Challenges
Datasets
Workspaces
Papers
Discussions
Leaderboard
Log inSign up
Challenges
Datasets
Workspaces
Papers
Discussions
Leaderboard
Blog
Job Board
Q3AS

© 2026 Aqora Quantum S.A.S.

TermsPrivacyLegal Notice

Applied Sciences

Double Spectral Electromagnetically Induced Transparency Based on Double-Bar Dielectric Grating and Its Sensor Application

Guofeng Li, Junbo Yang, Zhaojian Zhang, Kui Wen, Yuyu Tao, Yunxin Han, Zhenrong Zhang

Published Apr 27, 2020• 15 citations
Publisher

Abstract

The realization of the electromagnetically induced transparency (EIT) effect based on guided-mode resonance (GMR) has attracted a lot of attention. However, achieving the multispectral EIT effect in this way has not been studied. Here, we numerically realize a double EIT-ike effect with extremely high Q factors based on a GMR system with the double-bar dielectric grating structure, and the Q factors can reach 35,104 and 24,423, respectively. Moreover, the resonance wavelengths of the two EIT peaks can be flexibly controlled by changing the corresponding structural parameters. The figure of merit (FOM) of the dual-mode refractive index sensor based on this system can reach 571.88 and 587.42, respectively. Our work provides a novel method to achieve double EIT-like effects, which can be applied to the dual mode sensor, dual channel slow light and so on.

DOI
10.3390/app10093033

Related papers

Double Electromagnetically Induced Transparency and Its Slow Light Application Based on a Guided-Mode Resonance Grating Cascade Structure

Guofeng Li, Junbo Yang, Zhaojian Zhang +5 more

In recent years, the achievement of the electromagnetically induced transparency (EIT) effect based on the guided-mode resonance (GMR) effect has attracted extensive attention. However, few works have achieved a double EIT-like effect using this method. In this paper, we numerically achieve a double EIT-like effect in a GMR system with a three-layer silicon nitride waveguide grating structure (WGS), using the multi-level atomic system model for theoretical explanation. In terms of slow light performance, the corresponding two delay times reach 22.59 ps and 8.43 ps, respectively. We also investigate the influence of wavelength detuning of different GMR modes on the transparent window and slow light performance. Furthermore, a wide-band flat-top transparent window was also achieved by appropriately adjusting the wavelength detuning between GMR modes. These results indicate that the EIT-like effect in the WGS has potential application prospects in low-loss slow optical devices, optical sensing, and optical communications.

Materials•Aug 21, 2020•14 citations

High quality factor electromagnetically induced transparency-like effect in coupled guided-mode resonant systems

Yunxin Han, Junbo Yang, Xin He +4 more

substrates. It is confirmed that the coupling between the top and bottom GMR modes starts once a Fabry-Perot (F-P) resonator is introduced, and electromagnetically induced transparency (EIT)-like spectral responses occur in the coupled GMR systems. A very narrow transparency window with a high-quality (Q) factor EIT-like effect of up to 288,892 was demonstrated. Furthermore, EIT-like response wavelengths can be flexibly designed in wide wavelength range by modifying either the GMR resonance frequencies or the space between two GWLs. Therefore, this EIT-like response in coupled GMR systems would pave the way towards novel sensors with extremely high sensitivity.

Optics Express•Mar 1, 2019•20 citations

Plasmonic metamaterial for electromagnetically induced transparency analogue and ultra-high figure of merit sensor

Dong Wu, Yumin Liu, Li Yu +7 more

In this work, using finite-difference time-domain method, we propose and numerically demonstrate a novel way to achieve electromagnetically induced transparency (EIT) phenomenon in the reflection spectrum by stacking two different types of coupling effect among different elements of the designed metamaterial. Compared with the conventional EIT-like analogues coming from only one type of coupling effect between bright and dark meta-atoms on the same plane, to our knowledge the novel approach is the first to realize the optically active and precise control of the wavelength position of EIT-like phenomenon using optical metamaterials. An on-to-off dynamic control of the EIT-like phenomenon also can be achieved by changing the refractive index of the dielectric substrate via adjusting an optical pump pulse. Furthermore, in near infrared region, the metamaterial structure can be operated as an ultra-high resolution refractive index sensor with an ultra-high figure of merit (FOM) reaching 3200, which remarkably improve the FOM value of plasmonic refractive index sensors. The novel approach realizing EIT-like spectral shape with easy adjustment to the working wavelengths will open up new avenues for future research and practical application of active plasmonic switch, ultra-high resolution sensors and active slow-light devices.

Scientific Reports•Mar 23, 2017•63 citations

Analogue of electromagnetically induced transparency with high Q factor in Metal-dielectric metamaterials

Bingxin Han, Zhi Hong

We investigated numerically the electromagnetically induced transparency (EIT) behavior with the maximum Q factor is up to 28000 in a metal-dielectric metamaterial. It composed of two layers, a metallic strip as bright mode stacked above a dielectric rod as another bright mode. The coherent coupling between the broad electric dipole induced by the metal strip and the narrow toroidal dipole induced by the dielectric rod leads to the destructive interference, then introduces a transparency window. Interestingly, the EIT window could be effectively influenced by varying parameters of the two layers and the thickness of middle spacer. This process can be explained by using two-particle model. Furthermore, the radiation loss is greatly suppressed within the EIT windows and the slow light effect is improved a lot. These excellent properties also provide an effective platform for the filters and sensitive chemical and biological sensors in the optical range.

arXiv:1908.08632•Aug 23, 2019•1 citation

Electromagnetically Induced Transparency in an All-Dielectric Metamaterial-Waveguide With Large Group Index

Chuanshuai Sui, Bingxin Han, Tingting Lang +3 more

We investigate numerically an analog of electromagnetically induced transparency (EIT) in an all-dielectric metamaterial-waveguide (ADMW) that consists of a two-dimensional silicon rod array on quartz slab waveguide. The EIT-like response is achieved by the destructive interference between a broad magnetic resonance and a narrow guide mode resonance. By tailoring the guided mode through the thickness of the slab waveguide or the lattice period of the metamaterial, an EIT-like transmission window is achieved with both high Q-factor (>104) and high transmission (>94%). And the group refractive index at the EIT-like resonance of the ADMW can be up to several thousands. These results demonstrate that the proposed ADMW has potential applications in low-loss slow-light based devices, bio-chemical sensing, and optical modulations.

IEEE photonics journal•Jul 17, 2017•23 citations

Electromagnetically induced transparency in an all-dielectric nano-metamaterial for slow light application

Qiao Wang, Li Yu, Huixuan Gao +2 more

Slow light technique has significant potential applications in many contemporary photonic device developments for integrated all-optical circuit, such as buffers, regenerators, switches and interferometers. In this paper, we present an efficient coupling mechanism of an electromagnetically induced transparency like (EIT-like) effect in an all-dielectric nano-metamaterial. This EIT-like effect is generated by destructive interference between a radiative Fabry-Perot (FP) mode and a dark waveguide (WG) mode, which is based on a combined structure of a dielectric grating and multilayer films. The dark WG mode is excited by guided mode of dielectric grating instead of radiative FP mode. In analogy to the molecular transition process, the FP mode, guided mode and WG mode are denoted by excited states of |1〉, |2〉 and |3〉. The two coupling pathways of the EIT-like effect in our metamaterial are |0〉 → |1〉 and |0〉 → |2〉 → |3〉 → |1〉, where |0〉 is the ground state. The simulated resonant wavelength of WG mode is consistent with theoretical result. We further confirm this EIT-like effect through a two-oscillator coupling analysis. We achieve a group refractive index of 913.6 by adjusting these two modes coupling of the EIT-like effect, which is useful for developing slow light device. This work provides a valuable solution to realize electromagnetically induced transparency in all-dielectric nanomaterial.

Optics Express•Nov 15, 2019•33 citations
The realization of the electromagnetically induced transparency (EIT) effect based on guided-mode resonance (GMR) has attracted a lot of attention. However, achieving the multispectral EIT effect in this way has not been studied. Here, we numerically realize a double EIT-ike effect with extremely high Q factors based on a GMR system with the double-bar dielectric grating structure, and the Q factors can reach 35,104 and 24,423, respectively. Moreover, the resonance wavelengths of the two EIT peaks can be flexibly controlled by changing the corresponding structural parameters. The figure of merit (FOM) of the dual-mode refractive index sensor based on this system can reach 571.88 and 587.42, respectively. Our work provides a novel method to achieve double EIT-like effects, which can be applied to the dual mode sensor, dual channel slow light and so on.
In recent years, the achievement of the electromagnetically induced transparency (EIT) effect based on the guided-mode resonance (GMR) effect has attracted extensive attention. However, few works have achieved a double EIT-like effect using this method. In this paper, we numerically achieve a double EIT-like effect in a GMR system with a three-layer silicon nitride waveguide grating structure (WGS), using the multi-level atomic system model for theoretical explanation. In terms of slow light performance, the corresponding two delay times reach 22.59 ps and 8.43 ps, respectively. We also investigate the influence of wavelength detuning of different GMR modes on the transparent window and slow light performance. Furthermore, a wide-band flat-top transparent window was also achieved by appropriately adjusting the wavelength detuning between GMR modes. These results indicate that the EIT-like effect in the WGS has potential application prospects in low-loss slow optical devices, optical sensing, and optical communications.
substrates. It is confirmed that the coupling between the top and bottom GMR modes starts once a Fabry-Perot (F-P) resonator is introduced, and electromagnetically induced transparency (EIT)-like spectral responses occur in the coupled GMR systems. A very narrow transparency window with a high-quality (Q) factor EIT-like effect of up to 288,892 was demonstrated. Furthermore, EIT-like response wavelengths can be flexibly designed in wide wavelength range by modifying either the GMR resonance frequencies or the space between two GWLs. Therefore, this EIT-like response in coupled GMR systems would pave the way towards novel sensors with extremely high sensitivity.
In this work, using finite-difference time-domain method, we propose and numerically demonstrate a novel way to achieve electromagnetically induced transparency (EIT) phenomenon in the reflection spectrum by stacking two different types of coupling effect among different elements of the designed metamaterial. Compared with the conventional EIT-like analogues coming from only one type of coupling effect between bright and dark meta-atoms on the same plane, to our knowledge the novel approach is the first to realize the optically active and precise control of the wavelength position of EIT-like phenomenon using optical metamaterials. An on-to-off dynamic control of the EIT-like phenomenon also can be achieved by changing the refractive index of the dielectric substrate via adjusting an optical pump pulse. Furthermore, in near infrared region, the metamaterial structure can be operated as an ultra-high resolution refractive index sensor with an ultra-high figure of merit (FOM) reaching 3200, which remarkably improve the FOM value of plasmonic refractive index sensors. The novel approach realizing EIT-like spectral shape with easy adjustment to the working wavelengths will open up new avenues for future research and practical application of active plasmonic switch, ultra-high resolution sensors and active slow-light devices.
We investigated numerically the electromagnetically induced transparency (EIT) behavior with the maximum Q factor is up to 28000 in a metal-dielectric metamaterial. It composed of two layers, a metallic strip as bright mode stacked above a dielectric rod as another bright mode. The coherent coupling between the broad electric dipole induced by the metal strip and the narrow toroidal dipole induced by the dielectric rod leads to the destructive interference, then introduces a transparency window. Interestingly, the EIT window could be effectively influenced by varying parameters of the two layers and the thickness of middle spacer. This process can be explained by using two-particle model. Furthermore, the radiation loss is greatly suppressed within the EIT windows and the slow light effect is improved a lot. These excellent properties also provide an effective platform for the filters and sensitive chemical and biological sensors in the optical range.
We investigate numerically an analog of electromagnetically induced transparency (EIT) in an all-dielectric metamaterial-waveguide (ADMW) that consists of a two-dimensional silicon rod array on quartz slab waveguide. The EIT-like response is achieved by the destructive interference between a broad magnetic resonance and a narrow guide mode resonance. By tailoring the guided mode through the thickness of the slab waveguide or the lattice period of the metamaterial, an EIT-like transmission window is achieved with both high Q-factor (>104) and high transmission (>94%). And the group refractive index at the EIT-like resonance of the ADMW can be up to several thousands. These results demonstrate that the proposed ADMW has potential applications in low-loss slow-light based devices, bio-chemical sensing, and optical modulations.
Slow light technique has significant potential applications in many contemporary photonic device developments for integrated all-optical circuit, such as buffers, regenerators, switches and interferometers. In this paper, we present an efficient coupling mechanism of an electromagnetically induced transparency like (EIT-like) effect in an all-dielectric nano-metamaterial. This EIT-like effect is generated by destructive interference between a radiative Fabry-Perot (FP) mode and a dark waveguide (WG) mode, which is based on a combined structure of a dielectric grating and multilayer films. The dark WG mode is excited by guided mode of dielectric grating instead of radiative FP mode. In analogy to the molecular transition process, the FP mode, guided mode and WG mode are denoted by excited states of |1〉, |2〉 and |3〉. The two coupling pathways of the EIT-like effect in our metamaterial are |0〉 → |1〉 and |0〉 → |2〉 → |3〉 → |1〉, where |0〉 is the ground state. The simulated resonant wavelength of WG mode is consistent with theoretical result. We further confirm this EIT-like effect through a two-oscillator coupling analysis. We achieve a group refractive index of 913.6 by adjusting these two modes coupling of the EIT-like effect, which is useful for developing slow light device. This work provides a valuable solution to realize electromagnetically induced transparency in all-dielectric nanomaterial.