Challenges
Datasets
Workspaces
Papers
Discussions
Leaderboard
Log inSign up
Challenges
Datasets
Workspaces
Papers
Discussions
Leaderboard
Blog
Job Board
Q3AS

© 2026 Aqora Quantum S.A.S.

TermsPrivacyLegal Notice

Journal of Applied Optics

Single photon detection used in quantum communication

Haiqiang Ma

Published Jan 1, 2010• 0 citations
OpenAlex

Abstract

In order to improve the sensitivity of single-photon detection systems,InGaAs/InP avalanche photodiode(InGaAs/InP APD) is used in the design of single photon detector of quantum communication.Single photon detector bias generation circuit in gate pulse mode,single-photon signal amplification circuit,single photon signal detection circuit and temperature control module were realized.By selecting high-precision OP37 preamplifier and precision comparator AD8561,quantum efficiency was increased to 18.3%,dark count was controlled within 4.1 × 10-6/ns.

Related papers

Design of single-photon detection system used in quantum cryptography communication

Songhao Liu

A single-photon detection system with laser of 1310nm wavelength as light source is designed. Using InGaAs Avalanche Photodiode (InGaAs-APD) as single-photon detection device for quantum cryptography communication, the bias-voltage formation, low-temperature control and single-photon signal detection are comprehensively considered. The photon gate formed by pulse superimposed on DC level is equivalently performed by monostable circuit in pulse generator. Detection sensitivity of the system is improved by using a trans-impedance pre-amplifier and a precision comparator. The detection experiments in initial stage show that the waveform of -93dBm light signal can be observed by the detection system.

Guangdian gongcheng•Jan 1, 2004•1 citation

The single-photon detection and data acquisition for the quantum key distribution system

Xiuliang Chen, Chunyuan Zhou, Guang Wu +2 more

In our experiment, two InGaAs/InP avalanche photodiodes (APD) were used in the quantum key distribution (QKD) system for single-photon detection at telecom communication wavelength (1310/1550 nm). By using properly designed passive-quenching circuit, the photo-detection efficiency of the APD could reach 10% at 1550 nm. In order to decrease the dark count rate efficiently, we designed a coincident counting circuits for single-photon detection. Before the APD signals were sent to the signal processing circuit, the avalanche signals were amplified and shaped into the TTL pulses. In order to obtain an accurate and efficient data acquisition and to transfer synchronically several signals such as the TTL signals and pulses from Random generators, we designed a signal processing circuit with the parallel port whose speed limitation is about 100Kb/s. In our experiments of single-photon interference and quantum cryptography, the electronic designs presented us satisfactory performance and results. To achieve much higher speed for the data acquisition, we also employed the Universal Serial Bus System (USB2.0) to interface our single-photon avalanche detectors and random generators used in our QKD system, which was believed to improve the performance of QKD such as the key distribution speed.

Frontiers in Optics•Jan 1, 2003•0 citations

Single‐photon detector for long‐distance quantum cryptography

Naoto Namekata, Yuuki Makino, Shuichiro Inoue

Abstract In order to realize long‐distance quantum cryptography based on standard optical fiber network, we have developed a single‐photon detector at 1550 nm using InGaAs/InP avalanche photodiodes (APDs). To reduce the dark count probability, APDs were cooled and operated with a Gated Passive Quenching Circuit. A quantum efficiency of 13.7% was obtained at −55 °C while keeping the dark count probability per gate (2 ns) as low as 2.4 × 10−5. In this paper we will discuss the performance of the developed single‐photon detector in view of application to quantum cryptography. © 2003 Wiley Periodicals, Inc. Electron Comm Jpn Pt 2, 86(5): 10–15, 2003; Published online in Wiley InterScience ( www.interscience.wiley.com ). DOI 10.1002/ecjb.10115

Electronics and Communications in Japan (Part II Electronics)•Apr 4, 2003•0 citations

A single-photon detector for high-speed telecom-band quantum communication applications

Chuang Liang, Kim Fook Lee, Paul L. Voss +5 more

We present the design and construction of a high-speed telecom-band (1.5 μm) single-photon counting system based on an InGaAs/InP avalanche photodiode (APD) operating in the gated Geiger mode. The detector can be gated at high speeds (we examine its performance up to 25 MHz) to maximize the counting rate in long-distance, telecom-band, fiber-optic quantum communication applications. Narrow gate pulses (250 ps full width at half maximum) are used to reduce the dark-count and the after-pulse probability. In order to count the avalanche events, we employ a high-speed comparator to sample the unfiltered and unamplified avalanche photocurrent. The APD and all the associated electronics are integrated onto a printed circuit board with a computer interface. In addition, we cool the APD to -27°C to reduce the dark-count probability.

Proceedings of SPIE, the International Society for Optical Engineering/Proceedings of SPIE•Aug 18, 2005•6 citations

High-speed bridge circuit for InGaAs avalanche photodiode single-photon detector

Hirofumi Hashimoto, Akihisa Tomita, Atsushi Okamoto

Because of low power consumption and small footprint, avalanche photodiodes (APD) have been commonly applied to photon detection. Recently, high speed quantum communication has been demonstrated for high bit-rate quantum key distribution. For the high speed quantum communication, photon detectors should operate at GHz-clock frequencies. We propose balanced detection circuits for GHz-clock operation of InGaAs-APD photon detectors. The balanced single photon detector operates with sinusoidal wave gating. The sinusoidal wave appearing in the output is removed by the subtraction from APD signal without sharp band-elimination filters. Omission of the sharp filters removes the constraint on the operating frequency of the single photon detector. We present two designs, one works with two identical APDs, the other with one APD and a low-pass filter. The sinusoidal gating enables to eliminate the gating noise even with the simple configuration of the latter design. We demonstrated the balanced single photon detector operating with 1.020GHz clock at 233 K, 193 K, and 186.5 K. The dark count probability was 4.0 x 10-4 counts/pulse with the quantum efficiency of 10% at 233K, and 1.6 x 10-4 counts/pulse at 186.5 K. These results were obtained with easily available APDs (NR8300FP-C.C, RENESASS) originally developed for optical time-domain reflectmeters.

Proceedings of SPIE, the International Society for Optical Engineering/Proceedings of SPIE•Feb 19, 2014•2 citations

High-speed bridge circuit for InGaAs avalanche photodiode single-photon detector

Hirofumi Hashimoto, Akihisa Tomita, Atsushi Okamoto

Because of low power consumption and small footprint, avalanche photodiodes (APD) have been commonly applied to photon detection. Recently, high speed quantum communication has been demonstrated for high bit-rate quantum key distribution. For the high speed quantum communication, photon detectors should operate at GHz-clock frequencies. We propose balanced detection circuits for GHz-clock operation of InGaAs-APD photon detectors. The balanced single photon detector operates with sinusoidal wave gating. The sinusoidal wave appearing in the output is removed by the subtraction from APD signal without sharp band-elimination filters. Omission of the sharp filters removes the constraint on the operating frequency of the single photon detector. We present two designs, one works with two identical APDs, the other with one APD and a low-pass filter. The sinusoidal gating enables to eliminate the gating noise even with the simple configuration of the latter design. We demonstrated the balanced single photon detector operating with 1.020GHz clock at 233 K, 193 K, and 186.5 K. The dark count probability was 4.0 x 10-4 counts/pulse with the quantum efficiency of 10% at 233K, and 1.6 x 10-4 counts/pulse at 186.5 K. These results were obtained with easily available APDs (NR8300FP-C.C, RENESASS) originally developed for optical time-domain reflectmeters.

Proceedings of SPIE, the International Society for Optical Engineering/Proceedings of SPIE•Jan 1, 2014•0 citations
In order to improve the sensitivity of single-photon detection systems,InGaAs/InP avalanche photodiode(InGaAs/InP APD) is used in the design of single photon detector of quantum communication.Single photon detector bias generation circuit in gate pulse mode,single-photon signal amplification circuit,single photon signal detection circuit and temperature control module were realized.By selecting high-precision OP37 preamplifier and precision comparator AD8561,quantum efficiency was increased to 18.3%,dark count was controlled within 4.1 × 10-6/ns.
A single-photon detection system with laser of 1310nm wavelength as light source is designed. Using InGaAs Avalanche Photodiode (InGaAs-APD) as single-photon detection device for quantum cryptography communication, the bias-voltage formation, low-temperature control and single-photon signal detection are comprehensively considered. The photon gate formed by pulse superimposed on DC level is equivalently performed by monostable circuit in pulse generator. Detection sensitivity of the system is improved by using a trans-impedance pre-amplifier and a precision comparator. The detection experiments in initial stage show that the waveform of -93dBm light signal can be observed by the detection system.
In our experiment, two InGaAs/InP avalanche photodiodes (APD) were used in the quantum key distribution (QKD) system for single-photon detection at telecom communication wavelength (1310/1550 nm). By using properly designed passive-quenching circuit, the photo-detection efficiency of the APD could reach 10% at 1550 nm. In order to decrease the dark count rate efficiently, we designed a coincident counting circuits for single-photon detection. Before the APD signals were sent to the signal processing circuit, the avalanche signals were amplified and shaped into the TTL pulses. In order to obtain an accurate and efficient data acquisition and to transfer synchronically several signals such as the TTL signals and pulses from Random generators, we designed a signal processing circuit with the parallel port whose speed limitation is about 100Kb/s. In our experiments of single-photon interference and quantum cryptography, the electronic designs presented us satisfactory performance and results. To achieve much higher speed for the data acquisition, we also employed the Universal Serial Bus System (USB2.0) to interface our single-photon avalanche detectors and random generators used in our QKD system, which was believed to improve the performance of QKD such as the key distribution speed.
Abstract In order to realize long‐distance quantum cryptography based on standard optical fiber network, we have developed a single‐photon detector at 1550 nm using InGaAs/InP avalanche photodiodes (APDs). To reduce the dark count probability, APDs were cooled and operated with a Gated Passive Quenching Circuit. A quantum efficiency of 13.7% was obtained at −55 °C while keeping the dark count probability per gate (2 ns) as low as 2.4 × 10−5. In this paper we will discuss the performance of the developed single‐photon detector in view of application to quantum cryptography. © 2003 Wiley Periodicals, Inc. Electron Comm Jpn Pt 2, 86(5): 10–15, 2003; Published online in Wiley InterScience ( www.interscience.wiley.com ). DOI 10.1002/ecjb.10115
We present the design and construction of a high-speed telecom-band (1.5 μm) single-photon counting system based on an InGaAs/InP avalanche photodiode (APD) operating in the gated Geiger mode. The detector can be gated at high speeds (we examine its performance up to 25 MHz) to maximize the counting rate in long-distance, telecom-band, fiber-optic quantum communication applications. Narrow gate pulses (250 ps full width at half maximum) are used to reduce the dark-count and the after-pulse probability. In order to count the avalanche events, we employ a high-speed comparator to sample the unfiltered and unamplified avalanche photocurrent. The APD and all the associated electronics are integrated onto a printed circuit board with a computer interface. In addition, we cool the APD to -27°C to reduce the dark-count probability.
Because of low power consumption and small footprint, avalanche photodiodes (APD) have been commonly applied to photon detection. Recently, high speed quantum communication has been demonstrated for high bit-rate quantum key distribution. For the high speed quantum communication, photon detectors should operate at GHz-clock frequencies. We propose balanced detection circuits for GHz-clock operation of InGaAs-APD photon detectors. The balanced single photon detector operates with sinusoidal wave gating. The sinusoidal wave appearing in the output is removed by the subtraction from APD signal without sharp band-elimination filters. Omission of the sharp filters removes the constraint on the operating frequency of the single photon detector. We present two designs, one works with two identical APDs, the other with one APD and a low-pass filter. The sinusoidal gating enables to eliminate the gating noise even with the simple configuration of the latter design. We demonstrated the balanced single photon detector operating with 1.020GHz clock at 233 K, 193 K, and 186.5 K. The dark count probability was 4.0 x 10-4 counts/pulse with the quantum efficiency of 10% at 233K, and 1.6 x 10-4 counts/pulse at 186.5 K. These results were obtained with easily available APDs (NR8300FP-C.C, RENESASS) originally developed for optical time-domain reflectmeters.
Because of low power consumption and small footprint, avalanche photodiodes (APD) have been commonly applied to photon detection. Recently, high speed quantum communication has been demonstrated for high bit-rate quantum key distribution. For the high speed quantum communication, photon detectors should operate at GHz-clock frequencies. We propose balanced detection circuits for GHz-clock operation of InGaAs-APD photon detectors. The balanced single photon detector operates with sinusoidal wave gating. The sinusoidal wave appearing in the output is removed by the subtraction from APD signal without sharp band-elimination filters. Omission of the sharp filters removes the constraint on the operating frequency of the single photon detector. We present two designs, one works with two identical APDs, the other with one APD and a low-pass filter. The sinusoidal gating enables to eliminate the gating noise even with the simple configuration of the latter design. We demonstrated the balanced single photon detector operating with 1.020GHz clock at 233 K, 193 K, and 186.5 K. The dark count probability was 4.0 x 10-4 counts/pulse with the quantum efficiency of 10% at 233K, and 1.6 x 10-4 counts/pulse at 186.5 K. These results were obtained with easily available APDs (NR8300FP-C.C, RENESASS) originally developed for optical time-domain reflectmeters.