Challenges
Datasets
Workspaces
Papers
Discussions
Leaderboard
Log inSign up
Challenges
Datasets
Workspaces
Papers
Discussions
Leaderboard
Blog
Job Board
Q3AS

© 2026 Aqora Quantum S.A.S.

TermsPrivacyLegal Notice

IEICE Technical Report; IEICE Tech. Rep.

Fabrication and Characterization of a MSM diode as an optical input interface for SFQ circuit

Shinada Satoshi, Hirotaka Terai, Naoya Wada, Zhen Wang, Tetsuya Miyazaki

Published Mar 9, 2006• 0 citations
OpenAlex

Related papers

Fabrication and Characterization of a MSM photo diode for SFQ circuit

聡 品田, 弘高 寺井, 尚也 和田 +2 more

電子情報通信学会技術研究報告. LQE, レーザ・量子エレクトロニクス•Jan 22, 2007•0 citations

Fabrication and Characterization of 1550-nm band optical input interface for SFQ buffer memory

聡 品田, 弘高 寺井, 尚也 和田 +1 more

IEICE Technical Report; IEICE Tech. Rep.•Mar 1, 2010•0 citations

An Optical Input Module With Superconducting Single-Flux-Quantum Circuit Operating at 1550 nm

Hirotaka Terai, Satoshi Shinada, Kazumasa Makise +2 more

We developed an optical input module consisting of built-in metal-semiconductor-metal photodiodes (MSM-PDs) and co-planar waveguide transmission lines fabricated on an InP substrate, which is flip-chip bonded with a single-flux-quantum (SFQ) circuit fabricated on a Si substrate. To improve photosensitivity of the MSM-PD for a wavelength above 1530 nm at 4 K, we tested the MSM-PDs made of lattice mismatched In1-xGaxAs films on InP substrates. By employing In1-xGaxAs with x=0.44, an apparent reduction of photosensitivity for a wavelength above 1530 nm was suppressed. We also tested newly designed DC/SFQ converters with higher input current sensitivities. The observed current sensitivity was improved to 41 μA, while that in the conventional DC/SFQ converter was 140 μA.

IEEE Transactions on Applied Superconductivity•Feb 11, 2011•1 citation

Fabrication and characteristics of SFQ circuit elements made of oxide thin films

Y. Tarutani, Yoshihiro Ishimaru, H. Wakana +7 more

Physica C Superconductivity•Aug 9, 2005•2 citations

Optical data communication between Josephson-junction circuits and room-temperature electronics

Bart Van Zeghbroeck

The feasibility of optical data transmission to and from Josephson junction circuits, using metal-semiconductor-metal (MSM) photodiodes and GaAs/AlGaAs semiconductor laser diodes with sub-mA threshold current, is demonstrated. Standard devices can be used with the exception of a cooled GaAs detector. It is shown that silicon MSM detectors compatible with Josephson junction circuits can be fabricated. While these detectors show large photoconductive effects at room temperature they behave as good-quality photodiodes at low temperatures. Power dissipation in the laser diode scales with temperature while maintaining the modulation frequency. It is also shown that the combination of a laser diode and a photodiode provides the voltage gain needed to interface Josephson-junction circuits with room-temperature electronics. Experimental results on MSM detectors and laser diodes are presented. Expected power dissipation is below 1 mW per input/output (I/O) at a data rate of 1 Gb/s.>

IEEE Transactions on Applied Superconductivity•Mar 1, 1993•15 citations

Design of SFQ Circuits and Their Measurement

Kazunori Miyahara, Shuichi Nagasawa, H. Hasegawa +3 more

IEICE Transactions on Electronics•Mar 1, 2002•0 citations
We developed an optical input module consisting of built-in metal-semiconductor-metal photodiodes (MSM-PDs) and co-planar waveguide transmission lines fabricated on an InP substrate, which is flip-chip bonded with a single-flux-quantum (SFQ) circuit fabricated on a Si substrate. To improve photosensitivity of the MSM-PD for a wavelength above 1530 nm at 4 K, we tested the MSM-PDs made of lattice mismatched In1-xGaxAs films on InP substrates. By employing In1-xGaxAs with x=0.44, an apparent reduction of photosensitivity for a wavelength above 1530 nm was suppressed. We also tested newly designed DC/SFQ converters with higher input current sensitivities. The observed current sensitivity was improved to 41 μA, while that in the conventional DC/SFQ converter was 140 μA.
The feasibility of optical data transmission to and from Josephson junction circuits, using metal-semiconductor-metal (MSM) photodiodes and GaAs/AlGaAs semiconductor laser diodes with sub-mA threshold current, is demonstrated. Standard devices can be used with the exception of a cooled GaAs detector. It is shown that silicon MSM detectors compatible with Josephson junction circuits can be fabricated. While these detectors show large photoconductive effects at room temperature they behave as good-quality photodiodes at low temperatures. Power dissipation in the laser diode scales with temperature while maintaining the modulation frequency. It is also shown that the combination of a laser diode and a photodiode provides the voltage gain needed to interface Josephson-junction circuits with room-temperature electronics. Experimental results on MSM detectors and laser diodes are presented. Expected power dissipation is below 1 mW per input/output (I/O) at a data rate of 1 Gb/s.>