medium can be done numerically. In this paper, we are proposed a novel method to solve these equations. The reconstructed results are perfectly coincided the well known numerical results.
The effect of homogeneous upconversion on the performance of an erbium-doped fiber amplifier (EDFA) is analyzed numerically, by means of a set of rate equations model. In particular, the influence of pump power, signal power, and Er/sup 3+/ concentration on the degradation, due to upconversion, is examined. Forward pumping is considered and amplified spontaneous emission, as well as scattering loss are taken into account. In addition, approximate analytical solutions, for the rate equations, which include the effect of the cooperative upconversion, are presented. It is shown that under the considered conditions, these analytical solutions provide a good approximation to the exact numerical solution and thus may be used for the design of such amplifiers.
Erbium-doped fiber amplifier(EDFA)efficiency strongly depends on erbium concentration.Highly doped erbium devices show degraded performance when compared with low concentration ones.The mechanism of upconversion is studied and the effect of it on the performance of an EDFA is analyzed numerically,by means of a set of rate equations model.Approximate analytical solutions,for the rate equations,which include the effect of the upconversion,are presented,when the amplified spontaneous emission can be neglected,compared to the pump and signal powers.Results show that the pump and signal powers all bear degradation due to upconversion.,and the effect can't be neglected when the Er3+ concentration is larger than 2.95×1025 m-3.
In this paper we perform a theoretical study via simulations of both, Cand L-EDFAs dependence on the fiber length. The model used in all the simulations results here introduced is the well-known modeling of erbium ions as a two level homogeneously broadened system. The propagation equations for the light, coupled with the rate equation for the excited state population of the erbium ions, are solved in both possible directions into the fiber. Numerical simulations give the gain and NF of the amplifier for any input signal and pump powers configuration.
An apporoximative theoretical of an erbium-doped fiber amplifier (EDFA) has been proposed in this paper by the rate equation of three-level system. The optimum fiber length is obtained with different pump wavelength by considering the excited-stated-absorption(ESA) in EDFA. The relations between the gain and signal light intensity and pump light intensity are analyzed. It is found that the gain spectrum shape can be changed with the fiber length, which provides the evidence that EDFA is of great potential use in wavelength division multiplexed telecommunication systems.
The dependence of erbium-doped fiber amplifier (EDFA) performance on the erbium ion concentration is studied experimentally and theoretically. The quantum efficiency of the amplifier is found to he strongly dependent on the erbium ion concentration, the signal wavelength, and the relative propagation direction of the pump and signal beams. This dependence is fully explained by the presence of an upconversion mechanism between ions residing in pairs or larger clusters and suggests that other sources of amplifier performance degradation (back-ground loss, excited state absorption, homogenous upconversion) are negligible. The experimental data show that in the present EDFA designs with over 80% quantum/conversion efficiency, the aluminum co-doped fibers with erbium ion concentration less than 20/spl times/10/sup 24/ m/sup -3/ (900 molar ppm Er/sup 3+/) are most suitable.