A multi-element superconducting nanowire single photon detector (MESNSPD) is presented that consists of multiple independently-biased superconducting nanowire single photon detector (SNSPD) elements that form a continuous active area. A two-element SNSPD has been fabricated and tested, showing no measurable crosstalk between the elements, sub-50-ps relative timing jitter, and four times the maximum counting rate of a single SNSPD with the same active area. The MESNSPD can have a larger active area and higher speed than a single-element SNSPD and the input optics can be designed so that the detector provides spatial, spectral or photon number resolution.
A multi-element superconducting nanowire single photon detector (MESNSPD) is presented that consists of multiple independently-biased superconducting nanowire single photon detector (SNSPD) elements that form a continuous active area. A two-element SNSPD has been fabricated and tested, showing no measurable crosstalk between the elements, sub-50-ps relative timing jitter, and four times the maximum counting rate of a single SNSPD with the same active area. The MESNSPD can have a larger active area and higher speed than a single-element SNSPD and the input optics can be designed so that the detector provides spatial, spectral or photon number resolution.
Single-photon detection is extremely important for a number of different applications such as quantum cryptography, CMOS testing and even biomedical research. Most of the applications of single-photon detector require high efficiency combined with high time resolution, high count rates and low dark counts. Superconducting nanowire single-photon detectors has emerged provides this combination unlike any other available single-photon detectors. Some of the applications of superconducting nanowire single-photon detectors (SNSPD's) require larger area SNSPD's without affecting it's performance. For this purpose, multi-pixel SNSPD's would provide a solution. To this end, prototype 4- and 16-pixel detectors have been characterised in terms of a number of performance parameters such as critical current, count rate behaviour and timing jitter. Aside from this, simulations have been performed on detection statistics and relative illumination of the individual pixels of a multi-pixel SNSPD. Results show that for 4-pixel detectors, all desired aspects have been achieved, but not yet combined in one detector. The 16-pixel detectors showed excellent critical currents and count rate behaviour but, most likely due to the fact that they were prototype chips with little to no protection, had several not functioning pixels.
Superconducting Nanowire Single Photon Detectors (SNSPDs) excel at a wide variety of performance criteria for single photon counting. They combine unprecedented high detection efficiency, high timing resolution, high count rates, low intrinsic dark count rates, and are sensitive to ultraviolet through mid-infrared single-photons. At JPL, we are working on several projects to push the performance limits of SNSPDs to achieve higher maximum count rates, larger active areas, higher timing resolution, and a wider spectral range. Our recent advances enable new applications for dark matter detection, imaging, and space-to-ground communication and provide insight into the fundamental physics of single-photon detection in superconducting nanowires.
Detecting spatial and temporal information of individual photons is a crucial technology in today's quantum information science. Among the existing single-photon detectors, superconducting nanowire single-photon detectors (SNSPDs) have been demonstrated with a sub-50 ps timing jitter, near unity detection efficiency1, wide response spectrum from visible to infrared and ~10 ns reset time. However, to gain spatial sensitivity, multiple SNSPDs have to be integrated into an array, whose spatial and temporal resolutions are limited by the multiplexing circuit. Here, we add spatial sensitivity to a single nanowire while preserving the temporal resolution from an SNSPD, thereby turning an SNSPD into a superconducting nanowire single-photon imager (SNSPI). To achieve an SNSPI, we modify a nanowire's electrical behavior from a lumped inductor to a transmission line, where the signal velocity is slowed down to 0.02c (where c is the speed of light). Consequently, we are able to simultaneously read out the landing locations and arrival times of the photons from the output electrical pulses using only two connections. We have demonstrated single-photon imaging by using a 19.7 mm long SNSPI, which is meandered into an imaging area of 286 {\mu}m*193 {\mu}m. The nanowire has a temporal resolution of 50 ps for detecting 1.5 {\mu}m photons. The 2D spatial resolution is 13.0 {\mu}m in the vertical direction and 5.6 {\mu}m in the horizontal direction. The maximum number of resolvable locations (i.e., the effective number of pixels) in such a long nanowire is calculated to be 590. Rather than operating an individual detector in a scanning mode or using SPD arrays, this SNSPI gives an alternative approach to taking large-scale single-photon images and measuring temporal and spatial correlation.
Superconducting nanowire single-photon detectors (SNSPDs) have abstracted widespread attention in the fields of quantum information and quantum photonics due to their high detection efficiency and low dark count rates (DCR). However, single-pixel SNSPDs exist the notable limitations in detection speed and photon number resolution (PNR) capabilities, which pose challenges for practical applications. In this study, we propose a design of a series four-pixel SNSPD that incorporates a SPICE circuit simulation model to achieve PNR and spatial resolution of the four photons in an ideal state, and then determine the optical cavity structure of the detector at the highest light absorption of up to 97% through optical simulation. This design provides a theoretical foundation for the subsequent fabrication of large-area SNSPD with PNR and spatial resolution, significantly improving the flexibility and adaptability of SNSPDs to meet diverse detection requirements. Furthermore, our work also lays a research foundation for multi-photon detection in quantum communication and quantum computing.
Superconducting nanowire single photon detector (SNSPD) has been widely used in quantum communication, quantum computing and other fields because of its excellent timing jitter and response speed. However, due to the mutual restraint of the technical parameters of SNSPD nanowires, there are technical challenges to further improve the comprehensive performance of SNSPD, and thus limiting its application on a large scale. Combining high detection efficiency with high timing performance is still an outstanding challenge. In this work, we report the SNSPD with 12-μm small active area, which has high speed, high efficiency, low jitter and broadband absorption. Au/SiO2 membrane cavity, which is determined by finite element analysis simulation, is used to widen the optical response bandwidth. And it is easier to process and improve the alignment accuracy at the same time. The flat substrate is more conducive to the growth of superconducting thin films, so flattening process is introduced. Device package is also optimized to match smaller detector. Self-aligned packaging makes optical alignment more convenient and time-saving. Special optical fibers with small mode-field diameters can reduce the negative effect of the detector on optical coupling. The detector can achieve a maximum SDE of 82% at the central wavelength of 1310 nm and the temperature of 2.2 K, and the SDE of more than 65% in the wavelength range of 1200–1600 nm, with DCR of 70 cps. The detector also exhibits a count rate of 40 MHz@3 dB and a timing jitter of 38 ps, which is significantly improved compared with 23-μm active area detector. Furthermore, the minimum timing jitter of 22 ps can be obtained by using cryogenic amplifier readout. In this work, high comprehensive performance detector is developed, which provides an important technical reference for practical and product SNSPD.