Challenges
Datasets
Workspaces
Papers
Discussions
Leaderboard
Log inSign up
Challenges
Datasets
Workspaces
Papers
Discussions
Leaderboard
Blog
Job Board
Q3AS

© 2026 Aqora Quantum S.A.S.

TermsPrivacyLegal Notice

IEEE Transactions on Applied Superconductivity

Timing Jitter Characterization of the SFQ Coincidence Circuit by Optically Time-Controlled Signals From SSPDs

Shigehito Miki, Shigeyuki Miyajima, Masahiro Yabuno, Taro Yamashita, Takashi Yamamoto, Nobuyuki Imoto, Rikizo Ikuta, Robert A. Kirkwood, Robert H. Hadfield, Hirotaka Terai

Published Apr 15, 2019• 2 citations
Publisher

Abstract

We report on the timing jitter characterization of the superconducting single flux quantum (SFQ) coincidence circuit, which is an essential component of the superconducting coincidence photon counter. Two superconducting nanowire single photon detectors (SSPDs), each of which is irradiated with optically time-controlled photons, are connected to the SFQ coincidence circuit, and the timing jitter of the SFQ circuit is evaluated by changing the relative time delay between two input ports for the SFQ comparator unit. We successfully observe the transition curve of the probability of obtaining the signal from the SFQ coincidence circuit by sweeping photon arrival time to each SSPD and confirm that this curve shifts temporally upon changing the bias current to the Josephson transmission line (JTL) in the SFQ circuit. A systematic investigation reveals that the relation between time delay and the bias current to JTL can be estimated. The full width half maximum timing jitter of the SFQ circuit is 1.1 ps, which is sufficiently low so that it does not influence the entire timing jitter of the coincidence photon counter.

DOI
10.1109/tasc.2019.2906258

Related papers

Superconducting coincidence photon detector with short timing jitter

Shigehito Miki, Shigeyuki Miyajima, Masahiro Yabuno +7 more

We demonstrate the operation of a coincidence photon detector with a short timing jitter consisting of two superconducting nanowire single photon detectors (SSPDs) and a single flux quantum (SFQ) circuit. By utilizing the timing discrimination capability of the SFQ coincidence circuit, the full width at half maximum timing jitter of the entire coincidence photon detector was evaluated as 32.3 ps, which is 36 ps less than that of the standard commercial time correlated single photon counting module, and the timing jitter of the SSPD was estimated as ∼15 ps. Owing to the short timing jitter characteristics, our coincidence photon detector could correctly capture the effect of pulse-width broadening by insertion of an optical bandpass filter. We have also demonstrated that our coincidence photon detection clearly shows Hong-Ou-Mandel interference with a weak coherent pulse. These results are a crucial step to realizing high timing resolution coincidence measurements, ushering in a technology for timing measurement based multi-photon quantum interference.

Applied Physics Letters•Jun 25, 2018•24 citations

Timing discriminator based on single-flux-quantum circuit toward high time-resolved photon detection

Shigeyuki Miyajima, Shigehito Miki, Masahiro Yabuno +2 more

Abstract We propose a new time discriminating method based on a single-flux quantum (SFQ) circuit to realize a high time-resolved single-photon detection scheme that uses a superconducting nanowire single-photon detector (SSPD). The timing discriminator consists of an SFQ comparator and an interface circuit for converting the output signals of an SSPD into SFQ pulses. Prior to connecting with the SSPD, we evaluated the timing jitters of the SFQ timing discriminator itself by applying external electrical pulses. The timing jitters of the SFQ timing discriminator were found to be dominated by the timing jitters in the interface circuit. However, it was estimated to be below 10 ps even with an input pulse amplitude of 20 μ A, which is close to the typical output amplitude of the SSPD.

Superconductor Science and Technology•Oct 10, 2017•13 citations

Low-jitter single flux quantum signal readout from superconducting single photon detector

Hirotaka Terai, Taro Yamashita, Shigehito Miki +2 more

We developed a single-flux-quantum (SFQ) readout technology for superconducting single-photon detectors (SSPDs) to achieve low-jitter signal readout. By optimizing circuit parameters of the SFQ readout circuit, the input current sensitivity was improved below 10 μA, which is smaller than a typical critical current of SSPD. The experiment using a pulse-pattern generator as an input pulse source revealed that the measured jitter of the SFQ readout circuit is well below the system jitter of our measurement setup for the input current level above 15 μA. The measured jitter of the SSPD connected to the SFQ readout circuit was 37 ps full width at half maximum (FWHM) for an SSPD bias current of around 18 μA, which is a significant improvement on 67 ps FWHM jitter observed in conventional readout without an SFQ readout circuit.

Optics Express•Aug 17, 2012•41 citations

Improving the timing jitter of a superconducting nanowire single-photon detection system

Junjie Wu, Lixing You, Sijing Chen +5 more

Low timing jitter is a unique merit of superconducting nanowire single-photon detectors (SNSPDs) for time-correlated applications. Quantitative analysis was performed for the SNSPD system. Aided by an oscilloscope with an optimal signal amplitude, we were able to measure a full width at half-maximum system timing jitter as low as 14.2 ps for a high-switching-current SNSPD using a room-temperature low-noise amplifier. When using a time-correlated single-photon counting module, the system timing jitter was 17.3 ps. The detector's intrinsic timing jitter was estimated at ∼12.0 ps.

Applied Optics•Mar 6, 2017•96 citations

Readout Electronics Using Single-Flux-Quantum Circuit Technology for Superconducting Single-Photon Detector Array

Hirotaka Terai, Shigehito Miki, Zhen Wang

Superconducting single-photon detectors (SSPDs) based on NbN nanowires possess properties such as high counting rate, low dark count rate and small timing jitter, which are promising characteristics for a quantum key distribution system. An SSPD array has recently attracted attention, because it can provide a higher counting rate, and spatial and photon-number resolutions. We propose readout electronics using single-flux-quantum (SFQ) circuits to process a large number of output signals from an SSPD array. We designed and tested an interface circuit between an SSPD and SFQ circuit, and successfully observed SFQ pulse generation for an input pulse with a current amplitude of 17.4 ~ 36.4 muA , which is comparable with an output current amplitude of the SSPD. The interface circuit was also operational for an input pulse duration of 1.6 ns, which is shorter than the typical recovery time of the SSPD.

IEEE Transactions on Applied Superconductivity•Jun 1, 2009•63 citations

Design of integrated SSPD-SFQ two-photon coincidence correlator

I. Komissarov, Amir Jafari Salim, Oleg A. Mukhanov +3 more

We present a single-flux-quantum (SFQ) based digital correlator to trace independent signals from two superconducting single-photon detectors (SSPDs) triggering its inputs. In our design two SSPDs are magnetically coupled to inputs of a readout system where direct current (DC)-to-SFQ converters are used to convert transient SSPD output pulses, triggered by detection of single-photon events, to SFQ pulses. The coincidence verification of SFQ pulses, generated by the two DC-to-SFQ converters, is performed with a modified SFQ coincidence buffer. The coincidence buffer is designed to generate an SFQ output pulse only when its both inputs are triggered simultaneously, or within a preset margin time. The output of the coincidence buffer is connected via, this time, an SFQ-to-DC converter, to a pulse counter operated at room temperature. We performed extensive simulations of both the SSPD equivalent circuit and correlator redout elements for the proposed coincidence scheme, using a WRSpice and PSCAN2 simulation platforms that are specifically designated to model Josephson junctions and widely used to simulate operation of the SFQ circuitry. In particular, we investigated our coincidence correlator scheme for measurements of the second-order correlation function, used to demonstrate the antibunching effect in the single-photon detection of non-classical light.

Quantum Optics and Photon Counting•Jun 6, 2023•2 citations
We report on the timing jitter characterization of the superconducting single flux quantum (SFQ) coincidence circuit, which is an essential component of the superconducting coincidence photon counter. Two superconducting nanowire single photon detectors (SSPDs), each of which is irradiated with optically time-controlled photons, are connected to the SFQ coincidence circuit, and the timing jitter of the SFQ circuit is evaluated by changing the relative time delay between two input ports for the SFQ comparator unit. We successfully observe the transition curve of the probability of obtaining the signal from the SFQ coincidence circuit by sweeping photon arrival time to each SSPD and confirm that this curve shifts temporally upon changing the bias current to the Josephson transmission line (JTL) in the SFQ circuit. A systematic investigation reveals that the relation between time delay and the bias current to JTL can be estimated. The full width half maximum timing jitter of the SFQ circuit is 1.1 ps, which is sufficiently low so that it does not influence the entire timing jitter of the coincidence photon counter.
We demonstrate the operation of a coincidence photon detector with a short timing jitter consisting of two superconducting nanowire single photon detectors (SSPDs) and a single flux quantum (SFQ) circuit. By utilizing the timing discrimination capability of the SFQ coincidence circuit, the full width at half maximum timing jitter of the entire coincidence photon detector was evaluated as 32.3 ps, which is 36 ps less than that of the standard commercial time correlated single photon counting module, and the timing jitter of the SSPD was estimated as ∼15 ps. Owing to the short timing jitter characteristics, our coincidence photon detector could correctly capture the effect of pulse-width broadening by insertion of an optical bandpass filter. We have also demonstrated that our coincidence photon detection clearly shows Hong-Ou-Mandel interference with a weak coherent pulse. These results are a crucial step to realizing high timing resolution coincidence measurements, ushering in a technology for timing measurement based multi-photon quantum interference.
Abstract We propose a new time discriminating method based on a single-flux quantum (SFQ) circuit to realize a high time-resolved single-photon detection scheme that uses a superconducting nanowire single-photon detector (SSPD). The timing discriminator consists of an SFQ comparator and an interface circuit for converting the output signals of an SSPD into SFQ pulses. Prior to connecting with the SSPD, we evaluated the timing jitters of the SFQ timing discriminator itself by applying external electrical pulses. The timing jitters of the SFQ timing discriminator were found to be dominated by the timing jitters in the interface circuit. However, it was estimated to be below 10 ps even with an input pulse amplitude of 20 μ A, which is close to the typical output amplitude of the SSPD.
We developed a single-flux-quantum (SFQ) readout technology for superconducting single-photon detectors (SSPDs) to achieve low-jitter signal readout. By optimizing circuit parameters of the SFQ readout circuit, the input current sensitivity was improved below 10 μA, which is smaller than a typical critical current of SSPD. The experiment using a pulse-pattern generator as an input pulse source revealed that the measured jitter of the SFQ readout circuit is well below the system jitter of our measurement setup for the input current level above 15 μA. The measured jitter of the SSPD connected to the SFQ readout circuit was 37 ps full width at half maximum (FWHM) for an SSPD bias current of around 18 μA, which is a significant improvement on 67 ps FWHM jitter observed in conventional readout without an SFQ readout circuit.
Low timing jitter is a unique merit of superconducting nanowire single-photon detectors (SNSPDs) for time-correlated applications. Quantitative analysis was performed for the SNSPD system. Aided by an oscilloscope with an optimal signal amplitude, we were able to measure a full width at half-maximum system timing jitter as low as 14.2 ps for a high-switching-current SNSPD using a room-temperature low-noise amplifier. When using a time-correlated single-photon counting module, the system timing jitter was 17.3 ps. The detector's intrinsic timing jitter was estimated at ∼12.0 ps.
Superconducting single-photon detectors (SSPDs) based on NbN nanowires possess properties such as high counting rate, low dark count rate and small timing jitter, which are promising characteristics for a quantum key distribution system. An SSPD array has recently attracted attention, because it can provide a higher counting rate, and spatial and photon-number resolutions. We propose readout electronics using single-flux-quantum (SFQ) circuits to process a large number of output signals from an SSPD array. We designed and tested an interface circuit between an SSPD and SFQ circuit, and successfully observed SFQ pulse generation for an input pulse with a current amplitude of 17.4 ~ 36.4 muA , which is comparable with an output current amplitude of the SSPD. The interface circuit was also operational for an input pulse duration of 1.6 ns, which is shorter than the typical recovery time of the SSPD.
We present a single-flux-quantum (SFQ) based digital correlator to trace independent signals from two superconducting single-photon detectors (SSPDs) triggering its inputs. In our design two SSPDs are magnetically coupled to inputs of a readout system where direct current (DC)-to-SFQ converters are used to convert transient SSPD output pulses, triggered by detection of single-photon events, to SFQ pulses. The coincidence verification of SFQ pulses, generated by the two DC-to-SFQ converters, is performed with a modified SFQ coincidence buffer. The coincidence buffer is designed to generate an SFQ output pulse only when its both inputs are triggered simultaneously, or within a preset margin time. The output of the coincidence buffer is connected via, this time, an SFQ-to-DC converter, to a pulse counter operated at room temperature. We performed extensive simulations of both the SSPD equivalent circuit and correlator redout elements for the proposed coincidence scheme, using a WRSpice and PSCAN2 simulation platforms that are specifically designated to model Josephson junctions and widely used to simulate operation of the SFQ circuitry. In particular, we investigated our coincidence correlator scheme for measurements of the second-order correlation function, used to demonstrate the antibunching effect in the single-photon detection of non-classical light.