Challenges
Datasets
Workspaces
Papers
Discussions
Leaderboard
Log inSign up
Challenges
Datasets
Workspaces
Papers
Discussions
Leaderboard
Blog
Job Board
Q3AS

© 2026 Aqora Quantum S.A.S.

TermsPrivacyLegal Notice

arXiv:2105.10561 · Physical Review A

Continuous radio-frequency electric-field detection through adjacent Rydberg resonance tuning

Matthew T. Simons, Alexandra B. Artusio‐Glimpse, Christopher L. Holloway, Eric Imhof, Steven R. Jefferts, Robert Wyllie, Brian C. Sawyer, Thad G Walker

Published Sep 24, 2021• 84 citations
arXivHTMLPDF

Abstract

We demonstrate the use of multiple atomic-level Rydberg-atom schemes for continuous frequency detection of radio-frequency (RF) fields. Resonant detection of RF fields by electromagnetically induced transparency and Autler-Townes (AT) splitting in Rydberg atoms is typically limited to frequencies within the narrow bandwidth of a Rydberg transition. By applying a second field resonant with an adjacent Rydberg transition, far-detuned fields can be detected through a two-photon resonance AT splitting. This two-photon AT splitting method is several orders of magnitude more sensitive than off-resonant detection using the Stark shift. We present the results of various experimental configurations and a theoretical analysis to illustrate the effectiveness of this multiple level scheme. These results show that this approach allows for the detection of frequencies in a continuous band between resonances with adjacent Rydberg states.

DOI
10.1103/physreva.104.032824

Related papers

Rydberg-State Engineering: Investigations of Tuning Schemes for Continuous Frequency Sensing

Samuel Berweger, Nikunjkumar Prajapati, Alexandra B. Artusio‐Glimpse +11 more

On-resonance Rydberg atom--based radio-frequency- (rf) electric-field sensing methods remain limited by the narrow frequency-signal detection bands available from resonant transitions. An additional rf tuner field can be used to dress or shift a target Rydberg state to return a detuned signal field to resonance and thus dramatically extend the frequency range available for resonant sensing. Here we investigate three distinct tuning-level schemes based on adjacent Rydberg transitions, which are shown to have distinct characteristics and can be controlled with the frequency or the strength of the tuning field. We further show that a two-photon Raman peak can be used as an effective tuning feature separate from conventional Autler-Townes splitting. We compare our tuning schemes with ac Stark effect--based broadband rf-field sensing and show that although the sensitivity is diminished with tuning away from a resonant state, it nevertheless can be used in configurations where there is a low density of Rydberg states, which would result in a weak ac Stark effect.

Physical Review Applied•Apr 18, 2023•40 citations

Rydberg state engineering: A comparison of tuning schemes for continuous frequency sensing

Samuel Berweger, Nikunjkumar Prajapati, Alexandra B. Artusio‐Glimpse +11 more

On-resonance Rydberg atom-based radio-frequency (RF) electric field sensing methods remain limited by the narrow frequency signal detection bands available by resonant transitions. The use of an additional RF tuner field to dress or shift a target Rydberg state can be used to return a detuned signal field to resonance and thus dramatically extend the frequency range available for resonant sensing. Here we investigate three distinct tuning level schemes based on adjacent Rydberg transitions, which are shown to have distinct characteristics and can be controlled with mechanisms based on the tuning field frequency or field strength. We further show that a two-photon Raman feature can be used as an effective tuning mechanism separate from conventional Autler-Townes splitting. We compare our tuning schemes to AC Stark effect-based broadband RF field sensing and show that although the sensitivity is diminished as we tune away from a resonant state, it nevertheless can be used in configurations where there is a low density of Rydberg states, which would result in a weak AC Stark effect.

arXiv:2209.14407•Sep 28, 2022•1 citation

Extending bandwidth sensitivity of Rydberg-atom-based microwave electrometry using an auxiliary microwave field

Yue Cui, Feng-Dong Jia, Jianhai Hao +13 more

We demonstrate the use of an auxiliary microwave field to extend the bandwidth sensitivity of Rydberg-atom-based microwave electrometry. Electromagnetically induced transparency (EIT) and Autler-Townes (AT) splitting in Rydberg atom microwave electrometry provide advantageous sensitivity for the resonant detection of microwave (MW) fields because the Stark shift of the target Rydberg state takes the linear form of AT splitting. However, the sensitivity is reduced by several orders of magnitude for detuned MW fields because the Stark shift of the target Rydberg state depends on a weak nonlinear effect. We show that the auxiliary microwave field with appropriate Rabi frequency or detuning could shift the atomic energy levels to bring a particular Rydberg-Rydberg transition of interest for microwave sensing into resonance with the target microwave field. Using the atomic superheterodyne method, we verified the general method that regulates Rydberg energy levels using an auxiliary microwave field. The experimental results of this study confirm that this technique works efficiently for detecting microwave fields detuned by up to 100 MHz from resonance with the field-free Rydberg-Rydberg transition used for sensing. The measurement sensitivity of the detuned target field is increased by a factor of 10 compared with that achieved without the application of the auxiliary dressing field.

Physical Review A•Apr 3, 2023•47 citations

Sensitivity enhancement of far-detuned RF field sensing based on Rydberg atoms dressed by a near-resonant RF field

Jiawei Yao, Qiang An, Yan‐Li Zhou +3 more

Rydberg-atom electrometers promise traceable standards for RF electrometry by enabling stable and uniform measurement. In this Letter, we propose an approach to increase the sensitivity of the Rydberg-atom electrometer for far-detuned RF field sensing. The key physical mechanism is the addition of a new ingredient-a local RF field near-resonant with a Rydberg transition-so that the far-detuned field can be detected by the shift of an Autler-Townes (AT) splitting peak, which can be dozens of times larger than the AC Stark shift of the electromagnetic induced transparency (EIT) signal without the near-resonant field. The method enables us to measure far-detuned fields with higher sensitivities, including sub-GHz RF fields (even DC electric fields) which are rarely involved in the existing sensitivity enhancement methods.

Optics Letters•Sep 6, 2022•31 citations

Using frequency detuning to improve the sensitivity of electric field measurements via electromagnetically induced transparency and Autler-Townes splitting in Rydberg atoms

Matthew T. Simons, Joshua A. Gordon, Christopher L. Holloway +3 more

In this work, we demonstrate an approach for improved sensitivity in weak radio frequency (RF) electric-field strength measurements using Rydberg electromagnetically induced transparency (EIT) in an atomic vapor. This is accomplished by varying the RF frequency around a resonant atomic transition and extrapolating the weak on-resonant field strength from the resulting off-resonant Autler-Townes (AT) splittings. This measurement remains directly traceable to SI compared to previous techniques, precluding any knowledge of experimental parameters such as optical beam powers as is the case when using the curvature of the EIT line shape to measure weak fields. We use this approach to measure weak RF fields at 182 GHz and 208 GHz demonstrating improvement greater than a factor of 2 in the measurement sensitivity compared to on-resonant AT splitting RF electric field measurements.

Applied Physics Letters•Apr 25, 2016•155 citations

A read-out enhancement for microwave electric field sensing with Rydberg atoms

Harald Kübler, James P. Shaffer

We have shown that Rydberg atoms can be used for high-sensitivity, absolute sensing of radio frequency (RF) electric fields. We achieved a sensitivity of 3 μVcm-1Hz-1/2 for two read-out strategies. Results using a Mach-Zehnder interferometer2 and frequency modulated spectroscopy both achieve similar photon shot noise limited sensitivity. Fundamental limits to the sensitivity of the Rydberg atom-based RF electric field sensing have been addressed. Depending on the spectral resolution of the read-out, either the RF induced transmission line frequency splitting, the Autler-Townes regime, or a change in the on-resonant absorption, the amplitude regime, can be used to determine the RF electric field. Here, we present theoretical results of a 3-photon read-out scheme which enables the Autler-Townes regime of Rydberg atom-based RF electrometry to be extended to lower RF electric field strengths. We show that the residual Doppler shifts can, in principle, be reduced to ~11.8 kHz, on the order of the Rydberg atom natural lindewidths, using the approach.

SPIE Quantum Technologies•May 21, 2018•33 citations
We demonstrate the use of multiple atomic-level Rydberg-atom schemes for continuous frequency detection of radio-frequency (RF) fields. Resonant detection of RF fields by electromagnetically induced transparency and Autler-Townes (AT) splitting in Rydberg atoms is typically limited to frequencies within the narrow bandwidth of a Rydberg transition. By applying a second field resonant with an adjacent Rydberg transition, far-detuned fields can be detected through a two-photon resonance AT splitting. This two-photon AT splitting method is several orders of magnitude more sensitive than off-resonant detection using the Stark shift. We present the results of various experimental configurations and a theoretical analysis to illustrate the effectiveness of this multiple level scheme. These results show that this approach allows for the detection of frequencies in a continuous band between resonances with adjacent Rydberg states.
On-resonance Rydberg atom--based radio-frequency- (rf) electric-field sensing methods remain limited by the narrow frequency-signal detection bands available from resonant transitions. An additional rf tuner field can be used to dress or shift a target Rydberg state to return a detuned signal field to resonance and thus dramatically extend the frequency range available for resonant sensing. Here we investigate three distinct tuning-level schemes based on adjacent Rydberg transitions, which are shown to have distinct characteristics and can be controlled with the frequency or the strength of the tuning field. We further show that a two-photon Raman peak can be used as an effective tuning feature separate from conventional Autler-Townes splitting. We compare our tuning schemes with ac Stark effect--based broadband rf-field sensing and show that although the sensitivity is diminished with tuning away from a resonant state, it nevertheless can be used in configurations where there is a low density of Rydberg states, which would result in a weak ac Stark effect.
On-resonance Rydberg atom-based radio-frequency (RF) electric field sensing methods remain limited by the narrow frequency signal detection bands available by resonant transitions. The use of an additional RF tuner field to dress or shift a target Rydberg state can be used to return a detuned signal field to resonance and thus dramatically extend the frequency range available for resonant sensing. Here we investigate three distinct tuning level schemes based on adjacent Rydberg transitions, which are shown to have distinct characteristics and can be controlled with mechanisms based on the tuning field frequency or field strength. We further show that a two-photon Raman feature can be used as an effective tuning mechanism separate from conventional Autler-Townes splitting. We compare our tuning schemes to AC Stark effect-based broadband RF field sensing and show that although the sensitivity is diminished as we tune away from a resonant state, it nevertheless can be used in configurations where there is a low density of Rydberg states, which would result in a weak AC Stark effect.
We demonstrate the use of an auxiliary microwave field to extend the bandwidth sensitivity of Rydberg-atom-based microwave electrometry. Electromagnetically induced transparency (EIT) and Autler-Townes (AT) splitting in Rydberg atom microwave electrometry provide advantageous sensitivity for the resonant detection of microwave (MW) fields because the Stark shift of the target Rydberg state takes the linear form of AT splitting. However, the sensitivity is reduced by several orders of magnitude for detuned MW fields because the Stark shift of the target Rydberg state depends on a weak nonlinear effect. We show that the auxiliary microwave field with appropriate Rabi frequency or detuning could shift the atomic energy levels to bring a particular Rydberg-Rydberg transition of interest for microwave sensing into resonance with the target microwave field. Using the atomic superheterodyne method, we verified the general method that regulates Rydberg energy levels using an auxiliary microwave field. The experimental results of this study confirm that this technique works efficiently for detecting microwave fields detuned by up to 100 MHz from resonance with the field-free Rydberg-Rydberg transition used for sensing. The measurement sensitivity of the detuned target field is increased by a factor of 10 compared with that achieved without the application of the auxiliary dressing field.
Rydberg-atom electrometers promise traceable standards for RF electrometry by enabling stable and uniform measurement. In this Letter, we propose an approach to increase the sensitivity of the Rydberg-atom electrometer for far-detuned RF field sensing. The key physical mechanism is the addition of a new ingredient-a local RF field near-resonant with a Rydberg transition-so that the far-detuned field can be detected by the shift of an Autler-Townes (AT) splitting peak, which can be dozens of times larger than the AC Stark shift of the electromagnetic induced transparency (EIT) signal without the near-resonant field. The method enables us to measure far-detuned fields with higher sensitivities, including sub-GHz RF fields (even DC electric fields) which are rarely involved in the existing sensitivity enhancement methods.
In this work, we demonstrate an approach for improved sensitivity in weak radio frequency (RF) electric-field strength measurements using Rydberg electromagnetically induced transparency (EIT) in an atomic vapor. This is accomplished by varying the RF frequency around a resonant atomic transition and extrapolating the weak on-resonant field strength from the resulting off-resonant Autler-Townes (AT) splittings. This measurement remains directly traceable to SI compared to previous techniques, precluding any knowledge of experimental parameters such as optical beam powers as is the case when using the curvature of the EIT line shape to measure weak fields. We use this approach to measure weak RF fields at 182 GHz and 208 GHz demonstrating improvement greater than a factor of 2 in the measurement sensitivity compared to on-resonant AT splitting RF electric field measurements.
We have shown that Rydberg atoms can be used for high-sensitivity, absolute sensing of radio frequency (RF) electric fields. We achieved a sensitivity of 3 μVcm-1Hz-1/2 for two read-out strategies. Results using a Mach-Zehnder interferometer2 and frequency modulated spectroscopy both achieve similar photon shot noise limited sensitivity. Fundamental limits to the sensitivity of the Rydberg atom-based RF electric field sensing have been addressed. Depending on the spectral resolution of the read-out, either the RF induced transmission line frequency splitting, the Autler-Townes regime, or a change in the on-resonant absorption, the amplitude regime, can be used to determine the RF electric field. Here, we present theoretical results of a 3-photon read-out scheme which enables the Autler-Townes regime of Rydberg atom-based RF electrometry to be extended to lower RF electric field strengths. We show that the residual Doppler shifts can, in principle, be reduced to ~11.8 kHz, on the order of the Rydberg atom natural lindewidths, using the approach.