Challenges
Datasets
Workspaces
Papers
Discussions
Leaderboard
Log inSign up
Challenges
Datasets
Workspaces
Papers
Discussions
Leaderboard
Blog
Job Board
Q3AS

© 2026 Aqora Quantum S.A.S.

TermsPrivacyLegal Notice

Joint Conference of the European Frequency and Time Forum and IEEE International Frequency Control Symposium (EFTF/IFCS)

Low Phase Noise Cryogenic Amplifiers and Oscillators Based on Superconducting Resonators

D. Chaudy, Olivier Llopis, Bruno Marcilhac, Yves Lemaître, O. d’Allivy Kelly, J.M. Hodé

Published May 1, 2018• 2 citations
Publisher

Abstract

A cryogenic low phase noise amplifier and an high Q superconductor resonator at 1 GHz have been designed and realized. A good agreement between the measured and simulated data at 80 K for these two devices is observed. An all cryogenic oscillator has also been designed with the same devices on an alumina substrate. This oscillator is still under test.

DOI
10.1109/fcs.2018.8597508

Related papers

Active devices choice and design of an all cryogenic superconductor resonator oscillator

D. Chaudy, Olivier Llopis, Bruno Marcilhac +3 more

Several silicon-germanium bipolar transistors have been measured at cryogenic temperature regarding their gain and phase noise performance. The electrical model of the chosen device has been extracted. Using this model, the phase noise performance of a cryogenic superconductor oscillator has been simulated. The results are very promising, with a phase noise level of -155 dBc/Hz at 1 kHz offset from of a 1 GHz carrier.

Joint Conference of the European Frequency and Time Forum and IEEE International Frequency Control Symposium (EFTF/IFCS)•Jul 1, 2017•4 citations

Design and Analysis on a Cryogenic Current Amplifier with a Superconducting Microwave Resonator

Yuma Okazaki, Nobu‐Hisa Kaneko

We propose a new type of cryogenic current amplifiers, in which low-frequency power spectrum of current can be measured through a measurement of microwave response of a superconducting resonant circuit shunted by a series array of Josephson junctions. From numerical analysis on the equivalent circuit, the numerical value of the input-referred current noise of the proposed amplifier is found to be two orders of magnitude lower than the noise floor measured with the conventional cryogenic current amplifiers based on high-electron-mobility transistors or superconducting quantum interference devices. Our proposal can open new avenues for investigating low-temperature solid-state devices that require lower noise and wider bandwidth power spectrum measurements of current.

arXiv:1508.03131•IEEE International Superconductive Electronics Conference (ISEC)•Jul 1, 2015•0 citations

A wideband cryogenic microwave low-noise amplifier

Boris I Ivanov, Dmitry I. Volkhin, Ilya L. Novikov +5 more

A broadband low-noise four-stage high-electron-mobility transistor amplifier was designed and characterized in a cryogen-free dilution refrigerator at the 3.8 K temperature stage. The obtained power dissipation of the amplifier is below 20 mW. In the frequency range from 6 to 12 GHz its gain exceeds 30 dB. The equivalent noise temperature of the amplifier is below 6 K for the presented frequency range. The amplifier is applicable for any type of cryogenic microwave measurements. As an example we demonstrate here the characterization of the superconducting X-mon qubit coupled to an on-chip coplanar waveguide resonator.

Beilstein Journal of Nanotechnology•Sep 30, 2020•8 citations

Characterization of a low-noise superconductor–insulator–superconductor-based microwave amplifier with local oscillator phase-adjusting architecture

Takafumi Kojima, Sho Masui, Wenlei Shan +1 more

This paper describes a low-noise microwave amplifier based on up- and down-frequency-conversion processes in quasiparticle superconductor–insulator–superconductor (SIS) tunnel junctions. The SIS amplifier was configured with two SIS frequency-converter modules and a cryogenic millimeter-wave isolator inserted between them. Moreover, a local oscillator (LO) using millimeter-wave attenuators and a phase shifter was considered. This setup allowed the control of individual LO power and differential phase in these SIS frequency converters to optimize the amplifier performance. The SIS amplifier showed noise temperatures as low as 11 K and a 6–8 dB gain from nearly DC to 5 GHz. The attained microwave performance is promising for obtaining large-format arrays, such as multibeam heterodyne receivers. Moreover, this two-frequency-converter concept based on SIS junctions might enable microwave applications, such as wideband non-reciprocal circuits in isolators, gyrators, and circulators, which are essential devices in the quantum computing and radio astronomy fields.

Applied Physics Letters•Feb 13, 2023•9 citations

Cryogenic Low Noise Amplifiers and Filters for Superconducting Qubit Readout

Boris I. Ivanov, Dmitry I. Volkhin, Ilya L. Novikov +1 more

We show an experimental study of superconducting X-mon qubit based on low noise wideband measurement setup. The setup includes wide stop-band low frequency filters with a stopband frequency up to 13 GHz, the broadband low-noise cryogenic microwave amplifier (cLNA) operating at 3.8 K. The obtained power dissipation of the cLNA is below 20 mW, the frequency operating ranges from 6 GHz to 12 GHz with a gain of 30 dB. The equivalent noise temperature of the amplifier is bellow 6 K for the presented frequency range. We demonstrate here the characterization of the superconducting X-mon qubit coupled to an on-chip coplanar waveguide resonator. We show standard qubit experiments: one and two-tones qubit spectroscopy, ac-Stark shift experiments for probing and excitation power sweeps.

International Conference of Young Specialists on Micro/Nanotechnologies and Electron Devices•Jun 1, 2020•1 citation

Low-Noise Amplification, Detection and Spectroscopy of Ultra-Cold Systems in RF Cavities

M. H. S. Bukhari, Zahoor H. Shah

The design and development of a cryogenic Ultra-Low-Noise Signal Amplification (ULNA) and detection system for spectroscopy of ultra-cold systems are reported here for the operation in the 0.5 - 4 GHz spectrum of frequencies (the “L” and “S” microwave bands). The design is suitable for weak RF signal detection and spectroscopy from ultra-cold systems confined in cryogenic RF cavities, as entailed in a number of physics, physical chemistry and analytical chemistry applications, such as NMR/NQR/EPR and microwave spectroscopy, Paul traps, Bose-Einstein Condensates (BEC’s) and cavity Quantum Electrodynamics (cQED). Using a generic Low-Noise Amplifier (LNA) architecture for a GaAs enhancement mode High-Electron Mobility FET device, our design has especially been devised for scientific applications where ultra-low-noise amplification systems are sought to amplify and detect weak RF signals under various conditions and environments, including cryogenic temperatures, with the least possible noise susceptibility. The amplifier offers a 16 dB gain and a 0.8 dB noise figure at 2.5 GHz, while operating at room temperature, which can improve significantly at low temperatures. Both dc and RF outputs are provided by the amplifier to integrate it in a closed-loop or continuous-wave spectroscopy system or connect it to a variety of instruments, a factor which is lacking in commercial LNA devices. Following the amplification stage, the RF signal detection is carried out with the help of a post-amplifier and detection system based upon a set of Zero-Bias Schottky Barrier Diodes (ZBD’s) and a high-precision ultra-low noise jFET operational amplifier. The scheme offers unique benefits of sensitive detection and very-low noise amplification for measuring extremely weak on-resonance signals with substantial low- noise response and excellent stability while eliminating complicated and expensive heterodyne schemes. The LNA stage is fully capable to be a part of low-temperature experiments while being operated in cryogenic conditions down to about 500 mK.

Modern Instrumentation•Jan 1, 2016•4 citations
A cryogenic low phase noise amplifier and an high Q superconductor resonator at 1 GHz have been designed and realized. A good agreement between the measured and simulated data at 80 K for these two devices is observed. An all cryogenic oscillator has also been designed with the same devices on an alumina substrate. This oscillator is still under test.
We propose a new type of cryogenic current amplifiers, in which low-frequency power spectrum of current can be measured through a measurement of microwave response of a superconducting resonant circuit shunted by a series array of Josephson junctions. From numerical analysis on the equivalent circuit, the numerical value of the input-referred current noise of the proposed amplifier is found to be two orders of magnitude lower than the noise floor measured with the conventional cryogenic current amplifiers based on high-electron-mobility transistors or superconducting quantum interference devices. Our proposal can open new avenues for investigating low-temperature solid-state devices that require lower noise and wider bandwidth power spectrum measurements of current.
A broadband low-noise four-stage high-electron-mobility transistor amplifier was designed and characterized in a cryogen-free dilution refrigerator at the 3.8 K temperature stage. The obtained power dissipation of the amplifier is below 20 mW. In the frequency range from 6 to 12 GHz its gain exceeds 30 dB. The equivalent noise temperature of the amplifier is below 6 K for the presented frequency range. The amplifier is applicable for any type of cryogenic microwave measurements. As an example we demonstrate here the characterization of the superconducting X-mon qubit coupled to an on-chip coplanar waveguide resonator.
This paper describes a low-noise microwave amplifier based on up- and down-frequency-conversion processes in quasiparticle superconductor–insulator–superconductor (SIS) tunnel junctions. The SIS amplifier was configured with two SIS frequency-converter modules and a cryogenic millimeter-wave isolator inserted between them. Moreover, a local oscillator (LO) using millimeter-wave attenuators and a phase shifter was considered. This setup allowed the control of individual LO power and differential phase in these SIS frequency converters to optimize the amplifier performance. The SIS amplifier showed noise temperatures as low as 11 K and a 6–8 dB gain from nearly DC to 5 GHz. The attained microwave performance is promising for obtaining large-format arrays, such as multibeam heterodyne receivers. Moreover, this two-frequency-converter concept based on SIS junctions might enable microwave applications, such as wideband non-reciprocal circuits in isolators, gyrators, and circulators, which are essential devices in the quantum computing and radio astronomy fields.
We show an experimental study of superconducting X-mon qubit based on low noise wideband measurement setup. The setup includes wide stop-band low frequency filters with a stopband frequency up to 13 GHz, the broadband low-noise cryogenic microwave amplifier (cLNA) operating at 3.8 K. The obtained power dissipation of the cLNA is below 20 mW, the frequency operating ranges from 6 GHz to 12 GHz with a gain of 30 dB. The equivalent noise temperature of the amplifier is bellow 6 K for the presented frequency range. We demonstrate here the characterization of the superconducting X-mon qubit coupled to an on-chip coplanar waveguide resonator. We show standard qubit experiments: one and two-tones qubit spectroscopy, ac-Stark shift experiments for probing and excitation power sweeps.
The design and development of a cryogenic Ultra-Low-Noise Signal Amplification (ULNA) and detection system for spectroscopy of ultra-cold systems are reported here for the operation in the 0.5 - 4 GHz spectrum of frequencies (the “L” and “S” microwave bands). The design is suitable for weak RF signal detection and spectroscopy from ultra-cold systems confined in cryogenic RF cavities, as entailed in a number of physics, physical chemistry and analytical chemistry applications, such as NMR/NQR/EPR and microwave spectroscopy, Paul traps, Bose-Einstein Condensates (BEC’s) and cavity Quantum Electrodynamics (cQED). Using a generic Low-Noise Amplifier (LNA) architecture for a GaAs enhancement mode High-Electron Mobility FET device, our design has especially been devised for scientific applications where ultra-low-noise amplification systems are sought to amplify and detect weak RF signals under various conditions and environments, including cryogenic temperatures, with the least possible noise susceptibility. The amplifier offers a 16 dB gain and a 0.8 dB noise figure at 2.5 GHz, while operating at room temperature, which can improve significantly at low temperatures. Both dc and RF outputs are provided by the amplifier to integrate it in a closed-loop or continuous-wave spectroscopy system or connect it to a variety of instruments, a factor which is lacking in commercial LNA devices. Following the amplification stage, the RF signal detection is carried out with the help of a post-amplifier and detection system based upon a set of Zero-Bias Schottky Barrier Diodes (ZBD’s) and a high-precision ultra-low noise jFET operational amplifier. The scheme offers unique benefits of sensitive detection and very-low noise amplification for measuring extremely weak on-resonance signals with substantial low- noise response and excellent stability while eliminating complicated and expensive heterodyne schemes. The LNA stage is fully capable to be a part of low-temperature experiments while being operated in cryogenic conditions down to about 500 mK.