Challenges
Datasets
Workspaces
Papers
Discussions
Leaderboard
Log inSign up
Challenges
Datasets
Workspaces
Papers
Discussions
Leaderboard
Blog
Job Board
Q3AS

© 2026 Aqora Quantum S.A.S.

TermsPrivacyLegal Notice

IEICE Technical Report; IEICE Tech. Rep.

Quantitative evaluation of timing jitter for SFQ circuits

Terabe Masayoshi, Sekiya Akito, Fujimaki Akira

Published Oct 7, 2005• 0 citations
OpenAlex

Related papers

Evaluation of timing jitter of SSPD-SFQ system toward high time resolve coincidence circuit

Miki Shigehito, Shigeyuki Miyajima, Masahiro Yabuno +2 more

IEICE Technical Report; IEICE Tech. Rep.•Sep 27, 2017•0 citations

Quantitative evaluation of delay time in the single-flux-quantum circuit

S. Iwasaki, Masamitsu Tanaka, N. Irie +4 more

Physica C Superconductivity•May 30, 2007•15 citations

A Comparison of Clocking Schemes for SFQ Circuits

Takahiro Kawaguchi, Kazuyoshi Takagi, Takagi Naofumi

IEICE Technical Report; IEICE Tech. Rep.•Jan 9, 2020•0 citations

Timing Jitter Characterization of the SFQ Coincidence Circuit by Optically Time-Controlled Signals From SSPDs

Shigehito Miki, Shigeyuki Miyajima, Masahiro Yabuno +7 more

We report on the timing jitter characterization of the superconducting single flux quantum (SFQ) coincidence circuit, which is an essential component of the superconducting coincidence photon counter. Two superconducting nanowire single photon detectors (SSPDs), each of which is irradiated with optically time-controlled photons, are connected to the SFQ coincidence circuit, and the timing jitter of the SFQ circuit is evaluated by changing the relative time delay between two input ports for the SFQ comparator unit. We successfully observe the transition curve of the probability of obtaining the signal from the SFQ coincidence circuit by sweeping photon arrival time to each SSPD and confirm that this curve shifts temporally upon changing the bias current to the Josephson transmission line (JTL) in the SFQ circuit. A systematic investigation reveals that the relation between time delay and the bias current to JTL can be estimated. The full width half maximum timing jitter of the SFQ circuit is 1.1 ps, which is sufficiently low so that it does not influence the entire timing jitter of the coincidence photon counter.

IEEE Transactions on Applied Superconductivity•Apr 15, 2019•2 citations

Timing discriminator based on single-flux-quantum circuit toward high time-resolved photon detection

Shigeyuki Miyajima, Shigehito Miki, Masahiro Yabuno +2 more

Abstract We propose a new time discriminating method based on a single-flux quantum (SFQ) circuit to realize a high time-resolved single-photon detection scheme that uses a superconducting nanowire single-photon detector (SSPD). The timing discriminator consists of an SFQ comparator and an interface circuit for converting the output signals of an SSPD into SFQ pulses. Prior to connecting with the SSPD, we evaluated the timing jitters of the SFQ timing discriminator itself by applying external electrical pulses. The timing jitters of the SFQ timing discriminator were found to be dominated by the timing jitters in the interface circuit. However, it was estimated to be below 10 ps even with an input pulse amplitude of 20 μ A, which is close to the typical output amplitude of the SSPD.

Superconductor Science and Technology•Oct 10, 2017•13 citations

Challenges in the Realization of SFQ Digital Circuits

T. Van Duzer

Springer eBooks•Jan 1, 1999•0 citations
We report on the timing jitter characterization of the superconducting single flux quantum (SFQ) coincidence circuit, which is an essential component of the superconducting coincidence photon counter. Two superconducting nanowire single photon detectors (SSPDs), each of which is irradiated with optically time-controlled photons, are connected to the SFQ coincidence circuit, and the timing jitter of the SFQ circuit is evaluated by changing the relative time delay between two input ports for the SFQ comparator unit. We successfully observe the transition curve of the probability of obtaining the signal from the SFQ coincidence circuit by sweeping photon arrival time to each SSPD and confirm that this curve shifts temporally upon changing the bias current to the Josephson transmission line (JTL) in the SFQ circuit. A systematic investigation reveals that the relation between time delay and the bias current to JTL can be estimated. The full width half maximum timing jitter of the SFQ circuit is 1.1 ps, which is sufficiently low so that it does not influence the entire timing jitter of the coincidence photon counter.
Abstract We propose a new time discriminating method based on a single-flux quantum (SFQ) circuit to realize a high time-resolved single-photon detection scheme that uses a superconducting nanowire single-photon detector (SSPD). The timing discriminator consists of an SFQ comparator and an interface circuit for converting the output signals of an SSPD into SFQ pulses. Prior to connecting with the SSPD, we evaluated the timing jitters of the SFQ timing discriminator itself by applying external electrical pulses. The timing jitters of the SFQ timing discriminator were found to be dominated by the timing jitters in the interface circuit. However, it was estimated to be below 10 ps even with an input pulse amplitude of 20 μ A, which is close to the typical output amplitude of the SSPD.