Challenges
Datasets
Workspaces
Papers
Discussions
Leaderboard
Log inSign up
Challenges
Datasets
Workspaces
Papers
Discussions
Leaderboard
Blog
Job Board
Q3AS

© 2026 Aqora Quantum S.A.S.

TermsPrivacyLegal Notice

TEION KOGAKU (Journal of Cryogenics and Superconductivity Society of Japan)

Superconducting Electronics. Superconductor-Semiconductor Hybrid Device Technologies.

Akira Shoji

Published Jan 1, 1996• 0 citations
Publisher

Abstract

In this paper, the author describes studies on electronic devices and circuits utilizing both of superconductors and semniconductors. First, a design of an interface circuit composed of Josephson junctions and MOSFETs is described. The Josephson-MOS interface circuit will be used for realizing high-speed data communication between a Josephson digital circuit and a semiconductor one. Second, fabrication and characterization of MOSFETs with superconductive NbN gate electrodes are described. The use of superconductive gates makes it easy to hybridize MOSFETs with Josephson junctions. Finally, studies of Josephson-CMOS hybrid memory circuits are introduced.

DOI
10.2221/jcsj.31.601

Related papers

SPICE models and applications of superconducting FETs and higher-voltage Josephson gates

Uttam Ghoshal, T. Van Duzer, Harry Kroger

The authors describe the development of circuit models, applications of superconducting field effect transistors (SFETs), and higher-voltage Josephson junction (HVJJ) circuits which are important for the feasibility of several novel hybrid superconducting-semiconducting circuits. They also discuss the delay optimization involved in designing and embedding interface circuits in a hybrid superconductor-semiconductor technology. It is noted that, with the advances made in semiconductor technologies, interfaces between the two technologies are practical now and the advantages of hybrid circuits in various applications should be realizable in practice. In the case of interfacing typical Nb-based Josephson junction circuits to 0.5 mu m CMOS technologies, it was estimated that the minimum delay through the interface is approximately 110 ps and the optimum number of junctions in each branch of the HVJJ circuits is 10.>

Technical digest - International Electron Devices Meeting/Technical digest•Dec 9, 2002•6 citations

Superconducting/semiconducting hybrids and advance memory concepts for superconducting electronics. Final report, 1 May 1992-30 September 1997

M. R. Beasley, Horowitz

Superconducting logic circuits based on Josephson junctions (JJ) are the fastest, lowest power solid state digital circuit technology known. Large scale integration of such circuits has also been demonstrated. By contrast, current superconducting memory circuits based on flux quantization are not equivalently advanced. Very dense memory chips have not been possible to date and seem unlikely to come without new invention. The goal of this project was to explore alternative approaches to memory that would be compatible with Josephson junction logic circuits and capable of much denser memory arrays. Five new approaches were investigated ranging from modification to the current approach, use of semiconductor CMOS and wholly new concepts based on new physical principles. Three of these were identified as worth pursuing. They are use of cooled CMOS, use of cryogenic hybrid JJ/CMOS memory concepts and a totally new magnetoresistive approach to memory based on the superconductor/ferromagnet proximity effect.

•Nov 1, 1997•0 citations

An interface circuit for a Josephson-CMOS hybrid digital system

Makoto Suzuki, Masaaki Maezawa, Hidetaka Takato +6 more

For broadband data communication between Josephson and CMOS digital systems, amplification of small Josephson-output signals and synchronization between the systems are important issues. We present an interface circuit for a Josephson-CMOS hybrid digital system. The interface circuit consists of a parallel-in-parallel-out (PIPO) circuit and built-in Josephson-MOS amplifiers. The PIPO circuit, implemented based on 4JL latching logic technology, performs synchronized data transfer between the Josephson and CMOS circuits. The Josephson-MOS amplifiers consists of stacked Josephson junctions (Suzuki stacks) and MOS inverters which are monolithically integrated on a chip. The circuits have been designed, fabricated and tested. We have successfully confirmed correct operation of the circuits.

IEEE Transactions on Applied Superconductivity•Jun 1, 1999•22 citations

Can superconductive digital systems compete with semiconductor systems?

Harry Kroger, Uttam Ghoshal

The authors review the current status of silicon microprocessors and memories, and briefly contrast this with the current status of superconducting processors and memories. Possible applications for conventional Josephson computers are mentioned, and the difficulties in supplanting silicon technology by any new technology are discussed. An alternate strategy of hybridizing superconductor and semiconductor circuits is proposed. These hybrid circuits will be able to outperform either technology separately. The hybrid circuits combine the virtues of semiconductor circuits which have high density and excellent manufacturability with the virtues of superconductor circuits which are extremely sensitive in detecting currents and have the capability to drive currents in low impedance lines. The authors examine how hybrid circuits can improve two deficiencies of conventional silicon technology, high power dissipation in interconnection circuits and long memory access times, without requiring the use of many superconductive devices.>

IEEE Transactions on Applied Superconductivity•Mar 1, 1993•7 citations

Superconductive electronics-a high speed and low power technology complementing III-V technologies for advanced systems

Michael Leung, J.W. Spargo, Kevin W. Kobayashi +1 more

Superconductive electronics offers a unique combination of high bandwidth and low power for mission critical hardware such as digital processors at 20 to 100 GHz, microwatt per bit analog to digital converters, large digital switches at multi-Gb/s data rates, and low noise parametric amplifiers. This cryogenic technology, typically operating at a few degrees or a few tens of degrees Kelvin, depends upon the unique physics of superconducting materials such as Nb, NbN, and YBaCuO, and the fundamental circuit element, the Josephson junction (JJ) to create unique architectures of unprecedented design efficiency and performance. These circuits are based on the single flux quantum (SFQ) logic family, a technology that has no parallel in semiconductor electronics. Digital data is transmitted by voltage pulses with amplitude less than 1 mV, but at extremely high speeds. Individual gates have been operated as high as 370 GHz. In this paper, we present a brief overview of superconductive digital technology, describe some recent circuits, and discuss how the challenges to superconductive technology are being met, including the use of multi-chip module (MCM) technology, and the potential use of III-V HBT and HEMT circuits to provide interface drivers and amplifiers, possibly operated cryogenically.

Technical digest -- IEEE Compound Semiconductor Integrated Circuit Symposium•Nov 23, 2002•1 citation

Low-temperature electronics

Randall Kirschman

An overview of semiconductor-based and superconductor-based low-temperature electronics is presented. The general issues of reliability and thermal expansion mismatch are discussed. The discussion of semiconductor electronics starts with a description of a cryogenic supercomputer, the ETA, and then covers devices and materials, noise and applications to signal processing for sensors. Superconductor electronics is then discussed, including signal processing, digital systems, and oscillating junctions. The success of electronics with small numbers of Josephson junctions and the outlook for higher-temperature operation are addressed. Hybrid applications, combining semiconductor and superconductor technologies at the device, circuit, or system level, are examined, highlighting the problems of electrical interfacing and interconnections.>

IEEE Circuits and Devices Magazine•Mar 1, 1990•115 citations
In this paper, the author describes studies on electronic devices and circuits utilizing both of superconductors and semniconductors. First, a design of an interface circuit composed of Josephson junctions and MOSFETs is described. The Josephson-MOS interface circuit will be used for realizing high-speed data communication between a Josephson digital circuit and a semiconductor one. Second, fabrication and characterization of MOSFETs with superconductive NbN gate electrodes are described. The use of superconductive gates makes it easy to hybridize MOSFETs with Josephson junctions. Finally, studies of Josephson-CMOS hybrid memory circuits are introduced.
The authors describe the development of circuit models, applications of superconducting field effect transistors (SFETs), and higher-voltage Josephson junction (HVJJ) circuits which are important for the feasibility of several novel hybrid superconducting-semiconducting circuits. They also discuss the delay optimization involved in designing and embedding interface circuits in a hybrid superconductor-semiconductor technology. It is noted that, with the advances made in semiconductor technologies, interfaces between the two technologies are practical now and the advantages of hybrid circuits in various applications should be realizable in practice. In the case of interfacing typical Nb-based Josephson junction circuits to 0.5 mu m CMOS technologies, it was estimated that the minimum delay through the interface is approximately 110 ps and the optimum number of junctions in each branch of the HVJJ circuits is 10.>
Superconducting logic circuits based on Josephson junctions (JJ) are the fastest, lowest power solid state digital circuit technology known. Large scale integration of such circuits has also been demonstrated. By contrast, current superconducting memory circuits based on flux quantization are not equivalently advanced. Very dense memory chips have not been possible to date and seem unlikely to come without new invention. The goal of this project was to explore alternative approaches to memory that would be compatible with Josephson junction logic circuits and capable of much denser memory arrays. Five new approaches were investigated ranging from modification to the current approach, use of semiconductor CMOS and wholly new concepts based on new physical principles. Three of these were identified as worth pursuing. They are use of cooled CMOS, use of cryogenic hybrid JJ/CMOS memory concepts and a totally new magnetoresistive approach to memory based on the superconductor/ferromagnet proximity effect.
For broadband data communication between Josephson and CMOS digital systems, amplification of small Josephson-output signals and synchronization between the systems are important issues. We present an interface circuit for a Josephson-CMOS hybrid digital system. The interface circuit consists of a parallel-in-parallel-out (PIPO) circuit and built-in Josephson-MOS amplifiers. The PIPO circuit, implemented based on 4JL latching logic technology, performs synchronized data transfer between the Josephson and CMOS circuits. The Josephson-MOS amplifiers consists of stacked Josephson junctions (Suzuki stacks) and MOS inverters which are monolithically integrated on a chip. The circuits have been designed, fabricated and tested. We have successfully confirmed correct operation of the circuits.
The authors review the current status of silicon microprocessors and memories, and briefly contrast this with the current status of superconducting processors and memories. Possible applications for conventional Josephson computers are mentioned, and the difficulties in supplanting silicon technology by any new technology are discussed. An alternate strategy of hybridizing superconductor and semiconductor circuits is proposed. These hybrid circuits will be able to outperform either technology separately. The hybrid circuits combine the virtues of semiconductor circuits which have high density and excellent manufacturability with the virtues of superconductor circuits which are extremely sensitive in detecting currents and have the capability to drive currents in low impedance lines. The authors examine how hybrid circuits can improve two deficiencies of conventional silicon technology, high power dissipation in interconnection circuits and long memory access times, without requiring the use of many superconductive devices.>
Superconductive electronics offers a unique combination of high bandwidth and low power for mission critical hardware such as digital processors at 20 to 100 GHz, microwatt per bit analog to digital converters, large digital switches at multi-Gb/s data rates, and low noise parametric amplifiers. This cryogenic technology, typically operating at a few degrees or a few tens of degrees Kelvin, depends upon the unique physics of superconducting materials such as Nb, NbN, and YBaCuO, and the fundamental circuit element, the Josephson junction (JJ) to create unique architectures of unprecedented design efficiency and performance. These circuits are based on the single flux quantum (SFQ) logic family, a technology that has no parallel in semiconductor electronics. Digital data is transmitted by voltage pulses with amplitude less than 1 mV, but at extremely high speeds. Individual gates have been operated as high as 370 GHz. In this paper, we present a brief overview of superconductive digital technology, describe some recent circuits, and discuss how the challenges to superconductive technology are being met, including the use of multi-chip module (MCM) technology, and the potential use of III-V HBT and HEMT circuits to provide interface drivers and amplifiers, possibly operated cryogenically.
An overview of semiconductor-based and superconductor-based low-temperature electronics is presented. The general issues of reliability and thermal expansion mismatch are discussed. The discussion of semiconductor electronics starts with a description of a cryogenic supercomputer, the ETA, and then covers devices and materials, noise and applications to signal processing for sensors. Superconductor electronics is then discussed, including signal processing, digital systems, and oscillating junctions. The success of electronics with small numbers of Josephson junctions and the outlook for higher-temperature operation are addressed. Hybrid applications, combining semiconductor and superconductor technologies at the device, circuit, or system level, are examined, highlighting the problems of electrical interfacing and interconnections.>