We have shown that Rydberg states can be used for high-sensitivity, absolute sensing of microwave (MW) electric fields. We achieved a sensitivity of 3 μVcm-1Hz-1/2 for two read-out strategies. Depending on the spectral resolution of the read-out, either the MW induced transmission line frequency splitting, the Autler-Townes regime, or a change in the on-resonant absorption, the amplitude regime, can be used to determine the MW electric field. Results using a Mach-Zehnder interferometer and frequency modulated spectroscopy both achieve similar photon shot noise limited sensitivity. In addition, we have also explored amplitude modulation and the displacement of a probe laser beam due to index of refraction changes in a prism shaped vapor cell. These latter methods were not able to achieve photon shot noise limited performance. Fundamental limits to the sensitivity of the Rydberg atom-based MW electric field sensing have been addressed, but it is important to clarify the differences between noise in different parts or subsystems of the sensor. Shot noise in the probe laser usually dominates the projection noise of the atoms participating in the measurement of the MW electric field because of the desire to operate at low effective Rydberg atom densities in order to avoid collisional dephasing and ionization.
We have shown that Rydberg states can be used for high-sensitivity, absolute sensing of microwave (MW) electric fields. We achieved a sensitivity of 3 μVcm-1Hz-1/2 for two read-out strategies. Depending on the spectral resolution of the read-out, either the MW induced transmission line frequency splitting, the Autler-Townes regime, or a change in the on-resonant absorption, the amplitude regime, can be used to determine the MW electric field. Results using a Mach-Zehnder interferometer and frequency modulated spectroscopy both achieve similar photon shot noise limited sensitivity. In addition, we have also explored amplitude modulation and the displacement of a probe laser beam due to index of refraction changes in a prism shaped vapor cell. These latter methods were not able to achieve photon shot noise limited performance. Fundamental limits to the sensitivity of the Rydberg atom-based MW electric field sensing have been addressed, but it is important to clarify the differences between noise in different parts or subsystems of the sensor. Shot noise in the probe laser usually dominates the projection noise of the atoms participating in the measurement of the MW electric field because of the desire to operate at low effective Rydberg atom densities in order to avoid collisional dephasing and ionization.
We have shown that Rydberg atoms can be used for high-sensitivity, absolute sensing of radio frequency (RF) electric fields. We achieved a sensitivity of 3 μVcm-1Hz-1/2 for two read-out strategies. Results using a Mach-Zehnder interferometer2 and frequency modulated spectroscopy both achieve similar photon shot noise limited sensitivity. Fundamental limits to the sensitivity of the Rydberg atom-based RF electric field sensing have been addressed. Depending on the spectral resolution of the read-out, either the RF induced transmission line frequency splitting, the Autler-Townes regime, or a change in the on-resonant absorption, the amplitude regime, can be used to determine the RF electric field. Here, we present theoretical results of a 3-photon read-out scheme which enables the Autler-Townes regime of Rydberg atom-based RF electrometry to be extended to lower RF electric field strengths. We show that the residual Doppler shifts can, in principle, be reduced to ~11.8 kHz, on the order of the Rydberg atom natural lindewidths, using the approach.
Significant progress has been made in atom-based measurements of length, time, gravity and electromagnetic fields in recently years. Rydberg atom-based microwave electric field measurement, using electromagnetically induced transparency (EIT) in room temperature alkali-metal vapors, has been extensively investigated and aroused the broad interest. This approach may establish a new standard for the measurements of microwave (MW) and radio frequency (RF) electric fields.In this review, we describe the work on a new method of measuring electric fields based on quantum interference by using either cesium or rubidium atoms contained in a dielectric vapor cell. Rydberg atoms with principal quantum number n >>1 have large direct current (DC) polarizabilities and microwave transition dipole moments, thereby making them extremely sensitive to external electric fields. Using the Rydberg three-level EIT to detect the level splitting and shift that is induced by the external field, we can realize a rapid and robust self-calibration method of measuring the electric field in a frequency range from 0.01 GHz to 1000 GHz. For the MW electric field (frequency range > 1 GHz), the MW field causes the Rydberg states to split, known as an Autler-Townes splitting (A-T) effect when the applied microwave can resonate with adjacent Rydberg states. The MW coupled A-T splitting is proportional to the applied electric field strength, from which the field strength is measured. Using the EIT window, a high sensitivity of 3 μV·cm-1·Hz-1/2 and small electric field of 1 μV/cm are expected to be achieved with a modest setup, and the limitations of the sensitivity are also addressed in the review. For the RF field at frequency mj EIT lines, and avoided crossings formed with the fine-structure levels of equal mj and different J's, which is used to calibrate and measure the RF field amplitude. On the other hand, the dependence of the EIT-line strength on the RF field polarization provides a fast and robust polarization measurement of RF fields based on matching experimental data with a theoretical simulation. The measurements of minimum strengths and sensitivity of RF fields based on Rydberg atoms are one order magnitude below the values obtained by traditional antenna methods. The atom-based field measurement paves the way for determining fields through calibration-free, invariable atomic properties and miniaturization. We also propose its various potential applications in the future.
Atoms form the basis of precise measurement for many quantities (time, acceleration, rotation, magnetic field, etc.). Measurements of microwave frequency electric fields by traditional methods (i.e. engineered antennas) have limited sensitivity and can be difficult to calibrate properly. Highly-excited (Rydberg) neutral atoms have very large electric-dipole moments and many dipole allowed transitions in the range of 1 - 500 GHz. It is possible to sensitively probe the electric field in this range using the combination of two quantum interference phenomena: electromagnetically induced transparency and the Autler-Townes effect. This technique allows for very sensitive field amplitude, polarization, and sub-wavelength imaging measurements. These quantities can be extracted by measuring properties of a probe laser beam as it passes through a warm rubidium vapor cell. Thus far, Rydberg microwave electrometry has relied upon the absorption of the probe laser. We report on our use of polarization rotation, which corresponds to the real part of the susceptibility, for measuring the properties of microwave frequency electric fields. Our simulations show that when a magnetic field is present and directed along the optical propagation direction a polarization rotation signal exists and can be used for microwave electrometry. One central advantage in using the polarization rotation signal rather than the absorption signal is that common mode laser noise is naturally eliminated leading to a potentially dramatic increase in signal-to-noise ratio.
Rydberg atoms have demonstrated exceptional capabilities in the precise sensing microwave (MW) fields. Previous studies on Rydberg atom-based electrometers (RAEs) have predominantly focused on absorption measurements. Recently, phase-sensitive RAEs employing Mach-Zehnder interferometer (MZI) have been demonstrated, though their performance remains constrained by the standard quantum limit (SQL). In this study, we combine RAEs with advanced quantum interferometrics to enhance MW field sensing. Within the framework of electromagnetically induced transparency (EIT) and Autler-Townes (AT) splitting, the noise of our enhanced electrometer is suppressed below the photon shot noise (PSN) in measuring light dispersion through microwave-dressed atoms, when utilizing phase squeezed states. In our theory, the optimal sensitivity of the MW field can reach 1.36 × 10 −11 V/m/Hz 1/2 with a dressed MW field strength of 2.4 × 10 −4 V/m within a balanced SU(1,1) interferometer.
An atom-based approach is presented to detect absolute microwave (MW) electric fields (E-fields). The approach uses Rydberg atoms in vapor cells at room temperature. The MW E-field measurements utilize a bright resonance prepared within an electromagnetically induced transparency (EIT) window. The large transition dipole moments between energetically adjacent Rydberg states enable this method to make traceable E-field measurements with a sensitivity that is several orders of magnitude higher than the current standard for MW E-field measurements. The method can be used to image MW E-field in the near field regime with a subwavelength resolution of mathrmlambdaMW/650, where mathrmlambdaMW is the wavelength of the MW E-field. A high accuracy of $\\mathrm{1\\%}$ has been reached by minimizing the effects of the vapor cell geometry on the measured MW E-field. The dissertation also presents an alternative technique to perform the MW E-field measurement using dispersive properties of the EIT spectrum with a prism vapor cell. Recently, we applied a homodyne detection technique with a Mach Zehnder interferometer to achieve a new sensitivity limit for the MW E-field measurement, mathrmsim3muVcm−1Hz−1/2. The new sensitivity is one order of magnitude better than our prior best sensitivity presented in Ref. [Nat. Phys. 8, 819 (2012)]. The Rydberg atom-based method is promising to be a new standard for MW E-field measurements and to develop into portable devices in the field of MW technologies.
We present a Rydberg atom-based microwave electric field sensor that achieves extended dynamic range and enhanced sensitivity across a broad bandwidth. By characterizing the Autler-Townes (AT) splitting induced by a single-tone microwave field, we demonstrate a spectroscopic method that simultaneously extracts both the microwave frequency and electric field strength directly from the splitting pattern. We implement dual-tone heterodyne detection, achieving a minimum detectable field strength on the order of uV/cm and a sensitivity in the sub-uV/cm/Hz^1/2 regime, while extending the operational bandwidth up to 3 GHz. Through systematic characterization of frequency and power dependencies, we identify optimal operating conditions to minimize power broadening in the resonant AT regime and maximize sensitivity in the far-off-resonance AC Stark regime. The resulting platform combines high sensitivity, broad bandwidth, and a dynamic range of approximately 90 dB, establishing Rydberg atoms as practical sensors for precision electric field metrology.