Challenges
Datasets
Workspaces
Papers
Discussions
Leaderboard
Log inSign up
Challenges
Datasets
Workspaces
Papers
Discussions
Leaderboard
Blog
Job Board
Q3AS

© 2026 Aqora Quantum S.A.S.

TermsPrivacyLegal Notice

Superconductor Science and Technology

Flux transistor made from a single-layer niobium thin-film superconducting quantum interference device

S. K. H. Lam

Published Nov 21, 2005• 4 citations
Publisher

Abstract

A micrometre-size Josephson vortex flow transistor is demonstrated experimentally. The drain–source of this device is the output of a single-layer Nb superconducting quantum interference device (SQUID) with a nanometre-size hole, forming a nanoSQUID. The device input is a Nb strip, which is closely coupled to the nanoSQUID. The change of the input current induces a change in the magnetic flux coupling to the nanoSQUID, and hence modulates the current–voltage characteristics of the nanoSQUID. The current gain and transresistance of the device were investigated by evaluating the mutual coupling and the dynamic resistance of the nanoSQUID. A current gain of 0.3 and a transresistance >1 Ω were achieved.

DOI
10.1088/0953-2048/19/1/005

Related papers

Nano-superconducting quantum interference devices with suspended junctions

Dibyendu Hazra, John R. Kirtley, K. Hasselbach

Nano-Superconducting Quantum Interference Devices (nano-SQUIDs) are usually fabricated from a single layer of either Nb or Al. We describe here a simple method for fabricating suspended nano-bridges in Nb/Al thin-film bilayers. We use these suspended bridges, which act as Josephson weak links, to fabricate nano-SQUIDs which show critical current oscillations at temperatures up to 1.5 K and magnetic flux densities up to over 20 mT. These nano-SQUIDs exhibit flux modulation depths intermediate between all-Al and all-Nb devices, with some of the desirable characteristics of both. The suspended geometry is attractive for magnetic single nanoparticle measurements.

Applied Physics Letters•Apr 14, 2014•25 citations

Experimental results of a vortex flow transistor amplifier

David P. McGinnis, Gert K. G. Hohenwarter, M.A. Ketkar +2 more

A niobium-based superconducting amplifier consisting of a series array of 60 vortex flow transistors (VFT) was fabricated and tested. Each VFT consisted of a long Josephson junction biased in the flux flow state, magnetically coupled to a current based on a distributed amplifier configuration. The transresistance of the amplifier in a 50- Omega environment for frequencies up to 1 MHz was measured. The transresistance of the array was less than the expected value calculated from measurements obtained on a single VFT. The difference was probably due to nonuniformities in the fabrication process, which caused some of the junctions not to be biased in the flux flow state or receive the same amount of magnetic field from the control line. However, measurements of the array showed that a large number of VFTs could be connected in series and simultaneously be biased into the flux flow state.>

IEEE Transactions on Magnetics•Mar 1, 1989•11 citations

Fabrication and Characterization of Miniaturized NbN Superconducting Quantum Interference Devices With Nanobridge Junctions

Hao Wang, Lei Chen, Xiaoyu Liu +4 more

Reduction of the size of the superconducting quantum interference device (SQUID) ring structure improves its sensitivity to magnetic moments. Nanobridge junctions are advantageous for SQUID miniaturization. However, many planar SQUIDs with nanobridge junctions have shallow flux modulation depths because of their nonideal Josephson current-phase relationships. Here, we fabricated a three-dimensional niobium nitride (NbN) miniaturized SQUID in which the nanobridge junction structures are much thinner than the superconducting ring. We grew a thick superconducting NbN film on a silicon wafer and embedded an insulating slit in the middle of the film. By setting two thin nanobridge junctions across this insulating slit, we were able to manufacture NbN miniaturized SQUIDs that, in principle, can become nano-SQUIDs. The flux modulation depths of these devices reached 36% at 4.2 K. In addition, the fabricated devices show reversible current-voltage characteristics in the absence of any shunting resistance.

IEEE Transactions on Applied Superconductivity•Jan 18, 2017•10 citations

DC and AC Responses of Josephson Vortex Flow Transistors with High Tc Superconducting Thin Films

Yasushi Doda

We fabricated Josephson vortex flow transistors (JVFTs) with a parallel array of Josephson junctions that were prepared using c-axis-oriented 100-nm-thick YBa 2 Cu 3 O 7-δ (YBCO) thin films grown on 24° bicrystal MgO (100) substrates. We observed clear modulations of the critical current and the flow voltage with DC current input to the control line that was inductively coupled to the array of junctions. From the results, we estimated the parameters of the device, e.g., the mutual inductance and the self-inductance, and calculated the operation frequency at which the device potentially exhibited these parameters. Moreover, the current gain and the transresistance were evaluated and found to be 0.5 and 0.15 Ω, respectively. In addition, we observed the high-frequency responses of the JVFT to the input AC current of the sine wave or the square pulse wave. A clear oscillation of the output voltage could be observed with a 1 MHz sine wave and 250 kHz square pulse wave. We also discussed the feasibility of higher frequency operation by using it as an input interface for a single flux quantum (SFQ) logic circuit.

IEICE Transactions on Electronics•Feb 1, 2006•5 citations

A High-Performance Nb Nano-Superconducting Quantum Interference Device with a Three-Dimensional Structure

Lei Chen, Hao Wang, Xiaoyu Liu +2 more

A superconducting quantum interference device (SQUID) miniaturized into the nanoscale is promising in the inductive detection of a single electron spin. A nano-SQUID with a strong spin coupling coefficient, a low flux noise, and a wide working magnetic field range is highly desired in a single spin resonance measurement. Nano-SQUIDs with Dayem bridge junctions excel in a high working field range and in the direct coupling from spins to the bridge. However, the common planar structure of nano-SQUIDs is known for problems such as a shallow flux modulation depth and a troublesome hysteresis in current–voltage curves. Here, we developed a fabrication process for creating three-dimensional (3-D) niobium (Nb) nano-SQUIDs with nanobridge junctions that can be tuned independently. Characterization of the device shows up to 45.9% modulation depth with a reversible current–voltage curve. Owning to the large modulation depth, the measured flux noise is as low as 0.34 μΦ 0 /Hz 1/2 . The working field range of the SQUID is greater than 0.5 T parallel to the SQUID plane. We believe that 3-D Nb nano-SQUIDs provide a promising step toward effective single-spin inductive detection.

arXiv:1612.08149•Nano Letters•Nov 7, 2016•33 citations

Fabrication of Superconducting Quantum Interference Device with Thin-Film Quantum Point Contacts

Hiroya Abe, K. Hamasaki, Takashi Ishiguro

We have fabricated dc-superconducting quantum interference devices (SQUIDs) with all-thin-film point contacts (Nb–Nb nanoconstriction-NbN). The size of the nanoconstriction may be smaller than the superconducting coherence length of bulk Nb. The quasiparticle characteristic of the all-thin-film point contact can be explained using the Blonder, Tinkham and Klapwijk (BTK) quasiparticle current which is applicable to the superconducting quantum point contact. The flux noise of SQUID with 10 pH operated in a flux locked loop is 8 µΦ0/ Hz1/2 at 1 Hz, and 4 µΦ0/ Hz1/2 at frequencies above 10 Hz is limited by the preamplifier.

Japanese Journal of Applied Physics•Dec 1, 1994•2 citations
A micrometre-size Josephson vortex flow transistor is demonstrated experimentally. The drain–source of this device is the output of a single-layer Nb superconducting quantum interference device (SQUID) with a nanometre-size hole, forming a nanoSQUID. The device input is a Nb strip, which is closely coupled to the nanoSQUID. The change of the input current induces a change in the magnetic flux coupling to the nanoSQUID, and hence modulates the current–voltage characteristics of the nanoSQUID. The current gain and transresistance of the device were investigated by evaluating the mutual coupling and the dynamic resistance of the nanoSQUID. A current gain of 0.3 and a transresistance >1 Ω were achieved.
Nano-Superconducting Quantum Interference Devices (nano-SQUIDs) are usually fabricated from a single layer of either Nb or Al. We describe here a simple method for fabricating suspended nano-bridges in Nb/Al thin-film bilayers. We use these suspended bridges, which act as Josephson weak links, to fabricate nano-SQUIDs which show critical current oscillations at temperatures up to 1.5 K and magnetic flux densities up to over 20 mT. These nano-SQUIDs exhibit flux modulation depths intermediate between all-Al and all-Nb devices, with some of the desirable characteristics of both. The suspended geometry is attractive for magnetic single nanoparticle measurements.
A niobium-based superconducting amplifier consisting of a series array of 60 vortex flow transistors (VFT) was fabricated and tested. Each VFT consisted of a long Josephson junction biased in the flux flow state, magnetically coupled to a current based on a distributed amplifier configuration. The transresistance of the amplifier in a 50- Omega environment for frequencies up to 1 MHz was measured. The transresistance of the array was less than the expected value calculated from measurements obtained on a single VFT. The difference was probably due to nonuniformities in the fabrication process, which caused some of the junctions not to be biased in the flux flow state or receive the same amount of magnetic field from the control line. However, measurements of the array showed that a large number of VFTs could be connected in series and simultaneously be biased into the flux flow state.>
Reduction of the size of the superconducting quantum interference device (SQUID) ring structure improves its sensitivity to magnetic moments. Nanobridge junctions are advantageous for SQUID miniaturization. However, many planar SQUIDs with nanobridge junctions have shallow flux modulation depths because of their nonideal Josephson current-phase relationships. Here, we fabricated a three-dimensional niobium nitride (NbN) miniaturized SQUID in which the nanobridge junction structures are much thinner than the superconducting ring. We grew a thick superconducting NbN film on a silicon wafer and embedded an insulating slit in the middle of the film. By setting two thin nanobridge junctions across this insulating slit, we were able to manufacture NbN miniaturized SQUIDs that, in principle, can become nano-SQUIDs. The flux modulation depths of these devices reached 36% at 4.2 K. In addition, the fabricated devices show reversible current-voltage characteristics in the absence of any shunting resistance.
We fabricated Josephson vortex flow transistors (JVFTs) with a parallel array of Josephson junctions that were prepared using c-axis-oriented 100-nm-thick YBa 2 Cu 3 O 7-δ (YBCO) thin films grown on 24° bicrystal MgO (100) substrates. We observed clear modulations of the critical current and the flow voltage with DC current input to the control line that was inductively coupled to the array of junctions. From the results, we estimated the parameters of the device, e.g., the mutual inductance and the self-inductance, and calculated the operation frequency at which the device potentially exhibited these parameters. Moreover, the current gain and the transresistance were evaluated and found to be 0.5 and 0.15 Ω, respectively. In addition, we observed the high-frequency responses of the JVFT to the input AC current of the sine wave or the square pulse wave. A clear oscillation of the output voltage could be observed with a 1 MHz sine wave and 250 kHz square pulse wave. We also discussed the feasibility of higher frequency operation by using it as an input interface for a single flux quantum (SFQ) logic circuit.
A superconducting quantum interference device (SQUID) miniaturized into the nanoscale is promising in the inductive detection of a single electron spin. A nano-SQUID with a strong spin coupling coefficient, a low flux noise, and a wide working magnetic field range is highly desired in a single spin resonance measurement. Nano-SQUIDs with Dayem bridge junctions excel in a high working field range and in the direct coupling from spins to the bridge. However, the common planar structure of nano-SQUIDs is known for problems such as a shallow flux modulation depth and a troublesome hysteresis in current–voltage curves. Here, we developed a fabrication process for creating three-dimensional (3-D) niobium (Nb) nano-SQUIDs with nanobridge junctions that can be tuned independently. Characterization of the device shows up to 45.9% modulation depth with a reversible current–voltage curve. Owning to the large modulation depth, the measured flux noise is as low as 0.34 μΦ 0 /Hz 1/2 . The working field range of the SQUID is greater than 0.5 T parallel to the SQUID plane. We believe that 3-D Nb nano-SQUIDs provide a promising step toward effective single-spin inductive detection.
We have fabricated dc-superconducting quantum interference devices (SQUIDs) with all-thin-film point contacts (Nb–Nb nanoconstriction-NbN). The size of the nanoconstriction may be smaller than the superconducting coherence length of bulk Nb. The quasiparticle characteristic of the all-thin-film point contact can be explained using the Blonder, Tinkham and Klapwijk (BTK) quasiparticle current which is applicable to the superconducting quantum point contact. The flux noise of SQUID with 10 pH operated in a flux locked loop is 8 µΦ0/ Hz1/2 at 1 Hz, and 4 µΦ0/ Hz1/2 at frequencies above 10 Hz is limited by the preamplifier.