Challenges
Datasets
Workspaces
Papers
Discussions
Leaderboard
Log inSign up
Challenges
Datasets
Workspaces
Papers
Discussions
Leaderboard
Blog
Job Board
Q3AS

© 2026 Aqora Quantum S.A.S.

TermsPrivacyLegal Notice

Optics Letters

Sensitivity enhancement of far-detuned RF field sensing based on Rydberg atoms dressed by a near-resonant RF field

Jiawei Yao, Qiang An, Yan‐Li Zhou, Kai Yang, Feng-Chuan Wu, Yunqi Fu

Published Sep 6, 2022• 31 citations
Publisher

Abstract

Rydberg-atom electrometers promise traceable standards for RF electrometry by enabling stable and uniform measurement. In this Letter, we propose an approach to increase the sensitivity of the Rydberg-atom electrometer for far-detuned RF field sensing. The key physical mechanism is the addition of a new ingredient-a local RF field near-resonant with a Rydberg transition-so that the far-detuned field can be detected by the shift of an Autler-Townes (AT) splitting peak, which can be dozens of times larger than the AC Stark shift of the electromagnetic induced transparency (EIT) signal without the near-resonant field. The method enables us to measure far-detuned fields with higher sensitivities, including sub-GHz RF fields (even DC electric fields) which are rarely involved in the existing sensitivity enhancement methods.

DOI
10.1364/ol.465048

Related papers

Extending bandwidth sensitivity of Rydberg-atom-based microwave electrometry using an auxiliary microwave field

Yue Cui, Feng-Dong Jia, Jianhai Hao +13 more

We demonstrate the use of an auxiliary microwave field to extend the bandwidth sensitivity of Rydberg-atom-based microwave electrometry. Electromagnetically induced transparency (EIT) and Autler-Townes (AT) splitting in Rydberg atom microwave electrometry provide advantageous sensitivity for the resonant detection of microwave (MW) fields because the Stark shift of the target Rydberg state takes the linear form of AT splitting. However, the sensitivity is reduced by several orders of magnitude for detuned MW fields because the Stark shift of the target Rydberg state depends on a weak nonlinear effect. We show that the auxiliary microwave field with appropriate Rabi frequency or detuning could shift the atomic energy levels to bring a particular Rydberg-Rydberg transition of interest for microwave sensing into resonance with the target microwave field. Using the atomic superheterodyne method, we verified the general method that regulates Rydberg energy levels using an auxiliary microwave field. The experimental results of this study confirm that this technique works efficiently for detecting microwave fields detuned by up to 100 MHz from resonance with the field-free Rydberg-Rydberg transition used for sensing. The measurement sensitivity of the detuned target field is increased by a factor of 10 compared with that achieved without the application of the auxiliary dressing field.

Physical Review A•Apr 3, 2023•47 citations

Using frequency detuning to improve the sensitivity of electric field measurements via electromagnetically induced transparency and Autler-Townes splitting in Rydberg atoms

Matthew T. Simons, Joshua A. Gordon, Christopher L. Holloway +3 more

In this work, we demonstrate an approach for improved sensitivity in weak radio frequency (RF) electric-field strength measurements using Rydberg electromagnetically induced transparency (EIT) in an atomic vapor. This is accomplished by varying the RF frequency around a resonant atomic transition and extrapolating the weak on-resonant field strength from the resulting off-resonant Autler-Townes (AT) splittings. This measurement remains directly traceable to SI compared to previous techniques, precluding any knowledge of experimental parameters such as optical beam powers as is the case when using the curvature of the EIT line shape to measure weak fields. We use this approach to measure weak RF fields at 182 GHz and 208 GHz demonstrating improvement greater than a factor of 2 in the measurement sensitivity compared to on-resonant AT splitting RF electric field measurements.

Applied Physics Letters•Apr 25, 2016•155 citations

Rydberg state engineering: A comparison of tuning schemes for continuous frequency sensing

Samuel Berweger, Nikunjkumar Prajapati, Alexandra B. Artusio‐Glimpse +11 more

On-resonance Rydberg atom-based radio-frequency (RF) electric field sensing methods remain limited by the narrow frequency signal detection bands available by resonant transitions. The use of an additional RF tuner field to dress or shift a target Rydberg state can be used to return a detuned signal field to resonance and thus dramatically extend the frequency range available for resonant sensing. Here we investigate three distinct tuning level schemes based on adjacent Rydberg transitions, which are shown to have distinct characteristics and can be controlled with mechanisms based on the tuning field frequency or field strength. We further show that a two-photon Raman feature can be used as an effective tuning mechanism separate from conventional Autler-Townes splitting. We compare our tuning schemes to AC Stark effect-based broadband RF field sensing and show that although the sensitivity is diminished as we tune away from a resonant state, it nevertheless can be used in configurations where there is a low density of Rydberg states, which would result in a weak AC Stark effect.

arXiv:2209.14407•Sep 28, 2022•1 citation

Continuous radio-frequency electric-field detection through adjacent Rydberg resonance tuning

Matthew T. Simons, Alexandra B. Artusio‐Glimpse, Christopher L. Holloway +5 more

We demonstrate the use of multiple atomic-level Rydberg-atom schemes for continuous frequency detection of radio-frequency (RF) fields. Resonant detection of RF fields by electromagnetically induced transparency and Autler-Townes (AT) splitting in Rydberg atoms is typically limited to frequencies within the narrow bandwidth of a Rydberg transition. By applying a second field resonant with an adjacent Rydberg transition, far-detuned fields can be detected through a two-photon resonance AT splitting. This two-photon AT splitting method is several orders of magnitude more sensitive than off-resonant detection using the Stark shift. We present the results of various experimental configurations and a theoretical analysis to illustrate the effectiveness of this multiple level scheme. These results show that this approach allows for the detection of frequencies in a continuous band between resonances with adjacent Rydberg states.

arXiv:2105.10561•Physical Review A•Sep 24, 2021•84 citations

Rydberg Atom-Based Sensors: Principles, Recent Advances, and Applications

Dinelka Somaweera, Amer Abdulghani, Ambali Alade Odebowale +7 more

Rydberg atoms are neutral atoms excited to high principal quantum number states, which endows them with exaggerated properties such as large electric dipole moments, long lifetimes, and extreme sensitivity to external electromagnetic fields. These characteristics form the foundation of Rydberg atom-based sensors, an emerging class of quantum devices capable of optically detecting electric fields across frequencies from DC to the terahertz regime. Rydberg-based electrometry operates through both Autler–Townes (AT) splitting of resonant Rydberg transitions and Stark-shift measurements for high-frequency or far-detuned fields, enabling broadband field sensing from DC to the THz regime. Using ladder-type electromagnetically induced transparency (EIT) and AT splitting, these sensors enable non-invasive, SI-traceable measurements of field amplitude, frequency, phase, and polarization. Recent developments have demonstrated broadband electric field probes, voltage calibration standards, and compact RF receivers based on thermal vapor cells and integrated photonic architectures. Furthermore, innovations in multi-photon EIT, superheterodyne readout, and multi wave mixing have expanded the dynamic range and bandwidth of Rydberg-based electrometry. Despite challenges related to environmental perturbations, linewidth broadening, and laser stabilization, ongoing advances in atomic control, hybrid photonic integration, and EIT-based readout promise scalable, chip-compatible sensors. This review summarizes the physical principles, experimental progress, and emerging applications of Rydberg atom-based sensing, emphasizing their potential for next generation quantum metrology, wireless communication, and precision field mapping.

Photonics•Dec 12, 2025•12 citations

Atom-based RF electric field metrology above 100 GHz

Matthew T. Simons, Joshua A. Gordon, Christopher L. Holloway

Atom-based radio-frequency (RF) electric field probes have the potential to improve electric field measurements for a broad range of frequencies (from a few GHz to 100s of GHz) and field strengths (mV/m to kV/m). For these probes to become a common measurement method, their range must be extended to high frequency (>100 GHz) and low field strength regimes. We present SI-traceable electric field measurements of RF fields above 100 GHz, using Autler-Townes splitting of Rydberg electromagnetically-induced transparency in a rubidium (Rb) vapor. We also demonstrate several techniques, including RF detuning from resonance and enhanced absorption, for increasing the probe sensitivity.

Proceedings of SPIE, the International Society for Optical Engineering/Proceedings of SPIE•Feb 25, 2016•4 citations
Rydberg-atom electrometers promise traceable standards for RF electrometry by enabling stable and uniform measurement. In this Letter, we propose an approach to increase the sensitivity of the Rydberg-atom electrometer for far-detuned RF field sensing. The key physical mechanism is the addition of a new ingredient-a local RF field near-resonant with a Rydberg transition-so that the far-detuned field can be detected by the shift of an Autler-Townes (AT) splitting peak, which can be dozens of times larger than the AC Stark shift of the electromagnetic induced transparency (EIT) signal without the near-resonant field. The method enables us to measure far-detuned fields with higher sensitivities, including sub-GHz RF fields (even DC electric fields) which are rarely involved in the existing sensitivity enhancement methods.
We demonstrate the use of an auxiliary microwave field to extend the bandwidth sensitivity of Rydberg-atom-based microwave electrometry. Electromagnetically induced transparency (EIT) and Autler-Townes (AT) splitting in Rydberg atom microwave electrometry provide advantageous sensitivity for the resonant detection of microwave (MW) fields because the Stark shift of the target Rydberg state takes the linear form of AT splitting. However, the sensitivity is reduced by several orders of magnitude for detuned MW fields because the Stark shift of the target Rydberg state depends on a weak nonlinear effect. We show that the auxiliary microwave field with appropriate Rabi frequency or detuning could shift the atomic energy levels to bring a particular Rydberg-Rydberg transition of interest for microwave sensing into resonance with the target microwave field. Using the atomic superheterodyne method, we verified the general method that regulates Rydberg energy levels using an auxiliary microwave field. The experimental results of this study confirm that this technique works efficiently for detecting microwave fields detuned by up to 100 MHz from resonance with the field-free Rydberg-Rydberg transition used for sensing. The measurement sensitivity of the detuned target field is increased by a factor of 10 compared with that achieved without the application of the auxiliary dressing field.
In this work, we demonstrate an approach for improved sensitivity in weak radio frequency (RF) electric-field strength measurements using Rydberg electromagnetically induced transparency (EIT) in an atomic vapor. This is accomplished by varying the RF frequency around a resonant atomic transition and extrapolating the weak on-resonant field strength from the resulting off-resonant Autler-Townes (AT) splittings. This measurement remains directly traceable to SI compared to previous techniques, precluding any knowledge of experimental parameters such as optical beam powers as is the case when using the curvature of the EIT line shape to measure weak fields. We use this approach to measure weak RF fields at 182 GHz and 208 GHz demonstrating improvement greater than a factor of 2 in the measurement sensitivity compared to on-resonant AT splitting RF electric field measurements.
On-resonance Rydberg atom-based radio-frequency (RF) electric field sensing methods remain limited by the narrow frequency signal detection bands available by resonant transitions. The use of an additional RF tuner field to dress or shift a target Rydberg state can be used to return a detuned signal field to resonance and thus dramatically extend the frequency range available for resonant sensing. Here we investigate three distinct tuning level schemes based on adjacent Rydberg transitions, which are shown to have distinct characteristics and can be controlled with mechanisms based on the tuning field frequency or field strength. We further show that a two-photon Raman feature can be used as an effective tuning mechanism separate from conventional Autler-Townes splitting. We compare our tuning schemes to AC Stark effect-based broadband RF field sensing and show that although the sensitivity is diminished as we tune away from a resonant state, it nevertheless can be used in configurations where there is a low density of Rydberg states, which would result in a weak AC Stark effect.
We demonstrate the use of multiple atomic-level Rydberg-atom schemes for continuous frequency detection of radio-frequency (RF) fields. Resonant detection of RF fields by electromagnetically induced transparency and Autler-Townes (AT) splitting in Rydberg atoms is typically limited to frequencies within the narrow bandwidth of a Rydberg transition. By applying a second field resonant with an adjacent Rydberg transition, far-detuned fields can be detected through a two-photon resonance AT splitting. This two-photon AT splitting method is several orders of magnitude more sensitive than off-resonant detection using the Stark shift. We present the results of various experimental configurations and a theoretical analysis to illustrate the effectiveness of this multiple level scheme. These results show that this approach allows for the detection of frequencies in a continuous band between resonances with adjacent Rydberg states.
Rydberg atoms are neutral atoms excited to high principal quantum number states, which endows them with exaggerated properties such as large electric dipole moments, long lifetimes, and extreme sensitivity to external electromagnetic fields. These characteristics form the foundation of Rydberg atom-based sensors, an emerging class of quantum devices capable of optically detecting electric fields across frequencies from DC to the terahertz regime. Rydberg-based electrometry operates through both Autler–Townes (AT) splitting of resonant Rydberg transitions and Stark-shift measurements for high-frequency or far-detuned fields, enabling broadband field sensing from DC to the THz regime. Using ladder-type electromagnetically induced transparency (EIT) and AT splitting, these sensors enable non-invasive, SI-traceable measurements of field amplitude, frequency, phase, and polarization. Recent developments have demonstrated broadband electric field probes, voltage calibration standards, and compact RF receivers based on thermal vapor cells and integrated photonic architectures. Furthermore, innovations in multi-photon EIT, superheterodyne readout, and multi wave mixing have expanded the dynamic range and bandwidth of Rydberg-based electrometry. Despite challenges related to environmental perturbations, linewidth broadening, and laser stabilization, ongoing advances in atomic control, hybrid photonic integration, and EIT-based readout promise scalable, chip-compatible sensors. This review summarizes the physical principles, experimental progress, and emerging applications of Rydberg atom-based sensing, emphasizing their potential for next generation quantum metrology, wireless communication, and precision field mapping.
Atom-based radio-frequency (RF) electric field probes have the potential to improve electric field measurements for a broad range of frequencies (from a few GHz to 100s of GHz) and field strengths (mV/m to kV/m). For these probes to become a common measurement method, their range must be extended to high frequency (>100 GHz) and low field strength regimes. We present SI-traceable electric field measurements of RF fields above 100 GHz, using Autler-Townes splitting of Rydberg electromagnetically-induced transparency in a rubidium (Rb) vapor. We also demonstrate several techniques, including RF detuning from resonance and enhanced absorption, for increasing the probe sensitivity.