© 2026 Aqora Quantum S.A.S.

Terms Privacy Legal Notice

Sensors

Improving the Sensitivity of a Dark-Resonance Atomic Magnetometer

Hao Zhai, Wei Li, G. F. Jin

Published Feb 18, 2025• 6 citations

Abstract

The combination of unmanned aerial vehicles and atomic magnetometers can be used for detection applications such as mineral resource exploration, environmental protection, and earthquake monitoring, as well as the detection of sunken ships and unexploded ordnance. A dark-resonance atomic magnetometer offers the significant advantages of a fully optical probe and omnidirectional measurement with no dead zones, making it an ideal choice for airborne applications on unmanned aerial vehicles. Enhancing the sensitivity of such atomic magnetometers is an essential task. In this study, we sought to enhance the sensitivity of a dark-state resonance atomic magnetometer. Initially, through theoretical analysis, we compared the excitation effects of coherent population trapping (CPT) resonance on the D1 and D2 transitions of 133Cs thermal vapor. The results indicate that excitation via the D1 line yields an increase in resonance contrast and a reduction in linewidth when compared with excitation through the D2 line, aligning with theoretical predictions. Subsequently, considering the impact of various quantum system parameters on sensitivity, as well as their interdependent characteristics, two experimental setups were developed for empirical investigation. One setup focused on parameter optimization experiments, where we compared the linewidth and contrast of CPT resonances excited by both D1 and D2 transitions; this led to an optimization of atomic cell size, buffer gas pressure, and operating temperature, resulting in an ideal parameter range. The second setup was employed to validate these optimized parameters using a coupled dark-state atom magnetometer experiment, achieving approximately a 10-fold improvement in sensitivity.

DOI: 10.3390/s25041229

Related papers

Atomic magnetometer with microfabricated vapor cells based on coherent population trapping*

Xiaojie Li, Yuejiang Shi, Hongbo Xue +2 more

An atomic magnetometer based on coherent population trapping (CPT) resonances in microfabricated vapor cells is demonstrated. Fabricated by the micro-electro-mechanical-system (MEMS) technology, the cells are filled with Rb and Ne at a controlled pressure. An experimental apparatus is built for characterizing properties of microfabricated vapor cells via the CPT effects. The typical CPT linewidth is measured to be about 3 kHz (1.46 kHz with approximately zero laser intensity) for the rubidium D1 line at about 90 °C. The effects of pressure, temperature and laser intensity on CPT linewidth are studied experimentally. A closed-loop atomic magnetometer is finally finished with a sensitivity of 210.5 pT/Hz1/2 at 1 Hz bandwidth. This work paves the way for developing an integrated chip-scale atomic magnetometer in the future.

Chinese Physics B•Oct 20, 2020•8 citations

Comparison of quantum CPT and EPR magnetometers

Daba A. Radnatarov, Valeriy Andryushkov, Sergey M Kobtsev

Experimentally compared for the first time is the sensitivity of two magnetometer types implemented on a common base of rubidium atomic clock with coherent population trapping (CPT). The first magnetometer used a magneto-sensitive optically excited CPT resonance, the other measured field strength through the electron paramagnetic resonance (EPR) excited with alternating magnetic field. We show advantages and limitations of these promising quantum sensing technologies. Sensitivity of both types was measured under resonance excitation on the D1 line of 87Rb. We demonstrate that the СРТ magnetometer sensitivity may exceed that of the EPR device by two orders of magnitude.

Novel Optical Systems, Methods, and Applications•Aug 21, 2020•0 citations

High contrast atomic magnetometer based on coherent population trapping

Ailin Yang, Guoqing Yang, Yunfei Xu +1 more

We present an experimental and theoretical investigation of the coherent population trapping (CPT) resonance excited on the D1 line of 87 Rb atoms by bichromatic linearly polarized laser light. The experimental results show that a lin ‖ lin transition scheme is a promising alternative to the conventional circular—circular transition scheme for an atomic magnetometer. Compared with the circular light transition scheme, linear light accounts for high-contrast transmission resonances, which makes this excitation scheme promising for high-sensitivity magnetometers. We also use linear light and circular light to detect changes of a standard magnetic field, separately.

Chinese Physics B•Feb 1, 2014•12 citations

Coherent population trapping resonances in thermal ^85Rb vapor: D_1 versus D_2 line excitation

M. Stähler, R. Wynands, Svenja A. Knappe +4 more

We have compared coherent population trapping (CPT) resonances, both experimentally and theoretically, for excitation of the D(1) and D(2) transitions of thermal (85)Rb vapor. Excitation of the D(1) line results in greater resonance contrast than excitation of the D(2) line and in a reduction in the resonance width, in agreement with theoretical expectations. These results translate into a nearly tenfold improvement in performance for the application of CPT resonances to a frequency standard or a sensitive magnetometer when the D(1) line, rather than the D(2) line, is used.

Optics Letters•Aug 15, 2002•154 citations

Improving the sensitivity of an optically pumped rubidium atomic magnetometer by using of a repumping laser beam

Lulu Zhang, Le-Le Bai, Yu-Lin Yang +5 more

For the experimental implementation of an optically pumped atomic magnetometer, the magnetic resonance signal with a narrow linewidth and a high signal-to-noise ratio (SNR) is required for achieving a high sensitivity. Using 795-nm laser as both the pumping and the probe laser, we compare the magnetic resonance signals from different rubidium atomic vapor cells and investigate the variations of magnetic resonance signals with temperature. Optimized magnetic resonance signal is achieved with a paraffin-coated rubidium atomic vapor cell. Then the 780-nm laser at rubidium D2 line is introduced as a repumping laser, and we explore the changes of linewidth and SNR of the magnetic resonance signal under different power of the pumping laser and the repumping laser. Owing to the 780-nm repumping laser beam, the signal amplitude of rubidium-85 magnetic resonance signal is improved remarkably because more rubidium-85 atoms are spin- polarized by the 795-nm pumping laser beam. At the same time, the linewidth of rubidium-85 magnetic resonance signal is roughly not broadened anymore. We realize a closed-loop optically pumped rubidium-85 atomic magnetometer with a bandwidth of ~1.2 kHz, and the sensitivity is calibrated to be ~245.5 pT/Hz1/2 only with the 795-nm pumping laser beam. Owing to the employment of the 780-nm repumping laser beam, the sensitivity is improved to be ~26.4 pT/Hz1/2 which is improved roughly by one order of magnitude. We also calibrate the measurement accuracy and deviation of a commercial fluxgate magnetometer by using the enhanced rubidium magnetic resonance signal.

Acta Physica Sinica•Jan 1, 2021•5 citations

The Characterization of Atomic Vapor Cells for High-Sensitivity Magnetic Field Measurements in SERF Regime

Murat Salim Karabinaoğlu, Berfin Muhlise Caklı, Mehmet Hüseyin Sevim

Nowadays, quantum sensor research is a very interesting and popular topic. High-sensitivity magnetic field measurements using quantum sensors have evolved into the most sensitive magnetic field sensor category today with the invention of atomic magnetometers operating in the spin-exchange relaxation-free (SERF) regime. This letter was prepared to investigate the magnetic field sensitivity changes depending on the buffer gas, temperature, and laser intensity using indigenously produced atomic vapor cells. In addition, the aim was to determine the optimum operating conditions of the atomic magnetometer operating in the SERF regime. As a result, the resonance linewidth and signal-to-noise ratio were measured, and the minimum detectable magnetic field was calculated. According to the obtained results, the lowest magnetic field for Cells I–III was measured as 5.12, 4.21, and 4.81 pT, respectively. The lowest magnetic field of all conditions was obtained in vapor cell (Cell-II) at 100 °C with 5 mW laser intensity. As a result, it has been experimentally proven that under the same conditions, increasing the buffer gas pressure in vapor cells can narrow the resonance linewidth, and the magnetic field sensitivity can be improved by increasing the laser intensity applied to the vapor cells.

IEEE Sensors Letters•Feb 24, 2025•5 citations

The combination of unmanned aerial vehicles and atomic magnetometers can be used for detection applications such as mineral resource exploration, environmental protection, and earthquake monitoring, as well as the detection of sunken ships and unexploded ordnance. A dark-resonance atomic magnetometer offers the significant advantages of a fully optical probe and omnidirectional measurement with no dead zones, making it an ideal choice for airborne applications on unmanned aerial vehicles. Enhancing the sensitivity of such atomic magnetometers is an essential task. In this study, we sought to enhance the sensitivity of a dark-state resonance atomic magnetometer. Initially, through theoretical analysis, we compared the excitation effects of coherent population trapping (CPT) resonance on the D1 and D2 transitions of 133Cs thermal vapor. The results indicate that excitation via the D1 line yields an increase in resonance contrast and a reduction in linewidth when compared with excitation through the D2 line, aligning with theoretical predictions. Subsequently, considering the impact of various quantum system parameters on sensitivity, as well as their interdependent characteristics, two experimental setups were developed for empirical investigation. One setup focused on parameter optimization experiments, where we compared the linewidth and contrast of CPT resonances excited by both D1 and D2 transitions; this led to an optimization of atomic cell size, buffer gas pressure, and operating temperature, resulting in an ideal parameter range. The second setup was employed to validate these optimized parameters using a coupled dark-state atom magnetometer experiment, achieving approximately a 10-fold improvement in sensitivity.

An atomic magnetometer based on coherent population trapping (CPT) resonances in microfabricated vapor cells is demonstrated. Fabricated by the micro-electro-mechanical-system (MEMS) technology, the cells are filled with Rb and Ne at a controlled pressure. An experimental apparatus is built for characterizing properties of microfabricated vapor cells via the CPT effects. The typical CPT linewidth is measured to be about 3 kHz (1.46 kHz with approximately zero laser intensity) for the rubidium D1 line at about 90 °C. The effects of pressure, temperature and laser intensity on CPT linewidth are studied experimentally. A closed-loop atomic magnetometer is finally finished with a sensitivity of 210.5 pT/Hz1/2 at 1 Hz bandwidth. This work paves the way for developing an integrated chip-scale atomic magnetometer in the future.

Experimentally compared for the first time is the sensitivity of two magnetometer types implemented on a common base of rubidium atomic clock with coherent population trapping (CPT). The first magnetometer used a magneto-sensitive optically excited CPT resonance, the other measured field strength through the electron paramagnetic resonance (EPR) excited with alternating magnetic field. We show advantages and limitations of these promising quantum sensing technologies. Sensitivity of both types was measured under resonance excitation on the D1 line of 87Rb. We demonstrate that the СРТ magnetometer sensitivity may exceed that of the EPR device by two orders of magnitude.

We present an experimental and theoretical investigation of the coherent population trapping (CPT) resonance excited on the D1 line of 87 Rb atoms by bichromatic linearly polarized laser light. The experimental results show that a lin ‖ lin transition scheme is a promising alternative to the conventional circular—circular transition scheme for an atomic magnetometer. Compared with the circular light transition scheme, linear light accounts for high-contrast transmission resonances, which makes this excitation scheme promising for high-sensitivity magnetometers. We also use linear light and circular light to detect changes of a standard magnetic field, separately.

We have compared coherent population trapping (CPT) resonances, both experimentally and theoretically, for excitation of the D(1) and D(2) transitions of thermal (85)Rb vapor. Excitation of the D(1) line results in greater resonance contrast than excitation of the D(2) line and in a reduction in the resonance width, in agreement with theoretical expectations. These results translate into a nearly tenfold improvement in performance for the application of CPT resonances to a frequency standard or a sensitive magnetometer when the D(1) line, rather than the D(2) line, is used.

For the experimental implementation of an optically pumped atomic magnetometer, the magnetic resonance signal with a narrow linewidth and a high signal-to-noise ratio (SNR) is required for achieving a high sensitivity. Using 795-nm laser as both the pumping and the probe laser, we compare the magnetic resonance signals from different rubidium atomic vapor cells and investigate the variations of magnetic resonance signals with temperature. Optimized magnetic resonance signal is achieved with a paraffin-coated rubidium atomic vapor cell. Then the 780-nm laser at rubidium D2 line is introduced as a repumping laser, and we explore the changes of linewidth and SNR of the magnetic resonance signal under different power of the pumping laser and the repumping laser. Owing to the 780-nm repumping laser beam, the signal amplitude of rubidium-85 magnetic resonance signal is improved remarkably because more rubidium-85 atoms are spin- polarized by the 795-nm pumping laser beam. At the same time, the linewidth of rubidium-85 magnetic resonance signal is roughly not broadened anymore. We realize a closed-loop optically pumped rubidium-85 atomic magnetometer with a bandwidth of ~1.2 kHz, and the sensitivity is calibrated to be ~245.5 pT/Hz1/2 only with the 795-nm pumping laser beam. Owing to the employment of the 780-nm repumping laser beam, the sensitivity is improved to be ~26.4 pT/Hz1/2 which is improved roughly by one order of magnitude. We also calibrate the measurement accuracy and deviation of a commercial fluxgate magnetometer by using the enhanced rubidium magnetic resonance signal.

Nowadays, quantum sensor research is a very interesting and popular topic. High-sensitivity magnetic field measurements using quantum sensors have evolved into the most sensitive magnetic field sensor category today with the invention of atomic magnetometers operating in the spin-exchange relaxation-free (SERF) regime. This letter was prepared to investigate the magnetic field sensitivity changes depending on the buffer gas, temperature, and laser intensity using indigenously produced atomic vapor cells. In addition, the aim was to determine the optimum operating conditions of the atomic magnetometer operating in the SERF regime. As a result, the resonance linewidth and signal-to-noise ratio were measured, and the minimum detectable magnetic field was calculated. According to the obtained results, the lowest magnetic field for Cells I–III was measured as 5.12, 4.21, and 4.81 pT, respectively. The lowest magnetic field of all conditions was obtained in vapor cell (Cell-II) at 100 °C with 5 mW laser intensity. As a result, it has been experimentally proven that under the same conditions, increasing the buffer gas pressure in vapor cells can narrow the resonance linewidth, and the magnetic field sensitivity can be improved by increasing the laser intensity applied to the vapor cells.