Abstract : Single photons sources are desired for many potential quantum information applications. One common method to produce single photons is based on a heralding protocol, which involves generating a pair of photons in an optical nonlinear medium and then detecting one photon in the pair to announce the existence of the other photon of the pair. Compared to other schemes, such a method offers several significant advantages. A major challenge to overcome which is inherent to this method, however, is that the photon pairs are created stochastically in the optical nonlinear medium. Thus, in order to ensure high purity levels for the single photons generated via heralding, sources of this type must be operated at low photon-pair production rates in order to keep the probability for simultaneous creation of multiple photon-pairs to an acceptably low level. A direct result of this restriction is a low heralding rate of single photons. A potential solution for achieving high-rate, high-purity, single-photon generation combines several heralding single-photon sources which are actively multiplexed to act as one source. The overall goal of this project is to develop methods to perform such multiplexing based on the use of a low loss high speed fiber optical switch.
Abstract : Single photons sources are desired for many potential quantum information applications. One common method to produce single photons is based on a heralding protocol, which involves generating a pair of photons in an optical nonlinear medium and then detecting one photon in the pair to announce the existence of the other photon of the pair. Compared to other schemes, such a method offers several significant advantages. A major challenge to overcome which is inherent to this method, however, is that the photon pairs are created stochastically in the optical nonlinear medium. Thus, in order to ensure high purity levels for the single photons generated via heralding, sources of this type must be operated at low photon-pair production rates in order to keep the probability for simultaneous creation of multiple photon-pairs to an acceptably low level. A direct result of this restriction is a low heralding rate of single photons. A potential solution for achieving high-rate, high-purity, single-photon generation combines several heralding single-photon sources which are actively multiplexed to act as one source. The overall goal of this project is to develop methods to perform such multiplexing based on the use of a low loss high speed fiber optical switch.
Single-photon sources based on spontaneous photon-pair generation have enabled pioneering experiments in quantum physics. However, next-generation photonic quantum technologies require higher generation probabilities of photons in well-controlled pure states capable of high-visibility interference. We have harnessed bespoke fiber technology to develop virtually alignment-free sources that deliver high-purity heralded single photons in telecoms single-mode fiber. The resulting access to low-loss optical delay enabled us to actively route the heralded output from two almost identical sources to enhance the delivery probability of single photons relative to one individual source. Our results indicate how the scale of photonic quantum technologies might be increased via guided-wave multiplexing of high-purity photons.
Current sources of heralded single photons based on nonlinear optics operate in a probabilistic manner. In order to build quantum-enhanced devices based around the use of single photons, compact, turn-key and deterministic sources are required. A possible solution is to multiplex a number of sources to increase the single-photon generation probability and in so doing reducing the waiting time to deliver large numbers of photons simultaneously, from independent sources. Previously it has been shown that, in the ideal case, 17 multiplexed sources allow deterministic generation of heralded single photons [Christ and Silberhorn, Phys. Rev. A 85, 023829 (2012)]. Here we extend this analysis to include undesirable effects of detector inefficiency and photon loss on a number of multiplexed sources using a variety of different detectors for heralding. We compare these systems for fixed signal-to-noise ratio to allow a direct comparison of performance for real- world heralded single photon sources.
Two important challenges in quantum photonics are to generate useful states with high fidelity, and to detect them and verify their properties. Particularly valuable states are single photons and entangled photon pairs in well-defined optical modes, as they can be used in many quantum information protocols or used to build up more complex states. For sources, we employ integrated nonlinear optics (waveguides in lithium niobite and potassium titanyl phosphate) to maximize brightness and go beyond what is possible in bulk optics, showing simultaneously high state fidelity, heralding efficiency, and spectral purity across three experiments: first we show record heralding efficiency in a fully-fibered heralded single-photon source, and use it to probe the tradeoff between spectral purity and heralding efficiency in non-engineered sources. With an engineered source, we then herald up to 50 photons in a nonclassical state. The last source is for polarization-entangled photon pairs, with brightness of 3.5 million pairs/s·mW, fidelity to a Bell state of 96%, heralding efficiency of 43%, and HOM interference visibility of 82%. Once a complex state is constructed, it must also be verified. For this we employ a time-multiplexed detector consisting of a fibre loop and a single-photon detector. Surprisingly, we are able to extract information even in the saturation regime of the detector. We use the click statistics of the time-multiplexed detector to verify the non-classicality of quantum light, and we use its extremely high dynamic range (123 dB) to measure a macroscopic power level with a single-photon detector. Eliminating calibrated attenuators with this approach will allow direct standardization of quantum and classical optical power levels.
The preparation of single photons in a pure quantum state is a subject of great interest in physics, enabling the control of light at an unprecedented level. The ease with which certain degrees of freedom of photon states, such as polarisation, can be manipulated, along with the inherent resilience of photons to decoherence, makes them well suited for use as qubits. Recent rapid developments in the transmission and processing of quantum information, as well as the likely technological impact of potential real-world applications such as quantum cryptography and quantum computation, mean that the demand for high performance single photon sources is likely to increase in the near future. One approach to producing single photon states, which are known to be in a well-defined spatio-temporal mode without destructively measuring them, is to take advantage of nonlinear optics. Nonlinear processes can be used to realise frequency conversion by generating a single, correlated pair of photons from an intense pump laser source. The detection of one of the photons from a pair can then be used to indicate the presence of the other photon in the pair, a procedure known as heralding. This thesis describes the development of a source of heralded single photons at 1550 nm, generated directly in the core of a photonic crystal fibre (PCF). By taking advantage of low loss fibre components for the required spectral filtering of the generated photon state, a heralding fidelity of 52% was achieved. The source was designed to be used with a picosecond pulsed fibre laser, making it relatively low cost and maintenance free. With 148 mW of average pump power a heralded output photon rate of 6.4 × 104 s-1 was observed, demonstrating the brightness of the source. The purity of the generated single photons was established by measuring non-classical interference, with a visibility of 70%, between the photons output from this source and a source based on a PPLN waveguide. The fabrication of a series of birefringent PCFs for the generation of spectrally pure state photons at 1550 nm is also discussed. These PCFs will be useful for incorporation in the next generation of high performance, fibre-based photon sources.
Abstract : An on-demand single-photon source is a key requirement for scaling many optical quantum technologies. A promising approach to realize an on-demand single-photon source is to multiplex an array of heralded single-photon sources using an active optical switching network. However, the performance of multiplexed sources is degraded by photon loss in the optical components and the non-unit detection efficiency of the heralding detectors. We provide a theoretical description of a general multiplexed single-photon source with lossy components and derive expressions for the output probabilities of single-photon emission and multi-photon contamination. We apply these expressions to three specific multiplexing source architectures and consider their tradeoffs in design and performance. To assess the effect of lossy components on near- and long-term experimental goals, we simulate the multiplexed sources when used for many-photon state generation under various amounts of component loss. We find that with a multiplexed source composed of switches with0.20.4 dB loss and high efficiency number-resolving detectors, a single-photon source capable of efficiently producing 2040 photon states with low multi-photon contamination is possible, offering the possibility of unlocking new classes of experiments and technologies.
The field of quantum optics offers the intriguing possibility of developing new, potentially ground-breaking technologies based on the laws of quantum physics. Single quanta of light, called photons, are at the heart of many such quantum optical technologies. They can serve, for example, as information carriers in quantum cryptography and in quantum-information processing. If such applications are to fulfill their enormous potential, it is essential to have sources available that provide photons in the required quantum states. An established way of generating states of single photons is based on photon-pair sources. In this approach, the detection of one photon of a pair heralds the presence of the partner photon, which can then be further processed. However, to generate heralded photons in pure quantum states, specific conditions have to be met, making the design and implementation of such sources challenging. This thesis presents two new photon-pair sources that allow the heralded generation of single photons with high purity. Both sources are based on optical fiber, which allows high collection efficiencies for the generated states and opens the possibility of easy integration into modern-day fiber networks. Chapter 1 provides an introduction to quantum optical technologies and gives a short overview of current approaches to generate pure single photons. Chapter 2 presents the basic theory on which the experimental work presented in Chapters 3 and 4 is based. It explains the concept of a spectrally broad single photon and how photon purity can be tested using Hong-Ou-Mandel (HOM) interference. Subsequently, the properties of photon-pair states and the heralded generation of single photons from such states are discussed. It is shown that for a heralded photon to be pure, the original photon pair has to be in a factorable state, that is, free of any correlations. The introduced theory is then applied to spontaneous four-wave mixing (SFWM) in optical fibers, a nonlinear process that allows the generation of photon pairs. It is shown how the factorability of the created pairs depends on the fiber's dispersion properties, and the necessary conditions for the generation of factorable states are derived. The chapter concludes with an analysis of the photon statistics of the four-wave mixing process, explaining how statistics and the g(2) correlation function can be used to evaluate the factorability of the SFWM output state. Chapters 3 and 4 contain the main results of this thesis. Chapter 3 presents the first spectrally decorrelated photon-pair source bridging the visible and telecommunication wavelength ranges. The photon pairs are generated by SFWM in a photonic crystal fiber (PCF). The chapter documents the procedure of how the PCF source was designed and fabricated, as well as its characterization based on spectral measurements and photon statistics. One photon of the pair state is generated in the visible at 513.5 nm, where it can be efficiently detected with silicon-based single-photon detectors. It serves as a herald for its broadband partner photon, which is emitted in the telecom wavelength range at 1547 nm. A spectral coincidence measurement shows that the heralded photon exhibits a purity of up to 0.82. At increased pump powers, even the heralded generation of higher photon-number states in the telecom band becomes feasible. In Chapter 4, we use commercial birefringent fiber to herald high-purity photons of picosecond duration at 848 nm. The presented two-source HOM interference experiment shows that the heralded unfiltered state has a purity of at least 0.73. This value is increased to 0.84 with the application of wavelength filters suppressing low-intensity side peaks in the spectrum. The heralded photons are coupled into a single-mode fiber with an efficiency of 85%, the highest reported value to date for factorable sources. It is also shown that a commercial polarization controller can be used to fine-tune the generated wavelengths. This facilitates matching photons from multiple sources, as required for optical quantum computing schemes. Chapter 5 summarizes all results and provides an outlook toward potential future projects.