Challenges
Datasets
Workspaces
Papers
Discussions
Leaderboard
Log inSign up
Challenges
Datasets
Workspaces
Papers
Discussions
Leaderboard
Blog
Job Board
Q3AS

© 2026 Aqora Quantum S.A.S.

TermsPrivacyLegal Notice

IEEE Journal of Quantum Electronics

Analysis of the effect of upconversion on signal amplification in erbium-doped fiber amplifiers (EDFAs)

Inna Nusinsky, Amos A. Hardy

Published Mar 26, 2003• 14 citations
Publisher

Abstract

The effect of homogeneous upconversion on the performance of an erbium-doped fiber amplifier (EDFA) is analyzed numerically, by means of a set of rate equations model. In particular, the influence of pump power, signal power, and Er/sup 3+/ concentration on the degradation, due to upconversion, is examined. Forward pumping is considered and amplified spontaneous emission, as well as scattering loss are taken into account. In addition, approximate analytical solutions, for the rate equations, which include the effect of the cooperative upconversion, are presented. It is shown that under the considered conditions, these analytical solutions provide a good approximation to the exact numerical solution and thus may be used for the design of such amplifiers.

DOI
10.1109/jqe.2003.809339

Related papers

The effect of upconversion on erbium-doped fiber amplifiers (EDFA)

Zhou Meng

Erbium-doped fiber amplifier(EDFA)efficiency strongly depends on erbium concentration.Highly doped erbium devices show degraded performance when compared with low concentration ones.The mechanism of upconversion is studied and the effect of it on the performance of an EDFA is analyzed numerically,by means of a set of rate equations model.Approximate analytical solutions,for the rate equations,which include the effect of the upconversion,are presented,when the amplified spontaneous emission can be neglected,compared to the pump and signal powers.Results show that the pump and signal powers all bear degradation due to upconversion.,and the effect can't be neglected when the Er3+ concentration is larger than 2.95×1025 m-3.

Optical Technique•Jan 1, 2006•0 citations

Effects of concentration on the performance of erbium-doped fiber amplifiers

Piotr Myslinski, Dan Trung Nguyen, Jacek Chrostowski

The dependence of erbium-doped fiber amplifier (EDFA) performance on the erbium ion concentration is studied experimentally and theoretically. The quantum efficiency of the amplifier is found to he strongly dependent on the erbium ion concentration, the signal wavelength, and the relative propagation direction of the pump and signal beams. This dependence is fully explained by the presence of an upconversion mechanism between ions residing in pairs or larger clusters and suggests that other sources of amplifier performance degradation (back-ground loss, excited state absorption, homogenous upconversion) are negligible. The experimental data show that in the present EDFA designs with over 80% quantum/conversion efficiency, the aluminum co-doped fibers with erbium ion concentration less than 20/spl times/10/sup 24/ m/sup -3/ (900 molar ppm Er/sup 3+/) are most suitable.

Journal of Lightwave Technology•Jan 1, 1997•221 citations

Modeling the gain degradation of high concentration erbium-doped fiber amplifiers by introducing inhomogeneous cooperative up-conversion

H. Masuda, Atsushi Takada, K. Aida

The gain degradation of erbium-doped fiber amplifiers (EDFAs) with high erbium ion (Er/sup 3+/) concentration at 1.48- and 0.98- mu m pump wavelengths is modeled by introducing inhomogeneous cooperative up-conversion (IhCU). General formulas describing the gain degradation as a function of IhCU rate are obtained by solving rate equations for population probabilities in the relevant Er/sup 3+/ energy levels. The experimental results, such as low gain for high Er/sup 3+/ concentration, and higher saturated gain with counterpropagation than with copropagation pumping, which have not yet been explained theoretically, are qualitatively explained by this model. Good agreement between the measured and calculated gain is obtained. The gain degradation characteristics at 1.48- and 0.98- mu m pump wavelengths are analyzed with this model. The advantage of counterpropagation pumping is determined qualitatively. The noise figure degradation is also evaluated.>

Journal of Lightwave Technology•Dec 1, 1992•41 citations

"Analytical Model of Pulse Amplification in Erbium Doped Fiber Amplifier "

Nour. A. Naser, Muhammed. R. Harb, Hassan Abid Yasser

"Doping a part of the optical fiber core by (Er3+ ) ions in presence of external pumping power will lead to form the erbium-doped fiber amplifier (EDFA).The performance of this optical amplifier depends on (the power and the wavelength of the pumping laser, the power and wavelength of the input signal, amplifier length, ion concentration). These parameters will affect the characteristics of EDFA such as amplifier gain, gain saturation, noise figure and output power. However, these characteristics can be determined by solving the EDFA propagation and rate equations. The solution of these equations of two-level laser medium can be done numerically. In this paper, we are proposed a novel method to solve these equations. The reconstructed results are perfectly coincided the well known numerical results.

Muthanna Journal of Pure Science•Oct 14, 2020•0 citations

Analytical Model of Pulse Amplification inErbium Doped Fiber Amplifier

Muhammed. R. Harb

Doping a part of the optical fiber core by (Er3+ ) ions in presence of external pumping power will lead to form the erbium-doped fiber amplifier (EDFA).The performance of this optical amplifier depends on (the power and the wavelength of the pumping laser, the power and wavelength of the input signal, amplifier length, ion concentration). These parameters will affect the characteristics of EDFA such as amplifier gain, gain saturation, noise figure and output power. However, these characteristics can be determined by solving the EDFA propagation and rate equations. The solution of these equations of two-level laser medium can be done numerically. In this paper, we are proposed a novel method to solve these equations. The reconstructed results are perfectly coincided the well known numerical results.

Muthanna Journal of Pure Science•Dec 30, 2020•0 citations

Erbium-doped fiber amplifiers: theory of upconversion-pumped operation with a signal wavelength of 850 nm

Bernard Calvas, Paul Urquhart

A model is presented for erbium-doped fiber amplifiers that operate by an upconversion process in which two pump photons at ~800 nm are absorbed and can provide an inverted population and hence the ability to amplify signal photons at ~850 nm. The most important spectroscopic features of the amplifier are identified and used to formulate a theory that predicts how the amplifier gain varies with fiber length and doping density, as well as with launched pump and signal powers. The limitation that amplified spontaneous emission imposes on the gain is investigated, and useful approximate formulas are derived in the limit where amplified spontaneous emission is negligible.

Journal of the Optical Society of America B•Apr 1, 1993•5 citations
The effect of homogeneous upconversion on the performance of an erbium-doped fiber amplifier (EDFA) is analyzed numerically, by means of a set of rate equations model. In particular, the influence of pump power, signal power, and Er/sup 3+/ concentration on the degradation, due to upconversion, is examined. Forward pumping is considered and amplified spontaneous emission, as well as scattering loss are taken into account. In addition, approximate analytical solutions, for the rate equations, which include the effect of the cooperative upconversion, are presented. It is shown that under the considered conditions, these analytical solutions provide a good approximation to the exact numerical solution and thus may be used for the design of such amplifiers.
Erbium-doped fiber amplifier(EDFA)efficiency strongly depends on erbium concentration.Highly doped erbium devices show degraded performance when compared with low concentration ones.The mechanism of upconversion is studied and the effect of it on the performance of an EDFA is analyzed numerically,by means of a set of rate equations model.Approximate analytical solutions,for the rate equations,which include the effect of the upconversion,are presented,when the amplified spontaneous emission can be neglected,compared to the pump and signal powers.Results show that the pump and signal powers all bear degradation due to upconversion.,and the effect can't be neglected when the Er3+ concentration is larger than 2.95×1025 m-3.
The dependence of erbium-doped fiber amplifier (EDFA) performance on the erbium ion concentration is studied experimentally and theoretically. The quantum efficiency of the amplifier is found to he strongly dependent on the erbium ion concentration, the signal wavelength, and the relative propagation direction of the pump and signal beams. This dependence is fully explained by the presence of an upconversion mechanism between ions residing in pairs or larger clusters and suggests that other sources of amplifier performance degradation (back-ground loss, excited state absorption, homogenous upconversion) are negligible. The experimental data show that in the present EDFA designs with over 80% quantum/conversion efficiency, the aluminum co-doped fibers with erbium ion concentration less than 20/spl times/10/sup 24/ m/sup -3/ (900 molar ppm Er/sup 3+/) are most suitable.
The gain degradation of erbium-doped fiber amplifiers (EDFAs) with high erbium ion (Er/sup 3+/) concentration at 1.48- and 0.98- mu m pump wavelengths is modeled by introducing inhomogeneous cooperative up-conversion (IhCU). General formulas describing the gain degradation as a function of IhCU rate are obtained by solving rate equations for population probabilities in the relevant Er/sup 3+/ energy levels. The experimental results, such as low gain for high Er/sup 3+/ concentration, and higher saturated gain with counterpropagation than with copropagation pumping, which have not yet been explained theoretically, are qualitatively explained by this model. Good agreement between the measured and calculated gain is obtained. The gain degradation characteristics at 1.48- and 0.98- mu m pump wavelengths are analyzed with this model. The advantage of counterpropagation pumping is determined qualitatively. The noise figure degradation is also evaluated.>
"Doping a part of the optical fiber core by (Er3+ ) ions in presence of external pumping power will lead to form the erbium-doped fiber amplifier (EDFA).The performance of this optical amplifier depends on (the power and the wavelength of the pumping laser, the power and wavelength of the input signal, amplifier length, ion concentration). These parameters will affect the characteristics of EDFA such as amplifier gain, gain saturation, noise figure and output power. However, these characteristics can be determined by solving the EDFA propagation and rate equations. The solution of these equations of two-level laser medium can be done numerically. In this paper, we are proposed a novel method to solve these equations. The reconstructed results are perfectly coincided the well known numerical results.
Doping a part of the optical fiber core by (Er3+ ) ions in presence of external pumping power will lead to form the erbium-doped fiber amplifier (EDFA).The performance of this optical amplifier depends on (the power and the wavelength of the pumping laser, the power and wavelength of the input signal, amplifier length, ion concentration). These parameters will affect the characteristics of EDFA such as amplifier gain, gain saturation, noise figure and output power. However, these characteristics can be determined by solving the EDFA propagation and rate equations. The solution of these equations of two-level laser medium can be done numerically. In this paper, we are proposed a novel method to solve these equations. The reconstructed results are perfectly coincided the well known numerical results.
A model is presented for erbium-doped fiber amplifiers that operate by an upconversion process in which two pump photons at ~800 nm are absorbed and can provide an inverted population and hence the ability to amplify signal photons at ~850 nm. The most important spectroscopic features of the amplifier are identified and used to formulate a theory that predicts how the amplifier gain varies with fiber length and doping density, as well as with launched pump and signal powers. The limitation that amplified spontaneous emission imposes on the gain is investigated, and useful approximate formulas are derived in the limit where amplified spontaneous emission is negligible.