Challenges
Datasets
Workspaces
Papers
Discussions
Leaderboard
Log inSign up
Challenges
Datasets
Workspaces
Papers
Discussions
Leaderboard
Blog
Job Board
Q3AS

© 2026 Aqora Quantum S.A.S.

TermsPrivacyLegal Notice

IEEE Transactions on Applied Superconductivity

Observation of electromagnetic coupling to a closed superconducting thin-film cavity

C.D. Thomas, Melville P. Ulmer, John B. Ketterson

Published Jun 1, 2000• 0 citations
Publisher

Abstract

We have studied Josephson junctions coupled to closed, superconducting, thin-film cavities. We briefly discuss the coupling mechanism in this system as well as the fabrication methods and expected resonant modes. Cavities consisting of both quartz and anodized niobium were studied. Small current steps have been observed in the current-voltage (I-V) measurements of junctions at voltages corresponding to the calculated modes of the closed cavity indicating Josephson coupling.

DOI
10.1109/77.848313

Related papers

Josephson soliton oscillators in a superconducting thin film resonator

J. Holm, J. Mygind, N. F. Pedersen +3 more

Josephson soliton oscillators integrated in a resonator consisting of two closely spaced coplanar superconducting microstrips have been investigated experimentally. Pairs of long 1-D Josephson junctions with a current density of about 1000 A/cm/sup 2/ were made using the Nb-AlO/sub x/-Nb trilayer technique. Different modes of half-wave resonances in the thin-film structure impose different magnetic field configurations at the boundaries of the junctions. The DC I-V characteristic shows zero-field steps with a number of resonator-induced steps. These structures are compared to RF-induced steps generated by phase-locking of the soliton motion to an external microwave source. The two different resonant configurations identified may be interpreted as a coupling to the microwave field at the end boundary and as a more homogeneous coupling distributed over the junction length.>

IEEE Transactions on Applied Superconductivity•Mar 1, 1993•1 citation

Superconducting microwave cavities and Josephson junctions

T. I. Smith

The possibility of using very-high-Q superconducting microwave cavities to obtain a strong coupling between the electromagnetic field and a Josephson junction has prompted a study of such systems. Expressions have been obtained describing the dc I-V characteristic of a junction biased so that the Josephson radiation frequency is near a resonance of the cavity in which it is located. The rf power coupled into an X-band (10 GHz) TE011 mode cavity from a weakly coupled junction is approximately 3×10−13 I02 Q W, where I0 is the critical current of the junction and Q is the cavity Q. When the coupling between the junction and cavity is large enough, the I-V characteristic becomes multiple valued and the power coupled to the cavity depends on the state of the system. The maximum power which can be coupled to the cavity is approximately 0.58I0Vdc, where Vdc is the voltage required to bias the junction to the resonant frequency of the cavity.

Journal of Applied Physics•Apr 1, 1974•9 citations

Parametric effects in thin film niobium Josephson junctions

M. DENSHAM, Aaron Beck

This paper considers some of the problems that are encountered in the fabrication of thin film niobium Josephson junctions, and discusses the characteristics of the excess currents. A magnetic field is applied to test the uniformity of the oxide layar, and the plasma resonance is observed by mixing two microwave signals in the junction non-linearities.

International Journal of Electronics•Oct 1, 1974•0 citations

Topics in the physics of underdamped Josephson systems

I. Tornes

We describe a variety of models to characterize the behavior of several types of underdamped Josephson systems.We also present numerical results based on these models.We first discuss a stack of small junctions in a single mode resonant cavity.Such a stack is believed to be appropriate to model some high temperature cuprate superconductors such as Bi 2 Sr 2 CaCu 2 O 8+x .Our results show self-induced-resonant-steps in the current voltage (IV) curve.These steps represent a coherent phase locking between the junctions in the stack and the resonant cavity.Next we generalize these results to treat a single long junction coupled to a single mode resonant cavity.We find a number of features not seen in stacks of small junctions.Our numerical results show that if the electromagnetic fields of the cavity mode are spatially periodic, we again see steps in the IV curve and furthermore, for sufficiently large coupling, the cavity frequency is shifted by coupling to the long junction.We also discuss how a stack of long junctions could be used to model a layered high temperature superconductor.We then turn to some properties of single junctions in the "quantum" regime where the phase/number non-commutation is important.This quantum regime is crucial to all proposals to use such junctions as solid state quantum bits (qubits).We show that such qubits, when subjected to external a.c.perturbations, exhibit not only . . . . . . . . . .

•Jan 1, 2006•0 citations

The stripline coupling of thin-film josephson junctions to external circuits at microwave frequencies

Y. Sirkeinen, P. Somervuo, T. Wiik

A certain way of coupling to the thin-film Josephson tunneling junction has been studied. The coupling structure comprises a superconducting stripline which is terminated to the edge of the Nb-oxide-Pb junction. A mismatch of 23 dB has been obtained so far between the signal source and the junction at X-band compared to the earlier estimates of 40 dB between conventional size outer circuits and the junction. Prospects for improving the coupling are good. Methods of estimating the voltage and power which are coupled to the junction are given.

Revue de Physique Appliquée•Jan 1, 1974•5 citations

Observation of the intrinsic noise of a thin−film microbridge Josephson junction

S. S. Pei, James E. Lukens

We have measured the intrinsic noise of a thin−film microbridge Josephson junction included as part of a closed superconducting ring. This microbridge, which was fabricated using electron beam lithography and has submicron dimensions, exhibited a noise magnitude which was in excellent agreement with that predicted for an ideal Josephson junction.

Applied Physics Letters•Apr 15, 1975•2 citations
We have studied Josephson junctions coupled to closed, superconducting, thin-film cavities. We briefly discuss the coupling mechanism in this system as well as the fabrication methods and expected resonant modes. Cavities consisting of both quartz and anodized niobium were studied. Small current steps have been observed in the current-voltage (I-V) measurements of junctions at voltages corresponding to the calculated modes of the closed cavity indicating Josephson coupling.
Josephson soliton oscillators integrated in a resonator consisting of two closely spaced coplanar superconducting microstrips have been investigated experimentally. Pairs of long 1-D Josephson junctions with a current density of about 1000 A/cm/sup 2/ were made using the Nb-AlO/sub x/-Nb trilayer technique. Different modes of half-wave resonances in the thin-film structure impose different magnetic field configurations at the boundaries of the junctions. The DC I-V characteristic shows zero-field steps with a number of resonator-induced steps. These structures are compared to RF-induced steps generated by phase-locking of the soliton motion to an external microwave source. The two different resonant configurations identified may be interpreted as a coupling to the microwave field at the end boundary and as a more homogeneous coupling distributed over the junction length.>
The possibility of using very-high-Q superconducting microwave cavities to obtain a strong coupling between the electromagnetic field and a Josephson junction has prompted a study of such systems. Expressions have been obtained describing the dc I-V characteristic of a junction biased so that the Josephson radiation frequency is near a resonance of the cavity in which it is located. The rf power coupled into an X-band (10 GHz) TE011 mode cavity from a weakly coupled junction is approximately 3×10−13 I02 Q W, where I0 is the critical current of the junction and Q is the cavity Q. When the coupling between the junction and cavity is large enough, the I-V characteristic becomes multiple valued and the power coupled to the cavity depends on the state of the system. The maximum power which can be coupled to the cavity is approximately 0.58I0Vdc, where Vdc is the voltage required to bias the junction to the resonant frequency of the cavity.
We describe a variety of models to characterize the behavior of several types of underdamped Josephson systems.We also present numerical results based on these models.We first discuss a stack of small junctions in a single mode resonant cavity.Such a stack is believed to be appropriate to model some high temperature cuprate superconductors such as Bi 2 Sr 2 CaCu 2 O 8+x .Our results show self-induced-resonant-steps in the current voltage (IV) curve.These steps represent a coherent phase locking between the junctions in the stack and the resonant cavity.Next we generalize these results to treat a single long junction coupled to a single mode resonant cavity.We find a number of features not seen in stacks of small junctions.Our numerical results show that if the electromagnetic fields of the cavity mode are spatially periodic, we again see steps in the IV curve and furthermore, for sufficiently large coupling, the cavity frequency is shifted by coupling to the long junction.We also discuss how a stack of long junctions could be used to model a layered high temperature superconductor.We then turn to some properties of single junctions in the "quantum" regime where the phase/number non-commutation is important.This quantum regime is crucial to all proposals to use such junctions as solid state quantum bits (qubits).We show that such qubits, when subjected to external a.c.perturbations, exhibit not only . . . . . . . . . .
A certain way of coupling to the thin-film Josephson tunneling junction has been studied. The coupling structure comprises a superconducting stripline which is terminated to the edge of the Nb-oxide-Pb junction. A mismatch of 23 dB has been obtained so far between the signal source and the junction at X-band compared to the earlier estimates of 40 dB between conventional size outer circuits and the junction. Prospects for improving the coupling are good. Methods of estimating the voltage and power which are coupled to the junction are given.