Challenges
Datasets
Workspaces
Papers
Discussions
Leaderboard
Log inSign up
Challenges
Datasets
Workspaces
Papers
Discussions
Leaderboard
Blog
Job Board
Q3AS

© 2026 Aqora Quantum S.A.S.

TermsPrivacyLegal Notice

International Journal of Electronics

Parametric effects in thin film niobium Josephson junctions

M. DENSHAM, Aaron Beck

Published Oct 1, 1974• 0 citations
Publisher

Abstract

This paper considers some of the problems that are encountered in the fabrication of thin film niobium Josephson junctions, and discusses the characteristics of the excess currents. A magnetic field is applied to test the uniformity of the oxide layar, and the plasma resonance is observed by mixing two microwave signals in the junction non-linearities.

DOI
10.1080/00207217408900548

Related papers

Harmonic mixing in thin film niobium nitride Josephson tunnel junctions

M. C. Wicks

Beats between the harmonics of a microwave signal and various submillimetre laser lines above 890 GHz have been observed in the output from NbN Josephson junctions. Results of these mixing experiments will be described and discussed.

International Conference on Infrared, Millimeter, and Terahertz Waves (IRMMW-THz)•Dec 1, 1990•1 citation

Microwave and superconducting techniques for measurements on unconventional Josephson junctions

Georgina M. Klemencic

The frst part of the thesis describes the instrumentation, testing and analysis of a planar circuit designed for the measurement of the current-phase relationship of niobium-cobalt-insulator-niobium Josephson junctions. A detailed analysis method and fitting routine was developed but the results show that an irreducible mutual inductance places a limit on the accuracy of the chip for the intended measurement. The second part describes a study of the magnetic and microwave properties of a range of thin film niobium coplanar resonators with cobalt and normal metal layers. Magnetic measurements show a magnetic dead layer of 1.3 nm. The observed microwave losses are found to be two orders of magnitude higher than for high quality niobium films. Computer simulation shows that this is mainly due to conductive, rather than magnetic losses, and is in good agreement with the observed proportionality to cobalt thickness. Measurements of the temperature and magnetic field dependence of the losses and resonant frequency as a function of the cobalt thickness show no signs of the oscillatory thickness dependence reported in a number of other experiments. The temperature dependence of all films is found to be in good agreement with Mattis-Bardeen theory.

•Jul 1, 2013•1 citation

Observation of electromagnetic coupling to a closed superconducting thin-film cavity

C.D. Thomas, Melville P. Ulmer, John B. Ketterson

We have studied Josephson junctions coupled to closed, superconducting, thin-film cavities. We briefly discuss the coupling mechanism in this system as well as the fabrication methods and expected resonant modes. Cavities consisting of both quartz and anodized niobium were studied. Small current steps have been observed in the current-voltage (I-V) measurements of junctions at voltages corresponding to the calculated modes of the closed cavity indicating Josephson coupling.

IEEE Transactions on Applied Superconductivity•Jun 1, 2000•0 citations

Microwave phenomena in thin- film Josephson junctions coupled to a contiguous microstrip resonator

Thomas F. Finnegan, Louis B. Holdeman, S. Wahlsten

A half-wavelength microstrip resonator has been used to couple microwave radiation between Josephson junctions and an external 50 Ω transmission line, and various microwave properties of these resonator-coupled junction devices have been studied. The advantages of these devices in applications including coherent radiation emission, 2e/h precision voltage sources, and parametric plasma-related effects are described.

IEEE Transactions on Magnetics•Jan 1, 1977•3 citations

Josephson soliton oscillators in a superconducting thin film resonator

J. Holm, J. Mygind, N. F. Pedersen +3 more

Josephson soliton oscillators integrated in a resonator consisting of two closely spaced coplanar superconducting microstrips have been investigated experimentally. Pairs of long 1-D Josephson junctions with a current density of about 1000 A/cm/sup 2/ were made using the Nb-AlO/sub x/-Nb trilayer technique. Different modes of half-wave resonances in the thin-film structure impose different magnetic field configurations at the boundaries of the junctions. The DC I-V characteristic shows zero-field steps with a number of resonator-induced steps. These structures are compared to RF-induced steps generated by phase-locking of the soliton motion to an external microwave source. The two different resonant configurations identified may be interpreted as a coupling to the microwave field at the end boundary and as a more homogeneous coupling distributed over the junction length.>

IEEE Transactions on Applied Superconductivity•Mar 1, 1993•1 citation

Far infrared detection with Josephson junctions. Final report

C. K. So, William O. Hamilton

The response of Josephson junctions to microwave and far infrared radiation was studied. Junctions are formed by pressing a Nb or Nb-Ti pointed wire onto a Nb thin film which in turn is pressed against the open end of a waveguide. Electromagnetic radiation is applied through the back of the film so that only the wave magnetic field is coupled to the junctions. The change of the dc Josephson current is monitored at different levels of microwave power over a frequency range from 22GHz to 105GHz. The dependence of the responsivity of these current on film thickness over a range from 50 A to 500 A was studied. The observed responsivity agrees very well with that predicted by theory. Higher responsivity is observed for thinner films and lower microwave frequencies.

•Dec 1, 1976•0 citations
This paper considers some of the problems that are encountered in the fabrication of thin film niobium Josephson junctions, and discusses the characteristics of the excess currents. A magnetic field is applied to test the uniformity of the oxide layar, and the plasma resonance is observed by mixing two microwave signals in the junction non-linearities.
The frst part of the thesis describes the instrumentation, testing and analysis of a planar circuit designed for the measurement of the current-phase relationship of niobium-cobalt-insulator-niobium Josephson junctions. A detailed analysis method and fitting routine was developed but the results show that an irreducible mutual inductance places a limit on the accuracy of the chip for the intended measurement. The second part describes a study of the magnetic and microwave properties of a range of thin film niobium coplanar resonators with cobalt and normal metal layers. Magnetic measurements show a magnetic dead layer of 1.3 nm. The observed microwave losses are found to be two orders of magnitude higher than for high quality niobium films. Computer simulation shows that this is mainly due to conductive, rather than magnetic losses, and is in good agreement with the observed proportionality to cobalt thickness. Measurements of the temperature and magnetic field dependence of the losses and resonant frequency as a function of the cobalt thickness show no signs of the oscillatory thickness dependence reported in a number of other experiments. The temperature dependence of all films is found to be in good agreement with Mattis-Bardeen theory.
Josephson soliton oscillators integrated in a resonator consisting of two closely spaced coplanar superconducting microstrips have been investigated experimentally. Pairs of long 1-D Josephson junctions with a current density of about 1000 A/cm/sup 2/ were made using the Nb-AlO/sub x/-Nb trilayer technique. Different modes of half-wave resonances in the thin-film structure impose different magnetic field configurations at the boundaries of the junctions. The DC I-V characteristic shows zero-field steps with a number of resonator-induced steps. These structures are compared to RF-induced steps generated by phase-locking of the soliton motion to an external microwave source. The two different resonant configurations identified may be interpreted as a coupling to the microwave field at the end boundary and as a more homogeneous coupling distributed over the junction length.>
The response of Josephson junctions to microwave and far infrared radiation was studied. Junctions are formed by pressing a Nb or Nb-Ti pointed wire onto a Nb thin film which in turn is pressed against the open end of a waveguide. Electromagnetic radiation is applied through the back of the film so that only the wave magnetic field is coupled to the junctions. The change of the dc Josephson current is monitored at different levels of microwave power over a frequency range from 22GHz to 105GHz. The dependence of the responsivity of these current on film thickness over a range from 50 A to 500 A was studied. The observed responsivity agrees very well with that predicted by theory. Higher responsivity is observed for thinner films and lower microwave frequencies.