Challenges
Datasets
Workspaces
Papers
Discussions
Leaderboard
Log inSign up
Challenges
Datasets
Workspaces
Papers
Discussions
Leaderboard
Blog
Job Board
Q3AS

© 2026 Aqora Quantum S.A.S.

TermsPrivacyLegal Notice

Optics Express

Low-jitter single flux quantum signal readout from superconducting single photon detector

Hirotaka Terai, Taro Yamashita, Shigehito Miki, Kazumasa Makise, Zhen Wang

Published Aug 17, 2012• 41 citations
Publisher

Abstract

We developed a single-flux-quantum (SFQ) readout technology for superconducting single-photon detectors (SSPDs) to achieve low-jitter signal readout. By optimizing circuit parameters of the SFQ readout circuit, the input current sensitivity was improved below 10 μA, which is smaller than a typical critical current of SSPD. The experiment using a pulse-pattern generator as an input pulse source revealed that the measured jitter of the SFQ readout circuit is well below the system jitter of our measurement setup for the input current level above 15 μA. The measured jitter of the SSPD connected to the SFQ readout circuit was 37 ps full width at half maximum (FWHM) for an SSPD bias current of around 18 μA, which is a significant improvement on 67 ps FWHM jitter observed in conventional readout without an SFQ readout circuit.

DOI
10.1364/oe.20.020115

Related papers

Superconducting single photon detectors integrated with single flux quantum readout circuits in a cryocooler

Shigehito Miki, Hirotaka Terai, Taro Yamashita +4 more

We report the operation of superconducting single photon detectors (SSPDs) with integrated readout electronics based on a single-flux-quantum (SFQ) circuit. The SSPDs were connected to a SFQ readout circuit without bias tee in a cryocooler system, and detection efficiencies (DEs) were measured to verify their correct operation. The DE curves matched well with those measured by conventional readout electronics, and the maximum bias current for normal operation was increased. In addition, we confirmed that the SFQ circuit correctly merged the input signals from two SSPDs. SSPDs with a SFQ readout circuit demonstrated a favorable timing jitter of 50 ps.

Applied Physics Letters•Sep 12, 2011•55 citations

Readout Electronics Using Single-Flux-Quantum Circuit Technology for Superconducting Single-Photon Detector Array

Hirotaka Terai, Shigehito Miki, Zhen Wang

Superconducting single-photon detectors (SSPDs) based on NbN nanowires possess properties such as high counting rate, low dark count rate and small timing jitter, which are promising characteristics for a quantum key distribution system. An SSPD array has recently attracted attention, because it can provide a higher counting rate, and spatial and photon-number resolutions. We propose readout electronics using single-flux-quantum (SFQ) circuits to process a large number of output signals from an SSPD array. We designed and tested an interface circuit between an SSPD and SFQ circuit, and successfully observed SFQ pulse generation for an input pulse with a current amplitude of 17.4 ~ 36.4 muA , which is comparable with an output current amplitude of the SSPD. The interface circuit was also operational for an input pulse duration of 1.6 ns, which is shorter than the typical recovery time of the SSPD.

IEEE Transactions on Applied Superconductivity•Jun 1, 2009•63 citations

Demonstration of single-flux-quantum readout operation for superconducting single-photon detectors

Hirotaka Terai, Shigehito Miki, Taro Yamashita +2 more

A readout circuit using superconducting single-flux-quantum (SFQ) circuits has been developed to realize an independently addressable array of superconducting single-photon detectors (SSPDs). We tested the SFQ readout circuits by connecting with SSPDs. The error rates of readout circuits were below 10−5 for input signal amplitude of greater than 18.2 μA. Detection efficiencies (DEs) for single-photon incidents were measured both with and without the connection of a readout circuit. The observed DEs traced almost the same curves regardless of the connection of the readout circuit, except that the SSPD is likely to latch by connecting the readout circuit.

Applied Physics Letters•Sep 13, 2010•43 citations

Superconducting coincidence photon detector with short timing jitter

Shigehito Miki, Shigeyuki Miyajima, Masahiro Yabuno +7 more

We demonstrate the operation of a coincidence photon detector with a short timing jitter consisting of two superconducting nanowire single photon detectors (SSPDs) and a single flux quantum (SFQ) circuit. By utilizing the timing discrimination capability of the SFQ coincidence circuit, the full width at half maximum timing jitter of the entire coincidence photon detector was evaluated as 32.3 ps, which is 36 ps less than that of the standard commercial time correlated single photon counting module, and the timing jitter of the SSPD was estimated as ∼15 ps. Owing to the short timing jitter characteristics, our coincidence photon detector could correctly capture the effect of pulse-width broadening by insertion of an optical bandpass filter. We have also demonstrated that our coincidence photon detection clearly shows Hong-Ou-Mandel interference with a weak coherent pulse. These results are a crucial step to realizing high timing resolution coincidence measurements, ushering in a technology for timing measurement based multi-photon quantum interference.

Applied Physics Letters•Jun 25, 2018•24 citations

Timing Jitter Characterization of the SFQ Coincidence Circuit by Optically Time-Controlled Signals From SSPDs

Shigehito Miki, Shigeyuki Miyajima, Masahiro Yabuno +7 more

We report on the timing jitter characterization of the superconducting single flux quantum (SFQ) coincidence circuit, which is an essential component of the superconducting coincidence photon counter. Two superconducting nanowire single photon detectors (SSPDs), each of which is irradiated with optically time-controlled photons, are connected to the SFQ coincidence circuit, and the timing jitter of the SFQ circuit is evaluated by changing the relative time delay between two input ports for the SFQ comparator unit. We successfully observe the transition curve of the probability of obtaining the signal from the SFQ coincidence circuit by sweeping photon arrival time to each SSPD and confirm that this curve shifts temporally upon changing the bias current to the Josephson transmission line (JTL) in the SFQ circuit. A systematic investigation reveals that the relation between time delay and the bias current to JTL can be estimated. The full width half maximum timing jitter of the SFQ circuit is 1.1 ps, which is sufficiently low so that it does not influence the entire timing jitter of the coincidence photon counter.

IEEE Transactions on Applied Superconductivity•Apr 15, 2019•2 citations

Timing discriminator based on single-flux-quantum circuit toward high time-resolved photon detection

Shigeyuki Miyajima, Shigehito Miki, Masahiro Yabuno +2 more

Abstract We propose a new time discriminating method based on a single-flux quantum (SFQ) circuit to realize a high time-resolved single-photon detection scheme that uses a superconducting nanowire single-photon detector (SSPD). The timing discriminator consists of an SFQ comparator and an interface circuit for converting the output signals of an SSPD into SFQ pulses. Prior to connecting with the SSPD, we evaluated the timing jitters of the SFQ timing discriminator itself by applying external electrical pulses. The timing jitters of the SFQ timing discriminator were found to be dominated by the timing jitters in the interface circuit. However, it was estimated to be below 10 ps even with an input pulse amplitude of 20 μ A, which is close to the typical output amplitude of the SSPD.

Superconductor Science and Technology•Oct 10, 2017•13 citations
We developed a single-flux-quantum (SFQ) readout technology for superconducting single-photon detectors (SSPDs) to achieve low-jitter signal readout. By optimizing circuit parameters of the SFQ readout circuit, the input current sensitivity was improved below 10 μA, which is smaller than a typical critical current of SSPD. The experiment using a pulse-pattern generator as an input pulse source revealed that the measured jitter of the SFQ readout circuit is well below the system jitter of our measurement setup for the input current level above 15 μA. The measured jitter of the SSPD connected to the SFQ readout circuit was 37 ps full width at half maximum (FWHM) for an SSPD bias current of around 18 μA, which is a significant improvement on 67 ps FWHM jitter observed in conventional readout without an SFQ readout circuit.
We report the operation of superconducting single photon detectors (SSPDs) with integrated readout electronics based on a single-flux-quantum (SFQ) circuit. The SSPDs were connected to a SFQ readout circuit without bias tee in a cryocooler system, and detection efficiencies (DEs) were measured to verify their correct operation. The DE curves matched well with those measured by conventional readout electronics, and the maximum bias current for normal operation was increased. In addition, we confirmed that the SFQ circuit correctly merged the input signals from two SSPDs. SSPDs with a SFQ readout circuit demonstrated a favorable timing jitter of 50 ps.
Superconducting single-photon detectors (SSPDs) based on NbN nanowires possess properties such as high counting rate, low dark count rate and small timing jitter, which are promising characteristics for a quantum key distribution system. An SSPD array has recently attracted attention, because it can provide a higher counting rate, and spatial and photon-number resolutions. We propose readout electronics using single-flux-quantum (SFQ) circuits to process a large number of output signals from an SSPD array. We designed and tested an interface circuit between an SSPD and SFQ circuit, and successfully observed SFQ pulse generation for an input pulse with a current amplitude of 17.4 ~ 36.4 muA , which is comparable with an output current amplitude of the SSPD. The interface circuit was also operational for an input pulse duration of 1.6 ns, which is shorter than the typical recovery time of the SSPD.
A readout circuit using superconducting single-flux-quantum (SFQ) circuits has been developed to realize an independently addressable array of superconducting single-photon detectors (SSPDs). We tested the SFQ readout circuits by connecting with SSPDs. The error rates of readout circuits were below 10−5 for input signal amplitude of greater than 18.2 μA. Detection efficiencies (DEs) for single-photon incidents were measured both with and without the connection of a readout circuit. The observed DEs traced almost the same curves regardless of the connection of the readout circuit, except that the SSPD is likely to latch by connecting the readout circuit.
We demonstrate the operation of a coincidence photon detector with a short timing jitter consisting of two superconducting nanowire single photon detectors (SSPDs) and a single flux quantum (SFQ) circuit. By utilizing the timing discrimination capability of the SFQ coincidence circuit, the full width at half maximum timing jitter of the entire coincidence photon detector was evaluated as 32.3 ps, which is 36 ps less than that of the standard commercial time correlated single photon counting module, and the timing jitter of the SSPD was estimated as ∼15 ps. Owing to the short timing jitter characteristics, our coincidence photon detector could correctly capture the effect of pulse-width broadening by insertion of an optical bandpass filter. We have also demonstrated that our coincidence photon detection clearly shows Hong-Ou-Mandel interference with a weak coherent pulse. These results are a crucial step to realizing high timing resolution coincidence measurements, ushering in a technology for timing measurement based multi-photon quantum interference.
We report on the timing jitter characterization of the superconducting single flux quantum (SFQ) coincidence circuit, which is an essential component of the superconducting coincidence photon counter. Two superconducting nanowire single photon detectors (SSPDs), each of which is irradiated with optically time-controlled photons, are connected to the SFQ coincidence circuit, and the timing jitter of the SFQ circuit is evaluated by changing the relative time delay between two input ports for the SFQ comparator unit. We successfully observe the transition curve of the probability of obtaining the signal from the SFQ coincidence circuit by sweeping photon arrival time to each SSPD and confirm that this curve shifts temporally upon changing the bias current to the Josephson transmission line (JTL) in the SFQ circuit. A systematic investigation reveals that the relation between time delay and the bias current to JTL can be estimated. The full width half maximum timing jitter of the SFQ circuit is 1.1 ps, which is sufficiently low so that it does not influence the entire timing jitter of the coincidence photon counter.
Abstract We propose a new time discriminating method based on a single-flux quantum (SFQ) circuit to realize a high time-resolved single-photon detection scheme that uses a superconducting nanowire single-photon detector (SSPD). The timing discriminator consists of an SFQ comparator and an interface circuit for converting the output signals of an SSPD into SFQ pulses. Prior to connecting with the SSPD, we evaluated the timing jitters of the SFQ timing discriminator itself by applying external electrical pulses. The timing jitters of the SFQ timing discriminator were found to be dominated by the timing jitters in the interface circuit. However, it was estimated to be below 10 ps even with an input pulse amplitude of 20 μ A, which is close to the typical output amplitude of the SSPD.