Challenges
Datasets
Workspaces
Papers
Discussions
Leaderboard
Log inSign up
Challenges
Datasets
Workspaces
Papers
Discussions
Leaderboard
Blog
Job Board
Q3AS

© 2026 Aqora Quantum S.A.S.

TermsPrivacyLegal Notice

Journal of Applied Physics

Influence of the Josephson junction on the impedance and noise of a resistive superconductive quantum interference device

Robert J. Soulen, William E. Fogle, Jack H. Colwell, J. L. Cohn, Heikki Seppä

Published Oct 15, 1993• 4 citations
Publisher

Abstract

The impedance and noise of a resistive superconductive quantum interference device (R-SQUID) have been measured as a function of the dc and rf currents applied to it. The Josephson junction was adjustable so that data were also taken for several values of the junction critical current. The results were compared with the predictions of a resistively shunted junction (RSJ) model which takes into account the influence of the Josephson junction on the impedance and noise. The agreement was found to be quite good and demonstrates that the noise in the circuit is well understood. Use of the R-SQUID as a noise thermometer below 1 K is assessed in terms of corrections due to the RSJ model. It is demonstrated how the dc and rf currents may be adjusted so that the total noise of the R-SQUID is reduced to within 0.1% of the Johnson noise generated by the resistor alone. Under these conditions, the R-SQUID may be used as a noise thermometer to determine thermodynamic temperature to this inaccuracy from 6 to 700 mK.

DOI
10.1063/1.354264

Related papers

Influence of the tank circuit noise on the dc impedance of the rf-biased R-SQUID

Heikki Seppä

The tank circuit noise in an rf-biased R-SQUID noise thermometer is shown to have a small but a detectable influence on the dc impedance of the resistively shunted Josephson junction. The result supplements earlier calculations which have been used to explain some of the experimentally observed characteristics of the dc impedance.

Journal of Applied Physics•May 1, 1989•1 citation

Influence of the tank circuit on the low frequency impedance of an rf-biased R-SQUID

Heikki Seppä

The dc -impedance of an rf-biased R-SQUID is studied analytically for the nonhysteretic regime. A mathematical analysis of the intrinsic behavior of an R-SQUID, including the mutual interaction between the tank circuit and the SQUID loop, is presented. The results obtained give good agreement with some experimentally observed features. Although the main aim of the present paper was to find an analytic solution for the dc -impedance of an R-SQUID, the results given here can also be used to estimate the R-SQUID parameters and to optimize the performance of a R-SQUID noise thermometer. The theory presented here also provides a good basis for modelling the noise properties of a Josephson junction noise thermometer.

Journal of Applied Physics•Mar 15, 1984•10 citations

Flicker (1∕f) noise in the critical current of Josephson junctions at 0.09–4.2K

F. C. Wellstood, C. Urbina, John L. Clarke

We have measured the low-frequency noise in the critical current Ic of six dc superconducting quantum interference devices (SQUIDs) with resistively shunted Nb–NbOx–PbIn Josephson junctions in the temperature range T=0.09–4.2K. Each device is voltage biased, the applied flux is an integer number of flux quanta, and the current fluctuations are measured with a second dc SQUID. At low frequencies f, there is a component of the power spectrum of the critical current fluctuations given approximately by SIc(f)=CIc2T2∕Af, where A is the area of both junctions, and C≈(3.9±0.4)×10−23m2∕K2. For quantum bits based on Josephson junctions, the scaling of SIc(f) with T2 implies that the dephasing time limited by critical current l∕f noise should scale as 1∕T for temperatures down to at least 0.09K.

Applied Physics Letters•Nov 29, 2004•63 citations

The current–voltage characteristics of the resistive direct current superconducting quantum interference device

Ya. S. Greenberg, G.S. Krivoy, H. Koch

Partly resistive superconducting quantum interference devices (RSQUIDs) are used in noise thermometry in the liquid helium temperature range. Here we analyze one type of RSQUID that has not been thoroughly investigated until now: the direct current biased with two Josephson junctions and a resistive part connected in series with the junctions and closed by a superconducting ring. The resistive shunted model of the Josephson junctions is used for the analysis. Two cases of the RSQUID ring inductance were analyzed: (i) negligibly small and (ii) small but finite inductance. The expressions for the low frequency output signal, the current–voltage (I–V) characteristics, and the current flowing through the resistive part are obtained. In the dependence of the output frequency versus the dc current passed through the resistive part often an offset is observed experimentally. This phenomenon can be explained as an influence of an asymmetry in the critical currents of the junctions.

Journal of Applied Physics•Feb 15, 1997•9 citations

Impedance of radio-frequency-biased resistive superconducting quantum interference devices

Robert J. Soulen, Deborah van Vechten

We have measured with high accuracy (100 ppm) and high precision (5--10 ppm) the impedance of a rf-driven resistive superconducting quantum interference device (SQUID) as a function of the amplitude and frequency of the radio-frequency (rf) bias, as a function of the current bias, and as a function of several other circuit parameters. We have developed the coupled differential equations for the resistive SQUID and for the rf tank circuit. The fit of the solutions of these equations to the data for nonhysteretic junctions is excellent. We were unable to develop solutions for the hysteretic case and thus simply present examples of typical data obtained in order to illustrate the differences with the nonhysteretic case. The relationship of this study to noise thermometry using resistive SQUID's is indicated.

Physical review. B, Condensed matter•Jul 1, 1987•13 citations

Characteristics of Flux Noise in Long Superconducting Quantum Interference Device Array

T. Morooka, Hiroaki Myoren, S. Takada +1 more

The flux noise in a long superconducting quantum interference device (SQUID) array consisting of at least 100 dc-SQUID elements connected in series was characterized analytically, and then compared with measurements. In the analysis, noise sources in the array were shunt resistors for Josephson junctions, a damping resistor for a SQUID loop, the dynamic resistance of the SQUID array, and the noise of electronics at room temperature. The flux noise of the array was calculated analytically as a function of the number of dc-SQUID elements. The results reveal that the flux noise is significantly influenced by the dynamic resistance of the array, although the influence by the dynamic resistance for a single SQUID is negligibly small. The dynamic resistance becomes dominant for the flux noise when the number of SQUID elements in the array exceeds 100. These results agree well with the measured flux noise for a long SQUID array constructed using a Nb/AlO x /Nb fabrication process.

Japanese Journal of Applied Physics•Nov 10, 2003•3 citations
The impedance and noise of a resistive superconductive quantum interference device (R-SQUID) have been measured as a function of the dc and rf currents applied to it. The Josephson junction was adjustable so that data were also taken for several values of the junction critical current. The results were compared with the predictions of a resistively shunted junction (RSJ) model which takes into account the influence of the Josephson junction on the impedance and noise. The agreement was found to be quite good and demonstrates that the noise in the circuit is well understood. Use of the R-SQUID as a noise thermometer below 1 K is assessed in terms of corrections due to the RSJ model. It is demonstrated how the dc and rf currents may be adjusted so that the total noise of the R-SQUID is reduced to within 0.1% of the Johnson noise generated by the resistor alone. Under these conditions, the R-SQUID may be used as a noise thermometer to determine thermodynamic temperature to this inaccuracy from 6 to 700 mK.
The dc -impedance of an rf-biased R-SQUID is studied analytically for the nonhysteretic regime. A mathematical analysis of the intrinsic behavior of an R-SQUID, including the mutual interaction between the tank circuit and the SQUID loop, is presented. The results obtained give good agreement with some experimentally observed features. Although the main aim of the present paper was to find an analytic solution for the dc -impedance of an R-SQUID, the results given here can also be used to estimate the R-SQUID parameters and to optimize the performance of a R-SQUID noise thermometer. The theory presented here also provides a good basis for modelling the noise properties of a Josephson junction noise thermometer.
We have measured the low-frequency noise in the critical current Ic of six dc superconducting quantum interference devices (SQUIDs) with resistively shunted Nb–NbOx–PbIn Josephson junctions in the temperature range T=0.09–4.2K. Each device is voltage biased, the applied flux is an integer number of flux quanta, and the current fluctuations are measured with a second dc SQUID. At low frequencies f, there is a component of the power spectrum of the critical current fluctuations given approximately by SIc(f)=CIc2T2∕Af, where A is the area of both junctions, and C≈(3.9±0.4)×10−23m2∕K2. For quantum bits based on Josephson junctions, the scaling of SIc(f) with T2 implies that the dephasing time limited by critical current l∕f noise should scale as 1∕T for temperatures down to at least 0.09K.
Partly resistive superconducting quantum interference devices (RSQUIDs) are used in noise thermometry in the liquid helium temperature range. Here we analyze one type of RSQUID that has not been thoroughly investigated until now: the direct current biased with two Josephson junctions and a resistive part connected in series with the junctions and closed by a superconducting ring. The resistive shunted model of the Josephson junctions is used for the analysis. Two cases of the RSQUID ring inductance were analyzed: (i) negligibly small and (ii) small but finite inductance. The expressions for the low frequency output signal, the current–voltage (I–V) characteristics, and the current flowing through the resistive part are obtained. In the dependence of the output frequency versus the dc current passed through the resistive part often an offset is observed experimentally. This phenomenon can be explained as an influence of an asymmetry in the critical currents of the junctions.
We have measured with high accuracy (100 ppm) and high precision (5--10 ppm) the impedance of a rf-driven resistive superconducting quantum interference device (SQUID) as a function of the amplitude and frequency of the radio-frequency (rf) bias, as a function of the current bias, and as a function of several other circuit parameters. We have developed the coupled differential equations for the resistive SQUID and for the rf tank circuit. The fit of the solutions of these equations to the data for nonhysteretic junctions is excellent. We were unable to develop solutions for the hysteretic case and thus simply present examples of typical data obtained in order to illustrate the differences with the nonhysteretic case. The relationship of this study to noise thermometry using resistive SQUID's is indicated.
The flux noise in a long superconducting quantum interference device (SQUID) array consisting of at least 100 dc-SQUID elements connected in series was characterized analytically, and then compared with measurements. In the analysis, noise sources in the array were shunt resistors for Josephson junctions, a damping resistor for a SQUID loop, the dynamic resistance of the SQUID array, and the noise of electronics at room temperature. The flux noise of the array was calculated analytically as a function of the number of dc-SQUID elements. The results reveal that the flux noise is significantly influenced by the dynamic resistance of the array, although the influence by the dynamic resistance for a single SQUID is negligibly small. The dynamic resistance becomes dominant for the flux noise when the number of SQUID elements in the array exceeds 100. These results agree well with the measured flux noise for a long SQUID array constructed using a Nb/AlO x /Nb fabrication process.