Journal of Physics Conference Series

Cold atoms close to surfaces: measuring magnetic field roughness and disorder potentials

P. Krüger, Stephan Wildermuth, Sebastian Hofferberth, L. Mauritz Andersson, S. Groth, Israel Bar-Joseph, Jörg Schmiedmayer

Published Jan 1, 2005• 15 citations

Publisher

Abstract

Microscopic atom optical devices integrated on atom chips allow to precisely control and manipulate ultra-cold ( T < 1 µK) neutral atoms and Bose-Einstein condensates (BECs) close to surfaces. The relevant energy scale of a BEC is extremely small (down to < 10 −11 eV). Consequently, BECs can be utilized as a sensor for variations of the potential energy of the atoms close to the surface. Here we describe how to use trapped atoms as a measurement device and analyze the performance and flexibility of the field sensor. We demonstrate microscopic magnetic imaging with simultaneous high spatial resolution (3 µm) and high field sensitivity (4 nT). With one dimensional BECs, we probe the magnetic field variations close to the surface at distances down to a few microns. Measurements of the magnetic field of a 100 µm wide current carrying wire imply that the magnetic field variations stem from residual variations of the current flow direction, resulting from local properties of the wire. These disorder potentials found near lithographically fabricated wires are two orders of magnitude smaller than those measured close to electroplated conductors.

DOI: 10.1088/1742-6596/19/1/009

Related papers

Scanning magnetoresistance microscopy of atom chips

Michael Volk, S. Whitlock, C. H. Wolff +2 more

Surface based geometries of microfabricated wires or patterned magnetic films can be used to magnetically trap and manipulate ultracold neutral atoms or Bose-Einstein condensates. We investigate the magnetic properties of such atom chips using a scanning magnetoresistive (MR) microscope with high spatial resolution and high field sensitivity. By comparing MR scans of a permanent magnetic atom chip to field profiles obtained using ultracold atoms, we show that MR sensors are ideally suited to observe small variations of the magnetic field caused by imperfections in the wires or magnetic materials which ultimately lead to fragmentation of ultracold atom clouds. Measurements are also provided for the magnetic field produced by a thin current-carrying wire with small geometric modulations along the edge. Comparisons of our measurements with a full numeric calculation of the current flow in the wire and the subsequent magnetic field show excellent agreement. Our results highlight the use of scanning MR microscopy as a convenient and powerful technique for precisely characterizing the magnetic fields produced near the surface of atom chips.

arXiv:0704.3137Review of Scientific InstrumentsFeb 1, 20088 citations

Sensing electric and magnetic fields with Bose-Einstein condensates

Stephan Wildermuth, Sebastian Hofferberth, Igor Lesanovsky +4 more

We experimentally demonstrate that one-dimensional Bose-Einstein condensates brought close to microfabricated wires on an atom chip are a very sensitive sensor for magnetic and electric fields reaching a sensitivity to potential variations of ∼10−14eV at 3μm spatial resolution. We measure a two-dimensional magnetic field map 10μm above a 100-μm-wide wire and show how the transverse current-density component inside the wire can be reconstructed. The relation between the field sensitivity and the spatial resolution is discussed and further improvements utilizing Feshbach-resonances are outlined.

arXiv:cond-mat/0512520Applied Physics LettersJun 26, 2006103 citations

Bose-Einstein condensates on a magnetic film atom chip

S. Whitlock

Atom chips are devices used to magnetically trap and manipulate ultracold atoms and Bose-Einstein condensates near a surface. In particular, permanent magnetic film atom chips can allow very tight confinement and intricate magnetic field designs while circumventing technical current noise. Research described in this thesis is focused on the development of a magnetic film atom chip, the production of Bose-Einstein condensates near the film surface, the characterisation of the associated magnetic potentials using rf spectroscopy of ultracold atoms and the realisation of a precision sensor based on splitting Bose-Einstein condensates in a double-well potential. The atom chip itself combines the edge of a perpendicularly magnetised GdTbFeCo film with a machined silver wire structure. A mirror magneto-optical trap collects up to 5 x 108 87Rb atoms beneath the chip surface. The current-carrying wires are then used to transfer the cloud of atoms to the magnetic film microtrap and radio frequency evaporative cooling is applied to produce Bose-Einstein condensates consisting of 1 x 105 atoms. We have identified small spatial magnetic field variations near the film surface that fragment the ultracold atom cloud. These variations originate from inhomogeneity in the film magnetisation and are characterised using a novel technique based on spatially resolved radio frequency spectroscopy of the atoms to map the magnetic field landscape over a large area. The observations agree with an analytic model for the spatial decay of random magnetic fields from the film surface. Bose-Einstein condensates in our unique potential landscape have been used as a precision sensor for potential gradients. We transfer the atoms to the central region of the chip which produces a double-well potential. A single BEC is formed far from the surface and is then dynamically split in two by moving the trap closer to the surface. After splitting, the population of atoms in each well is extremely sensitive to the asymmetry of the potential and can be used to sense tiny magnetic field gradients or changes in gravity on a small spatial scale.

Jan 1, 20075 citations

Potential roughness near lithographically fabricated atom chips

P. Krüger, L. Mauritz Andersson, Stephan Wildermuth +6 more

Potential roughness has been reported to severely impair experiments in magnetic microtraps. We show that these obstacles can be overcome as we measure disorder potentials that are reduced by two orders of magnitude near lithographically patterned high-quality gold layers on semiconductor atom chip substrates. The spectrum of the remaining field variations exhibits a favorable scaling. A detailed analysis of the magnetic field roughness of a $100\text{\ensuremath{-}}\ensuremath{\mu}\mathrm{m}$-wide wire shows that these potentials stem from minute variations of the current flow caused by local properties of the wire rather than merely from rough edges. A technique for further reduction of potential roughness by several orders of magnitude based on time-orbiting magnetic fields is outlined.

arXiv:cond-mat/0504686Physical Review ADec 28, 200764 citations

Tools and fundamental techniques for Bose-Einstein condensate microscopy

Timothy M. James

Ultra-cold atoms have small kinetic energy and are therefore very sensitive to external fields that act on the atoms. By having fine control over the positioning of the ultra-cold atom cloud we can use the atom cloud as a sensor for magnetic fields. By imaging these atom clouds we can infer a spatial map of the magnetic field. This spatial map will have a resolution proportional to the distance between the source of the magnetic field and the atom cloud which can be on the order of 0:1 µm. In the first half of the thesis, we investigate the two colour magneto-optical trap. This is a simple technique that can lead to a multiplicative increase in the number of atoms in a magneto-optical trap with a simple change to the optical setup. Using the two colour magneto-optical trap we have observed an increase of 5 times in the number of trapped atoms. An increase in the number of atoms in a magneto-optical helps with later cooling processes that are not lossless such as evaporative cooling which in turn helps the realisation of the ultra-cold atom microscope. In the second half of the thesis, we demonstrate how a 2d current density can be recovered from a 2d magnetic field map generated by the ultra-cold atom microscope. We then go on to show the sensitivity and responsivity of a cold atom cloud and a Bose-Einstein condensate. We then use the results of the previous section to simulate the measurement of currents in a silver nanowire network. Properties of the silver nanowire network can be simulated and aid in showing the abilities and limitations of the ultra-cold atom microscope. We found that the ultra-cold atom microscope can directly measure currents in low-density silver nanowire networks. In a high-density silver nanowire network, the average distance between the wires becomes too small to resolve. Hot-spots, areas of high current density can still be identified using the ultra-cold atom microscope. The ultracold atom microscope could then be used as a tool to aid the research look to use silver nanowires in many industrial applications such as touch screens.

Aug 13, 20200 citations

A cold atom apparatus for the microscopy of thin membranes

Amruta Gadge

Ultracold atomic gases can be utilised as extremely sensitive probes of their surrounding environment. In particular, samples of ultracold atoms confined using chip-based microtraps are an ideal tool for mapping electric and magnetic field landscapes. Over the course of this thesis, a new experiment capable of performing surface microscopy using magnetically trapped clouds of cold rubidium-87 atoms has been built. The focus of the work is on the design and construction of the experimental system, which must incorporate many different aspects for manipulating thermal atomic gases, with a view to positioning them at sub-micron distances from special surfaces. This reduced atom-surface separation is necessary for implementing a high resolution, high sensitivity magnetic field sensor with cold atoms. Although current microfabrication techniques easily enable trapping at distances on the order of micrometres, several distance-dependent surface effects - such as the Casimir-Polder force, Johnson-Nyquist noise, and stray potentials - eventually impede magnetic trapping at the sub-micron level. These surface effects can greatly modify the confining potentials, which reduces the trap depth and consequently leads to an additional loss rate of atoms from the trap. We have explored the possibility of using special surfaces such as nano-membranes of silicon nitride and graphene, which have reduced atom- surface interactions, to enable trapping distances at the sub-micron level. A multilayer printed circuit board chip has been designed to form an initial magnetic trap and then transport the cloud of atoms to a desired location over the samples. This chip, along with various samples, is mounted on a custom-made electrical feedthrough designed to make connections to all conductor that are inside the vacuum chamber. The initial cloud of cold atoms can then be prepared in the central region of the chip and delivered to the location of the samples on either side. The experimental system is able to routinely capture over 10^8 rubidium-87 atoms at a temperature of 80 micro-Kelvin in a magneto-optical trap using a novel scheme of five laser beams. A method is demonstrated for enhancing the atom number in the magneto-optical traps by a factor of two by using laser beams with two slightly different frequencies. Atoms from the magneto-optical trap are then transferred to a purely magnetic trap formed by the wires on the printed circuit board chip. Time-dependent currents in the chip wires then create a dynamic potential, which is shown to successfully transport the atomic sample over a distance of 12 millimetre with minimal atom loss. This thesis describes the development of the apparatus in detail, along with careful characterisation of the cold cloud at various stages of the experimental sequence. Initial results on the long distance atom transport are presented. Finally, the experimental results of the two frequency magneto-optical trap for atom number improvement are discussed.

Jul 19, 20180 citations