Challenges
Datasets
Workspaces
Papers
Discussions
Leaderboard
Log inSign up
Challenges
Datasets
Workspaces
Papers
Discussions
Leaderboard
Blog
Job Board
Q3AS

© 2026 Aqora Quantum S.A.S.

TermsPrivacyLegal Notice

European Conference on Optical Communication

Effect of Dispersion Fluctuations on Large Frequency Shift Parametric Amplification in Photonic Crystal Fiber

J. S. Y. Chen, Stuart G. Murdoch, R. Leonhardt, J.D. Harvey

Published Sep 1, 2006• 0 citations
Publisher

Abstract

Large frequency shift parametric sidebands are shown to be sensitive to dispersion fluctuations. Comparing experimentally measured and theoretical calculated sideband conversion efficiencies allows us to estimate the uniformity of the photonic crystal fiber used.
DOI
10.1109/ecoc.2006.4800932

Related papers

Effect of dispersion fluctuations on widely tunable optical parametric amplification in photonic crystal fibers

J. S. Y. Chen, Stuart G. Murdoch, R. Leonhardt +1 more

The effect of dispersion fluctuations on the conversion efficiency of large frequency shift parametric sidebands is studied by numerical simulation and experiment. Numerical results based on periodic and random dispersion models are used to fit the experimental results. The fitting parameters provide a measure of the uniformity of the photonic crystal fiber used in the experiment. This allows us to place limits on the required uniformity of a photonic crystal fiber for strong frequency conversion.

Optics Express•Jan 1, 2006•54 citations

Parametric and Raman amplification in photonic crystal fiber

Stefan W. Wabnitz, Guy Millot, Stéphane Pitois +2 more

We study the interplay between parametric and Raman gain in photonic crystal fibers by taking into account the vector nature of the electric field, the fiber frequency dependent birefringence, the Kerr nonlinear coefficient, the Raman gain profile and chromatic dispersion. In particular, we show that an accurate representation of the frequency dependence of the nonlinear and dispersive properties of a photonic crystal fiber is essential for correctly describing the overall gain profile for a probe signal at large frequency detuning from a continuous wave or pulsed pump. For example, we found that fourth and higher order dispersion have a striking influence on the spectrum of modulation polarization instability gain in both the high and low birefringence regime, in that the vector parametric gain is suppressed above a critical level of linear birefringence. We validated the theory by experimental observations of vector parametric amplification in high birefringence holey fiber with triple defects.

Proceedings of SPIE, the International Society for Optical Engineering/Proceedings of SPIE•Sep 16, 2005•0 citations

Third-order dispersion drastically changes parametric gain in optical fiber systems

Mikhail I. Kolobov, Arnaud Mussot, Alexandre Kudlinski +2 more

We demonstrate that the third-order dispersion drastically changes the phase-sensitive parametric gain in cw-pumped fiber systems. We analytically calculate the phase-sensitive gain as a function of the frequency for amplification of two weak monochromatic fields with spectral components symmetric with respect to the pump field. In the absence of the third-order dispersion, the phase-sensitive gain is symmetric with respect to the frequency. When the third-order dispersion is present, the gain has an asymmetric shape. This asymmetry has its origin in the phase-sensitive nature of the parametric gain.

Physical Review A•Mar 1, 2011•15 citations

Spectral properties of photon pairs generated by spontaneous four wave mixing in inhomogeneous photonic crystal fibers

Liang Cui, Xiaoying Li, Ningbo Zhao +1 more

The theoretical analysis shows the un-uniform dispersion of photonic crystal fiber with inhomogeneous structure will lead to modulated spectra of photon pairs, and our experimental observations agree with the theoretical predictions.

•Aug 1, 2011•0 citations

Spectral Properties of Photon Pairs Generated by Spontaneous Four Wave Mixing in Inhomogeneous Photonic Crystal Fibers

Liang Cui, Xiaoying Li, Ningbo Zhao +1 more

The theoretical analysis shows the un-uniform dispersion of photonic crystal fiber with inhomogeneous structure will lead to modulated spectra of photon pairs, and our experimental observations agree with the theoretical predictions.

•Jan 1, 2011•2 citations

Frequency-dissymmetric nonlinear sideband generation in a photonic crystal fibre

Margaux Barbier, Philippe Leproux, Philippe Roy +1 more

Summary form only given. Generation of correlated photon pairs by spontaneous parametric four-wave mixing (FWM) in photonic crystal fibres (PCF) opens the way for many applications, particularly for fibre-based quantum communication devices. In degenerate FWM, two pump photons at frequency ωρare annihilated to produce simultaneously a signal photon at ωsand an idler photon at ωi, such as ωs+ ωi= 2ωp(energy conservation). This process occurs with high efficiency only if the phase-matching condition (i.e. momentum conservation) is satisfied [1].The group-velocity dispersion (GVD) of the silica-core PCF used in our experiments (fig.1.a, inset) has been experimentally determined by a time-of-flight measurement for wavelengths from 740 nm to 930 nm. The result is consistent with the analytical calculation provided by Saitoh and Koshiba [2]. Particularly, we estimate the zero-dispersion wavelength of the PCF: λZDW = 834 nm. From this GVD measurement, we deduce the phasematching curve given in fig.1.a, on which we note that there is a vertical asymptote at λp - 832 nm. Thus, FWM should not be observed if the pump wavelength λp is lower than this limit value. Our experimental observations are very different from this prediction. Indeed, by injecting inside the fundamental mode of a 1.3-m-long PCF hyperbolic secant picosecond pulses (with an intensity-FWHM duration of about 2 ps) at λinj = 815 nm with a 80-MHz repetition rate, we actually observe a spontaneous parametric FWM phenomenon (with sidebands generated around 925 nm and 745 nm), and moreover with a clear frequency dissymmetry with respect to the injected pulse frequency (ωinj = 2ππc/λinj) (fig.1.b): generated signal and idler frequencies ωs and ωi do not satisfy ωs + ωi = 2ωinj.A systematic study of this frequency-dissymmetric phenomenon shows that it occurs only when the injected pulse peak power (Pinj) is higher than a threshold value Pth, and that Pth increases when λinj decreases from λZDW. This variation of Pth as a function of λinj can be understood by considering the key role played by self-phase modulation (SPM) in the observed phenomenon. Indeed, the frequency-dissymmetric signal and idler waves are generated only when the spectral broadening (due to SPM) of the injected pulses is sufficient to reach a threshold wavelength λth (i.e. a threshold frequency ωth) of the order of 832 nm. This value corresponds to the position of the vertical asymptote in the phase-matching curve. Finally, we observe that ωs + ωi - 2ωth when Pinj Pth. All these observations highlight the fact that, when the injected pulse peak power Pinj is high enough, spectral broadening by SPM is sufficient to get a part of the injected pulse spectrum higher than the threshold value λth, and thus this part of the spectrum can play the role of pump in an efficient FWM process (i.e. with the phasematching condition satisfied). It is important to note that this phenomenon advantageously presents an extension of the spectral range on which an efficient FWM process can occur: instead of being restricted to injected pulse wavelengths higher than the zero-dispersion wavelength λZDW of the fibre (or at least, higher than a threshold wavelength λth of the order of λZDW), experimenters can work with lower wavelengths, providing the availability of a high enough peak power and/or interaction length to sufficiently broaden (by SPM) the injected pulse spectrum.

Conference on Lasers and Electro-Optics Europe & European Quantum Electronics Conference (CLEO/Europe-EQEC)•May 1, 2013•0 citations
The effect of dispersion fluctuations on the conversion efficiency of large frequency shift parametric sidebands is studied by numerical simulation and experiment. Numerical results based on periodic and random dispersion models are used to fit the experimental results. The fitting parameters provide a measure of the uniformity of the photonic crystal fiber used in the experiment. This allows us to place limits on the required uniformity of a photonic crystal fiber for strong frequency conversion.
We study the interplay between parametric and Raman gain in photonic crystal fibers by taking into account the vector nature of the electric field, the fiber frequency dependent birefringence, the Kerr nonlinear coefficient, the Raman gain profile and chromatic dispersion. In particular, we show that an accurate representation of the frequency dependence of the nonlinear and dispersive properties of a photonic crystal fiber is essential for correctly describing the overall gain profile for a probe signal at large frequency detuning from a continuous wave or pulsed pump. For example, we found that fourth and higher order dispersion have a striking influence on the spectrum of modulation polarization instability gain in both the high and low birefringence regime, in that the vector parametric gain is suppressed above a critical level of linear birefringence. We validated the theory by experimental observations of vector parametric amplification in high birefringence holey fiber with triple defects.
We demonstrate that the third-order dispersion drastically changes the phase-sensitive parametric gain in cw-pumped fiber systems. We analytically calculate the phase-sensitive gain as a function of the frequency for amplification of two weak monochromatic fields with spectral components symmetric with respect to the pump field. In the absence of the third-order dispersion, the phase-sensitive gain is symmetric with respect to the frequency. When the third-order dispersion is present, the gain has an asymmetric shape. This asymmetry has its origin in the phase-sensitive nature of the parametric gain.
Summary form only given. Generation of correlated photon pairs by spontaneous parametric four-wave mixing (FWM) in photonic crystal fibres (PCF) opens the way for many applications, particularly for fibre-based quantum communication devices. In degenerate FWM, two pump photons at frequency ωρare annihilated to produce simultaneously a signal photon at ωsand an idler photon at ωi, such as ωs+ ωi= 2ωp(energy conservation). This process occurs with high efficiency only if the phase-matching condition (i.e. momentum conservation) is satisfied [1].The group-velocity dispersion (GVD) of the silica-core PCF used in our experiments (fig.1.a, inset) has been experimentally determined by a time-of-flight measurement for wavelengths from 740 nm to 930 nm. The result is consistent with the analytical calculation provided by Saitoh and Koshiba [2]. Particularly, we estimate the zero-dispersion wavelength of the PCF: λZDW = 834 nm. From this GVD measurement, we deduce the phasematching curve given in fig.1.a, on which we note that there is a vertical asymptote at λp - 832 nm. Thus, FWM should not be observed if the pump wavelength λp is lower than this limit value. Our experimental observations are very different from this prediction. Indeed, by injecting inside the fundamental mode of a 1.3-m-long PCF hyperbolic secant picosecond pulses (with an intensity-FWHM duration of about 2 ps) at λinj = 815 nm with a 80-MHz repetition rate, we actually observe a spontaneous parametric FWM phenomenon (with sidebands generated around 925 nm and 745 nm), and moreover with a clear frequency dissymmetry with respect to the injected pulse frequency (ωinj = 2ππc/λinj) (fig.1.b): generated signal and idler frequencies ωs and ωi do not satisfy ωs + ωi = 2ωinj.A systematic study of this frequency-dissymmetric phenomenon shows that it occurs only when the injected pulse peak power (Pinj) is higher than a threshold value Pth, and that Pth increases when λinj decreases from λZDW. This variation of Pth as a function of λinj can be understood by considering the key role played by self-phase modulation (SPM) in the observed phenomenon. Indeed, the frequency-dissymmetric signal and idler waves are generated only when the spectral broadening (due to SPM) of the injected pulses is sufficient to reach a threshold wavelength λth (i.e. a threshold frequency ωth) of the order of 832 nm. This value corresponds to the position of the vertical asymptote in the phase-matching curve. Finally, we observe that ωs + ωi - 2ωth when Pinj Pth. All these observations highlight the fact that, when the injected pulse peak power Pinj is high enough, spectral broadening by SPM is sufficient to get a part of the injected pulse spectrum higher than the threshold value λth, and thus this part of the spectrum can play the role of pump in an efficient FWM process (i.e. with the phasematching condition satisfied). It is important to note that this phenomenon advantageously presents an extension of the spectral range on which an efficient FWM process can occur: instead of being restricted to injected pulse wavelengths higher than the zero-dispersion wavelength λZDW of the fibre (or at least, higher than a threshold wavelength λth of the order of λZDW), experimenters can work with lower wavelengths, providing the availability of a high enough peak power and/or interaction length to sufficiently broaden (by SPM) the injected pulse spectrum.