© 2026 Aqora Quantum S.A.S.

Terms Privacy Legal Notice

arXiv:2406.15312 · ACS Photonics

Enhanced Detection Rate and High Photon-Number Efficiencies with a Scalable Parallel SNSPD

Lorenzo Stasi, Towsif Taher, Giovanni V. Resta, Hugo Zbinden, Rob Thew, Félix Bussières

Published Dec 17, 2024• 26 citations

Abstract

Since their inception, superconducting nanowire single-photon detectors have been enabling quantum optical applications and the rise of the photonic quantum industry. The evolution in the detector design and read-out strategies has led to the introduction of devices with a plurality of independent pixels, which have been able to operate with high system detection efficiency at high speed while also supporting photon number resolution capabilities. However, this comes at the cost of a complex readout that requires one coaxial cable for each pixel of the array. Here, we report a 28-pixel SNSPD with a dedicated parallel architecture that, while maintaining a simple readout with a single coaxial line, enables the detector to operate at high speed with low-performance degradation. The device shows a maximum single-photon efficiency of 88% and is able to maintain its efficiency above 50%, coupled with a timing jitter lower than 80 ps, up to a detection rate of 200 million counts per second. The detector also provides state-of-the-art photon-number-resolving performances with a 2-photon efficiency of 75% and a 3-photon efficiency of 62%.

DOI: 10.1021/acsphotonics.4c01680

Related papers

Superconducting nanowire single-photon detector array with pixel-level photon-number resolution

Chenrui Wang, Chaomeng Ding, Jingxue Chen +6 more

We report a 16-pixel (4×4) superconducting nanowire single-photon detector (SNSPD) array featuring pixel-level photon-number-resolving capability. This multidimensional sensing is enabled by integrating a compact four-element series nanowire architecture into each spatial pixel, allowing direct discrimination of one to four photons. Under single-mode fiber illumination, the device achieves a total system detection efficiency of 41.5%, given the array geometrical fill factor of 53%. Across all channels, the device exhibits reliable multiphoton discrimination, maintaining minimum readout fidelities of 96%, 89%, 73%, and 77% for one- to four-photon states, respectively. Furthermore, independent channel evaluations reveal low timing jitter and negligible inter-channel crosstalk (<0.1 % ). By implementing differentiating pulse shaping for high-flux operation, a maximum single-channel −3 dB count rate of 984 MHz is achieved, establishing an aggregated array bandwidth potential of 8.9 GHz. This sensing architecture may provide a viable pathway toward high-flux single-photon imaging, offering potential applications in quantum optics and light detection and ranging (LiDAR) systems.

Photonics Research•Aug 28, 2026•0 citations

High-speed and high-efficiency superconducting nanowire single photon detector array

Danna Rosenberg, Andrew J. Kerman, R. J. Molnar +1 more

Superconducting nanowire single photon detectors (SNSPDs) have separately demonstrated high efficiency, low noise, and extremely high speed when detecting single photons. However, achieving all of these simultaneously has been limited by detector subtleties and tradeoffs. Here, we report an SNSPD system with <80 ps timing resolution, kHz noise count rates, and 76% fiber-coupled system detection efficiency in the low-flux limit at 1550 nm. We present a model for determining the detection efficiency penalty due to the detection recovery time, and we validate our method using experimental data obtained at high count rates. We demonstrate improved performance tradeoffs, such as 68% system detection efficiency, including losses due to detector recovery time, when coupled to a Poisson source emitting 100 million photons per second. Our system can provide limited photon number resolution, continuous cryogen-free operation, and scalability to future imaging and GHz-count-rate applications.

Optics Express•Jan 14, 2013•191 citations

Characterize the Speed of a Photon-Number-Resolving Superconducting Nanowire Detector

Tao Xu, Hao Hao, Xiang Li +8 more

Superconducting series nanowire single-photon detectors (SNDs) have been used for resolving photon numbers. But it can also exhibit a higher counting rate than a single superconducting nanowire single-photon detector (SNSPD), because the serial architecture allows multiple detectors working in parallel and the inductance of each pixel is reduced. In this paper, we found each pixel of the SND could reset fast although the whole detector took a much longer time for recovering. Therefore, the speed of an SND with a large kinetic inductance of 1.25 μH was characterized and compared to a standard SNSPD with the same total inductance. By measuring the detected photon rate over the input photon rate, we obtained a photon counting rate enhancement by 7.5 times. Meanwhile, the timing jitter of the SND was 63 ps at single photon detection regime. Our results show that the series structure and the readout scheme are quite practical in realizing high speed single-photon detectors besides resolving photon numbers.

IEEE photonics journal•Jul 28, 2020•12 citations

High-efficiency photon-number resolution and 250 Mcps detection rate with a 28-pixel superconducting nanowire single-photon detector

Lorenzo Stasi, Towsif Taher, Giovanni V. Resta +3 more

A 28-pixel superconducting nanowire single-photon detector in a parallel con-figuration is presented, displaying high photon-number efficiencies and 250 Mcps detection rate using only one coaxial cable.

Quantum 2.0 Conference and Exhibition•Jan 1, 2024•0 citations

Characterisation of multi-pixel superconducting nanowire single photon detectors

Jeroen Swens

Single-photon detection is extremely important for a number of different applications such as quantum cryptography, CMOS testing and even biomedical research. Most of the applications of single-photon detector require high efficiency combined with high time resolution, high count rates and low dark counts. Superconducting nanowire single-photon detectors has emerged provides this combination unlike any other available single-photon detectors. Some of the applications of superconducting nanowire single-photon detectors (SNSPD's) require larger area SNSPD's without affecting it's performance. For this purpose, multi-pixel SNSPD's would provide a solution. To this end, prototype 4- and 16-pixel detectors have been characterised in terms of a number of performance parameters such as critical current, count rate behaviour and timing jitter. Aside from this, simulations have been performed on detection statistics and relative illumination of the individual pixels of a multi-pixel SNSPD. Results show that for 4-pixel detectors, all desired aspects have been achieved, but not yet combined in one detector. The 16-pixel detectors showed excellent critical currents and count rate behaviour but, most likely due to the fact that they were prototype chips with little to no protection, had several not functioning pixels.

•Jan 1, 2018•0 citations

High-efficiency 8 × 8 superconducting nanowire single-photon detector array coupled with a 105-μm multimode fiber

Zhen Wan, Jia Huang, You Xiao +8 more

We present an 8 × 8 superconducting nanowire single-photon detector (SNSPD) array that addresses the trade-off between detection efficiency and count rates in large-area devices.The SNSPD array employs a distributed nanowire architecture and a polarization-insensitive optical cavity, when coupled with a 105-μm multimode fiber, achieves a system detection efficiency of 75% at 1064 nm with a count rate of 945 MHz at 3 dB compression and an average timing jitter of <100 ps.This design offers a scalable solution for high-speed photon counting with large-area detection and multimode compatibility.

Chinese Optics Letters•Jan 1, 2025•0 citations

Since their inception, superconducting nanowire single-photon detectors have been enabling quantum optical applications and the rise of the photonic quantum industry. The evolution in the detector design and read-out strategies has led to the introduction of devices with a plurality of independent pixels, which have been able to operate with high system detection efficiency at high speed while also supporting photon number resolution capabilities. However, this comes at the cost of a complex readout that requires one coaxial cable for each pixel of the array. Here, we report a 28-pixel SNSPD with a dedicated parallel architecture that, while maintaining a simple readout with a single coaxial line, enables the detector to operate at high speed with low-performance degradation. The device shows a maximum single-photon efficiency of 88% and is able to maintain its efficiency above 50%, coupled with a timing jitter lower than 80 ps, up to a detection rate of 200 million counts per second. The detector also provides state-of-the-art photon-number-resolving performances with a 2-photon efficiency of 75% and a 3-photon efficiency of 62%.

We report a 16-pixel (4×4) superconducting nanowire single-photon detector (SNSPD) array featuring pixel-level photon-number-resolving capability. This multidimensional sensing is enabled by integrating a compact four-element series nanowire architecture into each spatial pixel, allowing direct discrimination of one to four photons. Under single-mode fiber illumination, the device achieves a total system detection efficiency of 41.5%, given the array geometrical fill factor of 53%. Across all channels, the device exhibits reliable multiphoton discrimination, maintaining minimum readout fidelities of 96%, 89%, 73%, and 77% for one- to four-photon states, respectively. Furthermore, independent channel evaluations reveal low timing jitter and negligible inter-channel crosstalk (<0.1 % ). By implementing differentiating pulse shaping for high-flux operation, a maximum single-channel −3 dB count rate of 984 MHz is achieved, establishing an aggregated array bandwidth potential of 8.9 GHz. This sensing architecture may provide a viable pathway toward high-flux single-photon imaging, offering potential applications in quantum optics and light detection and ranging (LiDAR) systems.

Superconducting nanowire single photon detectors (SNSPDs) have separately demonstrated high efficiency, low noise, and extremely high speed when detecting single photons. However, achieving all of these simultaneously has been limited by detector subtleties and tradeoffs. Here, we report an SNSPD system with <80 ps timing resolution, kHz noise count rates, and 76% fiber-coupled system detection efficiency in the low-flux limit at 1550 nm. We present a model for determining the detection efficiency penalty due to the detection recovery time, and we validate our method using experimental data obtained at high count rates. We demonstrate improved performance tradeoffs, such as 68% system detection efficiency, including losses due to detector recovery time, when coupled to a Poisson source emitting 100 million photons per second. Our system can provide limited photon number resolution, continuous cryogen-free operation, and scalability to future imaging and GHz-count-rate applications.

Superconducting series nanowire single-photon detectors (SNDs) have been used for resolving photon numbers. But it can also exhibit a higher counting rate than a single superconducting nanowire single-photon detector (SNSPD), because the serial architecture allows multiple detectors working in parallel and the inductance of each pixel is reduced. In this paper, we found each pixel of the SND could reset fast although the whole detector took a much longer time for recovering. Therefore, the speed of an SND with a large kinetic inductance of 1.25 μH was characterized and compared to a standard SNSPD with the same total inductance. By measuring the detected photon rate over the input photon rate, we obtained a photon counting rate enhancement by 7.5 times. Meanwhile, the timing jitter of the SND was 63 ps at single photon detection regime. Our results show that the series structure and the readout scheme are quite practical in realizing high speed single-photon detectors besides resolving photon numbers.

Single-photon detection is extremely important for a number of different applications such as quantum cryptography, CMOS testing and even biomedical research. Most of the applications of single-photon detector require high efficiency combined with high time resolution, high count rates and low dark counts. Superconducting nanowire single-photon detectors has emerged provides this combination unlike any other available single-photon detectors. Some of the applications of superconducting nanowire single-photon detectors (SNSPD's) require larger area SNSPD's without affecting it's performance. For this purpose, multi-pixel SNSPD's would provide a solution. To this end, prototype 4- and 16-pixel detectors have been characterised in terms of a number of performance parameters such as critical current, count rate behaviour and timing jitter. Aside from this, simulations have been performed on detection statistics and relative illumination of the individual pixels of a multi-pixel SNSPD. Results show that for 4-pixel detectors, all desired aspects have been achieved, but not yet combined in one detector. The 16-pixel detectors showed excellent critical currents and count rate behaviour but, most likely due to the fact that they were prototype chips with little to no protection, had several not functioning pixels.

We present an 8 × 8 superconducting nanowire single-photon detector (SNSPD) array that addresses the trade-off between detection efficiency and count rates in large-area devices.The SNSPD array employs a distributed nanowire architecture and a polarization-insensitive optical cavity, when coupled with a 105-μm multimode fiber, achieves a system detection efficiency of 75% at 1064 nm with a count rate of 945 MHz at 3 dB compression and an average timing jitter of <100 ps.This design offers a scalable solution for high-speed photon counting with large-area detection and multimode compatibility.