Abstract : The purpose of this research program was to develop a device architecture that is capable of coherently coupling two silicon spin qubits via the electromagnetic field of superconducting resonator. Single Electron spins can be efficiently coupled using the exchange interaction, but the strength of exchange falls of very quickly as a function of the distance separating the two electron spins. Cavity based coupling schemes have recently emerged as a robust tool for coupling superconducting quantum bits. The main goal of this research program was to make the first steps toward combing elements of the superconducting and semiconductor qubit architectures.
Abstract : The purpose of this research program was to develop a device architecture that is capable of coherently coupling two silicon spin qubits via the electromagnetic field of superconducting resonator. Single Electron spins can be efficiently coupled using the exchange interaction, but the strength of exchange falls of very quickly as a function of the distance separating the two electron spins. Cavity based coupling schemes have recently emerged as a robust tool for coupling superconducting quantum bits. The main goal of this research program was to make the first steps toward combing elements of the superconducting and semiconductor qubit architectures.
This dissertation describes a set of experiments with the goal of creating a super-conductor-semiconductor hybrid circuit quantum electrodynamics architecture with single electron spins. Single spins in silicon quantum dots have emerged as attractive qubits for quantum computation. However, how to scale up spin qubit systems remains an open question. The hybrid architecture considered here could provide a route to realizing large networks of quantum dot–based spin qubit registers. The first experiment in this thesis is aimed at achieving strong coupling between a single electron spin and a single microwave photon. The electron is trapped in a gate-defined double quantum dot in a Si/SiGe heterostructure and the photon is stored in an on-chip superconducting high-impedance NbTiN cavity. The photon is coupled directly to the electron charge, and indirectly to the electron spin, mediated through a synthetic spin-orbit field. We observe a vacuum Rabi splitting that depends on the spin-charge hybridization. The ratio of spin-photon coupling strength to decoherence rates of the spin and cavity combined is larger than unity, confirming the strong coupling regime has been reached. In addition, we find an optimal degree of spin-charge hybridization for which this ratio is maximized. The demonstration of strong spin-photon coupling not only opens a new range of physics experiments, but fulfills also a crucial requirement for coupling spin qubits at a distance via a cavity. The second experiment is focused on spin readout with the on-chip cavity. Instead of the direct dispersive readout of a single spin, we use the cavity to detect whether the electron is allowed to tunnel between the two dots or not. We benchmark the charge sensitivity and bandwidth of the detector and find that rapid detection of the electron charge with high SNR is possible. In the two-electron regime, electron tunneling is contingent on the total spin state (Pauli spin blockade). This spin-to-charge conversion scheme enables single-shot detection of singlet states with high-fidelity. The demonstration of single-shot spin readout with a cavity is an essential step towards readout in dense spin qubit arrays, such as the crossbar network, where it is not possible to integrate electrometers and accompanying reservoirs adjacent to the qubit dots. In the third experiment, we develop on-chip microwave filters to suppress microwave photon leakage from the cavity through the gate electrodes that are necessary to form quantum dots. We introduce a new cavity design that is compatible with long-distance connectivity between spins, but is also more susceptible to microwave leakage. We test and compare two low-pass filter variations in terms of performance, footprint and integrability. They use the same nanowire inductor, but different implementations of the capacitor: one with a planar interdigitated capacitor and one novel design with an overlapping thin-film capacitor. We find that both approaches are effective against microwave leakage. However, the large footprint of the interdigitated capacitor makes this solution inconvenient as the number of gate lines increases. The thin-film capacitor, with its much smaller footprint, is better suited for our devices. The final part of this dissertation contains concluding remarks and possible future directions are proposed.
Coherent and strong coupling between photons and solid-state qubits, in the form of circuit quantum electrodynamics (QED), has been harnessed for two-qubit gates mediated by photons and high-fidelity quantum non-demolition readout, which are the building blocks of large-scale quantum computation. Recently, circuit QED has been extended to gate-defined semiconductor quantum dots. In this thesis, we develop a novel hybrid circuit QED architecture composed of a high-impedance superconducting microwave resonator and spins localized in silicon-MOS quantum dots. To control and measure the spin degrees of freedom, this hybrid system needs to operate at finite magnetic field. Consequently, we develop and characterize microwave resonators based on thin niobium nitride (NbN) films featuring a high kinetic inductance. We demonstrate high-impedance resonators with magnetic field resilience and low photon loss rates. We then co-integrate the NbN resonators on silicon spin qubit chips. With a hole confined in a double quantum dot (DQD), we report the first realization of a strong hole charge-photon interaction bordering the ultra-strong coupling regime. At finite magnetic field, putting the spin transition energy in resonance with the microwave cavity, we observe large vacuum Rabi mode splittings, signature of a strong spin-photon coupling. Our findings are well captured by the modelling of a hole DQD with different anisotropic Zeeman response in each dot and spin-orbit coupling dependent tunnel rates. We also find a sizeable spin-photon coupling when the hole is localized in the single quantum dot, in line with recent theoretical predictions. The different works presented in this manuscript pave the way for circuit QED with hole spins in gate-defined semiconductor quantum dots.
Semiconductor quantum dots in silicon demonstrate exceptionally long spin lifetimes as qubits and are therefore promising candidates for quantum information processing. However, control and readout techniques for these devices have thus far employed low frequency electrons, in contrast to high speed temperature readout techniques used in other qubit architectures, and coupling between multiple quantum dot qubits has not been satisfactorily addressed.This dissertation presents the design and characterization of a semiconductor charge qubit based on double quantum dot in silicon with an integrated microwave resonator for control and readout. The 6 GHz resonator is designed to achieve strong coupling with the quantum dot qubit, allowing the use of circuit QED control and readout techniques which have not previously been applicable to semiconductor qubits. To achieve this coupling, this document demonstrates successful operation of a novel silicon double quantum dot design with a single active metallic layer and a coplanar stripline resonator with a bias tee for dc excitation.Experiments presented here demonstrate quantum localization and measurement of both electrons on the quantum dot and photons in the resonator. Further, it is shown that the resonator-qubit coupling in these devices is sufficient to reach the strong coupling regime of circuit QED. The details of a measurement setup capable of performing simultaneous low noise measurements of the resonator and quantum dot structure are also presented here.The ultimate aim of this research is to integrate the long coherence times observed in electron spins in silicon with the sophisticated readout architectures available in circuit QED based quantum information systems. This would allow superconducting qubits to be coupled directly to semiconductor qubits to create hybrid quantum systems with separate quantum memory and processing components.
Quantum computing is a powerful way of improving computing efficiency. For some specific problems, quantum processor can exponentially reduce computation time compared to the classical computer. Cavity quantum electrodynamics, which studies the coherent interaction between photons in an optical cavity and atoms or other two-level systems, is of enormous significance to quantum computing and quantum information processing. The strong coupling regime where a cavity photon mode and an atom exchange a single quantum energy coherently has attracted extensive interest in varied experimental platforms and systems such as alkali atoms, Rydberg atoms, large spin ensembles, magnons, etc. The semiconductor gate-defined double quantum dot (DQD) system is one of the most promising platforms that possesses advantages of advanced micro-nano processing technology and outstanding scalability. Introducing the concept of cavity QED into superconducting circuits (circuit QED, cQED), provides an opportunity to study interaction between electrons confined in semiconductor DQD and photons trapped in a superconducting resonator. Reaching strong coupling regime in this hybrid system paves the way to large-scale network of quantum computing. Electrons confined in DQD have large electrical dipoles, thus are able to couple to photons with relatively large coupling rate. Whereas, due to the charge noise and other dissipation channels in the hybrid system, the decoherence rate of the system is larger than the coupling rate, leaving the strong coupling a great challenge. In recent years, different methods have been proposed to access the strong coupling regime. Taking advantage of a high-quality heterojunction structure, an overlapping gate architecture and a low-pass LC filter on the DC bias line, the decoherence of the charge qubit and microwave leakage of the resonator can be effectively suppressed. The coupling strength of the hybrid system can be improved utilizing a high impedance resonator which is comprised of high kinetic inductance materials. Spin, which does not interact directly with the electric field, is insensitive to charge noise and has much longer decoherence time than charge qubit. However, the weak interaction results in a small coupling rate between the spin and the photon. To solve this problem, the method of coherent hybridization between the spin and the charge state is proposed to improve the coupling strength. This hybridization can be achieved by applying a non-uniform magnetic field, utilizing spin-orbit interaction or spin exchange interaction. At present, both charge qubits and spin qubits have achieved strong coupling with the cavity and the coupling distance between long-range qubits is greatly expanded as long as millimeters. This review introduces basic ideas about cQED and fundamental elements in semiconductor cQED systems. Recent progress in strong coupling hybrid system and methods for improving coupling structures are discussed. In future research, more efforts will be devoted into long-range transfer of qubit states and photon-mediated two or multi-qubit gates.
We report the coherent coupling of two electron spins at a distance via virtual microwave photons. Each spin is trapped in a silicon double quantum dot at either end of a superconducting resonator, achieving spin-photon couplings up to around gs/2π=40MHz. As the two spins are brought into resonance with each other, but detuned from the photons, an avoided crossing larger than the spin linewidths is observed with an exchange splitting around 2J/2π=20MHz. In addition, photon number states are resolved from the shift 2χs/2π=−13MHz they induce on the spin frequency. These results could enable long-range two-qubit gates between spin qubits and scalable networks of spin qubits on a chip.
Semiconductor qubits rely on the control of charge and spin degrees of freedom of electrons or holes confined in quantum dots (QDs). Typically, semiconductor qubit-qubit coupling is short range, effectively limiting qubit distance to the spatial extent of the wavefunction of the confined particle (a few hundred nanometers). This is a significant constraint towards scaling of QD-based architectures to realize dense 1D or 2D arrays of QDs. Inspired by techniques originally developed for circuit QED, we recently demonstrated the strong coupling of individual electrons confined in GaAs quantum dots to individual microwave photons, making use of the enhanced electric component of the vacuum fluctuations of a resonator with impedance beyond the typical 50 Ohm of standard coplanar waveguides. In this hybrid technology, we recently realized a proof of concept experiment, where the coupling between a transmon and a double QD (DQD) is mediated by virtual microwave photon excitations in a high impedance SQUID array resonator, which acts as a quantum bus enabling long-range coupling between dissimilar qubits. Similarly, we achieved coherent coupling between two DQD charge qubits separated by approximately 50 um. In the dispersive regime, we spectroscopically observed qubit-qubit coupling as an avoided-crossing in the energy spectrum of the DQD charge qubits. The methods and techniques developed in this work are transferable to QD devices based on other material systems and can be beneficial for spin based hybrid systems.