Saturated Photon Detection Efficiency in NbN Superconducting Photon Detectors

Ryan P. Murphy, Matthew E. Grein, Theodore Gudmundsen, Adam N. McCaughan, Faraz Najafi, Karl K. Berggren, Francesco Marsili, Eric A. Dauler

Published Jan 1, 2015• 3 citations

Publisher

Abstract

In this work, we demonstrate saturated photon detection efficiency with narrow NbN nanowires and SNAPs to boost the signal-to-noise ratio, and we demonstrate a stabilizing choke inductance that is part of the optically-active area.

DOI: 10.1364/cleo_qels.2015.ff2a.3

Related papers

Large-area NbN superconducting nanowire avalanche photon detectors with saturated detection efficiency

Ryan P. Murphy, Matthew E. Grein, Theodore Gudmundsen +5 more

Superconducting circuits comprising SNSPDs placed in parallel—superconducting nanowire avalanche photodetectors, or SNAPs—have previously been demonstrated to improve the output signal-to-noise ratio (SNR) by increasing the critical current. In this work, we employ a 2-SNAP superconducting circuit with narrow (40 nm) niobium nitride (NbN) nanowires to improve the system detection efficiency to near-IR photons while maintaining high SNR. Additionally, while previous 2-SNAP demonstrations have added external choke inductance to stabilize the avalanching photocurrent, we show that the external inductance can be entirely folded into the active area by cascading 2-SNAP devices in series to produce a greatly increased active area. We fabricated series-2-SNAP (s2-SNAP) circuits with a nanowire length of 20 μm with cascades of 2-SNAPs providing the choke inductance necessary for SNAP operation. We observed that (1) the detection efficiency saturated at high bias currents, and (2) the 40 nm 2-SNAP circuit critical current was approximately twice that for a 40 nm non-SNAP configuration.

Proceedings of SPIE, the International Society for Optical Engineering/Proceedings of SPIEMay 13, 20150 citations

Niobium Superconducting Nanowire Single-Photon Detectors

A.J. Annunziata, Daniel F. Santavicca, J.D. Chudow +4 more

We investigate the performance of superconducting nanowire photon detectors fabricated from ultra-thin Nb. A direct comparison is made between these detectors and similar nanowire detectors fabricated from NbN. We find that Nb detectors are significantly more susceptible than NbN to thermal instability (latching) at high bias. We show that the devices can be stabilized by reducing the input resistance of the readout. Nb detectors optimized in this way are shown to have approximately 2/3 the reset time of similar large-active-area NbN detectors of the same geometry, with approximately 6% detection efficiency for single photons at 470 nm.

arXiv:0901.1146IEEE Transactions on Applied SuperconductivityJun 1, 200957 citations

NbN superconducting nanowire single-photon detector with an active area of 300 μm-in-diameter

Chengjun Zhang, Weijun Zhang, Jia Huang +8 more

Superconducting nanowire single-photon detectors (SNSPDs) with both an ultra-large-active area and a high count rate (CR) are challenging from the design and fabrication. Here, we develop a NbN SNSPD with a circular active area of 300 μm-in-diameter and use multiple approaches to boost the maximal count rate (MCR). This large-active-area SNSPD is divided into nine pixels (parts). Each pixel consists of serially connected two superconducting nanowire avalanche photodetectors (SC-2SNAP), which yielded a four-fold reduction in the kinetic inductance of a single pixel. To further increase MCR, an optimized series resistance of about 380 Ω is added to each pixel, reducing the full recovery time of each pixel from a few microseconds to approximately 90 ns. All nine pixels show uniform superconducting critical temperatures of ∼7.4 K and switching currents in the range of 15.3–16.7 μA. When the detector coupled to a single-mode fiber and illuminated with 1064-nm photons, the single-pixel exhibits a well-saturated system detection efficiency (SDE) of 67% at a dark CR of 30 Hz, and its CR exceeds 10 MHz with an SDE of 50%. When coupled to a 200-μm multi-mode fiber, the total SDE of nine pixels is approximately 42% and the total MCR exceeds 43 MHz.

AIP AdvancesJul 1, 201926 citations

NbN Superconducting Nanowire Single-Photon Detector With 90.5% Saturated System Detection Efficiency and 14.7 ps System Jitter at 1550 nm Wavelength

Xingyu Zhang, Weijun Zhang, Hui Zhou +8 more

Superconducting nanowire single-photon detectors (SNSPDs) play a pivotal role in infrared single-photon-detection applications owing to their free-running mode, near-unity detection efficiency, and excellent time resolution. However, conventional niobium nitride- (NbN) SNSPDs often have a trade-off between optimal detection efficiency and time resolution. We herein demonstrate NbN SNSPDs in the combination of high efficiency and time resolution by using the helium-ion-irradiated film of 10 nm and a homemade cryogenic amplifier to improve the signal-to-noise ratio. The proposed 18-μm-diameter device operated at 850 mK shows a saturated system detection efficiency of ∼90.5% at 1550 nm wavelength with a dark count rate below 50 counts per second (cps), and minimum system timing jitter of ∼14.7 ps. Meanwhile, the recovery time is 21.2 ns owing to its lower kinetic inductance. The time-of-flight light detection and ranging with this device was further carried out indoors, which demonstrates a submillimeter (<0.5 mm) depth resolution, as well as good depth and intensity reconstruction of a low-signature object even under the dwell time of 0.5 ms. It indicates that our device has a great advantage and potential in high-time-resolution and weak-signal-detection applications, such as real-time imaging, fluorescence lifetime detection, and remote laser sensing.

IEEE Journal of Selected Topics in Quantum ElectronicsFeb 23, 202227 citations

Fabrication and Characterization of Superconducting NbN Nanowire Single Photon Detectors

Jeff A. Stern, William H. Farr

We report on the fabrication and characterization of high-speed, single photon detectors using superconducting NbN nanowires at a wavelength of 1064 nm. A 15 by 15 microns detector with a detector efficiency of 40% has been measured. Due to kinetic inductance, the recovery time of such large area detectors is longer than that of smaller or single wire detectors. The recovery time of our detectors (50 ns) has been characterized by measuring the inter-arrival time statistics of our detector.

IEEE Transactions on Applied SuperconductivityJun 1, 200733 citations

Superconducting microstrip single-photon detector with system detection efficiency over 90% at 1550 nm

Guangzhao Xu, Wei-Jun Zhang, Li-Xing You +9 more

Generally, a superconducting nanowire single-photon detector (SNSPD) is composed of wires with a typical width of ∼ 100 nm . Recent studies have found that superconducting strips with a micrometer-scale width can also detect single photons. Compared with the SNSPD covering the same area, the superconducting microstrip single-photon detector (SMSPD) has smaller kinetic inductance, higher working current, and lower requirements in fabrication accuracy, providing potential applications in the development of ultralarge active area detectors. However, the study of SMSPD is still in its infancy, and the realization of its high-performance and practical use remains an open question. This study demonstrates a NbN SMSPD with a nearly saturated system detection efficiency (SDE) of ∼ 92.2 % at a dark count rate of ∼ 200 cps , a polarization sensitivity of ∼ 1.03 , and a minimum timing jitter of ∼ 48 ps at the telecom wavelength of 1550 nm when coupled with a single-mode fiber and operated at 0.84 K. Furthermore, the detector’s SDE is over 70% when operated at a 2.1 K closed-cycle cryocooler.

arXiv:2101.05407Photonics ResearchMar 23, 202168 citations