Challenges
Datasets
Workspaces
Papers
Discussions
Leaderboard
Log inSign up
Challenges
Datasets
Workspaces
Papers
Discussions
Leaderboard
Blog
Job Board
Q3AS

© 2026 Aqora Quantum S.A.S.

TermsPrivacyLegal Notice

Electronics Letters

Low-noise single-photon detection at wavelength1.55 µm

Philip A. Hiskett, Jason M. Smith, Gerald S. Buller, Paul D. Townsend

Published Aug 16, 2001• 30 citations
Publisher

Abstract

The photon-counting performance of commercially available InGaAs/InP avalanche photodiodes operated in Geiger mode was investigated at temperatures between 77 and 260 K. In particular, their noise equivalent power was measured to be 4 × 10-17 WHz-1/2 at 77 K. The implications of these results in the context of a quantum cryptography application are discussed.

DOI
10.1049/el:20010734

Related papers

Using InP/InGaAs avalanche photodiodes for 1.3 um photon detection

A. A. Anisimov, Andrei V. Medvedev, Sergey I. Markov

InGaAs/InP avalanche photodiode in photon detection mode was researched. The automatic experimental setup was developed. The parameters of single photon detector were optimized for quantum cryptography application in temperature range -38...-57C for 1.3 μm wavelength. Quantum efficiency 16% at quantum bit error rate 10% and dark count probability 7 10-5 at -38C was achieved.

Lasers for Measurements and Information Transfer•Feb 16, 2005•0 citations

Single photon counters in the telecom wavelength region of 1550 nm for quantum information applications

Mohamed Bourennane, Anders Karlsson, M. Mathes +1 more

We report on the performance of commercially available InGaAs/InP avalanche photodiodes for use as single-photon counters in the telecom wavelength region of 1550 nm, and on results for a "photon counting module" giving TTL level logic output.

Conference on Lasers and Electro-Optics Pacific Rim (CLEO-PR)•Nov 13, 2002•0 citations

Single photon counting at telecom wavelength and quantum key distribution

Alexei S. Trifonov, Darius Subacius, Audrius Berzanskis +1 more

A brief overview is given of single photon detector performance requirements for quantum cryptography applications. The analysis is made with respect to restrictions necessary to secure the quantum key distribution channel. InGaAs/InP avalanche photodiode performance is analysed for single photon counting at 1550 nm. Quantum efficiency, dark current and afterpulsing probability (for times up to 100μs after an initial avalanche) are studied in a wider temperature range than previously reported (0deg; C to –80deg;C). We show that photon counting is a bottle-neck in current quantum key distribution systems and provides the source for future performance improvement.

Journal of Modern Optics•Jan 1, 2004•52 citations

A single-photon detector for high-speed telecom-band quantum communication applications

Chuang Liang, Kim Fook Lee, Paul L. Voss +5 more

We present the design and construction of a high-speed telecom-band (1.5 μm) single-photon counting system based on an InGaAs/InP avalanche photodiode (APD) operating in the gated Geiger mode. The detector can be gated at high speeds (we examine its performance up to 25 MHz) to maximize the counting rate in long-distance, telecom-band, fiber-optic quantum communication applications. Narrow gate pulses (250 ps full width at half maximum) are used to reduce the dark-count and the after-pulse probability. In order to count the avalanche events, we employ a high-speed comparator to sample the unfiltered and unamplified avalanche photocurrent. The APD and all the associated electronics are integrated onto a printed circuit board with a computer interface. In addition, we cool the APD to -27°C to reduce the dark-count probability.

Proceedings of SPIE, the International Society for Optical Engineering/Proceedings of SPIE•Aug 18, 2005•6 citations

Single-photon avalanche diode detectors for quantum key distribution

Gerald S. Buller, Ryan E. Warburton, Saverio Pellegrini +5 more

The application of quantum key distribution (QKD) has raised particular demands for single-photon detectors. One of the most promising candidates at the low-loss optical fibre communications windows is the planar geometry InGaAs/InP single-photon avalanche diode. These detectors have been modelled, fabricated and characterised at 1.55 µm wavelength. Their performance in terms of single-photon detection efficiency, dark count rate, timing jitter and afterpulsing behaviour are reported and compared with the best commercially available, linear multiplication avalanche photodiodes operated in Geiger-mode. Their use in the application of QKD is discussed.

IET Optoelectronics•Dec 10, 2007•14 citations

Single Photon Detector Comparison in a Quantum Key Distribution Link Testbed

Jonathan L. Habif, David Pearson, Robert H. Hadfield +3 more

We provide a direct comparison between the InGaAs avalanche photodiode (APD) and the NbN superconducting single photon detector (SSPD) for applications in fiber-based quantum cryptography. The quantum efficiency and dark count rate were measured for each detector, and used to calculate the quantum bit error rate (QBER) and shared key rate for a QKD link. The results indicate that, despite low quantum efficiency, the speed of the SSPD makes it a superior detector for quantum information applications. Finally, we present results of an initial integration of an SSPD into a receiver node of the DARPA quantum network to perform quantum key distribution. Encoding quantum information on single photons has enabled the realization of a number of unique communication schemes such as the implementation of the BB84 protocol for quantum key distribution 1 and quantum dense coding. 2 Furthermore, the implementation of these schemes using photons at telecommunication wavelengths has permitted their extension to fiber optic networks, 3,4 drastically increasing the practicality of quantum information processing. To date, the state of the art in commercially available single photon detection at telecommunication wavelengths (1550 nm) has been the thermo-electrically cooled InGaAs avalanche photodiode (APD). The cooled InGaAs APD is generally operated at T = -60°C in the reverse-biased Geiger mode. Though these detectors have been successfully implemented in operating QKD links in optical fiber, the InGaAs APD suffers from afterpulsing effects that limit the key exchange rates. New SPD (single photon detector) technologies based on superconducting materials are emerging that hold tremendous promise for drastically increasing the photon counting rate and eliminating dark noise.57 The SSPD consists of a NbN thin film (t ∼ 5 nm) patterned into a narrow (w ∼ 100 nm) microstrip meander that is ∼ 500μm in length. The detector is cooled to T < 4K in a closed cycle refrigeration unit and a bias current I b is supplied to the device just below the superconducting critical current (I c ). When a photon is incident upon the microstrip superconductivity is broken in the region local to photon absorption and a normal state region is formed in the device. The current passing through the device causes a measurable voltage pulse in the detector that can be amplified and shaped to act as an input for traditional logic circuitry. Due to the unique electronic bandstructure in a superconducting material the intrinsic response time of the device is on the order of picoseconds, so that the repetition rate may be increased above 1 GHz 8 without being susceptible to afterpulsing effects that plague the InGaAs APD. 9 To make a direct comparison between the InGaAs APD and the SSPD both were placed in a SPD characterization testbed to measure quantum efficiency and dark count rate at a variety of bias conditions. The QBER for a QKD link is calculated from the measured parameters and then compared to requirements for a provably secure QKD link. Following detector characterization, one of the nodes of the DARPA Quantum Network operated by BBN Technologies 3 utilized an SSPD in the receiver to transmit key material. The demonstration provides an in situ comparison between the InGaAs APD, normally operated in the BBN link, and the SSPD.

Applied Physics Letters•Oct 25, 2006•0 citations
The photon-counting performance of commercially available InGaAs/InP avalanche photodiodes operated in Geiger mode was investigated at temperatures between 77 and 260 K. In particular, their noise equivalent power was measured to be 4 × 10-17 WHz-1/2 at 77 K. The implications of these results in the context of a quantum cryptography application are discussed.
A brief overview is given of single photon detector performance requirements for quantum cryptography applications. The analysis is made with respect to restrictions necessary to secure the quantum key distribution channel. InGaAs/InP avalanche photodiode performance is analysed for single photon counting at 1550 nm. Quantum efficiency, dark current and afterpulsing probability (for times up to 100μs after an initial avalanche) are studied in a wider temperature range than previously reported (0deg; C to –80deg;C). We show that photon counting is a bottle-neck in current quantum key distribution systems and provides the source for future performance improvement.
We present the design and construction of a high-speed telecom-band (1.5 μm) single-photon counting system based on an InGaAs/InP avalanche photodiode (APD) operating in the gated Geiger mode. The detector can be gated at high speeds (we examine its performance up to 25 MHz) to maximize the counting rate in long-distance, telecom-band, fiber-optic quantum communication applications. Narrow gate pulses (250 ps full width at half maximum) are used to reduce the dark-count and the after-pulse probability. In order to count the avalanche events, we employ a high-speed comparator to sample the unfiltered and unamplified avalanche photocurrent. The APD and all the associated electronics are integrated onto a printed circuit board with a computer interface. In addition, we cool the APD to -27°C to reduce the dark-count probability.
The application of quantum key distribution (QKD) has raised particular demands for single-photon detectors. One of the most promising candidates at the low-loss optical fibre communications windows is the planar geometry InGaAs/InP single-photon avalanche diode. These detectors have been modelled, fabricated and characterised at 1.55 µm wavelength. Their performance in terms of single-photon detection efficiency, dark count rate, timing jitter and afterpulsing behaviour are reported and compared with the best commercially available, linear multiplication avalanche photodiodes operated in Geiger-mode. Their use in the application of QKD is discussed.
We provide a direct comparison between the InGaAs avalanche photodiode (APD) and the NbN superconducting single photon detector (SSPD) for applications in fiber-based quantum cryptography. The quantum efficiency and dark count rate were measured for each detector, and used to calculate the quantum bit error rate (QBER) and shared key rate for a QKD link. The results indicate that, despite low quantum efficiency, the speed of the SSPD makes it a superior detector for quantum information applications. Finally, we present results of an initial integration of an SSPD into a receiver node of the DARPA quantum network to perform quantum key distribution. Encoding quantum information on single photons has enabled the realization of a number of unique communication schemes such as the implementation of the BB84 protocol for quantum key distribution 1 and quantum dense coding. 2 Furthermore, the implementation of these schemes using photons at telecommunication wavelengths has permitted their extension to fiber optic networks, 3,4 drastically increasing the practicality of quantum information processing. To date, the state of the art in commercially available single photon detection at telecommunication wavelengths (1550 nm) has been the thermo-electrically cooled InGaAs avalanche photodiode (APD). The cooled InGaAs APD is generally operated at T = -60°C in the reverse-biased Geiger mode. Though these detectors have been successfully implemented in operating QKD links in optical fiber, the InGaAs APD suffers from afterpulsing effects that limit the key exchange rates. New SPD (single photon detector) technologies based on superconducting materials are emerging that hold tremendous promise for drastically increasing the photon counting rate and eliminating dark noise.57 The SSPD consists of a NbN thin film (t ∼ 5 nm) patterned into a narrow (w ∼ 100 nm) microstrip meander that is ∼ 500μm in length. The detector is cooled to T < 4K in a closed cycle refrigeration unit and a bias current I b is supplied to the device just below the superconducting critical current (I c ). When a photon is incident upon the microstrip superconductivity is broken in the region local to photon absorption and a normal state region is formed in the device. The current passing through the device causes a measurable voltage pulse in the detector that can be amplified and shaped to act as an input for traditional logic circuitry. Due to the unique electronic bandstructure in a superconducting material the intrinsic response time of the device is on the order of picoseconds, so that the repetition rate may be increased above 1 GHz 8 without being susceptible to afterpulsing effects that plague the InGaAs APD. 9 To make a direct comparison between the InGaAs APD and the SSPD both were placed in a SPD characterization testbed to measure quantum efficiency and dark count rate at a variety of bias conditions. The QBER for a QKD link is calculated from the measured parameters and then compared to requirements for a provably secure QKD link. Following detector characterization, one of the nodes of the DARPA Quantum Network operated by BBN Technologies 3 utilized an SSPD in the receiver to transmit key material. The demonstration provides an in situ comparison between the InGaAs APD, normally operated in the BBN link, and the SSPD.