Challenges
Datasets
Workspaces
Papers
Discussions
Leaderboard
Log inSign up
Challenges
Datasets
Workspaces
Papers
Discussions
Leaderboard
Blog
Job Board
Q3AS

© 2026 Aqora Quantum S.A.S.

TermsPrivacyLegal Notice

IEEE Transactions on Applied Superconductivity

Operation of a 64-bit superconducting shift register at 8 GHz

Perng-Fei Yuh

Published Mar 1, 1993• 1 citation
Publisher

Abstract

A 64 b superconducting shift register based on edge-triggered gates has been tested up to 8.45 GHz with two-phase sine wave clocks. The edge-triggered gates are made by serial connection of a Josephson junction and a modified variable threshold gate, fabricated by an Nb-AlO/sub x/-Nb process. Wide operating margins and simple two-phase clocks make this shift register relatively easy to test. Power dissipation is 10 mu W/b.>

DOI
10.1109/77.233985

Related papers

Testing a 4-b shift register at 11 GHz

Perng-Fei Yuh

A 4-bit superconducting shift register based on edge triggered gates has been tested up to 11 GHz with two-phase offset sinewave clocks. The edge triggered gates are made by serial connection of a Josephson junction (JJ) and a modified variable threshold gate, fabricated by a Nb/AlO/sub x//Nb process.>

IEEE Transactions on Applied Superconductivity•Jun 1, 1992•8 citations

A 512-bit shift register using compact two-phase single flux quantum clock generators with large margins and low power

Perng-Fei Yuh

A 512-b shift register was built and tested up to 14.5 GHz. The shift register uses a two-phase clock which is generated by coupling a master control line over many asymmetrically biased two-junction SQUIDs. Compared with other shift registers with Josephson transmission lines to deliver clock, this new clock system provides short delay, low power dissipation, and large DC bias margins. The shift register uses about 3000 Nb/AlO/sub x//Nb Josephson junctions and consumes about 0.1 mW.>

IEEE Transactions on Applied Superconductivity•Jan 1, 1993•2 citations

Josephson shift registers

John X. Przybysz

A review of Josephson shift-register circuits that have been designed, fabricated, or tested is presented with emphasis on work in the 1980s. Operating speed is most important, since it often limits system performance. Older designs used square-wave clocks, but most modern designs use offset sine waves, with either two or three phases. Operating margins and gate bias uniformity are key concerns. The fastest measured Josephson shift register operated at 2.3 GHz, which compares well with a GaAs shift register that consumes 250 times more power. The difficulties of high-speed testing have prevented many Josephson shift registers from being operated at their highest speeds. Computer simulations suggest that 30-GHz operation is possible with current Nb/Al/sub 2/O/sub 3//Nb technology. Junctions with critical current densities near 10 kA/cm/sup 2/ would make 100-GHz shift registers feasible.>

Proceedings of the IEEE•Jan 1, 1989•7 citations

Design and testing of rapid single flux quantum shift registers with magnetically coupled readout gates

Perng-Fei Yuh, Oleg A. Mukhanov

Experimental superconducting shift registers consisting of on-chip clock generators, clock regeneration and distribution circuits, shift register elements, and readout circuits are designed using rapid single flux quantum logic/memory (RSFQ) gates. A 7-b shift register has been tested to 12 GHz and a 17-b to 21 GHz using external triggering clocks with relative delay measurements. Testing with internal clocks generated from Josephson oscillations shows a potential high-speed operation of 45 GHz for the 7-b and 30 GHz for the 17-b shift registers. Two types of magnetically coupled readout gates are discussed. The chips are fabricated using a Nb/AlO/sub /x/Nb Josephson-junction process at a critical-current density of 1000 A/cm/sup 2/. The power dissipation per bit is 3 mu W.>

IEEE Transactions on Applied Superconductivity•Jan 1, 1992•21 citations

Design and Testing of Rapid Single Flux Quantum Shift Registers with Magnetically Coupled

Readout Gates, Perng-Fei Yuh, Oleg A. Mukhanov

Experimental superconducting shift registers con- sisting of on-chip clock generators, clock regeneration and dis- tribution circuits, shift register elements, and readout circuits are designed using rapid single flux quantum logic / memory (RSFQ) gates. A 7-b shift register has been tested to 12 GHz and a 17-b to 21 GHz using external triggering clocks with relative delay measurements. Testing with internal clocks generated from Josephson oscillations shows a potential high-speed opera- tion of 45 GHz for the 7-b and 30 GHz for the 17-b shift registers. Two types of magnetically coupled readout gates are discussed. The chips are fabricated using a Nb/AIO,/Nb Josephson-junction process at a critical-current density of 1000 A / cm2. The power dissipation per bit is 3 p.W.

•Jan 1, 1992•0 citations

A fast Josephson SFQ shift register

F. Kuo, Stephen R. Whiteley, S. M. Faris

A Josephson SFQ (single flux quantum) shift register circuit operating under a two-phase power was designed and tested. The test cell was fabricated using the Nb/AlO/sub x//Nb junction SNEAP process. The main data latch is DC biased; the data storage is accomplished by the transfer of a single flux quantum in or out of a SQUID (superconducting quantum interference device) superconducting loop. A two-phase sinusoidal clock with offset is used to operate the circuit. Simulations verify that the operating frequency can go beyond 70 GHz, with operating margins exceeding 20%. Preliminary measurements indicate that the circuit operates as intended.>

IEEE Transactions on Magnetics•Mar 1, 1989•4 citations
A 64 b superconducting shift register based on edge-triggered gates has been tested up to 8.45 GHz with two-phase sine wave clocks. The edge-triggered gates are made by serial connection of a Josephson junction and a modified variable threshold gate, fabricated by an Nb-AlO/sub x/-Nb process. Wide operating margins and simple two-phase clocks make this shift register relatively easy to test. Power dissipation is 10 mu W/b.>
A review of Josephson shift-register circuits that have been designed, fabricated, or tested is presented with emphasis on work in the 1980s. Operating speed is most important, since it often limits system performance. Older designs used square-wave clocks, but most modern designs use offset sine waves, with either two or three phases. Operating margins and gate bias uniformity are key concerns. The fastest measured Josephson shift register operated at 2.3 GHz, which compares well with a GaAs shift register that consumes 250 times more power. The difficulties of high-speed testing have prevented many Josephson shift registers from being operated at their highest speeds. Computer simulations suggest that 30-GHz operation is possible with current Nb/Al/sub 2/O/sub 3//Nb technology. Junctions with critical current densities near 10 kA/cm/sup 2/ would make 100-GHz shift registers feasible.>
Experimental superconducting shift registers consisting of on-chip clock generators, clock regeneration and distribution circuits, shift register elements, and readout circuits are designed using rapid single flux quantum logic/memory (RSFQ) gates. A 7-b shift register has been tested to 12 GHz and a 17-b to 21 GHz using external triggering clocks with relative delay measurements. Testing with internal clocks generated from Josephson oscillations shows a potential high-speed operation of 45 GHz for the 7-b and 30 GHz for the 17-b shift registers. Two types of magnetically coupled readout gates are discussed. The chips are fabricated using a Nb/AlO/sub /x/Nb Josephson-junction process at a critical-current density of 1000 A/cm/sup 2/. The power dissipation per bit is 3 mu W.>
Experimental superconducting shift registers con- sisting of on-chip clock generators, clock regeneration and dis- tribution circuits, shift register elements, and readout circuits are designed using rapid single flux quantum logic / memory (RSFQ) gates. A 7-b shift register has been tested to 12 GHz and a 17-b to 21 GHz using external triggering clocks with relative delay measurements. Testing with internal clocks generated from Josephson oscillations shows a potential high-speed opera- tion of 45 GHz for the 7-b and 30 GHz for the 17-b shift registers. Two types of magnetically coupled readout gates are discussed. The chips are fabricated using a Nb/AIO,/Nb Josephson-junction process at a critical-current density of 1000 A / cm2. The power dissipation per bit is 3 p.W.
A Josephson SFQ (single flux quantum) shift register circuit operating under a two-phase power was designed and tested. The test cell was fabricated using the Nb/AlO/sub x//Nb junction SNEAP process. The main data latch is DC biased; the data storage is accomplished by the transfer of a single flux quantum in or out of a SQUID (superconducting quantum interference device) superconducting loop. A two-phase sinusoidal clock with offset is used to operate the circuit. Simulations verify that the operating frequency can go beyond 70 GHz, with operating margins exceeding 20%. Preliminary measurements indicate that the circuit operates as intended.>