Challenges
Datasets
Workspaces
Papers
Discussions
Leaderboard
Log inSign up
Challenges
Datasets
Workspaces
Papers
Discussions
Leaderboard
Blog
Job Board
Q3AS

© 2026 Aqora Quantum S.A.S.

TermsPrivacyLegal Notice

arXiv:1207.2164 · Applied Physics Letters

Energy-resolved detection of single infrared photons with λ = 8 μm using a superconducting microbolometer

Boris S. Karasik, Sergey Pereverzev, Alexander Soibel, Daniel F. Santavicca, Daniel E. Prober, David Olaya, Michael E. Gershenson

Published Jul 30, 2012• 45 citations
arXivHTMLPDF

Abstract

We report on the detection of single photons with λ = 8 μm using a superconducting hot-electron microbolometer. The sensing element is a titanium transition-edge sensor with a volume ∼0.1 μm3 fabricated on a silicon substrate. Poisson photon counting statistics including simultaneous detection of 3 photons was observed. The width of the photon-number peaks was 0.11 eV, 70% of the photon energy, at 50–100 mK. This achieved energy resolution is one of the best figures reported so far for superconducting devices. Such devices can be suitable for single-photon calorimetric spectroscopy throughout the mid-infrared and even the far-infrared.

DOI
10.1063/1.4739839

Related papers

Detection of single infrared, optical, and ultraviolet photons using superconducting transition edge sensors

Blas Cabrera, Roland M. Clarke, P. Colling +3 more

We have demonstrated the use of superconducting transition edge sensors for the wide-band detection of individual photons from the mid infrared (IR), through the optical, and into the far ultraviolet (UV). These tungsten transition edge sensors are squares about 18 μm on a side and detect single photon events above a threshold of 0.3 eV (4 μm wavelength), with an energy resolution of 0.15 eV full width at half maximum, and with a risetime (falltime) of .5 μs (60 μs). The calibration data extend up to the UV cutoff of the fiber optic feed at 3.5 eV (350 nm).

Applied Physics Letters•Aug 10, 1998•353 citations

Record-Low NEP in Hot-Electron Titanium Nanobolometers

Boris S. Karasik, David I. Olaya, Jian Wei +5 more

We are developing hot-electron superconducting transition-edge sensors (TES) capable of counting THz photons and operating at . We fabricated superconducting Ti nanosensors with Nb contacts with a volume of on planar Si substrates and have measured the thermal conductance in the material, G=4times10-3W/K at 0.3 K, caused predominantly by the weak electron-phonon coupling. The corresponding phonon-noise NEP=3times10-19W/Hz1/2. Detection of single optical photons (1550 nm and 670 nm wavelength) has been demonstrated for larger devices and yielded the thermal time constants of 30 mus at 145 mK and of 25 mus at 190 mK. This hot-electron direct detector (HEDD) is expected to have a small enough energy fluctuation noise for detecting individual photons with v>THz where NEP~3times10-20W/Hz1/2is needed for spectroscopy in space.

IEEE Transactions on Applied Superconductivity•Jun 1, 2007•40 citations

Development of Titanium-Based Transition-Edge Single-Photon Detector

Wen Zhang, Yue Geng, Zheng Wang +7 more

Superconducting transition-edge sensors (TESs), working as single-photon detectors with high quantum efficiency, low dark count rate, and photon number resolving capability, have been successfully used in quantum information experiments as well as astronomical transient object observations. Aiming to achieve high count rate, we are developing titanium-based superconducting TES single-photon detectors with a critical temperature of ~300 mK. Ti-based TESs with active area from 10 × 10 μm to 40 × 40 μm are first fabricated on silicon substrate coated with SiOx. The fabricated TES devices show a thermal conductance scaling with the active area and an effective time constant of ~4 μs from pulsed laser diode illumination. In order to get high quantum efficiency, we further design and fabricate a 1550-nm optical cavity based on dielectric mirror and antireflection layer, and study its absorption with an IR spectrometer. Ti TES devices on the dielectric mirror are then fabricated and the superconducting transition is measured.

IEEE Transactions on Applied Superconductivity•Mar 19, 2019•19 citations

Titanium Based Transition Edge Microcalorimeters for Optical Photon Measurements

Daiji Fukuda, R. M. T. Damayanthi, Akio Yoshizawa +4 more

Transition edge sensor microcalorimeters can be used in many optical quantum measurements because of its low dark counts, high quantum efficiency, and high resolving power of a photon number in weak light pulses. In order to increase count rates up to a few MHz, we have developed a titanium transition edge sensor for the optical measurements, and its performances were analysed. Titanium is one of the ideal superconductor because of its higher transition temperature and lower optical reflectance at 1.5 wavelength. Our titanium film was fabricated with electron-beam evaporation, and showed high residual resistance ratio of 3.5. The sharp superconducting transition also was found at 359 mK, which is close to the critical temperature in bulk. The fabricated device showed a fast response to pulsed laser illumination of 1.5 wavelength with the fall time constant of 300 ns. These features are very promising for high-speed single photon detection in many quantum optical measurements.

IEEE Transactions on Applied Superconductivity•Jun 1, 2007•29 citations

Mid-infrared superconducting nanowire single-photon detectors: Potential, progress, and challenges

Gregor G. Taylor, Robert H. Hadfield

The ability to detect single photons in the mid-infrared spectral range (beyond 2 μm wavelength, photon energy below 0.62 eV) is the key to unlocking a range of emerging scientific applications, from remote sensing LIDAR, molecular spectroscopy, and powerful new approaches to dark matter detection. Conventional detector types, such as semiconductor single-photon avalanche diodes, lose sensitivity at such low photon energy. Superconducting materials, with a much lower characteristic energy gap, hold particular promise. In this Perspective, we focus on recent advances in superconducting nanowire single-photon detectors, which have recently extended single-photon sensitivity up to 29 μm (0.043 eV). We discuss the potential for future advances and strategies to overcome challenges to technological development.

Applied Physics Letters•Jan 5, 2026•9 citations

Mid-infrared characterization of NbTiN superconducting nanowire single-photon detectors on silicon-on-insulator

Adan Azem, D. Morozov, Daniel Kuznesof +4 more

Superconducting nanowire single-photon detectors are widely used for detecting individual photons across various wavelengths from ultraviolet to near-infrared range. Recently, there has been increasing interest in enhancing their sensitivity to single photons in the mid-infrared spectrum, driven by applications in quantum communication, spectroscopy, and astrophysics. Here, we present our efforts to expand the spectral detection capabilities of U-shaped NbTiN-based superconducting nanowire single-photon detectors, fabricated in a 2-wire configuration on a silicon-on-insulator substrate, into the mid-infrared range. We demonstrate saturated internal detection efficiency extending up to a wavelength of 3.5 μm for a 5 nm thick and 50 nm wide NbTiN nanowire with a dark count rate less than 10 counts per second at 0.9 K and a rapid recovery time of 4.3 ns. The detectors are engineered for integration on waveguides in a silicon-on-insulator platform for compact, multi-channel device applications.

arXiv:2408.15959•Applied Physics Letters•Nov 18, 2024•12 citations
We report on the detection of single photons with λ = 8 μm using a superconducting hot-electron microbolometer. The sensing element is a titanium transition-edge sensor with a volume ∼0.1 μm3 fabricated on a silicon substrate. Poisson photon counting statistics including simultaneous detection of 3 photons was observed. The width of the photon-number peaks was 0.11 eV, 70% of the photon energy, at 50–100 mK. This achieved energy resolution is one of the best figures reported so far for superconducting devices. Such devices can be suitable for single-photon calorimetric spectroscopy throughout the mid-infrared and even the far-infrared.
We have demonstrated the use of superconducting transition edge sensors for the wide-band detection of individual photons from the mid infrared (IR), through the optical, and into the far ultraviolet (UV). These tungsten transition edge sensors are squares about 18 μm on a side and detect single photon events above a threshold of 0.3 eV (4 μm wavelength), with an energy resolution of 0.15 eV full width at half maximum, and with a risetime (falltime) of .5 μs (60 μs). The calibration data extend up to the UV cutoff of the fiber optic feed at 3.5 eV (350 nm).
We are developing hot-electron superconducting transition-edge sensors (TES) capable of counting THz photons and operating at . We fabricated superconducting Ti nanosensors with Nb contacts with a volume of on planar Si substrates and have measured the thermal conductance in the material, G=4times10-3W/K at 0.3 K, caused predominantly by the weak electron-phonon coupling. The corresponding phonon-noise NEP=3times10-19W/Hz1/2. Detection of single optical photons (1550 nm and 670 nm wavelength) has been demonstrated for larger devices and yielded the thermal time constants of 30 mus at 145 mK and of 25 mus at 190 mK. This hot-electron direct detector (HEDD) is expected to have a small enough energy fluctuation noise for detecting individual photons with v>THz where NEP~3times10-20W/Hz1/2is needed for spectroscopy in space.
Superconducting transition-edge sensors (TESs), working as single-photon detectors with high quantum efficiency, low dark count rate, and photon number resolving capability, have been successfully used in quantum information experiments as well as astronomical transient object observations. Aiming to achieve high count rate, we are developing titanium-based superconducting TES single-photon detectors with a critical temperature of ~300 mK. Ti-based TESs with active area from 10 × 10 μm to 40 × 40 μm are first fabricated on silicon substrate coated with SiOx. The fabricated TES devices show a thermal conductance scaling with the active area and an effective time constant of ~4 μs from pulsed laser diode illumination. In order to get high quantum efficiency, we further design and fabricate a 1550-nm optical cavity based on dielectric mirror and antireflection layer, and study its absorption with an IR spectrometer. Ti TES devices on the dielectric mirror are then fabricated and the superconducting transition is measured.
Transition edge sensor microcalorimeters can be used in many optical quantum measurements because of its low dark counts, high quantum efficiency, and high resolving power of a photon number in weak light pulses. In order to increase count rates up to a few MHz, we have developed a titanium transition edge sensor for the optical measurements, and its performances were analysed. Titanium is one of the ideal superconductor because of its higher transition temperature and lower optical reflectance at 1.5 wavelength. Our titanium film was fabricated with electron-beam evaporation, and showed high residual resistance ratio of 3.5. The sharp superconducting transition also was found at 359 mK, which is close to the critical temperature in bulk. The fabricated device showed a fast response to pulsed laser illumination of 1.5 wavelength with the fall time constant of 300 ns. These features are very promising for high-speed single photon detection in many quantum optical measurements.
The ability to detect single photons in the mid-infrared spectral range (beyond 2 μm wavelength, photon energy below 0.62 eV) is the key to unlocking a range of emerging scientific applications, from remote sensing LIDAR, molecular spectroscopy, and powerful new approaches to dark matter detection. Conventional detector types, such as semiconductor single-photon avalanche diodes, lose sensitivity at such low photon energy. Superconducting materials, with a much lower characteristic energy gap, hold particular promise. In this Perspective, we focus on recent advances in superconducting nanowire single-photon detectors, which have recently extended single-photon sensitivity up to 29 μm (0.043 eV). We discuss the potential for future advances and strategies to overcome challenges to technological development.
Superconducting nanowire single-photon detectors are widely used for detecting individual photons across various wavelengths from ultraviolet to near-infrared range. Recently, there has been increasing interest in enhancing their sensitivity to single photons in the mid-infrared spectrum, driven by applications in quantum communication, spectroscopy, and astrophysics. Here, we present our efforts to expand the spectral detection capabilities of U-shaped NbTiN-based superconducting nanowire single-photon detectors, fabricated in a 2-wire configuration on a silicon-on-insulator substrate, into the mid-infrared range. We demonstrate saturated internal detection efficiency extending up to a wavelength of 3.5 μm for a 5 nm thick and 50 nm wide NbTiN nanowire with a dark count rate less than 10 counts per second at 0.9 K and a rapid recovery time of 4.3 ns. The detectors are engineered for integration on waveguides in a silicon-on-insulator platform for compact, multi-channel device applications.