Challenges
Datasets
Workspaces
Papers
Discussions
Leaderboard
Log inSign up
Challenges
Datasets
Workspaces
Papers
Discussions
Leaderboard
Blog
Job Board
Q3AS

© 2026 Aqora Quantum S.A.S.

TermsPrivacyLegal Notice

Quantum 2.0 Conference and Exhibition

High-efficiency photon-number resolution and 250 Mcps detection rate with a 28-pixel superconducting nanowire single-photon detector

Lorenzo Stasi, Towsif Taher, Giovanni V. Resta, Hugo Zbinden, Rob Thew, Félix Bussières

Published Jan 1, 2024• 0 citations
Publisher

Abstract

A 28-pixel superconducting nanowire single-photon detector in a parallel con-figuration is presented, displaying high photon-number efficiencies and 250 Mcps detection rate using only one coaxial cable.
DOI
10.1364/quantum.2024.qm2a.2

Related papers

Enhanced Detection Rate and High Photon-Number Efficiencies with a Scalable Parallel SNSPD

Lorenzo Stasi, Towsif Taher, Giovanni V. Resta +3 more

Since their inception, superconducting nanowire single-photon detectors have been enabling quantum optical applications and the rise of the photonic quantum industry. The evolution in the detector design and read-out strategies has led to the introduction of devices with a plurality of independent pixels, which have been able to operate with high system detection efficiency at high speed while also supporting photon number resolution capabilities. However, this comes at the cost of a complex readout that requires one coaxial cable for each pixel of the array. Here, we report a 28-pixel SNSPD with a dedicated parallel architecture that, while maintaining a simple readout with a single coaxial line, enables the detector to operate at high speed with low-performance degradation. The device shows a maximum single-photon efficiency of 88% and is able to maintain its efficiency above 50%, coupled with a timing jitter lower than 80 ps, up to a detection rate of 200 million counts per second. The detector also provides state-of-the-art photon-number-resolving performances with a 2-photon efficiency of 75% and a 3-photon efficiency of 62%.

arXiv:2406.15312•ACS Photonics•Dec 17, 2024•26 citations

Characterisation of multi-pixel superconducting nanowire single photon detectors

Jeroen Swens

Single-photon detection is extremely important for a number of different applications such as quantum cryptography, CMOS testing and even biomedical research. Most of the applications of single-photon detector require high efficiency combined with high time resolution, high count rates and low dark counts. Superconducting nanowire single-photon detectors has emerged provides this combination unlike any other available single-photon detectors. Some of the applications of superconducting nanowire single-photon detectors (SNSPD's) require larger area SNSPD's without affecting it's performance. For this purpose, multi-pixel SNSPD's would provide a solution. To this end, prototype 4- and 16-pixel detectors have been characterised in terms of a number of performance parameters such as critical current, count rate behaviour and timing jitter. Aside from this, simulations have been performed on detection statistics and relative illumination of the individual pixels of a multi-pixel SNSPD. Results show that for 4-pixel detectors, all desired aspects have been achieved, but not yet combined in one detector. The 16-pixel detectors showed excellent critical currents and count rate behaviour but, most likely due to the fact that they were prototype chips with little to no protection, had several not functioning pixels.

•Jan 1, 2018•0 citations

High-fidelity photon-number-resolution using multi-element superconducting nanowire single photon detectors

Eric A. Dauler, R. J. Molnar, Andrew J. Kerman +5 more

Achieving photon-number-resolution using superconducting nanowire single photon detectors (SNSPDs) can enable high-speed source characterization and high-rate conditional state preparation. We report improved fidelity photon-number-resolution using high system-detection-efficiency four-element SNSPDs.

Conference on Lasers and Electro-Optics•May 4, 2008•0 citations

Fast High-Efficiency Photon-Number-Resolving Parallel Superconducting Nanowire Single-Photon Detector

Lorenzo Stasi, Gaëtan Gras, Riad Berrazouane +3 more

Photon-number-resolving (PNR) single-photon detectors are an enabling technology in many areas, such as photonic quantum computing, nonclassical light-source characterization, and quantum imaging.Here, we demonstrate high-efficiency PNR detectors using a parallel superconducting nanowire singlephoton-detector (P-SNSPD) architecture that does not suffer from crosstalk between the pixels and that is free of latching.The behavior of the detector is modeled and used to predict the possible outcomes given a certain number of incoming photons.We apply our model to a four-pixel P-SNSPD with a system detection efficiency of 92.5%.We also demonstrate how this detector allows reconstructing the photonnumber statistics of a coherent source of light, which paves the way towards the characterization of the photon statistics of other types of light source using a single detector.

arXiv:2207.14538•Physical Review Applied•Jun 13, 2023•41 citations

Design for superconducting nanowire single-photon detectors for photon number resolution and spatial resolution

Ying Yang, Junquan Guo, Yongliang Xu +3 more

Superconducting nanowire single-photon detectors (SNSPDs) have abstracted widespread attention in the fields of quantum information and quantum photonics due to their high detection efficiency and low dark count rates (DCR). However, single-pixel SNSPDs exist the notable limitations in detection speed and photon number resolution (PNR) capabilities, which pose challenges for practical applications. In this study, we propose a design of a series four-pixel SNSPD that incorporates a SPICE circuit simulation model to achieve PNR and spatial resolution of the four photons in an ideal state, and then determine the optical cavity structure of the detector at the highest light absorption of up to 97% through optical simulation. This design provides a theoretical foundation for the subsequent fabrication of large-area SNSPD with PNR and spatial resolution, significantly improving the flexibility and adaptability of SNSPDs to meet diverse detection requirements. Furthermore, our work also lays a research foundation for multi-photon detection in quantum communication and quantum computing.

Sixth Symposium on Novel Optoelectronic Detection Technology and Applications•Feb 17, 2025•0 citations

Characterize the Speed of a Photon-Number-Resolving Superconducting Nanowire Detector

Tao Xu, Hao Hao, Xiang Li +8 more

Superconducting series nanowire single-photon detectors (SNDs) have been used for resolving photon numbers. But it can also exhibit a higher counting rate than a single superconducting nanowire single-photon detector (SNSPD), because the serial architecture allows multiple detectors working in parallel and the inductance of each pixel is reduced. In this paper, we found each pixel of the SND could reset fast although the whole detector took a much longer time for recovering. Therefore, the speed of an SND with a large kinetic inductance of 1.25 μH was characterized and compared to a standard SNSPD with the same total inductance. By measuring the detected photon rate over the input photon rate, we obtained a photon counting rate enhancement by 7.5 times. Meanwhile, the timing jitter of the SND was 63 ps at single photon detection regime. Our results show that the series structure and the readout scheme are quite practical in realizing high speed single-photon detectors besides resolving photon numbers.

IEEE photonics journal•Jul 28, 2020•12 citations
Since their inception, superconducting nanowire single-photon detectors have been enabling quantum optical applications and the rise of the photonic quantum industry. The evolution in the detector design and read-out strategies has led to the introduction of devices with a plurality of independent pixels, which have been able to operate with high system detection efficiency at high speed while also supporting photon number resolution capabilities. However, this comes at the cost of a complex readout that requires one coaxial cable for each pixel of the array. Here, we report a 28-pixel SNSPD with a dedicated parallel architecture that, while maintaining a simple readout with a single coaxial line, enables the detector to operate at high speed with low-performance degradation. The device shows a maximum single-photon efficiency of 88% and is able to maintain its efficiency above 50%, coupled with a timing jitter lower than 80 ps, up to a detection rate of 200 million counts per second. The detector also provides state-of-the-art photon-number-resolving performances with a 2-photon efficiency of 75% and a 3-photon efficiency of 62%.
Single-photon detection is extremely important for a number of different applications such as quantum cryptography, CMOS testing and even biomedical research. Most of the applications of single-photon detector require high efficiency combined with high time resolution, high count rates and low dark counts. Superconducting nanowire single-photon detectors has emerged provides this combination unlike any other available single-photon detectors. Some of the applications of superconducting nanowire single-photon detectors (SNSPD's) require larger area SNSPD's without affecting it's performance. For this purpose, multi-pixel SNSPD's would provide a solution. To this end, prototype 4- and 16-pixel detectors have been characterised in terms of a number of performance parameters such as critical current, count rate behaviour and timing jitter. Aside from this, simulations have been performed on detection statistics and relative illumination of the individual pixels of a multi-pixel SNSPD. Results show that for 4-pixel detectors, all desired aspects have been achieved, but not yet combined in one detector. The 16-pixel detectors showed excellent critical currents and count rate behaviour but, most likely due to the fact that they were prototype chips with little to no protection, had several not functioning pixels.
Photon-number-resolving (PNR) single-photon detectors are an enabling technology in many areas, such as photonic quantum computing, nonclassical light-source characterization, and quantum imaging.Here, we demonstrate high-efficiency PNR detectors using a parallel superconducting nanowire singlephoton-detector (P-SNSPD) architecture that does not suffer from crosstalk between the pixels and that is free of latching.The behavior of the detector is modeled and used to predict the possible outcomes given a certain number of incoming photons.We apply our model to a four-pixel P-SNSPD with a system detection efficiency of 92.5%.We also demonstrate how this detector allows reconstructing the photonnumber statistics of a coherent source of light, which paves the way towards the characterization of the photon statistics of other types of light source using a single detector.
Superconducting nanowire single-photon detectors (SNSPDs) have abstracted widespread attention in the fields of quantum information and quantum photonics due to their high detection efficiency and low dark count rates (DCR). However, single-pixel SNSPDs exist the notable limitations in detection speed and photon number resolution (PNR) capabilities, which pose challenges for practical applications. In this study, we propose a design of a series four-pixel SNSPD that incorporates a SPICE circuit simulation model to achieve PNR and spatial resolution of the four photons in an ideal state, and then determine the optical cavity structure of the detector at the highest light absorption of up to 97% through optical simulation. This design provides a theoretical foundation for the subsequent fabrication of large-area SNSPD with PNR and spatial resolution, significantly improving the flexibility and adaptability of SNSPDs to meet diverse detection requirements. Furthermore, our work also lays a research foundation for multi-photon detection in quantum communication and quantum computing.
Superconducting series nanowire single-photon detectors (SNDs) have been used for resolving photon numbers. But it can also exhibit a higher counting rate than a single superconducting nanowire single-photon detector (SNSPD), because the serial architecture allows multiple detectors working in parallel and the inductance of each pixel is reduced. In this paper, we found each pixel of the SND could reset fast although the whole detector took a much longer time for recovering. Therefore, the speed of an SND with a large kinetic inductance of 1.25 μH was characterized and compared to a standard SNSPD with the same total inductance. By measuring the detected photon rate over the input photon rate, we obtained a photon counting rate enhancement by 7.5 times. Meanwhile, the timing jitter of the SND was 63 ps at single photon detection regime. Our results show that the series structure and the readout scheme are quite practical in realizing high speed single-photon detectors besides resolving photon numbers.