A Compact Voltage Pulse Multiplier for SFQ Circuit Readout

Yusuke Sato, Moriya Masataka, Shimada Hiroshi +2 more

Yoko Namatame, Kazuyuki Kato, Masataka Moriya +4 more

Jun Saito, Takeyuki Tanaka, Masataka Moriya +3 more

Sasan Razmkhah, Ali Bozbey, Pascal Febvre

Abstract The many advantages of cryogenically cooled single-flux quantum (SFQ) circuits imply that the high speed and low voltage output signals must be amplified and interfaced with standard electronics. State-of-the-art low-noise and wide-band amplifiers are required to interface with room temperature electronics. One solution is to place preamplifiers at the cryogenic stage, which requires specific semiconductor design and fabrication. However, a more viable and energy-efficient approach is to integrate the pulsed logic circuit output stages with on-chip superconductor preamplifiers. We designed, fabricated, and tested an on-chip compact voltage multiplier integrated with the output stage of SFQ circuits to increase the voltage amplitude of SFQ pulses. The circuit is designed with the same technology as the logic circuit hence its noise level is lower, and it works at higher frequencies compared to complementary metal-oxide semi-conductor amplifiers and due to quantized nature of it there is no added noise. The fabricated circuit has a compact size of 160 µ m × 320 µ m and provides about 10 dB gain with measured 600 µ V output voltage at frequencies up to ∼25 GHz in simulations. By stacking more levels, over 20 dB gain at circuit level is achievable as shown in simulations. Moreover the gain of the superconductor voltage amplifier is quantized and programmable.

Hajime SASAKI, Shogo Kiryu, Fuminori Hirayama +4 more

Digital to analog converters based on the Josephson effect are promising for voltage standards, because they produce voltage steps with ultimate precision and stability. In this paper, we describe a project to develop a Josephson D/A converter designed for synthesizing a sinusoidal waveform with metrological accuracy. The D/A converter is based on RSFQ (Rapid Single Flux Quantum) logic circuits, and consists of a frequency multiplier (FM), a pulse distributor (PD), and a number of voltage multipliers (VMs). Each VM circuit, corresponding to the n-th bit digital code, multiplies the number of SFQ pulses by a factor of 2/sup n/. By gating the input SFQ pulses from the FM to the VMs using the PD circuits, a programmable output voltage is obtained. Possible sources of uncertainties in the measurement of the rms value of the synthesized sine wave are discussed.

Yoshitaka Takahashi, Moriya Masataka, Shimada Hiroshi +2 more