Challenges
Datasets
Workspaces
Papers
Discussions
Leaderboard
Log inSign up
Challenges
Datasets
Workspaces
Papers
Discussions
Leaderboard
Blog
Job Board
Q3AS

© 2026 Aqora Quantum S.A.S.

TermsPrivacyLegal Notice

Journal of the Optical Society of America B

Erbium-doped fiber amplifiers: theory of upconversion-pumped operation with a signal wavelength of 850 nm

Bernard Calvas, Paul Urquhart

Published Apr 1, 1993• 5 citations
Publisher

Abstract

A model is presented for erbium-doped fiber amplifiers that operate by an upconversion process in which two pump photons at ~800 nm are absorbed and can provide an inverted population and hence the ability to amplify signal photons at ~850 nm. The most important spectroscopic features of the amplifier are identified and used to formulate a theory that predicts how the amplifier gain varies with fiber length and doping density, as well as with launched pump and signal powers. The limitation that amplified spontaneous emission imposes on the gain is investigated, and useful approximate formulas are derived in the limit where amplified spontaneous emission is negligible.

DOI
10.1364/josab.10.000666

Related papers

The effect of upconversion on erbium-doped fiber amplifiers (EDFA)

Zhou Meng

Erbium-doped fiber amplifier(EDFA)efficiency strongly depends on erbium concentration.Highly doped erbium devices show degraded performance when compared with low concentration ones.The mechanism of upconversion is studied and the effect of it on the performance of an EDFA is analyzed numerically,by means of a set of rate equations model.Approximate analytical solutions,for the rate equations,which include the effect of the upconversion,are presented,when the amplified spontaneous emission can be neglected,compared to the pump and signal powers.Results show that the pump and signal powers all bear degradation due to upconversion.,and the effect can't be neglected when the Er3+ concentration is larger than 2.95×1025 m-3.

Optical Technique•Jan 1, 2006•0 citations

Analysis of the effect of upconversion on signal amplification in erbium-doped fiber amplifiers (EDFAs)

Inna Nusinsky, Amos A. Hardy

The effect of homogeneous upconversion on the performance of an erbium-doped fiber amplifier (EDFA) is analyzed numerically, by means of a set of rate equations model. In particular, the influence of pump power, signal power, and Er/sup 3+/ concentration on the degradation, due to upconversion, is examined. Forward pumping is considered and amplified spontaneous emission, as well as scattering loss are taken into account. In addition, approximate analytical solutions, for the rate equations, which include the effect of the cooperative upconversion, are presented. It is shown that under the considered conditions, these analytical solutions provide a good approximation to the exact numerical solution and thus may be used for the design of such amplifiers.

IEEE Journal of Quantum Electronics•Mar 26, 2003•14 citations

Excited-State Absorption at 1.5 µm in Er3+-Doped Fiber Amplifiers

Peter Blixt, Johan Nilsson, Jurgis Gintautas Babonas +1 more

Erbium-Doped Fiber Amplifiers (EDFAs) can very efficiently convert pump to signal energy. Quantum efficiencies higher than 80 % with 1.48 pm pump [1], and 93% when pumped at 980 nm [2] are reported. However, even higher values should be theoretically possible for an ideal EDFA. Various physical effects may lead to quantum efficiency (QE) reduction. Not all of them are quite well understood yet. At Erbium concentrations above 100 ppm by weight the pump loss is partly explained by energy transfer between two excited ions resulting in upcon- version process [3]. At low concentrations Excited-State Absorption (ESA) could be a more significant effect reducing QE. ESA of photons from 1.5 |im band have been predicted from absorption measurements [4] and also observed [5]. However, to our knowledge, no quantitative analysis has been made which would distinguish between the contributions of ESA and two-particle upconversion when measurements of short wavelength luminescence were performed.

Optical Amplifiers and Their Applications•Jan 1, 1992•2 citations

Rare-earth doped fiber amplifiers for the first telecommunication window

Balakrishnan Sridhar

A complete experimental and theoretical study of rare earth doped fiber-optic amplifiers for the first tele-communication window has been made. The thulium doped fluoride fiber amplifier is shown to provide amplification in the 800nm-820nm signal region. A complete steady state theoretical model has been presented and the model has been experimentally verified. The model predicts the gain, noise figure and the amplified spontaneous emission in the 800nm, 1470nm, 1900nm and 2300nm bands. The effect of population trapping at the $\\sp3F\\sb4$ energy level of thulium ion is also shown with the help of the model. It has been shown that about 5-15%o of the population is trapped at the $\\sp3F\\sb4$ energy level. We have also shown theoretically, the expected gain and noise performance of Thulium doped fluoride fiber amplifiers pumped in the 680nm absorption band. The maximum gain at 806nm is slightly lower than with comparable 780 nm pumping. The gain bandwidth is however found to increase with 680nm pumping. The higher ASE at shorter wavelengths ($<$806nm) reduces the gain at the peak wavelength (806nm). This is a result of the better inversion with three level pumping at 680nm as compared to two level resonant pumping at 780nm. We report an efficient single mode erbium doped flouride fiber amplifier in the 850nm signal band for the first time. The amplification is through an up-conversion process. The erbium doped flouride fiber amplifier was pumped with an estimated pump power of 35mW at 792nm. We have also considered a theoretical model for a single mode erbium doped fluoride fiber amplifier. Efficient amplification occurs because of the strong excited state absorption at the pump wavelength from the $\\sp4I\\sb{13/2}$ energy level.

Journal of Media Literacy Education•Jan 1, 1995•0 citations

Modulation and Gain Modulation Performance of Erbium-Doped Fiber Amplifier Pumped by 980nm-Laser

Dian Liu

The erbium-doped fiber amplifiers pumped by 980 nm-laser can be simplified into two level system.Neglecting amplifier spontaneous emission,we obtained the population of metastable state in steady-state case by Newton-Raphson iteration from EDFA rate equation.Introducing a sinusoidal time variation power as modulation of signal or pump,we got the expression for amplitude and phase modulation of population of metastable state.We got the numerical analytic model of gain modulation and discussed about last simulation results.

Journal of Liaoning University•Jan 1, 2010•0 citations

High-gain erbium-doped traveling-wave fiber amplifier

E. Desurvire, J.R. Simpson, P. C. Becker

Traveling-wave amplification of a lambda = 1.53 microm signal with +22-dB gain is achieved at 295 K in an Er(3+)-doped single-mode fiber using a lambda = 514.5 nm pump source. The optimum fiber length for maximum gain is determined experimentally. A limit in signal-to-noise ratio that is due to concurrent amplification of spontaneous emission is observed. By cooling the fiber to 77 K, the amplifier gain is increased to +29 dB as a result of depopulation of the lower laser level.

Optics Letters•Nov 1, 1987•634 citations
A model is presented for erbium-doped fiber amplifiers that operate by an upconversion process in which two pump photons at ~800 nm are absorbed and can provide an inverted population and hence the ability to amplify signal photons at ~850 nm. The most important spectroscopic features of the amplifier are identified and used to formulate a theory that predicts how the amplifier gain varies with fiber length and doping density, as well as with launched pump and signal powers. The limitation that amplified spontaneous emission imposes on the gain is investigated, and useful approximate formulas are derived in the limit where amplified spontaneous emission is negligible.
Erbium-doped fiber amplifier(EDFA)efficiency strongly depends on erbium concentration.Highly doped erbium devices show degraded performance when compared with low concentration ones.The mechanism of upconversion is studied and the effect of it on the performance of an EDFA is analyzed numerically,by means of a set of rate equations model.Approximate analytical solutions,for the rate equations,which include the effect of the upconversion,are presented,when the amplified spontaneous emission can be neglected,compared to the pump and signal powers.Results show that the pump and signal powers all bear degradation due to upconversion.,and the effect can't be neglected when the Er3+ concentration is larger than 2.95×1025 m-3.
The effect of homogeneous upconversion on the performance of an erbium-doped fiber amplifier (EDFA) is analyzed numerically, by means of a set of rate equations model. In particular, the influence of pump power, signal power, and Er/sup 3+/ concentration on the degradation, due to upconversion, is examined. Forward pumping is considered and amplified spontaneous emission, as well as scattering loss are taken into account. In addition, approximate analytical solutions, for the rate equations, which include the effect of the cooperative upconversion, are presented. It is shown that under the considered conditions, these analytical solutions provide a good approximation to the exact numerical solution and thus may be used for the design of such amplifiers.
Erbium-Doped Fiber Amplifiers (EDFAs) can very efficiently convert pump to signal energy. Quantum efficiencies higher than 80 % with 1.48 pm pump [1], and 93% when pumped at 980 nm [2] are reported. However, even higher values should be theoretically possible for an ideal EDFA. Various physical effects may lead to quantum efficiency (QE) reduction. Not all of them are quite well understood yet. At Erbium concentrations above 100 ppm by weight the pump loss is partly explained by energy transfer between two excited ions resulting in upcon- version process [3]. At low concentrations Excited-State Absorption (ESA) could be a more significant effect reducing QE. ESA of photons from 1.5 |im band have been predicted from absorption measurements [4] and also observed [5]. However, to our knowledge, no quantitative analysis has been made which would distinguish between the contributions of ESA and two-particle upconversion when measurements of short wavelength luminescence were performed.
A complete experimental and theoretical study of rare earth doped fiber-optic amplifiers for the first tele-communication window has been made. The thulium doped fluoride fiber amplifier is shown to provide amplification in the 800nm-820nm signal region. A complete steady state theoretical model has been presented and the model has been experimentally verified. The model predicts the gain, noise figure and the amplified spontaneous emission in the 800nm, 1470nm, 1900nm and 2300nm bands. The effect of population trapping at the sp3Fsb4\\sp3F\\sb4sp3Fsb4 energy level of thulium ion is also shown with the help of the model. It has been shown that about 5-15%o of the population is trapped at the sp3Fsb4\\sp3F\\sb4sp3Fsb4 energy level. We have also shown theoretically, the expected gain and noise performance of Thulium doped fluoride fiber amplifiers pumped in the 680nm absorption band. The maximum gain at 806nm is slightly lower than with comparable 780 nm pumping. The gain bandwidth is however found to increase with 680nm pumping. The higher ASE at shorter wavelengths ($<$806nm) reduces the gain at the peak wavelength (806nm). This is a result of the better inversion with three level pumping at 680nm as compared to two level resonant pumping at 780nm. We report an efficient single mode erbium doped flouride fiber amplifier in the 850nm signal band for the first time. The amplification is through an up-conversion process. The erbium doped flouride fiber amplifier was pumped with an estimated pump power of 35mW at 792nm. We have also considered a theoretical model for a single mode erbium doped fluoride fiber amplifier. Efficient amplification occurs because of the strong excited state absorption at the pump wavelength from the sp4Isb13/2\\sp4I\\sb{13/2}sp4Isb13/2 energy level.
The erbium-doped fiber amplifiers pumped by 980 nm-laser can be simplified into two level system.Neglecting amplifier spontaneous emission,we obtained the population of metastable state in steady-state case by Newton-Raphson iteration from EDFA rate equation.Introducing a sinusoidal time variation power as modulation of signal or pump,we got the expression for amplitude and phase modulation of population of metastable state.We got the numerical analytic model of gain modulation and discussed about last simulation results.