Challenges
Datasets
Workspaces
Papers
Discussions
Leaderboard
Log inSign up
Challenges
Datasets
Workspaces
Papers
Discussions
Leaderboard
Blog
Job Board
Q3AS

© 2026 Aqora Quantum S.A.S.

TermsPrivacyLegal Notice

Review of Scientific Instruments

Measurement and control of residual amplitude modulation in optical phase modulation

Liufeng Li, Fang Liu, Wang Chun, Lisheng Chen

Published Apr 1, 2012• 77 citations
Publisher

Abstract

Residual amplitude modulation is one of the major sources of instability in ultra-sensitive optical detections based on frequency modulation. Using a MgO·LiNbO(3) electro-optic crystal, we systematically measure the temperature and polarization dependence of residual amplitude modulation and our experimental results are in good agreement with a previous theoretical analysis. After optical phase modulation, two independent arms including optical detection and frequency demodulation are employed to closely examine the instability of the residual amplitude modulation. Residual amplitude modulation below 25 ppm is obtained with an active cancellation scheme in which the crystal temperature is varied so as to zero the baseline drifts with different origins. Possible improvements for better suppression and stability are discussed.

DOI
10.1063/1.4704084

Related papers

Suppressing residual amplitude modulation to the 10−7 level in optical phase modulation

Jin Bi, Yunlin Zhi, Liufeng Li +1 more

Residual amplitude modulation is one of the major stability-degrading factors in many precision measurements. Using an electro-optic (EO) crystal with wedged input and output surfaces is an effective way to suppress residual amplitude modulation. Here the mechanism of residual amplitude modulation in this approach is investigated. The residual amplitude modulations measured in standard and wedged EO crystals bear similarities in their temperature and polarization dependences, implying that a mixture of the two orthogonal polarizations in the extraordinary light is responsible for the residual amplitude modulation in the wedged EO crystal. Similar to a standard EO crystal, a non-uniform spatial distribution of residual amplitude modulation is also observed in the extraordinary light emerging from the wedged EO crystal. The optical isolator after the EO crystal is replaced by a Faraday rotator, and an improvement in the long-term stability is observed. With the wedged-crystal approach, residual amplitude modulation as low as 2×10−7 is observed, contributing a frequency instability of 8×10−18 (500 s) in Pound–Drever–Hall frequency stabilization with a discrimination slope of 1×10−4 V/Hz.

Applied Optics•Jan 16, 2019•38 citations

Polarization dependent photorefractive amplitude modulation production in MgO:LiNbO3 phase modulators

Juna Sathian, Esa A. Jaatinen

We present experimental and theoretical results of the intensity dependence of residual amplitude modulation (RAM) production in electro-optic phase modulators. By utilizing the anisotropy of the medium, we show that RAM has a photorefractive origin.

•Aug 1, 2011•5 citations

Characterization of a Two-Photon Rubidium-87 Optical Clock

Sophia Rojas

Atomic clocks are based on highly stable and well-characterized atomic transitions, mak-ing precise control and understanding of systematic frequency shifts essential for improved timekeeping performance. This thesis presents an experimental study of light-induced Stark shifts in rubidium and their impact on precision laser spectroscopy relevant to atomic frequency standards, as well as the effects of residual amplitude modulation on the laser lock point and the resulting sensitivity of both short- and long-term stability. A laser-based spectroscopy system was developed to probe rubidium transitions while enabling controlled variation of optical intensity. The optical beam was experimentally characterized through calculations of beam waist and measurements of power to accurately determine the intensity at the interaction region. Frequency shifts arising from the AC Stark effect were measured as a function of optical power, allowing extraction of the differential polarizability between atomic energy levels using a theoretical model relating energy shifts to electric-field intensity. Uncertainty analysis was performed through systematic propagation of experimental errors associated with beam geometry, optical power calibration, and frequency measurements. In addition, residual amplitude modulation generated by electro-optic phase modulation was investigated as a significant source of systematic error in frequency stabilization systems used in atomic clocks. The magnitude and behavior of RAM were experimentally characterized, and its impact on frequency stability was quantified by measuring the sensitivity of the laser lock point to controlled variations in RAM. Potential mitigation strategies were then explored through active pre-compensation of RAM using an amplitude electro-optic modulator in a closed-loop feedback system.

•Jan 1, 2026•0 citations

Reducing residual amplitude modulation in electro-optic phase modulators by erasing photorefractive scatter

Juna Sathian, Esa A. Jaatinen

Residual amplitude modulation (RAM) is an unwanted noise source in electro-optic phase modulators. The analysis presented shows that while the magnitude of the RAM produced by a MgO:LiNbO(3) modulator increases with intensity, its associated phase becomes less well defined. This combination results in temporal fluctuations in RAM that increase with intensity. This behavior is explained by the presented phenomenological model based on gradually evolving photorefractive scattering centers randomly distributed throughout the optically thick medium. This understanding is exploited to show that RAM can be reduced to below the 10(-5) level by introducing an intense optical beam to erase the photorefractive scatter.

Optics Express•May 13, 2013•25 citations

Investigation of residual amplitude modulation in squeezed state generation system

Zhixiu Li, Xiaocong Sun, Yajun Wang +2 more

We present an analysis on how the optical parametric oscillator (OPO) detuning and the relative phase drift deteriorate the stability of the squeezed states, including the output power and the squeezed degree, and investigate the influence of RAM on the cavity detuning and the relative phase drift under different cases. Subsequently, the RAM is experimentally measured. In term of the measurement results, we perform a comparative study about RAM's influence on the cavity and phase locking in two cases. As a result, with the error signal extracted from the transmission of the OPO, the output power stability of the squeezed light is greatly improved. With the phase modulation imposed on the signal beam, the long-term stability of the squeezed degree is significantly enhanced.

Optics Express•Jul 10, 2018•10 citations

Microwave electric field measurement using frequency modulation spectroscopy in Rydberg atoms vapor cells

Santosh Kumar, Haoquan Fan, Akbar Jahangiri Jozani +2 more

We recently proposed a method to detect weak microwave electric field ~8µV/cm with sensitivity ~ 30 µV cm−1Hz−1/2 [Nat. Phys. 8, 819 (2012)]. This technique is based on Rydberg atoms using the concept of electromagnetically induced transparency in room temperature vapor cells. Here we show that frequency modulation spectroscopy with active control of residual amplitude modulation improves the read out signal-to-noise. The method has the potential for high sensitivity and can be self-calibrated.

International conference on fiber optics and photonics•Jan 1, 2016•0 citations
Residual amplitude modulation is one of the major sources of instability in ultra-sensitive optical detections based on frequency modulation. Using a MgO·LiNbO(3) electro-optic crystal, we systematically measure the temperature and polarization dependence of residual amplitude modulation and our experimental results are in good agreement with a previous theoretical analysis. After optical phase modulation, two independent arms including optical detection and frequency demodulation are employed to closely examine the instability of the residual amplitude modulation. Residual amplitude modulation below 25 ppm is obtained with an active cancellation scheme in which the crystal temperature is varied so as to zero the baseline drifts with different origins. Possible improvements for better suppression and stability are discussed.
Residual amplitude modulation is one of the major stability-degrading factors in many precision measurements. Using an electro-optic (EO) crystal with wedged input and output surfaces is an effective way to suppress residual amplitude modulation. Here the mechanism of residual amplitude modulation in this approach is investigated. The residual amplitude modulations measured in standard and wedged EO crystals bear similarities in their temperature and polarization dependences, implying that a mixture of the two orthogonal polarizations in the extraordinary light is responsible for the residual amplitude modulation in the wedged EO crystal. Similar to a standard EO crystal, a non-uniform spatial distribution of residual amplitude modulation is also observed in the extraordinary light emerging from the wedged EO crystal. The optical isolator after the EO crystal is replaced by a Faraday rotator, and an improvement in the long-term stability is observed. With the wedged-crystal approach, residual amplitude modulation as low as 2×10−7 is observed, contributing a frequency instability of 8×10−18 (500 s) in Pound–Drever–Hall frequency stabilization with a discrimination slope of 1×10−4 V/Hz.
Atomic clocks are based on highly stable and well-characterized atomic transitions, mak-ing precise control and understanding of systematic frequency shifts essential for improved timekeeping performance. This thesis presents an experimental study of light-induced Stark shifts in rubidium and their impact on precision laser spectroscopy relevant to atomic frequency standards, as well as the effects of residual amplitude modulation on the laser lock point and the resulting sensitivity of both short- and long-term stability. A laser-based spectroscopy system was developed to probe rubidium transitions while enabling controlled variation of optical intensity. The optical beam was experimentally characterized through calculations of beam waist and measurements of power to accurately determine the intensity at the interaction region. Frequency shifts arising from the AC Stark effect were measured as a function of optical power, allowing extraction of the differential polarizability between atomic energy levels using a theoretical model relating energy shifts to electric-field intensity. Uncertainty analysis was performed through systematic propagation of experimental errors associated with beam geometry, optical power calibration, and frequency measurements. In addition, residual amplitude modulation generated by electro-optic phase modulation was investigated as a significant source of systematic error in frequency stabilization systems used in atomic clocks. The magnitude and behavior of RAM were experimentally characterized, and its impact on frequency stability was quantified by measuring the sensitivity of the laser lock point to controlled variations in RAM. Potential mitigation strategies were then explored through active pre-compensation of RAM using an amplitude electro-optic modulator in a closed-loop feedback system.
Residual amplitude modulation (RAM) is an unwanted noise source in electro-optic phase modulators. The analysis presented shows that while the magnitude of the RAM produced by a MgO:LiNbO(3) modulator increases with intensity, its associated phase becomes less well defined. This combination results in temporal fluctuations in RAM that increase with intensity. This behavior is explained by the presented phenomenological model based on gradually evolving photorefractive scattering centers randomly distributed throughout the optically thick medium. This understanding is exploited to show that RAM can be reduced to below the 10(-5) level by introducing an intense optical beam to erase the photorefractive scatter.
We present an analysis on how the optical parametric oscillator (OPO) detuning and the relative phase drift deteriorate the stability of the squeezed states, including the output power and the squeezed degree, and investigate the influence of RAM on the cavity detuning and the relative phase drift under different cases. Subsequently, the RAM is experimentally measured. In term of the measurement results, we perform a comparative study about RAM's influence on the cavity and phase locking in two cases. As a result, with the error signal extracted from the transmission of the OPO, the output power stability of the squeezed light is greatly improved. With the phase modulation imposed on the signal beam, the long-term stability of the squeezed degree is significantly enhanced.
We recently proposed a method to detect weak microwave electric field ~8µV/cm with sensitivity ~ 30 µV cm−1Hz−1/2 [Nat. Phys. 8, 819 (2012)]. This technique is based on Rydberg atoms using the concept of electromagnetically induced transparency in room temperature vapor cells. Here we show that frequency modulation spectroscopy with active control of residual amplitude modulation improves the read out signal-to-noise. The method has the potential for high sensitivity and can be self-calibrated.