Ultra-cold atoms have small kinetic energy and are therefore very sensitive to external fields that act on the atoms. By having fine control over the positioning of the ultra-cold atom cloud we can use the atom cloud as a sensor for magnetic fields. By imaging these atom clouds we can infer a spatial map of the magnetic field. This spatial map will have a resolution proportional to the distance between the source of the magnetic field and the atom cloud which can be on the order of 0:1 µm. In the first half of the thesis, we investigate the two colour magneto-optical trap. This is a simple technique that can lead to a multiplicative increase in the number of atoms in a magneto-optical trap with a simple change to the optical setup. Using the two colour magneto-optical trap we have observed an increase of 5 times in the number of trapped atoms. An increase in the number of atoms in a magneto-optical helps with later cooling processes that are not lossless such as evaporative cooling which in turn helps the realisation of the ultra-cold atom microscope. In the second half of the thesis, we demonstrate how a 2d current density can be recovered from a 2d magnetic field map generated by the ultra-cold atom microscope. We then go on to show the sensitivity and responsivity of a cold atom cloud and a Bose-Einstein condensate. We then use the results of the previous section to simulate the measurement of currents in a silver nanowire network. Properties of the silver nanowire network can be simulated and aid in showing the abilities and limitations of the ultra-cold atom microscope. We found that the ultra-cold atom microscope can directly measure currents in low-density silver nanowire networks. In a high-density silver nanowire network, the average distance between the wires becomes too small to resolve. Hot-spots, areas of high current density can still be identified using the ultra-cold atom microscope. The ultracold atom microscope could then be used as a tool to aid the research look to use silver nanowires in many industrial applications such as touch screens.
Ultra-cold atoms have small kinetic energy and are therefore very sensitive to external fields that act on the atoms. By having fine control over the positioning of the ultra-cold atom cloud we can use the atom cloud as a sensor for magnetic fields. By imaging these atom clouds we can infer a spatial map of the magnetic field. This spatial map will have a resolution proportional to the distance between the source of the magnetic field and the atom cloud which can be on the order of 0:1 µm. In the first half of the thesis, we investigate the two colour magneto-optical trap. This is a simple technique that can lead to a multiplicative increase in the number of atoms in a magneto-optical trap with a simple change to the optical setup. Using the two colour magneto-optical trap we have observed an increase of 5 times in the number of trapped atoms. An increase in the number of atoms in a magneto-optical helps with later cooling processes that are not lossless such as evaporative cooling which in turn helps the realisation of the ultra-cold atom microscope. In the second half of the thesis, we demonstrate how a 2d current density can be recovered from a 2d magnetic field map generated by the ultra-cold atom microscope. We then go on to show the sensitivity and responsivity of a cold atom cloud and a Bose-Einstein condensate. We then use the results of the previous section to simulate the measurement of currents in a silver nanowire network. Properties of the silver nanowire network can be simulated and aid in showing the abilities and limitations of the ultra-cold atom microscope. We found that the ultra-cold atom microscope can directly measure currents in low-density silver nanowire networks. In a high-density silver nanowire network, the average distance between the wires becomes too small to resolve. Hot-spots, areas of high current density can still be identified using the ultra-cold atom microscope. The ultracold atom microscope could then be used as a tool to aid the research look to use silver nanowires in many industrial applications such as touch screens.
People have been measuring magnetic fields since 200 BC, giving rise to the field of magnetometry. Recently there has been a drive to measure smaller fields with better resolution, resulting in the production of many different types of magnetometers, each with their own unique features. These magnetometers can have a diverse range of applications such as, GNSS free navigation, biomedical sensing, space and weather measurements, and material physics. When designing a magnetomoter there is a trade off between high sensitivity to magnetic fields and high spatial resolution. Currently, there is a unoccupied niche in direct current (DC) magnetometry, that requires a magnetic field sensitivity in the picotesla range and micron scale spatial resolution. Here, I introduce the Bose-Einstein condensate (BEC), which is a macroscopic quantum object, ideal for probing magnetic fields on the nanotesla to picotesla range, with micron scale resolution. This thesis discusses the use of a BEC microscope (BEC-M) to characterise mate- rials with novel applications in nanotechnology by producing 2D current density maps. To produce the atomic probe for microscopy, a BEC in the quasi-1D regime is carefully prepared, requiring an ultra high vacuum (UHV) environment along with custom designed trapping structures, to optically and magnetically confine the atoms. The sensitivity and resolution of the BEC-M makes it an ideal tool for characterising electrical properties of structures on the micron scale such as carbon nanotube (CNT) bundles and biological samples. Current network configuration in samples such as these, can be mapped via a raster scanning procedure. A measurement was made to identify current pathways in CNTs by measuring the atomic distribution of the ultra cold cloud and converting these images to magnetic field and current density maps.
Atom chips are devices used to magnetically trap and manipulate ultracold atoms and Bose-Einstein condensates near a surface. In particular, permanent magnetic film atom chips can allow very tight confinement and intricate magnetic field designs while circumventing technical current noise. Research described in this thesis is focused on the development of a magnetic film atom chip, the production of Bose-Einstein condensates near the film surface, the characterisation of the associated magnetic potentials using rf spectroscopy of ultracold atoms and the realisation of a precision sensor based on splitting Bose-Einstein condensates in a double-well potential. The atom chip itself combines the edge of a perpendicularly magnetised GdTbFeCo film with a machined silver wire structure. A mirror magneto-optical trap collects up to 5 x 108 87Rb atoms beneath the chip surface. The current-carrying wires are then used to transfer the cloud of atoms to the magnetic film microtrap and radio frequency evaporative cooling is applied to produce Bose-Einstein condensates consisting of 1 x 105 atoms. We have identified small spatial magnetic field variations near the film surface that fragment the ultracold atom cloud. These variations originate from inhomogeneity in the film magnetisation and are characterised using a novel technique based on spatially resolved radio frequency spectroscopy of the atoms to map the magnetic field landscape over a large area. The observations agree with an analytic model for the spatial decay of random magnetic fields from the film surface. Bose-Einstein condensates in our unique potential landscape have been used as a precision sensor for potential gradients. We transfer the atoms to the central region of the chip which produces a double-well potential. A single BEC is formed far from the surface and is then dynamically split in two by moving the trap closer to the surface. After splitting, the population of atoms in each well is extremely sensitive to the asymmetry of the potential and can be used to sense tiny magnetic field gradients or changes in gravity on a small spatial scale.
The development of an experimental apparatus to produce Bose-Einstein condensates (BECs) of ⁸⁷Rb atoms and their application to magnetometry are discussed. Optical detection of atomic Larmor precession is a widely explored method for high-sensitivity measurements of magnetic fields. In this context, short laser/atom interaction time, atomic thermal diffusion and decoherence effects are among the main limitations. In this thesis, we overcome such problems by using spin-polarised ⁸⁷Rb ultra-cold atoms as the sensing element. After the atoms are polarised, a resonant pulse of radio-frequency excites Larmor precession, which is sensitive to external magnetic fields. By measuring the perturbations of the radio-frequency induced spin precession, information on the magnetic fields of interest. This is achieved by monitoring the polarisation plane’s rotation of a linearly polarised resonant laser probe. In the first part of this thesis, the building and optimisation of a laser-cooling set up to obtain a BEC in a hybrid trap is reported. In order to achieve the Phase Space Density (PSD) required for BEC, several different stages of trapping and cooling are necessary. Each phase has been implemented and optimised. The first step consists in the magneto-optical trap (MOT). Here a velocity dependent damping force and a spatially dependent confining force give the largest changes in PSD. Then atoms are loaded into a hybrid trap obtained by overlapping a quadrupole magnetic potential and a far detuned optical crossed dipole trap. The final stage for the condensation consists of forced evaporative cooling, both via magnetic and optical evaporation. In the second part of the thesis, a general overview of the principles of optical atomic magnetometry is provided and the advantages of using ultra-cold atoms with respect to conventional thermal vapours are discussed. The implementation, operation and a preliminary characterisation of the ultra-cold atom magnetometer are described along with the preliminary results collected. Finally, a plan for future improvements of its sensitivity is presented.
Microscopic atom optical devices integrated on atom chips allow to precisely control and manipulate ultra-cold ( T < 1 µK) neutral atoms and Bose-Einstein condensates (BECs) close to surfaces. The relevant energy scale of a BEC is extremely small (down to < 10 −11 eV). Consequently, BECs can be utilized as a sensor for variations of the potential energy of the atoms close to the surface. Here we describe how to use trapped atoms as a measurement device and analyze the performance and flexibility of the field sensor. We demonstrate microscopic magnetic imaging with simultaneous high spatial resolution (3 µm) and high field sensitivity (4 nT). With one dimensional BECs, we probe the magnetic field variations close to the surface at distances down to a few microns. Measurements of the magnetic field of a 100 µm wide current carrying wire imply that the magnetic field variations stem from residual variations of the current flow direction, resulting from local properties of the wire. These disorder potentials found near lithographically fabricated wires are two orders of magnitude smaller than those measured close to electroplated conductors.
Ultracold atomic gases can be utilised as extremely sensitive probes of their surrounding environment. In particular, samples of ultracold atoms confined using chip-based microtraps are an ideal tool for mapping electric and magnetic field landscapes. Over the course of this thesis, a new experiment capable of performing surface microscopy using magnetically trapped clouds of cold rubidium-87 atoms has been built. The focus of the work is on the design and construction of the experimental system, which must incorporate many different aspects for manipulating thermal atomic gases, with a view to positioning them at sub-micron distances from special surfaces. This reduced atom-surface separation is necessary for implementing a high resolution, high sensitivity magnetic field sensor with cold atoms. Although current microfabrication techniques easily enable trapping at distances on the order of micrometres, several distance-dependent surface effects - such as the Casimir-Polder force, Johnson-Nyquist noise, and stray potentials - eventually impede magnetic trapping at the sub-micron level. These surface effects can greatly modify the confining potentials, which reduces the trap depth and consequently leads to an additional loss rate of atoms from the trap. We have explored the possibility of using special surfaces such as nano-membranes of silicon nitride and graphene, which have reduced atom- surface interactions, to enable trapping distances at the sub-micron level. A multilayer printed circuit board chip has been designed to form an initial magnetic trap and then transport the cloud of atoms to a desired location over the samples. This chip, along with various samples, is mounted on a custom-made electrical feedthrough designed to make connections to all conductor that are inside the vacuum chamber. The initial cloud of cold atoms can then be prepared in the central region of the chip and delivered to the location of the samples on either side. The experimental system is able to routinely capture over 10^8 rubidium-87 atoms at a temperature of 80 micro-Kelvin in a magneto-optical trap using a novel scheme of five laser beams. A method is demonstrated for enhancing the atom number in the magneto-optical traps by a factor of two by using laser beams with two slightly different frequencies. Atoms from the magneto-optical trap are then transferred to a purely magnetic trap formed by the wires on the printed circuit board chip. Time-dependent currents in the chip wires then create a dynamic potential, which is shown to successfully transport the atomic sample over a distance of 12 millimetre with minimal atom loss. This thesis describes the development of the apparatus in detail, along with careful characterisation of the cold cloud at various stages of the experimental sequence. Initial results on the long distance atom transport are presented. Finally, the experimental results of the two frequency magneto-optical trap for atom number improvement are discussed.
Ultra-cold atoms have become indispensable in quantum sensing, quantum computing, and quantum communication applications, as well as in fundamental sciences. In quantum sensing, they enable precision measurements with outstanding sensitivities that can be of great benefit in navigation, geodesy, and fundamental physics applications. The sensitivity of the atom interferometers used herefore typically scales with the square of the interrogation time. Therefore, in atom interferometric measurements, one seeks ensembles that feature a particularly low internal kinetic energy and can thus be detected after a long time-of-flight. The lowest values are achieved using Bose-Einstein condensates in conjunction with delta-kick collimation, a technique for the collimation of the atomic wave function. Bose-Einstein condensation can be achieved using a multi-stage laser cooling scheme, followed by evaporative cooling, which finally brings the temperature down to the critical temperature, typically in the nanokelvin regime. In addition to the low thermal spread, microgravity enables particularly long observation times, as it avoids limitations of the interrogation time due to vacuum chamber constraints, which are present when falling freely under the influence of gravity. Additionally, microgravity enables measurements that are not possible under normal gravity conditions, such as buoyancy-free miscibility studies, truly uniform potentials, and advanced cold atom quantum memories, which are projected to feature unprecedented time-bandwidth products. For the preparation of a Bose-Einstein condensate, two techniques are widely used in science, namely magnetic traps and optical dipole traps. For microgravity missions, magnetic traps on atom chips have been used in nearly all setups so far due to their particularly low SWAP budget and high cold atom flux. In contrast, ground-based experiments often prefer optical traps due to their higher versatility, full optical access, and the absence of surfaces in proximity to the atoms, which is fundamental for precision measurements. Additionally, optical traps enable the manipulation of intra- and inter-species scattering lengths using Feshbach resonances. Compared to atom chip traps, they also feature an intrinsically better symmetry of the trapping potential, in theory leading to fewer aberrations in matter-wave optics. The latter could enable the generation of ensembles in the yet unreached femtokelvin regime using delta-kick collimation with fewer perturbations. This thesis is about the realization of a 1064nm optical dipole trap set up for the microgravity environment of the Bremen Drop Tower. It aims to highlight the advantages of optical traps in conjunction with microgravity and prepare optical trapping technology for use in future microgravity and space missions. The thesis describes the experimental setup, the direct loading process, the characterization of the optical potential, and the optimization and investigation of the evaporative cooling in the optical dipole trap. For the evaporation process, the influence of gravity is comprehensively investigated through analytical calculations and microgravity tests. Bose-Einstein condensation is demonstrated, proving the achievement of condensation through absorption imaging of the spatial distribution, tests on the free evolution of the ensemble, and investigation of the phase-space densities achieved. Up to (74 ± 4)% condensation of an ensemble featuring (30 000 ± 13 000) atoms at a kinetic temperature of (37 ± 3) nK is demonstrated. The evaporation shows high efficiency down to a 3 s evaporation time, while a critical phase-space density can be achieved within (1.29 ± 0.07) s using an even faster evaporation ramp. This opens the door to fundamental physics experiments on Bose-Einstein condensates in microgravity, as well as applications pursuing atomic ensembles with exceptionally low expansion velocities.