Challenges
Datasets
Workspaces
Papers
Discussions
Leaderboard
Log inSign up
Challenges
Datasets
Workspaces
Papers
Discussions
Leaderboard
Blog
Job Board
Q3AS

© 2026 Aqora Quantum S.A.S.

TermsPrivacyLegal Notice

Scalable, High-Speed, Digital Single-Flux-Quantum Circuits at NIST

P. F. Hopkins, Manuel C. Castellanos Beltran, Christine A. Donnelly, Paul D. Dresselhaus, David I. Olaya, Adam J. Sirois, Samuel P. Benz

Published Jun 12, 2017• 0 citations
OpenAlex

Related papers

Fabrication of High-Speed and High-Density Single-Flux-Quantum Circuits at NIST

David I. Olaya, Paul D. Dresselhaus, P. F. Hopkins +1 more

•Jun 12, 2017•0 citations

Ultra-high-speed rapid single-flux-quantum digital circuits. using a planarized-niobium-trilaver josephson junction technology

P. Bunyk, Vasili K. Semenov, A. Oliva +6 more

Conference digest•Aug 25, 2005•1 citation

Superconductive single-flux quantum technology

Oleg A. Mukhanov

Key digital circuits for signal processing with tens of gigahertz speed and a few microwatts power dissipation have been recently demonstrated using a simple, 2 /spl mu/m linewidth process. These are the fastest digital circuits reported to date. These circuits use novel rapid single flux quantum (RSFQ) technology that takes advantage of the fundamental properties of superconductivity. In this technology, data and clock are picosecond-long quantized voltage pulses corresponding to the transfer of single magnetic flux quanta, /spl Phisub 0/=h/2e=2 mVps. These SFQ pulses are regenerated at each gate and are processed by circuits comprised of overdamped Josephson junctions interconnected via microstrip inductances. The inherent internal memory of all RSFQ gates (primarily flip-flops), combined with high switching speed, makes serial, bit-pipelined circuit design advantageous. This paper presents experiments in RSFQ digital circuits, including an N/spl times/8b serial multiplier, and on-chip test systems based on RSFQ shift registers and on SFQ samplers. They enable test and study of RSFQ circuits at full GHz speed while communicating with semiconductor electronics at low speed.>

Digest of technical papers/Digest of technical papers - IEEE International Solid-State Circuits Conference•Dec 17, 2002•8 citations

Recent Progress in Rapid-Single-Flux-Quantum Circuits

Akira Fujimaki, Takahiro Yamada, Masamitsu Tanaka +4 more

Advances in science and technology•Oct 1, 2006•1 citation

Experimental Investigation of Energy-Efficient Digital Circuits Based on eSFQ Logic

Mark H. Volkmann, Anubhav Sahu, Coenrad Johann Fourie +1 more

We present the design and results of experimental verification methods for ultra-low-power digital circuits based on the recently introduced energy-efficient single flux quantum (eSFQ) logic. Similar to another low-power SFQ logic, ERSFQ, eSFQ circuits make use of superconducting dc bias current dividers and thus avoid static power dissipation. As a result, per-gate power dissipation is reduced by two orders of magnitude as compared to conventional rapid single flux quantum and static power dissipation is zero. The eSFQ circuits are fabricated using the HYPRES standard 4.5 kA/cm2process. We integrate a low-pass analog-to-digital modulator with our eSFQ deserializer to enable testing at high speed. In this paper, we demonstrate the viability and performance metrics of eSFQ circuits through functional and high-speed tests. Specifically, we confirmed correct operation and present measured parameter margins.

IEEE Transactions on Applied Superconductivity•Jan 16, 2013•30 citations

Design and Implementation of a Single Flux Quantum Logic-Based Memory Controller for Josephson-CMOS Hybrid Memory Systems

Seda Demirhan, Ali Bozbey

Single flux quantum (SFQ) digital circuits have shown the potential for high speed/low power computation applications. Unfortunately, because of the low integration density and low driving capability of SFQ circuits, realizing large-scale memories by using only SFQ circuits is still a challenge. Josephson-CMOS hybrid memory, hybridizing high-speed, low power SFQ circuits, and high-density CMOS memories is already proposed as a solution to the large-scale memory problem in RSFQ digital systems. In this article, an SFQ-based memory controller which works up to 10 GHz clock frequencies is designed for Josephson-CMOS hybrid memory systems. The memory controller acts as a SFQ/CMOS interface between the SFQ circuit and SRAM module and generates the required waveforms for SRAM read and write operations. The circuit which has 4-b data and 2-b address lines is fabricated with AIST 2.5 kA/cm2STP2 process and operations of the circuits are verified. To demonstrate the scalability of the circuit, memory controller was scaled to 8-b data and 13-b address to control of the 64kb SRAM. Operations of the scaled memory controller are verified with analog simulations. Scaled circuit consumes 0.76 mW power in an area of 1.64 mm × 1.60 mm.

IEEE Transactions on Applied Superconductivity•Jul 28, 2020•5 citations
Key digital circuits for signal processing with tens of gigahertz speed and a few microwatts power dissipation have been recently demonstrated using a simple, 2 /spl mu/m linewidth process. These are the fastest digital circuits reported to date. These circuits use novel rapid single flux quantum (RSFQ) technology that takes advantage of the fundamental properties of superconductivity. In this technology, data and clock are picosecond-long quantized voltage pulses corresponding to the transfer of single magnetic flux quanta, /spl Phisub 0/=h/2e=2 mVps. These SFQ pulses are regenerated at each gate and are processed by circuits comprised of overdamped Josephson junctions interconnected via microstrip inductances. The inherent internal memory of all RSFQ gates (primarily flip-flops), combined with high switching speed, makes serial, bit-pipelined circuit design advantageous. This paper presents experiments in RSFQ digital circuits, including an N/spl times/8b serial multiplier, and on-chip test systems based on RSFQ shift registers and on SFQ samplers. They enable test and study of RSFQ circuits at full GHz speed while communicating with semiconductor electronics at low speed.>
We present the design and results of experimental verification methods for ultra-low-power digital circuits based on the recently introduced energy-efficient single flux quantum (eSFQ) logic. Similar to another low-power SFQ logic, ERSFQ, eSFQ circuits make use of superconducting dc bias current dividers and thus avoid static power dissipation. As a result, per-gate power dissipation is reduced by two orders of magnitude as compared to conventional rapid single flux quantum and static power dissipation is zero. The eSFQ circuits are fabricated using the HYPRES standard 4.5 kA/cm2process. We integrate a low-pass analog-to-digital modulator with our eSFQ deserializer to enable testing at high speed. In this paper, we demonstrate the viability and performance metrics of eSFQ circuits through functional and high-speed tests. Specifically, we confirmed correct operation and present measured parameter margins.
Single flux quantum (SFQ) digital circuits have shown the potential for high speed/low power computation applications. Unfortunately, because of the low integration density and low driving capability of SFQ circuits, realizing large-scale memories by using only SFQ circuits is still a challenge. Josephson-CMOS hybrid memory, hybridizing high-speed, low power SFQ circuits, and high-density CMOS memories is already proposed as a solution to the large-scale memory problem in RSFQ digital systems. In this article, an SFQ-based memory controller which works up to 10 GHz clock frequencies is designed for Josephson-CMOS hybrid memory systems. The memory controller acts as a SFQ/CMOS interface between the SFQ circuit and SRAM module and generates the required waveforms for SRAM read and write operations. The circuit which has 4-b data and 2-b address lines is fabricated with AIST 2.5 kA/cm2STP2 process and operations of the circuits are verified. To demonstrate the scalability of the circuit, memory controller was scaled to 8-b data and 13-b address to control of the 64kb SRAM. Operations of the scaled memory controller are verified with analog simulations. Scaled circuit consumes 0.76 mW power in an area of 1.64 mm × 1.60 mm.