© 2026 Aqora Quantum S.A.S.

Terms Privacy Legal Notice

IEEE Transactions on Magnetics

High-tolerance three-Josephson-junction curent-injection logic devices (HTCID)

H. Beha, Heinz Jäckel

Published Nov 1, 1981• 10 citations

Abstract

A new 3-Josephson-junction interferometer is presented as a high-tolerance nonlinear current-injection 2-input AND gate. In Josephson LSI circuits, the tolerances are an important issue. Thus, in our new logic device emphasis has been placed on its static and dynamic tolerance properties. The new HTCID offers considerably better input-signal tolerances than known 2-junction current-injection devices (CID) for identical fabrication tolerance assumptions. The HTCID in this example has a Josephson current ratio of 1:3:1 and a characteristic phase λ = 0.72π. Including circuit parameter variations, this new 3-junction CID allows attractive, high input-signal tolerances of ± 33.3%. Therefore, an almost threefold tolerance improvement over the published 2-junction CID (λ = 0.66π) could be achieved. Trade-off between signal tolerances and device speed is discussed. Computer simulation indicates a worst-case delay of less than 47 ps.

DOI: 10.1109/tmag.1981.1061582

Related papers

Josephson logic circuits based on nonlinear current injection in interferometer devices

Tushar R. Gheewala

Nonlinear current-injection switching of Josephson interferometer devices is achieved by current injection into an asymmetric feedpoint. This method of switching interferometers has two important features: higher gain than in previous approaches and a novel nonlinear threshold curve which is of practical interest. A new family of high-performance logic gates based on nonlinear current injection is described. Logic circuits have been experimentally tested and preliminary results are presented.

Applied Physics Letters•Oct 15, 1978•30 citations

A novel current injection Josephson logic gate with high gain

K. Hohkawa, Masaru Okada, Akira Ishida

A novel Josephson logic gate achieving high gain, employing current injection, and having a noninterferometer configuration has been proposed and studied. The gate includes three small junctions for input sensing, output driving, and I-O isolation. The junctions are appropriately biased by source resistors to obtain high current gain. Computer simulation and preliminary experiment have demonstrated that a current gain higher than 2 can easily be obtained through the proposed configuration.

Applied Physics Letters•Oct 15, 1981•31 citations

Josephson compensating junction logic

C.J. Anderson

A Josephson superconducting quantum interference device (SQUID) digital logic family was developed that uses the R/sub nn/ region of a Josephson junction (JJ) to compensate for variations in where R/sub nn/ is the effective resistance of a JJ in the linear I-V region beyond the gap. The basic compensating junction logic (CJL) circuit is two 2-input-OR 1-2-1 interferometer isolators that, when switched, inject current into a 2-input-AND 1-2-1 interferometer. The R/sub nn/ region of several JJs is used in series with a resistor to set the current from the power supply to the 2-input-OR interferometers. The 2-input-AND interferometer is implemented with both current injection and magnetic coupling. The latch circuit uses both current injection and magnetic coupling design techniques to increase the range of I/sub O/, inductance, and resistance variation over which the latch will function correctly. Experimental measurements of CJL circuits are described.>

IEEE Transactions on Applied Superconductivity•Mar 1, 1993•0 citations

Damped three-junction interferometers for latching logic

Linda Geppert, J. H. Greiner, Dennis Herrell +1 more

This paper describes the design, fabrication and characterization of damped three-junction interferometers suitable for LSI latching logic. The high speed and low power dissipation of Josephson interferometers make them ideal devices for logic applications. However, their inherent high Q gives rise to resonances which appear as current steps in the quasiparticle curve. If not controlled, these current steps can interfere with the proper operation of logic circuits. Studies have shown that these resonances can be effectively damped by shunting the interferometer inductance with a small resistance. In this work the interferometers were made by placing the interferometer loops parallel to the groundplane and clustering the Josephson junctions together. This minimized the loop inductance associated with the counterelectrode which in turn meant that adequate damping could be achieved with metallurgically compatible short resistors connected only to the base electrode. The resultant structure with two overlying control lines each 2.5μm wide had an area of 0.008mm2. The Josephson junctions were 5μm in diameter. The measured damped resonance characteristics and threshold characteristics (Ig(Vg) and Im(Ic) respectively) of these structures agreed very well with theory.

IEEE Transactions on Magnetics•Jan 1, 1979•24 citations

Current Injection Logic Gate with Four Josephson Junctions

S. Takada, S. Kosaka, Hisao Hayakawa

A novel current switching Josephson logic gate in which four junctions are connected in a loop is described. This four-junction logic gate can reduce an inductance included in the loop as small as possible, so that the higher switching speed and the smaller device size is expected. The switching threshold and the switching characteristics of the gate are investigated both theoretically and experimentally. Logic circuits based on the gates are also experimentally demonstrated.

International Conference on Solid State Devices and Materials (SSDM)•Aug 28, 1979•4 citations

Current-injection Josephson latch employing a single-flux quantum. I

J. Sone, Toshishige Yamada

A new current-injection Josephson latch employing a single-flux quantum is proposed. It has a master-slave circuit configuration and operates under ac power supply. In the circuit, data are stored as a circulating current in a superconducting loop consisting of a single junction and inductances. A two-junction interferometer gate directly coupled to the loop reads out the stored data. Dual-rail signals are generated from the read-out data by Josephson junctions and resister-coupled Josephson logic gates. The isolation between a master circuit and a slave circuit is realized using high-impedance states in the Josephson junctions. The circuit design and computer-simulation results on the circuit operation are described in this paper.

Journal of Applied Physics•May 1, 1986•2 citations

A new 3-Josephson-junction interferometer is presented as a high-tolerance nonlinear current-injection 2-input AND gate. In Josephson LSI circuits, the tolerances are an important issue. Thus, in our new logic device emphasis has been placed on its static and dynamic tolerance properties. The new HTCID offers considerably better input-signal tolerances than known 2-junction current-injection devices (CID) for identical fabrication tolerance assumptions. The HTCID in this example has a Josephson current ratio of 1:3:1 and a characteristic phase λ = 0.72π. Including circuit parameter variations, this new 3-junction CID allows attractive, high input-signal tolerances of ± 33.3%. Therefore, an almost threefold tolerance improvement over the published 2-junction CID (λ = 0.66π) could be achieved. Trade-off between signal tolerances and device speed is discussed. Computer simulation indicates a worst-case delay of less than 47 ps.

A Josephson superconducting quantum interference device (SQUID) digital logic family was developed that uses the R/sub nn/ region of a Josephson junction (JJ) to compensate for variations in where R/sub nn/ is the effective resistance of a JJ in the linear I-V region beyond the gap. The basic compensating junction logic (CJL) circuit is two 2-input-OR 1-2-1 interferometer isolators that, when switched, inject current into a 2-input-AND 1-2-1 interferometer. The R/sub nn/ region of several JJs is used in series with a resistor to set the current from the power supply to the 2-input-OR interferometers. The 2-input-AND interferometer is implemented with both current injection and magnetic coupling. The latch circuit uses both current injection and magnetic coupling design techniques to increase the range of I/sub O/, inductance, and resistance variation over which the latch will function correctly. Experimental measurements of CJL circuits are described.>

This paper describes the design, fabrication and characterization of damped three-junction interferometers suitable for LSI latching logic. The high speed and low power dissipation of Josephson interferometers make them ideal devices for logic applications. However, their inherent high Q gives rise to resonances which appear as current steps in the quasiparticle curve. If not controlled, these current steps can interfere with the proper operation of logic circuits. Studies have shown that these resonances can be effectively damped by shunting the interferometer inductance with a small resistance. In this work the interferometers were made by placing the interferometer loops parallel to the groundplane and clustering the Josephson junctions together. This minimized the loop inductance associated with the counterelectrode which in turn meant that adequate damping could be achieved with metallurgically compatible short resistors connected only to the base electrode. The resultant structure with two overlying control lines each 2.5μm wide had an area of 0.008mm2. The Josephson junctions were 5μm in diameter. The measured damped resonance characteristics and threshold characteristics (Ig(Vg) and Im(Ic) respectively) of these structures agreed very well with theory.

A new current-injection Josephson latch employing a single-flux quantum is proposed. It has a master-slave circuit configuration and operates under ac power supply. In the circuit, data are stored as a circulating current in a superconducting loop consisting of a single junction and inductances. A two-junction interferometer gate directly coupled to the loop reads out the stored data. Dual-rail signals are generated from the read-out data by Josephson junctions and resister-coupled Josephson logic gates. The isolation between a master circuit and a slave circuit is realized using high-impedance states in the Josephson junctions. The circuit design and computer-simulation results on the circuit operation are described in this paper.