Challenges
Datasets
Workspaces
Papers
Discussions
Leaderboard
Log inSign up
Challenges
Datasets
Workspaces
Papers
Discussions
Leaderboard
Blog
Job Board
Q3AS

© 2026 Aqora Quantum S.A.S.

TermsPrivacyLegal Notice

Materials

Double Electromagnetically Induced Transparency and Its Slow Light Application Based on a Guided-Mode Resonance Grating Cascade Structure

Guofeng Li, Junbo Yang, Zhaojian Zhang, Yuyu Tao, Lingjun Zhou, Huimin Huang, Zhenrong Zhang, Yunxin Han

Published Aug 21, 2020• 14 citations
Publisher

Abstract

In recent years, the achievement of the electromagnetically induced transparency (EIT) effect based on the guided-mode resonance (GMR) effect has attracted extensive attention. However, few works have achieved a double EIT-like effect using this method. In this paper, we numerically achieve a double EIT-like effect in a GMR system with a three-layer silicon nitride waveguide grating structure (WGS), using the multi-level atomic system model for theoretical explanation. In terms of slow light performance, the corresponding two delay times reach 22.59 ps and 8.43 ps, respectively. We also investigate the influence of wavelength detuning of different GMR modes on the transparent window and slow light performance. Furthermore, a wide-band flat-top transparent window was also achieved by appropriately adjusting the wavelength detuning between GMR modes. These results indicate that the EIT-like effect in the WGS has potential application prospects in low-loss slow optical devices, optical sensing, and optical communications.

DOI
10.3390/ma13173710

Related papers

Double Spectral Electromagnetically Induced Transparency Based on Double-Bar Dielectric Grating and Its Sensor Application

Guofeng Li, Junbo Yang, Zhaojian Zhang +4 more

The realization of the electromagnetically induced transparency (EIT) effect based on guided-mode resonance (GMR) has attracted a lot of attention. However, achieving the multispectral EIT effect in this way has not been studied. Here, we numerically realize a double EIT-ike effect with extremely high Q factors based on a GMR system with the double-bar dielectric grating structure, and the Q factors can reach 35,104 and 24,423, respectively. Moreover, the resonance wavelengths of the two EIT peaks can be flexibly controlled by changing the corresponding structural parameters. The figure of merit (FOM) of the dual-mode refractive index sensor based on this system can reach 571.88 and 587.42, respectively. Our work provides a novel method to achieve double EIT-like effects, which can be applied to the dual mode sensor, dual channel slow light and so on.

Applied Sciences•Apr 27, 2020•15 citations

Electromagnetically induced transparency in an all-dielectric nano-metamaterial for slow light application

Qiao Wang, Li Yu, Huixuan Gao +2 more

Slow light technique has significant potential applications in many contemporary photonic device developments for integrated all-optical circuit, such as buffers, regenerators, switches and interferometers. In this paper, we present an efficient coupling mechanism of an electromagnetically induced transparency like (EIT-like) effect in an all-dielectric nano-metamaterial. This EIT-like effect is generated by destructive interference between a radiative Fabry-Perot (FP) mode and a dark waveguide (WG) mode, which is based on a combined structure of a dielectric grating and multilayer films. The dark WG mode is excited by guided mode of dielectric grating instead of radiative FP mode. In analogy to the molecular transition process, the FP mode, guided mode and WG mode are denoted by excited states of |1〉, |2〉 and |3〉. The two coupling pathways of the EIT-like effect in our metamaterial are |0〉 → |1〉 and |0〉 → |2〉 → |3〉 → |1〉, where |0〉 is the ground state. The simulated resonant wavelength of WG mode is consistent with theoretical result. We further confirm this EIT-like effect through a two-oscillator coupling analysis. We achieve a group refractive index of 913.6 by adjusting these two modes coupling of the EIT-like effect, which is useful for developing slow light device. This work provides a valuable solution to realize electromagnetically induced transparency in all-dielectric nanomaterial.

Optics Express•Nov 15, 2019•33 citations

Optical Analog to Electromagnetically Induced Transparency in Cascaded Ring-Resonator Systems

Yonghua Wang, Hua Zheng, Chenyang Xue +1 more

The analogue of electromagnetically induced transparency in optical methods has shown great potential in slow light and sensing applications. Here, we experimentally demonstrated a coupled resonator induced transparency system with three cascaded ring coupled resonators in a silicon chip. The structure was modeled by using the transfer matrix method. Influences of various parameters including coupling ratio of couplers, waveguide loss and additional loss of couplers on transmission characteristic and group index have been investigated theoretically and numerically in detail. The transmission character of the system was measured by the vertical grating coupling method. The enhanced quality factor reached 1.22 × 10⁵. In addition, we further test the temperature performance of the device. The results provide a new method for the manipulation of light in highly integrated optical circuits and sensing applications.

Sensors•Jul 25, 2016•7 citations

Electromagnetically Induced Transparency-Like Effect by Dark-Dark Mode Coupling

Qiao Wang, Kaili Kuang, Huixuan Gao +3 more

Electromagnetically induced transparency-like (EIT-like) effect is a promising research area for applications of slow light, sensing and metamaterials. The EIT-like effect is generally formed by the destructive interference of bright-dark mode coupling and bright-bright mode coupling. There are seldom reports about EIT-like effect realized by the coupling of two dark modes. In this paper, we numerically and theoretically demonstrated that the EIT-like effect is achieved through dark-dark mode coupling of two waveguide resonances in a compound nanosystem with metal grating and multilayer structure. If we introduce |1⟩, |2⟩ and |3⟩ to represent the surface plasmon polaritons (SPPs) resonance, waveguide resonance in layer 2, and waveguide resonance in layer 4, the destructive interference occurs between two pathways of |0⟩→|1⟩→|2⟩ and |0⟩→|1⟩→|2⟩→|3⟩→|2⟩, where |0⟩ is the ground state without excitation. Our work will stimulate more studies on EIT-like effect with dark-dark mode coupling in other systems.

Nanomaterials•May 20, 2021•12 citations

High quality factor electromagnetically induced transparency-like effect in coupled guided-mode resonant systems

Yunxin Han, Junbo Yang, Xin He +4 more

substrates. It is confirmed that the coupling between the top and bottom GMR modes starts once a Fabry-Perot (F-P) resonator is introduced, and electromagnetically induced transparency (EIT)-like spectral responses occur in the coupled GMR systems. A very narrow transparency window with a high-quality (Q) factor EIT-like effect of up to 288,892 was demonstrated. Furthermore, EIT-like response wavelengths can be flexibly designed in wide wavelength range by modifying either the GMR resonance frequencies or the space between two GWLs. Therefore, this EIT-like response in coupled GMR systems would pave the way towards novel sensors with extremely high sensitivity.

Optics Express•Mar 1, 2019•20 citations

Electromagnetically induced transparency analogue and slow light effect in an asymmetric plasma waveguide

Guoqiang Wei, Qiuyue Nie, Zhonglin Zhang +4 more

Abstract Electromagnetically induced transparency (EIT), characterised by strong dispersion and a narrow transparency window, holds great potential for developing slow light devices in communications. However, in the GHz regime, achieving a simple EIT structure with high group delay and tunability remains challenging. This paper reports an asymmetric plasma waveguide capable of producing EIT analogues, as demonstrated by finite element method simulations and a two-oscillator model (TOM). The asymmetric plasma waveguide consists of a plasma–dielectric–plasma structure with non-uniformly sized teeth. The results indicate that the EIT analogue is attributed to detuning induced by the difference in tooth size. Specifically, the detuning creates an interference band, which governs the interaction between two bright modes (i.e. resonance modes in the two teeth). The TOM aligns excellently with numerical simulations. Notably, unlike previous works, the TOM is also analysed from a fundamental energy perspective. The operating frequency can be easily tuned by adjusting plasma frequencies. The maximum group delay can reach 8.5 ns. Our study advances the understanding of the EIT phenomenon in slot waveguides with asymmetric resonators and may offer a new platform for developing actively tunable microwave slow-light devices.

Journal of Physics D Applied Physics•Jul 25, 2025•0 citations
In recent years, the achievement of the electromagnetically induced transparency (EIT) effect based on the guided-mode resonance (GMR) effect has attracted extensive attention. However, few works have achieved a double EIT-like effect using this method. In this paper, we numerically achieve a double EIT-like effect in a GMR system with a three-layer silicon nitride waveguide grating structure (WGS), using the multi-level atomic system model for theoretical explanation. In terms of slow light performance, the corresponding two delay times reach 22.59 ps and 8.43 ps, respectively. We also investigate the influence of wavelength detuning of different GMR modes on the transparent window and slow light performance. Furthermore, a wide-band flat-top transparent window was also achieved by appropriately adjusting the wavelength detuning between GMR modes. These results indicate that the EIT-like effect in the WGS has potential application prospects in low-loss slow optical devices, optical sensing, and optical communications.
The realization of the electromagnetically induced transparency (EIT) effect based on guided-mode resonance (GMR) has attracted a lot of attention. However, achieving the multispectral EIT effect in this way has not been studied. Here, we numerically realize a double EIT-ike effect with extremely high Q factors based on a GMR system with the double-bar dielectric grating structure, and the Q factors can reach 35,104 and 24,423, respectively. Moreover, the resonance wavelengths of the two EIT peaks can be flexibly controlled by changing the corresponding structural parameters. The figure of merit (FOM) of the dual-mode refractive index sensor based on this system can reach 571.88 and 587.42, respectively. Our work provides a novel method to achieve double EIT-like effects, which can be applied to the dual mode sensor, dual channel slow light and so on.
Slow light technique has significant potential applications in many contemporary photonic device developments for integrated all-optical circuit, such as buffers, regenerators, switches and interferometers. In this paper, we present an efficient coupling mechanism of an electromagnetically induced transparency like (EIT-like) effect in an all-dielectric nano-metamaterial. This EIT-like effect is generated by destructive interference between a radiative Fabry-Perot (FP) mode and a dark waveguide (WG) mode, which is based on a combined structure of a dielectric grating and multilayer films. The dark WG mode is excited by guided mode of dielectric grating instead of radiative FP mode. In analogy to the molecular transition process, the FP mode, guided mode and WG mode are denoted by excited states of |1〉, |2〉 and |3〉. The two coupling pathways of the EIT-like effect in our metamaterial are |0〉 → |1〉 and |0〉 → |2〉 → |3〉 → |1〉, where |0〉 is the ground state. The simulated resonant wavelength of WG mode is consistent with theoretical result. We further confirm this EIT-like effect through a two-oscillator coupling analysis. We achieve a group refractive index of 913.6 by adjusting these two modes coupling of the EIT-like effect, which is useful for developing slow light device. This work provides a valuable solution to realize electromagnetically induced transparency in all-dielectric nanomaterial.
The analogue of electromagnetically induced transparency in optical methods has shown great potential in slow light and sensing applications. Here, we experimentally demonstrated a coupled resonator induced transparency system with three cascaded ring coupled resonators in a silicon chip. The structure was modeled by using the transfer matrix method. Influences of various parameters including coupling ratio of couplers, waveguide loss and additional loss of couplers on transmission characteristic and group index have been investigated theoretically and numerically in detail. The transmission character of the system was measured by the vertical grating coupling method. The enhanced quality factor reached 1.22 × 10⁵. In addition, we further test the temperature performance of the device. The results provide a new method for the manipulation of light in highly integrated optical circuits and sensing applications.
Electromagnetically induced transparency-like (EIT-like) effect is a promising research area for applications of slow light, sensing and metamaterials. The EIT-like effect is generally formed by the destructive interference of bright-dark mode coupling and bright-bright mode coupling. There are seldom reports about EIT-like effect realized by the coupling of two dark modes. In this paper, we numerically and theoretically demonstrated that the EIT-like effect is achieved through dark-dark mode coupling of two waveguide resonances in a compound nanosystem with metal grating and multilayer structure. If we introduce |1⟩, |2⟩ and |3⟩ to represent the surface plasmon polaritons (SPPs) resonance, waveguide resonance in layer 2, and waveguide resonance in layer 4, the destructive interference occurs between two pathways of |0⟩→|1⟩→|2⟩ and |0⟩→|1⟩→|2⟩→|3⟩→|2⟩, where |0⟩ is the ground state without excitation. Our work will stimulate more studies on EIT-like effect with dark-dark mode coupling in other systems.
substrates. It is confirmed that the coupling between the top and bottom GMR modes starts once a Fabry-Perot (F-P) resonator is introduced, and electromagnetically induced transparency (EIT)-like spectral responses occur in the coupled GMR systems. A very narrow transparency window with a high-quality (Q) factor EIT-like effect of up to 288,892 was demonstrated. Furthermore, EIT-like response wavelengths can be flexibly designed in wide wavelength range by modifying either the GMR resonance frequencies or the space between two GWLs. Therefore, this EIT-like response in coupled GMR systems would pave the way towards novel sensors with extremely high sensitivity.
Abstract Electromagnetically induced transparency (EIT), characterised by strong dispersion and a narrow transparency window, holds great potential for developing slow light devices in communications. However, in the GHz regime, achieving a simple EIT structure with high group delay and tunability remains challenging. This paper reports an asymmetric plasma waveguide capable of producing EIT analogues, as demonstrated by finite element method simulations and a two-oscillator model (TOM). The asymmetric plasma waveguide consists of a plasma–dielectric–plasma structure with non-uniformly sized teeth. The results indicate that the EIT analogue is attributed to detuning induced by the difference in tooth size. Specifically, the detuning creates an interference band, which governs the interaction between two bright modes (i.e. resonance modes in the two teeth). The TOM aligns excellently with numerical simulations. Notably, unlike previous works, the TOM is also analysed from a fundamental energy perspective. The operating frequency can be easily tuned by adjusting plasma frequencies. The maximum group delay can reach 8.5 ns. Our study advances the understanding of the EIT phenomenon in slot waveguides with asymmetric resonators and may offer a new platform for developing actively tunable microwave slow-light devices.