Challenges
Datasets
Workspaces
Papers
Discussions
Leaderboard
Log inSign up
Challenges
Datasets
Workspaces
Papers
Discussions
Leaderboard
Blog
Job Board
Q3AS

© 2026 Aqora Quantum S.A.S.

TermsPrivacyLegal Notice

Superconductor Science and Technology

Timing discriminator based on single-flux-quantum circuit toward high time-resolved photon detection

Shigeyuki Miyajima, Shigehito Miki, Masahiro Yabuno, Taro Yamashita, Hirotaka Terai

Published Oct 10, 2017• 13 citations
Publisher

Abstract

Abstract We propose a new time discriminating method based on a single-flux quantum (SFQ) circuit to realize a high time-resolved single-photon detection scheme that uses a superconducting nanowire single-photon detector (SSPD). The timing discriminator consists of an SFQ comparator and an interface circuit for converting the output signals of an SSPD into SFQ pulses. Prior to connecting with the SSPD, we evaluated the timing jitters of the SFQ timing discriminator itself by applying external electrical pulses. The timing jitters of the SFQ timing discriminator were found to be dominated by the timing jitters in the interface circuit. However, it was estimated to be below 10 ps even with an input pulse amplitude of 20 μ A, which is close to the typical output amplitude of the SSPD.

DOI
10.1088/1361-6668/aa926e

Related papers

Superconducting coincidence photon detector with short timing jitter

Shigehito Miki, Shigeyuki Miyajima, Masahiro Yabuno +7 more

We demonstrate the operation of a coincidence photon detector with a short timing jitter consisting of two superconducting nanowire single photon detectors (SSPDs) and a single flux quantum (SFQ) circuit. By utilizing the timing discrimination capability of the SFQ coincidence circuit, the full width at half maximum timing jitter of the entire coincidence photon detector was evaluated as 32.3 ps, which is 36 ps less than that of the standard commercial time correlated single photon counting module, and the timing jitter of the SSPD was estimated as ∼15 ps. Owing to the short timing jitter characteristics, our coincidence photon detector could correctly capture the effect of pulse-width broadening by insertion of an optical bandpass filter. We have also demonstrated that our coincidence photon detection clearly shows Hong-Ou-Mandel interference with a weak coherent pulse. These results are a crucial step to realizing high timing resolution coincidence measurements, ushering in a technology for timing measurement based multi-photon quantum interference.

Applied Physics Letters•Jun 25, 2018•24 citations

Readout Electronics Using Single-Flux-Quantum Circuit Technology for Superconducting Single-Photon Detector Array

Hirotaka Terai, Shigehito Miki, Zhen Wang

Superconducting single-photon detectors (SSPDs) based on NbN nanowires possess properties such as high counting rate, low dark count rate and small timing jitter, which are promising characteristics for a quantum key distribution system. An SSPD array has recently attracted attention, because it can provide a higher counting rate, and spatial and photon-number resolutions. We propose readout electronics using single-flux-quantum (SFQ) circuits to process a large number of output signals from an SSPD array. We designed and tested an interface circuit between an SSPD and SFQ circuit, and successfully observed SFQ pulse generation for an input pulse with a current amplitude of 17.4 ~ 36.4 muA , which is comparable with an output current amplitude of the SSPD. The interface circuit was also operational for an input pulse duration of 1.6 ns, which is shorter than the typical recovery time of the SSPD.

IEEE Transactions on Applied Superconductivity•Jun 1, 2009•63 citations

Timing Jitter Characterization of the SFQ Coincidence Circuit by Optically Time-Controlled Signals From SSPDs

Shigehito Miki, Shigeyuki Miyajima, Masahiro Yabuno +7 more

We report on the timing jitter characterization of the superconducting single flux quantum (SFQ) coincidence circuit, which is an essential component of the superconducting coincidence photon counter. Two superconducting nanowire single photon detectors (SSPDs), each of which is irradiated with optically time-controlled photons, are connected to the SFQ coincidence circuit, and the timing jitter of the SFQ circuit is evaluated by changing the relative time delay between two input ports for the SFQ comparator unit. We successfully observe the transition curve of the probability of obtaining the signal from the SFQ coincidence circuit by sweeping photon arrival time to each SSPD and confirm that this curve shifts temporally upon changing the bias current to the Josephson transmission line (JTL) in the SFQ circuit. A systematic investigation reveals that the relation between time delay and the bias current to JTL can be estimated. The full width half maximum timing jitter of the SFQ circuit is 1.1 ps, which is sufficiently low so that it does not influence the entire timing jitter of the coincidence photon counter.

IEEE Transactions on Applied Superconductivity•Apr 15, 2019•2 citations

Low-jitter single flux quantum signal readout from superconducting single photon detector

Hirotaka Terai, Taro Yamashita, Shigehito Miki +2 more

We developed a single-flux-quantum (SFQ) readout technology for superconducting single-photon detectors (SSPDs) to achieve low-jitter signal readout. By optimizing circuit parameters of the SFQ readout circuit, the input current sensitivity was improved below 10 μA, which is smaller than a typical critical current of SSPD. The experiment using a pulse-pattern generator as an input pulse source revealed that the measured jitter of the SFQ readout circuit is well below the system jitter of our measurement setup for the input current level above 15 μA. The measured jitter of the SSPD connected to the SFQ readout circuit was 37 ps full width at half maximum (FWHM) for an SSPD bias current of around 18 μA, which is a significant improvement on 67 ps FWHM jitter observed in conventional readout without an SFQ readout circuit.

Optics Express•Aug 17, 2012•41 citations

Scalable implementation of a superconducting nanowire single-photon detector array with a superconducting digital signal processor

Masahiro Yabuno, Shigeyuki Miyajima, Shigehito Miki +1 more

A two-dimensional single-photon imaging system with high sensitivity and high time resolution is the ultimate camera and useful in a wide range of fields. A superconducting nanowire single-photon detector (SSPD or SNSPD) is one of the best candidates for realizing such an ultimate camera due to its high detection efficiency in a wide spectral range, low dark count rate without after-pulsing, and excellent time resolution. Here we propose a new readout scheme to realize a large-scale imaging array based on SSPD, where a row-column readout architecture is combined with a digital signal processor based on a single-flux-quantum (SFQ) circuit. A 16-pixel row-column readout SSPD array is fabricated and measured with an SFQ digital signal processor. We successfully acquired spatial information as encoded digital bit codes with the temporal information of the photon detection. The system timing jitter was measured as <80 ps for all 16 pixels even through the SFQ signal processor, indicating the potential for an imaging array with an extremely high time resolution.

Optics Express•Apr 1, 2020•40 citations

High-time-resolved 64-channel single-flux quantum-based address encoder integrated with a multi-pixel superconducting nanowire single-photon detector

Shigeyuki Miyajima, Masahiro Yabuno, Shigehito Miki +2 more

We propose and demonstrate a 64-channel event-driven encoder based on single-flux quantum (SFQ) circuits for application to a multi-pixel superconducting nanowire single-photon detector (SSPD) system. Multi-pixel SSPD systems were developed to improve maximum count rates and realize ultra-sensitive imaging systems. An intelligent signal processor is required, which we designed based on SFQ circuits. We were able to obtain an address based on the reserve timing information for the photon detection that occurs in the SSPD, as well as read the time-tagged address information for the SSPDs through the SFQ encoder. The overall observed FWHM jitter was 56.5 ps.

Optics Express•Oct 24, 2018•65 citations
Abstract We propose a new time discriminating method based on a single-flux quantum (SFQ) circuit to realize a high time-resolved single-photon detection scheme that uses a superconducting nanowire single-photon detector (SSPD). The timing discriminator consists of an SFQ comparator and an interface circuit for converting the output signals of an SSPD into SFQ pulses. Prior to connecting with the SSPD, we evaluated the timing jitters of the SFQ timing discriminator itself by applying external electrical pulses. The timing jitters of the SFQ timing discriminator were found to be dominated by the timing jitters in the interface circuit. However, it was estimated to be below 10 ps even with an input pulse amplitude of 20 μ A, which is close to the typical output amplitude of the SSPD.
We demonstrate the operation of a coincidence photon detector with a short timing jitter consisting of two superconducting nanowire single photon detectors (SSPDs) and a single flux quantum (SFQ) circuit. By utilizing the timing discrimination capability of the SFQ coincidence circuit, the full width at half maximum timing jitter of the entire coincidence photon detector was evaluated as 32.3 ps, which is 36 ps less than that of the standard commercial time correlated single photon counting module, and the timing jitter of the SSPD was estimated as ∼15 ps. Owing to the short timing jitter characteristics, our coincidence photon detector could correctly capture the effect of pulse-width broadening by insertion of an optical bandpass filter. We have also demonstrated that our coincidence photon detection clearly shows Hong-Ou-Mandel interference with a weak coherent pulse. These results are a crucial step to realizing high timing resolution coincidence measurements, ushering in a technology for timing measurement based multi-photon quantum interference.
Superconducting single-photon detectors (SSPDs) based on NbN nanowires possess properties such as high counting rate, low dark count rate and small timing jitter, which are promising characteristics for a quantum key distribution system. An SSPD array has recently attracted attention, because it can provide a higher counting rate, and spatial and photon-number resolutions. We propose readout electronics using single-flux-quantum (SFQ) circuits to process a large number of output signals from an SSPD array. We designed and tested an interface circuit between an SSPD and SFQ circuit, and successfully observed SFQ pulse generation for an input pulse with a current amplitude of 17.4 ~ 36.4 muA , which is comparable with an output current amplitude of the SSPD. The interface circuit was also operational for an input pulse duration of 1.6 ns, which is shorter than the typical recovery time of the SSPD.
We report on the timing jitter characterization of the superconducting single flux quantum (SFQ) coincidence circuit, which is an essential component of the superconducting coincidence photon counter. Two superconducting nanowire single photon detectors (SSPDs), each of which is irradiated with optically time-controlled photons, are connected to the SFQ coincidence circuit, and the timing jitter of the SFQ circuit is evaluated by changing the relative time delay between two input ports for the SFQ comparator unit. We successfully observe the transition curve of the probability of obtaining the signal from the SFQ coincidence circuit by sweeping photon arrival time to each SSPD and confirm that this curve shifts temporally upon changing the bias current to the Josephson transmission line (JTL) in the SFQ circuit. A systematic investigation reveals that the relation between time delay and the bias current to JTL can be estimated. The full width half maximum timing jitter of the SFQ circuit is 1.1 ps, which is sufficiently low so that it does not influence the entire timing jitter of the coincidence photon counter.
We developed a single-flux-quantum (SFQ) readout technology for superconducting single-photon detectors (SSPDs) to achieve low-jitter signal readout. By optimizing circuit parameters of the SFQ readout circuit, the input current sensitivity was improved below 10 μA, which is smaller than a typical critical current of SSPD. The experiment using a pulse-pattern generator as an input pulse source revealed that the measured jitter of the SFQ readout circuit is well below the system jitter of our measurement setup for the input current level above 15 μA. The measured jitter of the SSPD connected to the SFQ readout circuit was 37 ps full width at half maximum (FWHM) for an SSPD bias current of around 18 μA, which is a significant improvement on 67 ps FWHM jitter observed in conventional readout without an SFQ readout circuit.
A two-dimensional single-photon imaging system with high sensitivity and high time resolution is the ultimate camera and useful in a wide range of fields. A superconducting nanowire single-photon detector (SSPD or SNSPD) is one of the best candidates for realizing such an ultimate camera due to its high detection efficiency in a wide spectral range, low dark count rate without after-pulsing, and excellent time resolution. Here we propose a new readout scheme to realize a large-scale imaging array based on SSPD, where a row-column readout architecture is combined with a digital signal processor based on a single-flux-quantum (SFQ) circuit. A 16-pixel row-column readout SSPD array is fabricated and measured with an SFQ digital signal processor. We successfully acquired spatial information as encoded digital bit codes with the temporal information of the photon detection. The system timing jitter was measured as <80 ps for all 16 pixels even through the SFQ signal processor, indicating the potential for an imaging array with an extremely high time resolution.
We propose and demonstrate a 64-channel event-driven encoder based on single-flux quantum (SFQ) circuits for application to a multi-pixel superconducting nanowire single-photon detector (SSPD) system. Multi-pixel SSPD systems were developed to improve maximum count rates and realize ultra-sensitive imaging systems. An intelligent signal processor is required, which we designed based on SFQ circuits. We were able to obtain an address based on the reserve timing information for the photon detection that occurs in the SSPD, as well as read the time-tagged address information for the SSPDs through the SFQ encoder. The overall observed FWHM jitter was 56.5 ps.