Challenges
Datasets
Workspaces
Papers
Discussions
Leaderboard
Log inSign up
Challenges
Datasets
Workspaces
Papers
Discussions
Leaderboard
Blog
Job Board
Q3AS

© 2026 Aqora Quantum S.A.S.

TermsPrivacyLegal Notice

Proceedings of the IEEE

Josephson shift registers

John X. Przybysz

Published Jan 1, 1989• 7 citations
Publisher

Abstract

A review of Josephson shift-register circuits that have been designed, fabricated, or tested is presented with emphasis on work in the 1980s. Operating speed is most important, since it often limits system performance. Older designs used square-wave clocks, but most modern designs use offset sine waves, with either two or three phases. Operating margins and gate bias uniformity are key concerns. The fastest measured Josephson shift register operated at 2.3 GHz, which compares well with a GaAs shift register that consumes 250 times more power. The difficulties of high-speed testing have prevented many Josephson shift registers from being operated at their highest speeds. Computer simulations suggest that 30-GHz operation is possible with current Nb/Al/sub 2/O/sub 3//Nb technology. Junctions with critical current densities near 10 kA/cm/sup 2/ would make 100-GHz shift registers feasible.>

DOI
10.1109/5.34125

Related papers

Josephson shift register design and layout

John X. Przybysz, Richard D. Blaugher, J. Buttyan

Integrated circuit chips were designed and fabricated, based on a Josephson shift register circuit that simulated operation at 25 GHz using the SPICE program. The 6.25-mm/sup 2/ chip featured a twelve-gate, four-stage shift register fabricated with Nb/AlO/sub x//Nb Josephson junctions with a design value of 2000 A/cm/sup 2/ critical current density. SUPERCOMPACT, a general program for the design of monolithic microwave integrated circuits, was used to model the effects of layout geometry on the uniformity and phase coherence of logic gate bias currents. A layout geometry for the superconductive transmission lines and thin-film bias resistors was developed. The original SPICE-designed circuit was modified as a result of these calculations. Modeling indicated that bias current variations could be limited to 3% for all possible logic states of the shift register, and phase coherence of the gates could be maintained to within 2 degrees at 10 GHz. The fundamental soundness of the circuit design was demonstrated by the proper operation of fabricated shift registers.>

IEEE Transactions on Magnetics•Mar 1, 1989•14 citations

Operation of a 64-bit superconducting shift register at 8 GHz

Perng-Fei Yuh

A 64 b superconducting shift register based on edge-triggered gates has been tested up to 8.45 GHz with two-phase sine wave clocks. The edge-triggered gates are made by serial connection of a Josephson junction and a modified variable threshold gate, fabricated by an Nb-AlO/sub x/-Nb process. Wide operating margins and simple two-phase clocks make this shift register relatively easy to test. Power dissipation is 10 mu W/b.>

IEEE Transactions on Applied Superconductivity•Mar 1, 1993•1 citation

Design and testing of rapid single flux quantum shift registers with magnetically coupled readout gates

Perng-Fei Yuh, Oleg A. Mukhanov

Experimental superconducting shift registers consisting of on-chip clock generators, clock regeneration and distribution circuits, shift register elements, and readout circuits are designed using rapid single flux quantum logic/memory (RSFQ) gates. A 7-b shift register has been tested to 12 GHz and a 17-b to 21 GHz using external triggering clocks with relative delay measurements. Testing with internal clocks generated from Josephson oscillations shows a potential high-speed operation of 45 GHz for the 7-b and 30 GHz for the 17-b shift registers. Two types of magnetically coupled readout gates are discussed. The chips are fabricated using a Nb/AlO/sub /x/Nb Josephson-junction process at a critical-current density of 1000 A/cm/sup 2/. The power dissipation per bit is 3 mu W.>

IEEE Transactions on Applied Superconductivity•Jan 1, 1992•21 citations

A fast Josephson SFQ shift register

F. Kuo, Stephen R. Whiteley, S. M. Faris

A Josephson SFQ (single flux quantum) shift register circuit operating under a two-phase power was designed and tested. The test cell was fabricated using the Nb/AlO/sub x//Nb junction SNEAP process. The main data latch is DC biased; the data storage is accomplished by the transfer of a single flux quantum in or out of a SQUID (superconducting quantum interference device) superconducting loop. A two-phase sinusoidal clock with offset is used to operate the circuit. Simulations verify that the operating frequency can go beyond 70 GHz, with operating margins exceeding 20%. Preliminary measurements indicate that the circuit operates as intended.>

IEEE Transactions on Magnetics•Mar 1, 1989•4 citations

Design of a fast variable-frequency Josephson shift register

V. Nandakumar, T. Van Duzer

The design of a very-high-speed Josephson junction shift register is presented. Computer simulations show that the circuit can be operated with a two-phase sinusoidal clock at frequencies over 60 GHz. The shift register is based on using nonlatching superconducting interferometric switches to shift a bias current between arms of superconducting loops. The operating margins of the circuit are discussed.>

IEEE Transactions on Circuits and Systems•Jan 1, 1988•7 citations

Performance issues in single flux quantum shift registers

J.H. Hang, John X. Przybysz

Testing on a single-flux-quantum (SFQ) shift register fabricated with a SFQ Nb-AlO/sub x/Nb Josephson junction process indicates that a stable flux quantum can be stored in a rapid SFQ (RSFQ) shift register stage and be shifted by SFQ pulses. Design simulations showed that logic errors can occur in SFQ shift registers even though the circuit passes the average voltage test. Three-junction-per-stage shift registers had an advantage over the two-junction-per-stage shift register in handling data with successive 1's and in incorporating resistors to increase tolerance of trapped magnetic flux. Input and output buffers for data and clock pulses were added to get an RSFQ shift register to obtain correct performance. The highest error-free operation speed for the data with successive 1's is about half of the speed for propagation of a lone data 1. Error-free operation of SFQ shift registers with three junctions per stage could be obtained up to speeds of 30-60 GHz with Josephson junctions having I/sub c/R/sub n/ (critical-current-normal-resistance product) values of 600 mu V.>

IEEE Transactions on Applied Superconductivity•Mar 1, 1993•8 citations
A review of Josephson shift-register circuits that have been designed, fabricated, or tested is presented with emphasis on work in the 1980s. Operating speed is most important, since it often limits system performance. Older designs used square-wave clocks, but most modern designs use offset sine waves, with either two or three phases. Operating margins and gate bias uniformity are key concerns. The fastest measured Josephson shift register operated at 2.3 GHz, which compares well with a GaAs shift register that consumes 250 times more power. The difficulties of high-speed testing have prevented many Josephson shift registers from being operated at their highest speeds. Computer simulations suggest that 30-GHz operation is possible with current Nb/Al/sub 2/O/sub 3//Nb technology. Junctions with critical current densities near 10 kA/cm/sup 2/ would make 100-GHz shift registers feasible.>
Integrated circuit chips were designed and fabricated, based on a Josephson shift register circuit that simulated operation at 25 GHz using the SPICE program. The 6.25-mm/sup 2/ chip featured a twelve-gate, four-stage shift register fabricated with Nb/AlO/sub x//Nb Josephson junctions with a design value of 2000 A/cm/sup 2/ critical current density. SUPERCOMPACT, a general program for the design of monolithic microwave integrated circuits, was used to model the effects of layout geometry on the uniformity and phase coherence of logic gate bias currents. A layout geometry for the superconductive transmission lines and thin-film bias resistors was developed. The original SPICE-designed circuit was modified as a result of these calculations. Modeling indicated that bias current variations could be limited to 3% for all possible logic states of the shift register, and phase coherence of the gates could be maintained to within 2 degrees at 10 GHz. The fundamental soundness of the circuit design was demonstrated by the proper operation of fabricated shift registers.>
Experimental superconducting shift registers consisting of on-chip clock generators, clock regeneration and distribution circuits, shift register elements, and readout circuits are designed using rapid single flux quantum logic/memory (RSFQ) gates. A 7-b shift register has been tested to 12 GHz and a 17-b to 21 GHz using external triggering clocks with relative delay measurements. Testing with internal clocks generated from Josephson oscillations shows a potential high-speed operation of 45 GHz for the 7-b and 30 GHz for the 17-b shift registers. Two types of magnetically coupled readout gates are discussed. The chips are fabricated using a Nb/AlO/sub /x/Nb Josephson-junction process at a critical-current density of 1000 A/cm/sup 2/. The power dissipation per bit is 3 mu W.>
A Josephson SFQ (single flux quantum) shift register circuit operating under a two-phase power was designed and tested. The test cell was fabricated using the Nb/AlO/sub x//Nb junction SNEAP process. The main data latch is DC biased; the data storage is accomplished by the transfer of a single flux quantum in or out of a SQUID (superconducting quantum interference device) superconducting loop. A two-phase sinusoidal clock with offset is used to operate the circuit. Simulations verify that the operating frequency can go beyond 70 GHz, with operating margins exceeding 20%. Preliminary measurements indicate that the circuit operates as intended.>
Testing on a single-flux-quantum (SFQ) shift register fabricated with a SFQ Nb-AlO/sub x/Nb Josephson junction process indicates that a stable flux quantum can be stored in a rapid SFQ (RSFQ) shift register stage and be shifted by SFQ pulses. Design simulations showed that logic errors can occur in SFQ shift registers even though the circuit passes the average voltage test. Three-junction-per-stage shift registers had an advantage over the two-junction-per-stage shift register in handling data with successive 1's and in incorporating resistors to increase tolerance of trapped magnetic flux. Input and output buffers for data and clock pulses were added to get an RSFQ shift register to obtain correct performance. The highest error-free operation speed for the data with successive 1's is about half of the speed for propagation of a lone data 1. Error-free operation of SFQ shift registers with three junctions per stage could be obtained up to speeds of 30-60 GHz with Josephson junctions having I/sub c/R/sub n/ (critical-current-normal-resistance product) values of 600 mu V.>