Challenges
Datasets
Workspaces
Papers
Discussions
Leaderboard
Log inSign up
Challenges
Datasets
Workspaces
Papers
Discussions
Leaderboard
Blog
Job Board
Q3AS

© 2026 Aqora Quantum S.A.S.

TermsPrivacyLegal Notice

Joint Conference of the European Frequency and Time Forum and IEEE International Frequency Control Symposium (EFTF/IFCS)

Active devices choice and design of an all cryogenic superconductor resonator oscillator

D. Chaudy, Olivier Llopis, Bruno Marcilhac, Yves Lemaître, O. d’Allivy Kelly, J.M. Hodé

Published Jul 1, 2017• 4 citations
Publisher

Abstract

Several silicon-germanium bipolar transistors have been measured at cryogenic temperature regarding their gain and phase noise performance. The electrical model of the chosen device has been extracted. Using this model, the phase noise performance of a cryogenic superconductor oscillator has been simulated. The results are very promising, with a phase noise level of -155 dBc/Hz at 1 kHz offset from of a 1 GHz carrier.

DOI
10.1109/fcs.2017.8089050

Related papers

Low Phase Noise Cryogenic Amplifiers and Oscillators Based on Superconducting Resonators

D. Chaudy, Olivier Llopis, Bruno Marcilhac +3 more

A cryogenic low phase noise amplifier and an high Q superconductor resonator at 1 GHz have been designed and realized. A good agreement between the measured and simulated data at 80 K for these two devices is observed. An all cryogenic oscillator has also been designed with the same devices on an alumina substrate. This oscillator is still under test.

Joint Conference of the European Frequency and Time Forum and IEEE International Frequency Control Symposium (EFTF/IFCS)•May 1, 2018•2 citations

Cryogenic preamplification of a single-electron-transistor using a silicon-germanium heterojunction-bipolar-transistor

Matthew Curry, Troy D. England, N. C. Bishop +6 more

We examine a silicon-germanium heterojunction bipolar transistor (HBT) for cryogenic pre-amplification of a single electron transistor (SET). The SET current modulates the base current of the HBT directly. The HBT-SET circuit is immersed in liquid helium, and its frequency response from low frequency to several MHz is measured. The current gain and the noise spectrum with the HBT result in a signal-to-noise-ratio (SNR) that is a factor of 10–100 larger than without the HBT at lower frequencies. The transition frequency defined by SNR = 1 has been extended by as much as a factor of 10 compared to without the HBT amplification. The power dissipated by the HBT cryogenic pre-amplifier is approximately 5 nW to 5 μW for the investigated range of operation. The circuit is also operated in a single electron charge read-out configuration in the time-domain as a proof-of-principle demonstration of the amplification approach for single spin read-out.

arXiv:1509.08201•Applied Physics Letters•May 18, 2015•39 citations

Characterization of a low-noise superconductor–insulator–superconductor-based microwave amplifier with local oscillator phase-adjusting architecture

Takafumi Kojima, Sho Masui, Wenlei Shan +1 more

This paper describes a low-noise microwave amplifier based on up- and down-frequency-conversion processes in quasiparticle superconductor–insulator–superconductor (SIS) tunnel junctions. The SIS amplifier was configured with two SIS frequency-converter modules and a cryogenic millimeter-wave isolator inserted between them. Moreover, a local oscillator (LO) using millimeter-wave attenuators and a phase shifter was considered. This setup allowed the control of individual LO power and differential phase in these SIS frequency converters to optimize the amplifier performance. The SIS amplifier showed noise temperatures as low as 11 K and a 6–8 dB gain from nearly DC to 5 GHz. The attained microwave performance is promising for obtaining large-format arrays, such as multibeam heterodyne receivers. Moreover, this two-frequency-converter concept based on SIS junctions might enable microwave applications, such as wideband non-reciprocal circuits in isolators, gyrators, and circulators, which are essential devices in the quantum computing and radio astronomy fields.

Applied Physics Letters•Feb 13, 2023•9 citations

Use of SiGe bipolar transistors for cryogenic readout of SQUIDs

M. Kiviranta

We have measured characteristics and noise of four commercially available SiGe heterojunction bipolar transistors at 4.2 K. One device exhibits 75 pV Hz −1/2 white noise and a 1/ f noise corner of 20 kHz at 9 mW power dissipation, proving suitable for readout of SQUIDs immersed in liquid He. Another device exhibits 370 pV Hz −1/2 white noise and a 1/ f noise corner of 5 kHz at 50 µW dissipation, and still gives useable gain at 7 µW dissipation. This device is useful for SQUID multiplexers intended for closed-cycle refrigerators, in which the cooling power is limited. The achievable dissipation is even compatible for operation in the low-temperature stages of dilution refrigerators or ADRs. Furthermore, SiGe-based dc SQUID readout with 0.35 μΦ 0 Hz −1/2 flux noise was demonstrated. Applying negative flux feedback yielded a slew rate exceeding 50Φ 0 μs −1 .

Superconductor Science and Technology•Nov 13, 2006•29 citations

A microwave cryogenic low-noise amplifier based on sige heterostructures

Boris I. Ivanov, M. Grajcar, Ilya L. Novikov +2 more

A low-noise cryogenic amplifier for the measurement of weak microwave signals at sub-Kelvin temperatures is constructed. The amplifier has five stages based on SiGe bipolar heterostructure transistors and has a gain factor of 35 dB in the frequency band from 100 MHz to 4 GHz at an operating temperature of 800 mK. The parameters of a superconducting quantum bit measured with this amplifier in the ultralow-power mode are presented as an application example. The amplitude–frequency response of the “supercon-ducting qubit–coplanar cavity” structure is demonstrated. The ground state of the qubit is characterized in the quasi-dispersive measurement mode.

Technical Physics Letters•Apr 1, 2016•19 citations

A wideband cryogenic microwave low-noise amplifier

Boris I Ivanov, Dmitry I. Volkhin, Ilya L. Novikov +5 more

A broadband low-noise four-stage high-electron-mobility transistor amplifier was designed and characterized in a cryogen-free dilution refrigerator at the 3.8 K temperature stage. The obtained power dissipation of the amplifier is below 20 mW. In the frequency range from 6 to 12 GHz its gain exceeds 30 dB. The equivalent noise temperature of the amplifier is below 6 K for the presented frequency range. The amplifier is applicable for any type of cryogenic microwave measurements. As an example we demonstrate here the characterization of the superconducting X-mon qubit coupled to an on-chip coplanar waveguide resonator.

Beilstein Journal of Nanotechnology•Sep 30, 2020•8 citations
Several silicon-germanium bipolar transistors have been measured at cryogenic temperature regarding their gain and phase noise performance. The electrical model of the chosen device has been extracted. Using this model, the phase noise performance of a cryogenic superconductor oscillator has been simulated. The results are very promising, with a phase noise level of -155 dBc/Hz at 1 kHz offset from of a 1 GHz carrier.
We examine a silicon-germanium heterojunction bipolar transistor (HBT) for cryogenic pre-amplification of a single electron transistor (SET). The SET current modulates the base current of the HBT directly. The HBT-SET circuit is immersed in liquid helium, and its frequency response from low frequency to several MHz is measured. The current gain and the noise spectrum with the HBT result in a signal-to-noise-ratio (SNR) that is a factor of 10–100 larger than without the HBT at lower frequencies. The transition frequency defined by SNR = 1 has been extended by as much as a factor of 10 compared to without the HBT amplification. The power dissipated by the HBT cryogenic pre-amplifier is approximately 5 nW to 5 μW for the investigated range of operation. The circuit is also operated in a single electron charge read-out configuration in the time-domain as a proof-of-principle demonstration of the amplification approach for single spin read-out.
This paper describes a low-noise microwave amplifier based on up- and down-frequency-conversion processes in quasiparticle superconductor–insulator–superconductor (SIS) tunnel junctions. The SIS amplifier was configured with two SIS frequency-converter modules and a cryogenic millimeter-wave isolator inserted between them. Moreover, a local oscillator (LO) using millimeter-wave attenuators and a phase shifter was considered. This setup allowed the control of individual LO power and differential phase in these SIS frequency converters to optimize the amplifier performance. The SIS amplifier showed noise temperatures as low as 11 K and a 6–8 dB gain from nearly DC to 5 GHz. The attained microwave performance is promising for obtaining large-format arrays, such as multibeam heterodyne receivers. Moreover, this two-frequency-converter concept based on SIS junctions might enable microwave applications, such as wideband non-reciprocal circuits in isolators, gyrators, and circulators, which are essential devices in the quantum computing and radio astronomy fields.
We have measured characteristics and noise of four commercially available SiGe heterojunction bipolar transistors at 4.2 K. One device exhibits 75 pV Hz −1/2 white noise and a 1/ f noise corner of 20 kHz at 9 mW power dissipation, proving suitable for readout of SQUIDs immersed in liquid He. Another device exhibits 370 pV Hz −1/2 white noise and a 1/ f noise corner of 5 kHz at 50 µW dissipation, and still gives useable gain at 7 µW dissipation. This device is useful for SQUID multiplexers intended for closed-cycle refrigerators, in which the cooling power is limited. The achievable dissipation is even compatible for operation in the low-temperature stages of dilution refrigerators or ADRs. Furthermore, SiGe-based dc SQUID readout with 0.35 μΦ 0 Hz −1/2 flux noise was demonstrated. Applying negative flux feedback yielded a slew rate exceeding 50Φ 0 μs −1 .
A low-noise cryogenic amplifier for the measurement of weak microwave signals at sub-Kelvin temperatures is constructed. The amplifier has five stages based on SiGe bipolar heterostructure transistors and has a gain factor of 35 dB in the frequency band from 100 MHz to 4 GHz at an operating temperature of 800 mK. The parameters of a superconducting quantum bit measured with this amplifier in the ultralow-power mode are presented as an application example. The amplitude–frequency response of the “supercon-ducting qubit–coplanar cavity” structure is demonstrated. The ground state of the qubit is characterized in the quasi-dispersive measurement mode.
A broadband low-noise four-stage high-electron-mobility transistor amplifier was designed and characterized in a cryogen-free dilution refrigerator at the 3.8 K temperature stage. The obtained power dissipation of the amplifier is below 20 mW. In the frequency range from 6 to 12 GHz its gain exceeds 30 dB. The equivalent noise temperature of the amplifier is below 6 K for the presented frequency range. The amplifier is applicable for any type of cryogenic microwave measurements. As an example we demonstrate here the characterization of the superconducting X-mon qubit coupled to an on-chip coplanar waveguide resonator.