Increasing the count rate (CR) is one of the key issues in the development of superconducting nanowire single-photon detectors (SNSPDs) for different applications. This study aims to design, fabricate, and analyze a 16-pixel interleaved nanowire SNSPD array, which exhibits a system detection efficiency (SDE) of 72% and a dark CR of 100 Hz at a low-photon-flux limit and a wavelength of 1550 nm. By exploiting the increased pixel number and reduced dead time (10photons/s. Moreover, the SNSPD achieved a photon number resolution of up to 16 photons.
Increasing the count rate (CR) is one of the key issues in the development of superconducting nanowire single-photon detectors (SNSPDs) for different applications. This study aims to design, fabricate, and analyze a 16-pixel interleaved nanowire SNSPD array, which exhibits a system detection efficiency (SDE) of 72% and a dark CR of 100 Hz at a low-photon-flux limit and a wavelength of 1550 nm. By exploiting the increased pixel number and reduced dead time (10photons/s. Moreover, the SNSPD achieved a photon number resolution of up to 16 photons.
Abstract Count rate (CR) is one of the key parameters of superconducting nanowire single-photon detectors (SNSPDs). The practical SNSPDs usually have a CR of a few MHz to a few tens of MHz owing to the large kinetic inductance originating from the long nanowire, which is necessary for effectively coupling the photons. A feasible approach to decrease the kinetic inductance and consequently increase the detection speed is to replace a long single nanowire with multiple individual nanowires in an array. In this study, we report an SNSPD of nine interleaved nanowires with 70% system detection efficiency (SDE) and 200 Hz dark count rate at the low-photon-flux limit of 1550 nm. Owing to the small dead time (<6 ns) of each nanowire, the SNSPD achieved a maximum CR of 0.93 GHz at a photon flux of 1.26 × 10 10 photons s −1 with an SDE of ∼7.4%, and a CR of 200 MHz with an SDE of over 50%. Furthermore, a photon number resolvability of up to nine photons was also demonstrated.
We report a 16-pixel (4×4) superconducting nanowire single-photon detector (SNSPD) array featuring pixel-level photon-number-resolving capability. This multidimensional sensing is enabled by integrating a compact four-element series nanowire architecture into each spatial pixel, allowing direct discrimination of one to four photons. Under single-mode fiber illumination, the device achieves a total system detection efficiency of 41.5%, given the array geometrical fill factor of 53%. Across all channels, the device exhibits reliable multiphoton discrimination, maintaining minimum readout fidelities of 96%, 89%, 73%, and 77% for one- to four-photon states, respectively. Furthermore, independent channel evaluations reveal low timing jitter and negligible inter-channel crosstalk (<0.1 % ). By implementing differentiating pulse shaping for high-flux operation, a maximum single-channel −3 dB count rate of 984 MHz is achieved, establishing an aggregated array bandwidth potential of 8.9 GHz. This sensing architecture may provide a viable pathway toward high-flux single-photon imaging, offering potential applications in quantum optics and light detection and ranging (LiDAR) systems.
Superconducting nanowire single photon detectors (SNSPDs) have separately demonstrated high efficiency, low noise, and extremely high speed when detecting single photons. However, achieving all of these simultaneously has been limited by detector subtleties and tradeoffs. Here, we report an SNSPD system with <80 ps timing resolution, kHz noise count rates, and 76% fiber-coupled system detection efficiency in the low-flux limit at 1550 nm. We present a model for determining the detection efficiency penalty due to the detection recovery time, and we validate our method using experimental data obtained at high count rates. We demonstrate improved performance tradeoffs, such as 68% system detection efficiency, including losses due to detector recovery time, when coupled to a Poisson source emitting 100 million photons per second. Our system can provide limited photon number resolution, continuous cryogen-free operation, and scalability to future imaging and GHz-count-rate applications.
Superconducting nanowire single-photon detectors (SNSPDs) have enabled the realization of several quantum optics technologies thanks to their high system detection efficiency (SDE), low dark counts, and fast recovery time. However, the widespread use of linear optical quantum computing, quasi-deterministic single-photon sources, and quantum repeaters requires even faster detectors that can also distinguish between different photon-number states. Here, we present an SNSPD array composed of 14 independent pixels, achieving an SDE of 90% in the telecommunications band. By reading each pixel of the array independently, we show detection of telecommunication photons at 1.5 GHz with 45% absolute SDE. We exploit the dynamic photon-number resolution of the array to demonstrate accurate state reconstruction for a wide range of light inputs, including operation with long-duration light pulses, as obtained with some cavity-based sources. We show two-photon and three-photon fidelities of 74% and 57%, respectively, which represent state-of-the-art results for fiber-coupled SNSPDs.
We report a compact, scalable, and high-performance superconducting nanowire single-photon detector (SNSPD) array by using a multichannel optical fiber array-coupled configuration. For single pixels with an active area of 18 µm in diameter and illuminated at the telecom wavelength of 1550 nm, we achieved a pixel yield of 13/16 on one chip, an average system detection efficiency of 69% at a dark count rate of 160 cps, a minimum timing jitter of 74 ps, and a maximum count rate of ∼ 40 M c p s . The optical crosstalk coefficient between adjacent channels is better than − 60 d B . The performance of the fiber array-coupled detectors is comparable with a standalone detector coupled to a single fiber. Our method is promising for the development of scalable, high-performance, and high-yield SNSPDs.
Single-photon detection is extremely important for a number of different applications such as quantum cryptography, CMOS testing and even biomedical research. Most of the applications of single-photon detector require high efficiency combined with high time resolution, high count rates and low dark counts. Superconducting nanowire single-photon detectors has emerged provides this combination unlike any other available single-photon detectors. Some of the applications of superconducting nanowire single-photon detectors (SNSPD's) require larger area SNSPD's without affecting it's performance. For this purpose, multi-pixel SNSPD's would provide a solution. To this end, prototype 4- and 16-pixel detectors have been characterised in terms of a number of performance parameters such as critical current, count rate behaviour and timing jitter. Aside from this, simulations have been performed on detection statistics and relative illumination of the individual pixels of a multi-pixel SNSPD. Results show that for 4-pixel detectors, all desired aspects have been achieved, but not yet combined in one detector. The 16-pixel detectors showed excellent critical currents and count rate behaviour but, most likely due to the fact that they were prototype chips with little to no protection, had several not functioning pixels.