Optics Express

Reducing residual amplitude modulation in electro-optic phase modulators by erasing photorefractive scatter

Juna Sathian, Esa A. Jaatinen

Published May 13, 2013• 25 citations

Abstract

Residual amplitude modulation (RAM) is an unwanted noise source in electro-optic phase modulators. The analysis presented shows that while the magnitude of the RAM produced by a MgO:LiNbO(3) modulator increases with intensity, its associated phase becomes less well defined. This combination results in temporal fluctuations in RAM that increase with intensity. This behavior is explained by the presented phenomenological model based on gradually evolving photorefractive scattering centers randomly distributed throughout the optically thick medium. This understanding is exploited to show that RAM can be reduced to below the 10(-5) level by introducing an intense optical beam to erase the photorefractive scatter.

DOI: 10.1364/oe.21.012309

Related papers

Polarization dependent photorefractive amplitude modulation production in MgO:LiNbO3 phase modulators

Juna Sathian, Esa A. Jaatinen

We present experimental and theoretical results of the intensity dependence of residual amplitude modulation (RAM) production in electro-optic phase modulators. By utilizing the anisotropy of the medium, we show that RAM has a photorefractive origin.

Aug 1, 20115 citations

Fundamental level of residual amplitude modulation in phase modulation processes

Alfredo E. Domínguez, Walter E. Ortega Larcher, Carlos N. Kozameh

The residual amplitude modulation (RAM) is a spurious effect of the phase modulation in the laser beam power. In this work we show that the optical modulators that are used to generate the sidebands on the laser beam generate a RAM that should be regarded as a fundamental level of noise in the optical setup.

Oct 29, 20170 citations

Measurement and control of residual amplitude modulation in optical phase modulation

Liufeng Li, Fang Liu, Wang Chun +1 more

Residual amplitude modulation is one of the major sources of instability in ultra-sensitive optical detections based on frequency modulation. Using a MgO·LiNbO(3) electro-optic crystal, we systematically measure the temperature and polarization dependence of residual amplitude modulation and our experimental results are in good agreement with a previous theoretical analysis. After optical phase modulation, two independent arms including optical detection and frequency demodulation are employed to closely examine the instability of the residual amplitude modulation. Residual amplitude modulation below 25 ppm is obtained with an active cancellation scheme in which the crystal temperature is varied so as to zero the baseline drifts with different origins. Possible improvements for better suppression and stability are discussed.

Review of Scientific InstrumentsApr 1, 201277 citations

Suppressing residual amplitude modulation to the 10−7 level in optical phase modulation

Jin Bi, Yunlin Zhi, Liufeng Li +1 more

Residual amplitude modulation is one of the major stability-degrading factors in many precision measurements. Using an electro-optic (EO) crystal with wedged input and output surfaces is an effective way to suppress residual amplitude modulation. Here the mechanism of residual amplitude modulation in this approach is investigated. The residual amplitude modulations measured in standard and wedged EO crystals bear similarities in their temperature and polarization dependences, implying that a mixture of the two orthogonal polarizations in the extraordinary light is responsible for the residual amplitude modulation in the wedged EO crystal. Similar to a standard EO crystal, a non-uniform spatial distribution of residual amplitude modulation is also observed in the extraordinary light emerging from the wedged EO crystal. The optical isolator after the EO crystal is replaced by a Faraday rotator, and an improvement in the long-term stability is observed. With the wedged-crystal approach, residual amplitude modulation as low as 2×10−7 is observed, contributing a frequency instability of 8×10−18 (500 s) in Pound–Drever–Hall frequency stabilization with a discrimination slope of 1×10−4 V/Hz.

Applied OpticsJan 16, 201938 citations

Detection of stably bright squeezed light with the quantum noise reduction of 126 dB by mutually compensating the phase fluctuations

Wenhai Yang, Shaoping Shi, Yajun Wang +3 more

We present a mutual compensation scheme of three phase fluctuations, originating from the residual amplitude modulation (RAM) in the phase modulation process, in the bright squeezed light generation system. The influence of the RAM on each locking loop is harmonized by using one electro-optic modulator (EOM), and the direction of the phase fluctuation is manipulated by positioning the photodetector (PD) that extracts the error signal before or after the optical parametric amplifier (OPA). Therefore a bright squeezed light with non-classical noise reduction of π is obtained. By fitting the squeezing and antisqueezing measurement results, we confirm that the total phase fluctuation of the system is around 3.1 mrad. The fluctuation of the noise suppression is 0.2 dB for 3 h.

Optics LettersOct 30, 201781 citations

Investigation of residual amplitude modulation in squeezed state generation system

Zhixiu Li, Xiaocong Sun, Yajun Wang +2 more

We present an analysis on how the optical parametric oscillator (OPO) detuning and the relative phase drift deteriorate the stability of the squeezed states, including the output power and the squeezed degree, and investigate the influence of RAM on the cavity detuning and the relative phase drift under different cases. Subsequently, the RAM is experimentally measured. In term of the measurement results, we perform a comparative study about RAM's influence on the cavity and phase locking in two cases. As a result, with the error signal extracted from the transmission of the OPO, the output power stability of the squeezed light is greatly improved. With the phase modulation imposed on the signal beam, the long-term stability of the squeezed degree is significantly enhanced.

Optics ExpressJul 10, 201810 citations