Challenges
Datasets
Workspaces
Papers
Discussions
Leaderboard
Log inSign up
Challenges
Datasets
Workspaces
Papers
Discussions
Leaderboard
Blog
Job Board
Q3AS

© 2026 Aqora Quantum S.A.S.

TermsPrivacyLegal Notice

Optical Engineering

Phase detection through four-wave mixing in an optical fiber

Amira S. Ahsan, Aneesh Sobhanan, Deepa Venkitesh, Govind Prasad Agrawal

Published Nov 26, 2020• 2 citations
Publisher

Abstract

A scheme for detecting the phase of an incoming optical signal is systematically optimized and demonstrated experimentally. It makes use of four-wave mixing in a highly nonlinear fiber but differs from a phase-sensitive amplifier by its focus on phase detection, rather than on phase-dependent noise reduction. This experimental setup combines the signal with its phase-conjugated idler at the same frequency, before sending the combination to a photodetector. Experimental results show that the ratio of maximum and minimum currents can exceed 1000 even at a relatively low pump power of 10 mW. The proposed scheme may be useful for detecting the signal phase in coherent communication systems without the need of heterodyne detection.

DOI
10.1117/1.oe.59.11.116109

Related papers

Fiber-based phase-sensitive optical amplifiers and their applications

Peter A. Andrekson, Magnus Karlsson

Optical parametric amplifiers rely on second-order susceptibility (three-wave mixing) or third-order susceptibility (four-wave mixing) in a nonlinear process where the energy of incoming photons is not changed (elastic scattering). In the latter case, two pump photons are converted to a signal and to an idler photon. Under certain conditions, related to the phase evolution of the waves involved, this conversion can be very efficient, resulting in large amplification of an input signal. As the nonlinear process can be very fast, all-optical applications aside from pure amplification are also possible. If the amplifier is implemented in an optical input-phase-sensitive manner, it is possible to amplify a signal wave without excess noise, i.e., with a noise figure of 0 dB. In this paper, we will provide the fundamental concepts and theory of such amplifiers, with a focus on their implementation in highly nonlinear optical fibers relying on four-wave mixing. We will discuss the distinctions between phase-insensitive and phase-sensitive operation and include several experimental results to illustrate their capability. Different applications of parametric amplifiers are also discussed, including their use in optical communication links.

Advances in Optics and Photonics•Feb 20, 2020•102 citations

Orthogonal Phase Quadratures Conversion to Different Wavelengths Through Phase-Sensitive Four Wave Mixing in an Highly Nonlinear Fiber

Francesco Da Ros, Pachito Marco Calabrese, Ning Kang +2 more

Phase-sensitive processes exploiting FWM in an HNLF allow simultaneously converting two orthogonal quadratures of an optical signal to different wavelengths. Conversion efficiencies to two 90°-phase-shifted idlers exceeding 10 dB of phase-sensitive extinction ratio are obtained experimentally.

Optical Fiber Communication Conference•Jan 1, 2013•2 citations

Phase evolution of the direct detection noise figure of a nondegenerate fiber phase-sensitive amplifier.

Tarek Labidi, Ihsan Fsaifes, Weilin Xie +3 more

We experimentally investigate the evolution of the direct detection noise figure of a nondegenerate phase-sensitive amplifier based on a nonlinear fiber, as a function of the relative phase between the signal, idler, and pump, all other parameters remaining fixed. The use of a fiber with a high stimulated Brillouin scattering threshold permits us to investigate the full range of phase-sensitive gain and noise figure without pump dithering. Good agreement is found with theory, both for signal only and combined signal and idler direct detections.

•Sep 15, 2018•4 citations

Phase evolution of the direct detection noise figure of a nondegenerate fiber phase-sensitive amplifier

Tarek Labidi, Ihsan Fsaifes, Weilin Xie +3 more

We experimentally investigate the evolution of the direct detection noise figure of a nondegenerate phase-sensitive amplifier based on a nonlinear fiber, as a function of the relative phase between the signal, idler, and pump, all other parameters remaining fixed. The use of a fiber with a high stimulated Brillouin scattering threshold permits us to investigate the full range of phase-sensitive gain and noise figure without pump dithering. Good agreement is found with theory, both for signal only and combined signal and idler direct detections.

arXiv:1812.03708•Optics Letters•Sep 14, 2018•5 citations

Phase quadrature discrimination based on three-pump four-wave mixing in nonlinear optical fibers

Maxime Baillot, Mathilde Gay, Christophe Peucheret +2 more

We theoretically and experimentally study the principle of phase-sensitive frequency conversion in a highly-nonlinear fiber using three pump waves. This mechanism, originally demonstrated with four continuous-wave pumps and a signal wave, is based on four-wave mixing and enables to convert the two quadrature components of the signal to different frequencies. In this work, we derive a set of two simple equations to describe this mechanism and find analytic solutions. We show that only three pumps are required, instead of four as originally proposed. We give simple relations to determine the initial conditions for the power levels and the phases of the pumps. To validate this approach, we perform an experimental demonstration of the three-pump scheme and find excellent agreement with the theory.

Optics Express•Nov 11, 2016•19 citations

Signal Processing using Nonlinear Optical Eects in Single- and Few-Mode Fibers

Søren Friis

The stagnating increase in data transmission capacity in optical communication systems combined with the ever growing demand of transmission bandwidth is leading to an impending capacity crunch, referring to the point in time after which the available bandwidth of the individual user starts to decrease. To postpone this point in time, existing technologies in terms of data transmission through optical fibers must be optimized and new degrees of freedom must be introduced to continue the exponential increase in available bandwidth; space-division multiplexing is believed to be the strongest candidate for another degree of freedom in transmission fibers. This thesis is two-fold: firstly, starting at Maxwell’s equations and basic principles of quantum mechanics, a semi-classical model of the noise properties of fiber optical parametric amplifiers and frequency converters is presented. The model accounts for multiple effects present in nonlinear fibers such as four-wave mixing, Raman scattering, distributed loss, and dispersion, and it is valid in the depleted pump regime. After validating the model against well-known results of quantum models, the model is used to predict the impacts of Raman noise, loss, and pump depletion on the noise properties of parametric frequency conversion and phase-insensitive and phase-sensitive parametric amplification. An important part of realizing space-division multiplexing is the ability of optical signal processing so the second part of this thesis addresses few-mode Raman fiber amplifiers and parametric amplifiers and frequency converters. A model of weak random linear mode coupling in the pump of a two-mode distributed Raman fiber amplifier is presented and it is shown that an amplification noise figure induced by mode coupling increases with the degree of mode coupling and that this tendency increases as the pump depletes. Also, a very low mode-dependent gain of 0.25 dB per 10 dB gain is experimentally demonstrated in a two-mode distributed Raman fiber amplifier by exciting the pump in a combination of two modes. A comprehensive model of four-wave mixing in two-mode fibers acvi counting for six simultaneous processes is derived, and the conversion efficiency from signal to idler in the four-wave mixing processes of phase conjugation and Bragg scattering in two two-mode fibers with different phase matching properties are experimentally investigated. A conversion efficiency of > −2.70 dB is demonstrated for Bragg scattering in the conversion of a signal in the LP01-mode to the idler in the LP11-mode; the signal-to-idler separation is ∼ 25 nm. Good qualitative agreement between experiments and theory is found for both processes in both fibers.

•Jan 1, 2016•0 citations
A scheme for detecting the phase of an incoming optical signal is systematically optimized and demonstrated experimentally. It makes use of four-wave mixing in a highly nonlinear fiber but differs from a phase-sensitive amplifier by its focus on phase detection, rather than on phase-dependent noise reduction. This experimental setup combines the signal with its phase-conjugated idler at the same frequency, before sending the combination to a photodetector. Experimental results show that the ratio of maximum and minimum currents can exceed 1000 even at a relatively low pump power of 10 mW. The proposed scheme may be useful for detecting the signal phase in coherent communication systems without the need of heterodyne detection.
Optical parametric amplifiers rely on second-order susceptibility (three-wave mixing) or third-order susceptibility (four-wave mixing) in a nonlinear process where the energy of incoming photons is not changed (elastic scattering). In the latter case, two pump photons are converted to a signal and to an idler photon. Under certain conditions, related to the phase evolution of the waves involved, this conversion can be very efficient, resulting in large amplification of an input signal. As the nonlinear process can be very fast, all-optical applications aside from pure amplification are also possible. If the amplifier is implemented in an optical input-phase-sensitive manner, it is possible to amplify a signal wave without excess noise, i.e., with a noise figure of 0 dB. In this paper, we will provide the fundamental concepts and theory of such amplifiers, with a focus on their implementation in highly nonlinear optical fibers relying on four-wave mixing. We will discuss the distinctions between phase-insensitive and phase-sensitive operation and include several experimental results to illustrate their capability. Different applications of parametric amplifiers are also discussed, including their use in optical communication links.
We experimentally investigate the evolution of the direct detection noise figure of a nondegenerate phase-sensitive amplifier based on a nonlinear fiber, as a function of the relative phase between the signal, idler, and pump, all other parameters remaining fixed. The use of a fiber with a high stimulated Brillouin scattering threshold permits us to investigate the full range of phase-sensitive gain and noise figure without pump dithering. Good agreement is found with theory, both for signal only and combined signal and idler direct detections.
We experimentally investigate the evolution of the direct detection noise figure of a nondegenerate phase-sensitive amplifier based on a nonlinear fiber, as a function of the relative phase between the signal, idler, and pump, all other parameters remaining fixed. The use of a fiber with a high stimulated Brillouin scattering threshold permits us to investigate the full range of phase-sensitive gain and noise figure without pump dithering. Good agreement is found with theory, both for signal only and combined signal and idler direct detections.
We theoretically and experimentally study the principle of phase-sensitive frequency conversion in a highly-nonlinear fiber using three pump waves. This mechanism, originally demonstrated with four continuous-wave pumps and a signal wave, is based on four-wave mixing and enables to convert the two quadrature components of the signal to different frequencies. In this work, we derive a set of two simple equations to describe this mechanism and find analytic solutions. We show that only three pumps are required, instead of four as originally proposed. We give simple relations to determine the initial conditions for the power levels and the phases of the pumps. To validate this approach, we perform an experimental demonstration of the three-pump scheme and find excellent agreement with the theory.
The stagnating increase in data transmission capacity in optical communication systems combined with the ever growing demand of transmission bandwidth is leading to an impending capacity crunch, referring to the point in time after which the available bandwidth of the individual user starts to decrease. To postpone this point in time, existing technologies in terms of data transmission through optical fibers must be optimized and new degrees of freedom must be introduced to continue the exponential increase in available bandwidth; space-division multiplexing is believed to be the strongest candidate for another degree of freedom in transmission fibers. This thesis is two-fold: firstly, starting at Maxwell’s equations and basic principles of quantum mechanics, a semi-classical model of the noise properties of fiber optical parametric amplifiers and frequency converters is presented. The model accounts for multiple effects present in nonlinear fibers such as four-wave mixing, Raman scattering, distributed loss, and dispersion, and it is valid in the depleted pump regime. After validating the model against well-known results of quantum models, the model is used to predict the impacts of Raman noise, loss, and pump depletion on the noise properties of parametric frequency conversion and phase-insensitive and phase-sensitive parametric amplification. An important part of realizing space-division multiplexing is the ability of optical signal processing so the second part of this thesis addresses few-mode Raman fiber amplifiers and parametric amplifiers and frequency converters. A model of weak random linear mode coupling in the pump of a two-mode distributed Raman fiber amplifier is presented and it is shown that an amplification noise figure induced by mode coupling increases with the degree of mode coupling and that this tendency increases as the pump depletes. Also, a very low mode-dependent gain of 0.25 dB per 10 dB gain is experimentally demonstrated in a two-mode distributed Raman fiber amplifier by exciting the pump in a combination of two modes. A comprehensive model of four-wave mixing in two-mode fibers acvi counting for six simultaneous processes is derived, and the conversion efficiency from signal to idler in the four-wave mixing processes of phase conjugation and Bragg scattering in two two-mode fibers with different phase matching properties are experimentally investigated. A conversion efficiency of > −2.70 dB is demonstrated for Bragg scattering in the conversion of a signal in the LP01-mode to the idler in the LP11-mode; the signal-to-idler separation is ∼ 25 nm. Good qualitative agreement between experiments and theory is found for both processes in both fibers.