We demonstrate the high-speed operation of a 16-element superconducting nanostrip single-photon detector (SNSPD) array with a single flux quantum (SFQ) multiplexer. The SFQ multiplexer can reshape the output signals from 16-element SNSPD into pulses with durations shorter than 1 ns and bundle these pulses into one output line, which is advantageous for high-speed operation of the SNSPD array system. We confirmed the correct operation of the 16-element SNSPD system with a system detection efficiency of 80% at a wavelength of 1550 nm, timing jitter of 45 ps, and successful observation of photons at 1 ns time intervals as distinguishable output pulses. The reduction in detection efficiency could also be suppressed to ∼ 0.93 during the dead time of ∼ 10 n s for each SNSPD pixel when the incident photon flux was relatively low at 0.1 photon/pulse.
We demonstrate the high-speed operation of a 16-element superconducting nanostrip single-photon detector (SNSPD) array with a single flux quantum (SFQ) multiplexer. The SFQ multiplexer can reshape the output signals from 16-element SNSPD into pulses with durations shorter than 1 ns and bundle these pulses into one output line, which is advantageous for high-speed operation of the SNSPD array system. We confirmed the correct operation of the 16-element SNSPD system with a system detection efficiency of 80% at a wavelength of 1550 nm, timing jitter of 45 ps, and successful observation of photons at 1 ns time intervals as distinguishable output pulses. The reduction in detection efficiency could also be suppressed to ∼ 0.93 during the dead time of ∼ 10 n s for each SNSPD pixel when the incident photon flux was relatively low at 0.1 photon/pulse.
We developed a monolithic integration process for a superconducting nanostrip single-photon detector (SNSPD) and a cryogenic signal processor based on a single-flux-quantum (SFQ) circuit. Sixteen-pixel SNSPDs consisting of a 10-nm-thick and 100-nm-wide NbTiN nanowire were fabricated on a 3-in. Si wafer with an SFQ merger fabricated by the National Institute of Advanced Industrial Science and Technology Nb 2.5 kA/cm2 standard process 2. Subsequently, we illuminated the photons on the 16-pixel SNSPD array through an optical fiber and obtained a similar bias-current dependence of the detection efficiency with a single-pixel SNSPD without the SFQ merger. This indicates that the SFQ merger works correctly, and that the power dissipation of the SFQ circuit, which is estimated to be 200 μW, does not deteriorate the photon detection of SNSPD fabricated on the same chip with a size of 5 × 5 mm2. Furthermore, we measured timing jitter using a pulsed laser as the photon source. Owing to the careful tuning of the wiring length between each pixel of the 16-pixel SNSPD and each input port of the SFQ merger, the obtained timing jitter was 41.4 ps, which is approximately equal to or less than that of the single-pixel SNSPD.
A two-dimensional single-photon imaging system with high sensitivity and high time resolution is the ultimate camera and useful in a wide range of fields. A superconducting nanowire single-photon detector (SSPD or SNSPD) is one of the best candidates for realizing such an ultimate camera due to its high detection efficiency in a wide spectral range, low dark count rate without after-pulsing, and excellent time resolution. Here we propose a new readout scheme to realize a large-scale imaging array based on SSPD, where a row-column readout architecture is combined with a digital signal processor based on a single-flux-quantum (SFQ) circuit. A 16-pixel row-column readout SSPD array is fabricated and measured with an SFQ digital signal processor. We successfully acquired spatial information as encoded digital bit codes with the temporal information of the photon detection. The system timing jitter was measured as <80 ps for all 16 pixels even through the SFQ signal processor, indicating the potential for an imaging array with an extremely high time resolution.
We report a 16-pixel (4×4) superconducting nanowire single-photon detector (SNSPD) array featuring pixel-level photon-number-resolving capability. This multidimensional sensing is enabled by integrating a compact four-element series nanowire architecture into each spatial pixel, allowing direct discrimination of one to four photons. Under single-mode fiber illumination, the device achieves a total system detection efficiency of 41.5%, given the array geometrical fill factor of 53%. Across all channels, the device exhibits reliable multiphoton discrimination, maintaining minimum readout fidelities of 96%, 89%, 73%, and 77% for one- to four-photon states, respectively. Furthermore, independent channel evaluations reveal low timing jitter and negligible inter-channel crosstalk (<0.1 % ). By implementing differentiating pulse shaping for high-flux operation, a maximum single-channel −3 dB count rate of 984 MHz is achieved, establishing an aggregated array bandwidth potential of 8.9 GHz. This sensing architecture may provide a viable pathway toward high-flux single-photon imaging, offering potential applications in quantum optics and light detection and ranging (LiDAR) systems.
Since their inception, superconducting nanowire single-photon detectors have been enabling quantum optical applications and the rise of the photonic quantum industry. The evolution in the detector design and read-out strategies has led to the introduction of devices with a plurality of independent pixels, which have been able to operate with high system detection efficiency at high speed while also supporting photon number resolution capabilities. However, this comes at the cost of a complex readout that requires one coaxial cable for each pixel of the array. Here, we report a 28-pixel SNSPD with a dedicated parallel architecture that, while maintaining a simple readout with a single coaxial line, enables the detector to operate at high speed with low-performance degradation. The device shows a maximum single-photon efficiency of 88% and is able to maintain its efficiency above 50%, coupled with a timing jitter lower than 80 ps, up to a detection rate of 200 million counts per second. The detector also provides state-of-the-art photon-number-resolving performances with a 2-photon efficiency of 75% and a 3-photon efficiency of 62%.
Fast and efficient detection of single photons with high timing accuracy is a crucial requirement in most quantum optics experiments and enables novel sensing and imaging solutions. Superconducting nanowire single-photon detectors (SNSPD) achieve technology-leading performance in terms of detection efficiency, dark count rate, timing jitter, and detector dead times. However, conventional SNSPDs with high system detection efficiency typically rely on resonant enhancement of the absorption efficiency, thus only achieving attractive detector benchmarks over narrow spectral windows. Waveguide-integrated SNSPDs allow for leveraging the wideband material absorption in superconducting nanowires by absorbing light in a traveling-wave geometry but have been limited to low system detection efficiencies due to interface losses when coupling to optical fibers. Here, we show how high system detection efficiencies of 22%–73% are realized over a broad wavelength range from 532 nm to 1640 nm in a single waveguide-integrated SNSPD device. We accomplish efficient coupling between optical fibers and waveguide-integrated nanowire detectors by employing a 3D interface, produced in direct laser writing, that relies on total internal reflection for achieving a broad transmission bandwidth. We further find low timing jitter of 25.7 ps and detector decay times of 9.8 ns, allowing for single-photon counting with high repetition rates up to 100 MHz. Our work paves the way for an efficient single-photon detector solution that combines the spectral requirements of an extremely wide range of quantum optics experiments in a single device. The coupling approach and SNSPD-integration with nanophotonic circuits are further well-suited for realizing large-scale detector arrays.
We report a compact, scalable, and high-performance superconducting nanowire single-photon detector (SNSPD) array by using a multichannel optical fiber array-coupled configuration. For single pixels with an active area of 18 µm in diameter and illuminated at the telecom wavelength of 1550 nm, we achieved a pixel yield of 13/16 on one chip, an average system detection efficiency of 69% at a dark count rate of 160 cps, a minimum timing jitter of 74 ps, and a maximum count rate of ∼ 40 M c p s . The optical crosstalk coefficient between adjacent channels is better than − 60 d B . The performance of the fiber array-coupled detectors is comparable with a standalone detector coupled to a single fiber. Our method is promising for the development of scalable, high-performance, and high-yield SNSPDs.