Challenges
Datasets
Workspaces
Papers
Discussions
Leaderboard
Log inSign up
Challenges
Datasets
Workspaces
Papers
Discussions
Leaderboard
Blog
Job Board
Q3AS

© 2026 Aqora Quantum S.A.S.

TermsPrivacyLegal Notice

AIP conference proceedings

Improving noise performance of the SQUID in presence of high resistive signal leads

Narayanan Mariyappa, C. Parasakthi, S. Sengottuvel, Rajesh Patel, K. Gireesan, Thimmakudy Sambasiva Radhakrishnan, M.P. Janawadkar, C. S. Sundar

Published Jan 1, 2012• 0 citations
Publisher
DOI
10.1063/1.4710289

Related papers

Signal amplification and signal to noise ratio improvements in thermally switching SQUIDs

Andrew D. Hibbs, Brian R. Whitecotton

Applied Superconductivity•Oct 1, 1999•9 citations

SIGNAL AND NOISE CHARACTERISTICS OF RF-SQUIDS

V. I. Shnyrkov, Georgy M. Tsoi

WORLD SCIENTIFIC eBooks•Jun 1, 1992•6 citations

Improving high-TCdc SQUID performance by means of junction asymmetry

Urbasi Sinha, Aninda Sinha, Frank K. Wilhelm

We study noise and noise energy of a high-T$_c$ dc SQUID fabricated on a high-$ε_R$ substrate whose conduction properties are given by transmission line physics. We show that transmission line resonances greatly enhance the noise. Remarkably, resistance asymmetry enhances these resonances even more. However, as the transfer function scales the same way, the noise energy is reduced by asymmetry greatly enhancing the flexibility and performance of the SQUID.

arXiv:0812.4237•Superconductor Science and Technology•Mar 30, 2009•3 citations

Mixing of Low Frequency Signals on a Resistive SQUID

Б.В. Васильев, G.S. Krivoy

•Jan 1, 1977•0 citations

Noise characteristics of a dc SQUID with a resistively shunted inductance. II. Optimum damping

Keiji Enpuku, Keiji Yoshida, Satoshi Kohjiro

Effects of a damping resistance on noise characteristics of a dc SQUID are studied theoretically, where the damping resistance is in shunt with a loop inductance of the SQUID. An analytical expression for the energy resolution of the SQUID is obtained, with which the relation between the damping resistance and the energy resolution is studied in detail. It is shown that an optimum value of the damping resistance exists, which is determined by the tradeoff between the improvement of the transfer function and the additional noise due to the damping resistance. Optimum values of the damping resistance are about twice the shunt resistance of the SQUID and vary slightly with SQUID modulation parameter β. For optimum damping, the energy resolution is improved, compared with the case without the damping resistance. This means that the SQUID with large β can be used without significant degradation of the performance, i.e., the previous restriction of β=1 can be loosened. The analytical results agree quantitatively with numerical ones.

Journal of Applied Physics•Dec 15, 1986•66 citations

An ultra-low-noise tunnel junction dc SQUID

M. B. Ketchen, Richard F. Voss

The design, fabrication, and noise properties of an ultra-low-noise tunnel junction dc SQUID (superconducting quantum interference device) are presented. The two resistively shunted Pb-alloy tunnel junctions are each 3.6 μm diam. The SQUID has an inductance L of ≈11 pH, a critical current per junction, I0 of ≈100 μA, and a resistance per shunt R of ≈2 Ω. At 2.3 K, eI0R≈kBT, and simple theory predicts that the minimum intrinsic energy sensitivity should be ≈2h. The actual minimum value of the measured high-frequency (70 kHz) flux noise at 4.2 K is φn=1.3×10−7φ0 Hz−1/2. This corresponds to an intrinsic energy sensitivity, φ2n/2L, of 3.2×10−33 J Hz−1 or 5h. Lowering the bath temperature to 1.8 K gave no improvement in performance.

Applied Physics Letters•Nov 15, 1979•61 citations
We study noise and noise energy of a high-Tc_cc​ dc SQUID fabricated on a high-εRε_RεR​ substrate whose conduction properties are given by transmission line physics. We show that transmission line resonances greatly enhance the noise. Remarkably, resistance asymmetry enhances these resonances even more. However, as the transfer function scales the same way, the noise energy is reduced by asymmetry greatly enhancing the flexibility and performance of the SQUID.
Effects of a damping resistance on noise characteristics of a dc SQUID are studied theoretically, where the damping resistance is in shunt with a loop inductance of the SQUID. An analytical expression for the energy resolution of the SQUID is obtained, with which the relation between the damping resistance and the energy resolution is studied in detail. It is shown that an optimum value of the damping resistance exists, which is determined by the tradeoff between the improvement of the transfer function and the additional noise due to the damping resistance. Optimum values of the damping resistance are about twice the shunt resistance of the SQUID and vary slightly with SQUID modulation parameter β. For optimum damping, the energy resolution is improved, compared with the case without the damping resistance. This means that the SQUID with large β can be used without significant degradation of the performance, i.e., the previous restriction of β=1 can be loosened. The analytical results agree quantitatively with numerical ones.
The design, fabrication, and noise properties of an ultra-low-noise tunnel junction dc SQUID (superconducting quantum interference device) are presented. The two resistively shunted Pb-alloy tunnel junctions are each 3.6 μm diam. The SQUID has an inductance L of ≈11 pH, a critical current per junction, I0 of ≈100 μA, and a resistance per shunt R of ≈2 Ω. At 2.3 K, eI0R≈kBT, and simple theory predicts that the minimum intrinsic energy sensitivity should be ≈2h. The actual minimum value of the measured high-frequency (70 kHz) flux noise at 4.2 K is φn=1.3×10−7φ0 Hz−1/2. This corresponds to an intrinsic energy sensitivity, φ2n/2L, of 3.2×10−33 J Hz−1 or 5h. Lowering the bath temperature to 1.8 K gave no improvement in performance.