Challenges
Datasets
Workspaces
Papers
Discussions
Leaderboard
Log inSign up
Challenges
Datasets
Workspaces
Papers
Discussions
Leaderboard
Blog
Job Board
Q3AS

© 2026 Aqora Quantum S.A.S.

TermsPrivacyLegal Notice

arXiv:2303.17401 · Nano Letters

Gigahertz Detection Rates and Dynamic Photon-Number Resolution with Superconducting Nanowire Arrays

Giovanni V. Resta, Lorenzo Stasi, Matthieu Perrenoud, Sylvain El-Khoury, Tiff Brydges, Rob Thew, Hugo Zbinden, Félix Bussières

Published Jun 23, 2023• 55 citations
arXivHTMLPDF

Abstract

Superconducting nanowire single-photon detectors (SNSPDs) have enabled the realization of several quantum optics technologies thanks to their high system detection efficiency (SDE), low dark counts, and fast recovery time. However, the widespread use of linear optical quantum computing, quasi-deterministic single-photon sources, and quantum repeaters requires even faster detectors that can also distinguish between different photon-number states. Here, we present an SNSPD array composed of 14 independent pixels, achieving an SDE of 90% in the telecommunications band. By reading each pixel of the array independently, we show detection of telecommunication photons at 1.5 GHz with 45% absolute SDE. We exploit the dynamic photon-number resolution of the array to demonstrate accurate state reconstruction for a wide range of light inputs, including operation with long-duration light pulses, as obtained with some cavity-based sources. We show two-photon and three-photon fidelities of 74% and 57%, respectively, which represent state-of-the-art results for fiber-coupled SNSPDs.

DOI
10.1021/acs.nanolett.3c01228

Related papers

Superconducting nanowire single-photon detector array with pixel-level photon-number resolution

Chenrui Wang, Chaomeng Ding, Jingxue Chen +6 more

We report a 16-pixel (4×4) superconducting nanowire single-photon detector (SNSPD) array featuring pixel-level photon-number-resolving capability. This multidimensional sensing is enabled by integrating a compact four-element series nanowire architecture into each spatial pixel, allowing direct discrimination of one to four photons. Under single-mode fiber illumination, the device achieves a total system detection efficiency of 41.5%, given the array geometrical fill factor of 53%. Across all channels, the device exhibits reliable multiphoton discrimination, maintaining minimum readout fidelities of 96%, 89%, 73%, and 77% for one- to four-photon states, respectively. Furthermore, independent channel evaluations reveal low timing jitter and negligible inter-channel crosstalk (<0.1 % ). By implementing differentiating pulse shaping for high-flux operation, a maximum single-channel −3 dB count rate of 984 MHz is achieved, establishing an aggregated array bandwidth potential of 8.9 GHz. This sensing architecture may provide a viable pathway toward high-flux single-photon imaging, offering potential applications in quantum optics and light detection and ranging (LiDAR) systems.

Photonics Research•Aug 28, 2026•0 citations

Design for superconducting nanowire single-photon detectors for photon number resolution and spatial resolution

Ying Yang, Junquan Guo, Yongliang Xu +3 more

Superconducting nanowire single-photon detectors (SNSPDs) have abstracted widespread attention in the fields of quantum information and quantum photonics due to their high detection efficiency and low dark count rates (DCR). However, single-pixel SNSPDs exist the notable limitations in detection speed and photon number resolution (PNR) capabilities, which pose challenges for practical applications. In this study, we propose a design of a series four-pixel SNSPD that incorporates a SPICE circuit simulation model to achieve PNR and spatial resolution of the four photons in an ideal state, and then determine the optical cavity structure of the detector at the highest light absorption of up to 97% through optical simulation. This design provides a theoretical foundation for the subsequent fabrication of large-area SNSPD with PNR and spatial resolution, significantly improving the flexibility and adaptability of SNSPDs to meet diverse detection requirements. Furthermore, our work also lays a research foundation for multi-photon detection in quantum communication and quantum computing.

Sixth Symposium on Novel Optoelectronic Detection Technology and Applications•Feb 17, 2025•0 citations

A 16-Pixel Interleaved Superconducting Nanowire Single-Photon Detector Array With A Maximum Count Rate Exceeding 1.5 GHz

Weijun Zhang, Jia Huang, Chengjun Zhang +6 more

Increasing the count rate (CR) is one of the key issues in the development of superconducting nanowire single-photon detectors (SNSPDs) for different applications. This study aims to design, fabricate, and analyze a 16-pixel interleaved nanowire SNSPD array, which exhibits a system detection efficiency (SDE) of 72% and a dark CR of 100 Hz at a low-photon-flux limit and a wavelength of 1550 nm. By exploiting the increased pixel number and reduced dead time (10photons/s. Moreover, the SNSPD achieved a photon number resolution of up to 16 photons.

IEEE Transactions on Applied Superconductivity•Feb 9, 2019•95 citations

Superconducting nanowire single-photon detectors with 98% system detection efficiency at 1550 nm

Dileep V. Reddy, Robert R. Nerem, Sae Woo Nam +2 more

Superconducting nanowire single-photon detectors (SNSPDs) are an enabling technology for myriad quantum-optics experiments that require high-efficiency detection, large count rates, and precise timing resolution. The system detection efficiencies (SDEs) for fiber-coupled SNSPDs have fallen short of theoretical predictions of near unity by at least 7%, with the discrepancy being attributed to scattering, material absorption, and other SNSPD dynamics. We optimize the design and fabrication of an all-dielectric layered stack and fiber coupling package in order to achieve 98.0 ± 0.5 % SDE, measured for single-mode-fiber guided photons derived from a highly attenuated 1550 nm continuous-wave laser. This enforces a smaller bound on the scattering and absorption losses in such systems and opens the use of SNSPDs for scenarios that demand high-SDE for throughput and fidelity.

Optica•Oct 28, 2020•407 citations

High speed superconducting nanowire single-photon detector with nine interleaved nanowires

Jia Huang, Weijun Zhang, Lixing You +6 more

Abstract Count rate (CR) is one of the key parameters of superconducting nanowire single-photon detectors (SNSPDs). The practical SNSPDs usually have a CR of a few MHz to a few tens of MHz owing to the large kinetic inductance originating from the long nanowire, which is necessary for effectively coupling the photons. A feasible approach to decrease the kinetic inductance and consequently increase the detection speed is to replace a long single nanowire with multiple individual nanowires in an array. In this study, we report an SNSPD of nine interleaved nanowires with 70% system detection efficiency (SDE) and 200 Hz dark count rate at the low-photon-flux limit of 1550 nm. Owing to the small dead time (<6 ns) of each nanowire, the SNSPD achieved a maximum CR of 0.93 GHz at a photon flux of 1.26 × 10 10 photons s −1 with an SDE of ∼7.4%, and a CR of 200 MHz with an SDE of over 50%. Furthermore, a photon number resolvability of up to nine photons was also demonstrated.

Superconductor Science and Technology•May 1, 2018•37 citations

Enhanced Detection Rate and High Photon-Number Efficiencies with a Scalable Parallel SNSPD

Lorenzo Stasi, Towsif Taher, Giovanni V. Resta +3 more

Since their inception, superconducting nanowire single-photon detectors have been enabling quantum optical applications and the rise of the photonic quantum industry. The evolution in the detector design and read-out strategies has led to the introduction of devices with a plurality of independent pixels, which have been able to operate with high system detection efficiency at high speed while also supporting photon number resolution capabilities. However, this comes at the cost of a complex readout that requires one coaxial cable for each pixel of the array. Here, we report a 28-pixel SNSPD with a dedicated parallel architecture that, while maintaining a simple readout with a single coaxial line, enables the detector to operate at high speed with low-performance degradation. The device shows a maximum single-photon efficiency of 88% and is able to maintain its efficiency above 50%, coupled with a timing jitter lower than 80 ps, up to a detection rate of 200 million counts per second. The detector also provides state-of-the-art photon-number-resolving performances with a 2-photon efficiency of 75% and a 3-photon efficiency of 62%.

arXiv:2406.15312•ACS Photonics•Dec 17, 2024•26 citations
Superconducting nanowire single-photon detectors (SNSPDs) have enabled the realization of several quantum optics technologies thanks to their high system detection efficiency (SDE), low dark counts, and fast recovery time. However, the widespread use of linear optical quantum computing, quasi-deterministic single-photon sources, and quantum repeaters requires even faster detectors that can also distinguish between different photon-number states. Here, we present an SNSPD array composed of 14 independent pixels, achieving an SDE of 90% in the telecommunications band. By reading each pixel of the array independently, we show detection of telecommunication photons at 1.5 GHz with 45% absolute SDE. We exploit the dynamic photon-number resolution of the array to demonstrate accurate state reconstruction for a wide range of light inputs, including operation with long-duration light pulses, as obtained with some cavity-based sources. We show two-photon and three-photon fidelities of 74% and 57%, respectively, which represent state-of-the-art results for fiber-coupled SNSPDs.
We report a 16-pixel (4×4) superconducting nanowire single-photon detector (SNSPD) array featuring pixel-level photon-number-resolving capability. This multidimensional sensing is enabled by integrating a compact four-element series nanowire architecture into each spatial pixel, allowing direct discrimination of one to four photons. Under single-mode fiber illumination, the device achieves a total system detection efficiency of 41.5%, given the array geometrical fill factor of 53%. Across all channels, the device exhibits reliable multiphoton discrimination, maintaining minimum readout fidelities of 96%, 89%, 73%, and 77% for one- to four-photon states, respectively. Furthermore, independent channel evaluations reveal low timing jitter and negligible inter-channel crosstalk (<0.1 % ). By implementing differentiating pulse shaping for high-flux operation, a maximum single-channel −3 dB count rate of 984 MHz is achieved, establishing an aggregated array bandwidth potential of 8.9 GHz. This sensing architecture may provide a viable pathway toward high-flux single-photon imaging, offering potential applications in quantum optics and light detection and ranging (LiDAR) systems.
Superconducting nanowire single-photon detectors (SNSPDs) have abstracted widespread attention in the fields of quantum information and quantum photonics due to their high detection efficiency and low dark count rates (DCR). However, single-pixel SNSPDs exist the notable limitations in detection speed and photon number resolution (PNR) capabilities, which pose challenges for practical applications. In this study, we propose a design of a series four-pixel SNSPD that incorporates a SPICE circuit simulation model to achieve PNR and spatial resolution of the four photons in an ideal state, and then determine the optical cavity structure of the detector at the highest light absorption of up to 97% through optical simulation. This design provides a theoretical foundation for the subsequent fabrication of large-area SNSPD with PNR and spatial resolution, significantly improving the flexibility and adaptability of SNSPDs to meet diverse detection requirements. Furthermore, our work also lays a research foundation for multi-photon detection in quantum communication and quantum computing.
Increasing the count rate (CR) is one of the key issues in the development of superconducting nanowire single-photon detectors (SNSPDs) for different applications. This study aims to design, fabricate, and analyze a 16-pixel interleaved nanowire SNSPD array, which exhibits a system detection efficiency (SDE) of 72% and a dark CR of 100 Hz at a low-photon-flux limit and a wavelength of 1550 nm. By exploiting the increased pixel number and reduced dead time (10photons/s. Moreover, the SNSPD achieved a photon number resolution of up to 16 photons.
Superconducting nanowire single-photon detectors (SNSPDs) are an enabling technology for myriad quantum-optics experiments that require high-efficiency detection, large count rates, and precise timing resolution. The system detection efficiencies (SDEs) for fiber-coupled SNSPDs have fallen short of theoretical predictions of near unity by at least 7%, with the discrepancy being attributed to scattering, material absorption, and other SNSPD dynamics. We optimize the design and fabrication of an all-dielectric layered stack and fiber coupling package in order to achieve 98.0 ± 0.5 % SDE, measured for single-mode-fiber guided photons derived from a highly attenuated 1550 nm continuous-wave laser. This enforces a smaller bound on the scattering and absorption losses in such systems and opens the use of SNSPDs for scenarios that demand high-SDE for throughput and fidelity.
Abstract Count rate (CR) is one of the key parameters of superconducting nanowire single-photon detectors (SNSPDs). The practical SNSPDs usually have a CR of a few MHz to a few tens of MHz owing to the large kinetic inductance originating from the long nanowire, which is necessary for effectively coupling the photons. A feasible approach to decrease the kinetic inductance and consequently increase the detection speed is to replace a long single nanowire with multiple individual nanowires in an array. In this study, we report an SNSPD of nine interleaved nanowires with 70% system detection efficiency (SDE) and 200 Hz dark count rate at the low-photon-flux limit of 1550 nm. Owing to the small dead time (<6 ns) of each nanowire, the SNSPD achieved a maximum CR of 0.93 GHz at a photon flux of 1.26 × 10 10 photons s −1 with an SDE of ∼7.4%, and a CR of 200 MHz with an SDE of over 50%. Furthermore, a photon number resolvability of up to nine photons was also demonstrated.
Since their inception, superconducting nanowire single-photon detectors have been enabling quantum optical applications and the rise of the photonic quantum industry. The evolution in the detector design and read-out strategies has led to the introduction of devices with a plurality of independent pixels, which have been able to operate with high system detection efficiency at high speed while also supporting photon number resolution capabilities. However, this comes at the cost of a complex readout that requires one coaxial cable for each pixel of the array. Here, we report a 28-pixel SNSPD with a dedicated parallel architecture that, while maintaining a simple readout with a single coaxial line, enables the detector to operate at high speed with low-performance degradation. The device shows a maximum single-photon efficiency of 88% and is able to maintain its efficiency above 50%, coupled with a timing jitter lower than 80 ps, up to a detection rate of 200 million counts per second. The detector also provides state-of-the-art photon-number-resolving performances with a 2-photon efficiency of 75% and a 3-photon efficiency of 62%.