Challenges
Datasets
Workspaces
Papers
Discussions
Leaderboard
Log inSign up
Challenges
Datasets
Workspaces
Papers
Discussions
Leaderboard
Blog
Job Board
Q3AS

© 2026 Aqora Quantum S.A.S.

TermsPrivacyLegal Notice

Applied Physics Letters

Low-noise 0.5THz all-NbN superconductor-insulator-superconductor mixer for submillimeter wave astronomy

Jing Li, Masanori Takeda, Zhen Wang, Sheng‐Cai Shi, Ji Yang

Published Jun 2, 2008• 40 citations
Publisher

Abstract

We report the detection of spectral line emission from CO (J=4–3) at 0.46THz using a low-noise 0.5THz superconductor-insulator-superconductor (SIS) mixer incorporating NbN∕AlN∕NbN tunnel junctions (with an energy gap of 5.6meV) and a NbN∕MgO∕NbN tuning circuit, which is installed on a 30cm submillimeter telescope. Uncorrected receiver noise temperatures as low as 149K are measured on the telescope from 0.45–0.50THz for an unoptimized device. Moreover, the 0.5THz all-NbN SIS mixer exhibits high stability in a considerably large dc bias range and low noise at significantly high temperatures compared with a 0.5THz Nb SIS mixer.

DOI
10.1063/1.2940235

Related papers

0.5-THz waveguide SIS mixers with NbN/AlN/NbN technology

Jing Li, Masanori Takeda, Zhen Wang +1 more

Heterodyne mixers based on superconducting SIS (superconductor-insulator-superconductor) tunnel junctions have been demonstrated to be the most sensitive coherent detectors at millimeter and submillimeter wavelengths. In fact, conventional superconducting SIS mixers with Nb/AlOx/Nb junction and Nb/SiO2/Nb tuning circuit have shown good performances with the noise temperature reaching as low as three times the quantum limit below 0.7THz, which is the gap frequency of Nb-based SIS junctions. However, due to the large loss in Nb thin-film superconducting microstrip lines, the noise performance of Nb SIS mixers deteriorates significantly above 0.7THz. With a gap frequency double that of Nb-based SIS junctions, NbN-based SIS junctions are of particular interest for the development of heterodyne mixers in the terahertz region. Considering the bandwidth and output power of local-oscillator (LO) signal sources are quite limited around 1THz, we firstly develop a waveguide NbN-based SIS mixer at 0.5THz. Three types of SIS junctions, i.e., long junction, parallel-connected tunnel junction (PCTJ) and distributed junction array (DJ) are investigated. They are all comprised of NbN-AlN-NbN tri-layer fabricated on an MgO substrate and have the same current density (Jc) of 10kA/cm2. In this paper, we describe their design, fabrication and preliminary experimental results.

Proceedings of SPIE, the International Society for Optical Engineering/Proceedings of SPIE•Nov 29, 2007•3 citations

Comparison of the performance of a 0.5-THz Nb and NbN superconducting SIS mixer

Jing Li, Masanori Takeda, Zhen Wang +1 more

In THz regime, NbN Superconductor - Insulator - Superconductor (SIS) mixers are potentially applicable to astronomy and atmospheric research. We have developed a 0.5-THz waveguide SIS mixer incorporating twin NbN/AlN/NbN junctions and NbN/MgO/NbN tuning circuit. In this paper, we compare it with a 0.5-THz Nb SIS mixer, which has been successfully used on POST telescope. The design and fabrication parameters of the two mixers are introduced, and the noise temperatures are measured. In addition, the direct detection performance is analyzed, such as the shot noise, the current responsivity and the noise equivalent power. The detailed results are presented.

Asia-Pacific Microwave Conference (APMC)•Dec 1, 2009•1 citation

0.5-THz waveguide SIS mixers with NbN/AlN/NbN technology - art. no. 684013

Jing Li, Takeda Masanon, Zhen Wang

Heterodyne mixers based on superconducting SIS (superconductor-insulator-superconductor) tunnel junctions have been demonstrated to be the most sensitive coherent detectors at millimeter and submillimeter wavelengths. In fact, conventional superconducting SIS mixers with Nb/AIO(x)/Nb junction and Nb/SiO2/Nb tuning circuit have shown good performances with the noise temperature reaching as low as three times the quantum limit below 0.7THz, which is the gap frequency of Nb-based SIS junctions. However, due to the large loss in Nb thin-film superconducting microstrip lines, the noise performance of Nb SIS mixers deteriorates significantly above 0.7THz. With a gap frequency double that of Nb-based SIS junctions, NbN-based SIS junctions are of particular interest for the development of heterodyne mixers in the terahertz region.

•Jan 1, 2008•0 citations

Characterization of the Mixing Performance of All-NbN Superconducting Tunnel Junctions at 0.5 THz

Jing Li, Mahoto Takeda, Zhen Wang +1 more

With a gap frequency of 1.4 THz, all-NbN Superconductor-Insulator-Superconductor (SIS) junctions are potentially applicable to sensitive heterodyne mixers for THz astronomy and atmospheric research. In this paper, we report the design, fabrication, and performance characterization of a 0.5-THz waveguide SIS mixer incorporating twin NbN/AlN/NbN junctions and an NbN/MgO/NbN tuning circuit with no impedance transformers. The noise performance of two NbN SIS junctions with different tuning inductances is measured, compared with the simulated results without and with the multiple Andreev reflection (MAR) effect taken into account, and also compared with the video detection response. In addition, the IF-output-power stability and aging effect of fabricated NbN SIS junctions are investigated.

IEEE Transactions on Applied Superconductivity•Jun 1, 2009•13 citations

Low-noise submillimeter-wave NbTiN superconducting tunnel junction mixers

Jonathan H. Kawamura, Jian Chen, David Miller +5 more

We have developed a low-noise 850 GHz superconductor–insulator–superconductor quasiparticle mixer with NbTiN thin-film microstrip tuning circuits and hybrid Nb/AlN/NbTiN tunnel junctions. The mixer uses a quasioptical configuration with a planar twin-slot antenna feeding a two-junction tuning circuit. At 798 GHz, we measured an uncorrected double-sideband receiver noise temperature of TRX=260 K at 4.2 K bath temperature. This mixer outperforms current Nb SIS mixers by a factor of nearly 2 near 800 GHz. The high-gap frequency and low loss at 800 GHz make NbTiN an attractive material with which to fabricate tuning circuits for SIS mixers. NbTiN mixers can potentially operate up to the gap frequency, 2Δ/h∼1.2 THz.

Applied Physics Letters•Dec 20, 1999•81 citations

Noise performance of a 200–280 GHz mixer with Nb-AlN-NbN superconducting tunnel junctions

Boliang Liu, Dong Liu, Ming Yao +6 more

Superconductor–insulator–superconductor (SIS) mixers remain the choice of heterodyne mixers for single-dish telescopes and interferometers at millimeter and submillimeter wavelengths. Compared with conventional Nb/AlOx/Nb superconducting tunnel junctions, Nb/AlN/NbN ones have larger gap voltage and may reach critical-current density beyond 10kA/cm2, which are both of particularly interest in developing broadband SIS mixers. Here we report on the design and measurement of an SIS mixer based on Nb/AlN/NbN parallel connected twin junctions (PCTJ) incorporating NbTiN/SiO2/Al microstrip circuit. The junctions have a gap voltage of 3.18mV and a critical-current density of 15kA/cm2. The measured receiver noise temperature reach 5hν/kB among 200-260GHz band, and the mixer’s fractional bandwidth is about 40% centered at 230GHz.

Infrared, Millimeter-Wave, and Terahertz Technologies•Dec 16, 2022•0 citations
We report the detection of spectral line emission from CO (J=4–3) at 0.46THz using a low-noise 0.5THz superconductor-insulator-superconductor (SIS) mixer incorporating NbN∕AlN∕NbN tunnel junctions (with an energy gap of 5.6meV) and a NbN∕MgO∕NbN tuning circuit, which is installed on a 30cm submillimeter telescope. Uncorrected receiver noise temperatures as low as 149K are measured on the telescope from 0.45–0.50THz for an unoptimized device. Moreover, the 0.5THz all-NbN SIS mixer exhibits high stability in a considerably large dc bias range and low noise at significantly high temperatures compared with a 0.5THz Nb SIS mixer.
Heterodyne mixers based on superconducting SIS (superconductor-insulator-superconductor) tunnel junctions have been demonstrated to be the most sensitive coherent detectors at millimeter and submillimeter wavelengths. In fact, conventional superconducting SIS mixers with Nb/AlOx/Nb junction and Nb/SiO2/Nb tuning circuit have shown good performances with the noise temperature reaching as low as three times the quantum limit below 0.7THz, which is the gap frequency of Nb-based SIS junctions. However, due to the large loss in Nb thin-film superconducting microstrip lines, the noise performance of Nb SIS mixers deteriorates significantly above 0.7THz. With a gap frequency double that of Nb-based SIS junctions, NbN-based SIS junctions are of particular interest for the development of heterodyne mixers in the terahertz region. Considering the bandwidth and output power of local-oscillator (LO) signal sources are quite limited around 1THz, we firstly develop a waveguide NbN-based SIS mixer at 0.5THz. Three types of SIS junctions, i.e., long junction, parallel-connected tunnel junction (PCTJ) and distributed junction array (DJ) are investigated. They are all comprised of NbN-AlN-NbN tri-layer fabricated on an MgO substrate and have the same current density (Jc) of 10kA/cm2. In this paper, we describe their design, fabrication and preliminary experimental results.
In THz regime, NbN Superconductor - Insulator - Superconductor (SIS) mixers are potentially applicable to astronomy and atmospheric research. We have developed a 0.5-THz waveguide SIS mixer incorporating twin NbN/AlN/NbN junctions and NbN/MgO/NbN tuning circuit. In this paper, we compare it with a 0.5-THz Nb SIS mixer, which has been successfully used on POST telescope. The design and fabrication parameters of the two mixers are introduced, and the noise temperatures are measured. In addition, the direct detection performance is analyzed, such as the shot noise, the current responsivity and the noise equivalent power. The detailed results are presented.
Heterodyne mixers based on superconducting SIS (superconductor-insulator-superconductor) tunnel junctions have been demonstrated to be the most sensitive coherent detectors at millimeter and submillimeter wavelengths. In fact, conventional superconducting SIS mixers with Nb/AIO(x)/Nb junction and Nb/SiO2/Nb tuning circuit have shown good performances with the noise temperature reaching as low as three times the quantum limit below 0.7THz, which is the gap frequency of Nb-based SIS junctions. However, due to the large loss in Nb thin-film superconducting microstrip lines, the noise performance of Nb SIS mixers deteriorates significantly above 0.7THz. With a gap frequency double that of Nb-based SIS junctions, NbN-based SIS junctions are of particular interest for the development of heterodyne mixers in the terahertz region.
With a gap frequency of 1.4 THz, all-NbN Superconductor-Insulator-Superconductor (SIS) junctions are potentially applicable to sensitive heterodyne mixers for THz astronomy and atmospheric research. In this paper, we report the design, fabrication, and performance characterization of a 0.5-THz waveguide SIS mixer incorporating twin NbN/AlN/NbN junctions and an NbN/MgO/NbN tuning circuit with no impedance transformers. The noise performance of two NbN SIS junctions with different tuning inductances is measured, compared with the simulated results without and with the multiple Andreev reflection (MAR) effect taken into account, and also compared with the video detection response. In addition, the IF-output-power stability and aging effect of fabricated NbN SIS junctions are investigated.
We have developed a low-noise 850 GHz superconductor–insulator–superconductor quasiparticle mixer with NbTiN thin-film microstrip tuning circuits and hybrid Nb/AlN/NbTiN tunnel junctions. The mixer uses a quasioptical configuration with a planar twin-slot antenna feeding a two-junction tuning circuit. At 798 GHz, we measured an uncorrected double-sideband receiver noise temperature of TRX=260 K at 4.2 K bath temperature. This mixer outperforms current Nb SIS mixers by a factor of nearly 2 near 800 GHz. The high-gap frequency and low loss at 800 GHz make NbTiN an attractive material with which to fabricate tuning circuits for SIS mixers. NbTiN mixers can potentially operate up to the gap frequency, 2Δ/h∼1.2 THz.
Superconductor–insulator–superconductor (SIS) mixers remain the choice of heterodyne mixers for single-dish telescopes and interferometers at millimeter and submillimeter wavelengths. Compared with conventional Nb/AlOx/Nb superconducting tunnel junctions, Nb/AlN/NbN ones have larger gap voltage and may reach critical-current density beyond 10kA/cm2, which are both of particularly interest in developing broadband SIS mixers. Here we report on the design and measurement of an SIS mixer based on Nb/AlN/NbN parallel connected twin junctions (PCTJ) incorporating NbTiN/SiO2/Al microstrip circuit. The junctions have a gap voltage of 3.18mV and a critical-current density of 15kA/cm2. The measured receiver noise temperature reach 5hν/kB among 200-260GHz band, and the mixer’s fractional bandwidth is about 40% centered at 230GHz.