Challenges
Datasets
Workspaces
Papers
Discussions
Leaderboard
Log inSign up
Challenges
Datasets
Workspaces
Papers
Discussions
Leaderboard
Blog
Job Board
Q3AS

© 2026 Aqora Quantum S.A.S.

TermsPrivacyLegal Notice

arXiv:1402.2879 · Applied Physics Letters

Nano-optical observation of cascade switching in a parallel superconducting nanowire single photon detector

Robert M. Heath, Michael G. Tanner, Alessandro Casaburi, Mark G. Webster, Lara San Emeterio Alvarez, Weitao Jiang, Zoe H. Barber, Richard John Warburton, Robert H. Hadfield

Published Feb 10, 2014• 14 citations
arXivHTMLPDF

Abstract

The device physics of parallel-wire superconducting nanowire single photon detectors is based on a cascade process. Using nano-optical techniques and a parallel wire device with spatially separate pixels, we explicitly demonstrate the single- and multi-photon triggering regimes. We develop a model for describing efficiency of a detector operating in the arm-trigger regime. We investigate the timing response of the detector when illuminating a single pixel and two pixels. We see a change in the active area of the detector between the two regimes and find the two-pixel trigger regime to have a faster timing response than the one-pixel regime.

DOI
10.1063/1.4865199

Related papers

Nano-optical studies of superconducting nanowire devices for single-photon detection

Robert M. Heath

Superconducting nanowire single photon detectors (SNSPDs) are a rapidly maturing detector technology that offer superior performance relative to competing infrared photon counting technologies. The original experimental work presented here explores three novel methods of improving and analysing detector characteristics, employing low-temperature piezoelectric motors at temperatures below 4 K in a closed-cycle cryostat. Utilizing the low-temperature piezoelectric nanopositioners in tandem with a miniature confocal microscope, this work specifically shows a spatially-separable parallel-wire SNSPD demonstrating one- and two-pixel photon discrimination, with the detector responding more quickly when triggering two pixels. The work demonstrates nanoantenna-coupled SNSPDs, which are simulated, designed, and tested using the same nano-optical setup. In these an increased local absorption into the nanowire is seen at the antennas' resonant wavelengths, enhancing the efficiency of the detector by up to 130 %. Finally, a modified optical setup using a distributed Bragg reflector fibre in place of the microscope to form a tunable cavity around two configurations of SNSPD is demonstrated, improving absorption of the incident light into the nanowire across the whole active area. For these, enhancement in the system detection efficiency of up to 40 % is seen.

•Jan 1, 2015•1 citation

Characterization of parallel superconducting nanowire single photon detectors

Mikkel Ejrnaes, A. Casaburi, Orlando Quaranta +6 more

Superconducting nanowire single photon detectors (SNSPDs) have been realized using an innovative parallel wire configuration. This configuration allows, at the same time, a large detection area and a fast response, with the additional advantage of large signal amplitudes. The detectors have been thoroughly characterized in terms of signal properties (amplitude, risetime and falltime), detector operation (latching and not latching) and quantum efficiency (at 850 nm). It has been shown that the parallel SNSPD is able to provide significantly higher maximum count rates for large area SNSPDs than meandered SNSPDs. Through a proper parallel wire configuration the increase in maximum count rate can be obtained without latching problems.

Superconductor Science and Technology•Mar 30, 2009•55 citations

Characterisation of multi-pixel superconducting nanowire single photon detectors

Jeroen Swens

Single-photon detection is extremely important for a number of different applications such as quantum cryptography, CMOS testing and even biomedical research. Most of the applications of single-photon detector require high efficiency combined with high time resolution, high count rates and low dark counts. Superconducting nanowire single-photon detectors has emerged provides this combination unlike any other available single-photon detectors. Some of the applications of superconducting nanowire single-photon detectors (SNSPD's) require larger area SNSPD's without affecting it's performance. For this purpose, multi-pixel SNSPD's would provide a solution. To this end, prototype 4- and 16-pixel detectors have been characterised in terms of a number of performance parameters such as critical current, count rate behaviour and timing jitter. Aside from this, simulations have been performed on detection statistics and relative illumination of the individual pixels of a multi-pixel SNSPD. Results show that for 4-pixel detectors, all desired aspects have been achieved, but not yet combined in one detector. The 16-pixel detectors showed excellent critical currents and count rate behaviour but, most likely due to the fact that they were prototype chips with little to no protection, had several not functioning pixels.

•Jan 1, 2018•0 citations

A cascade switching superconducting single photon detector

Mikkel Ejrnaes, Roberto Cristiano, Orlando Quaranta +6 more

We have realized superconducting single photon detectors with reduced inductance and increased signal pulse amplitude. The detectors are based on a parallel connection of ultrathin NbN nanowires with a common bias inductance. When properly biased, an absorbed photon induces a cascade switch of all the parallel wires generating a signal pulse amplitude of 2mV. The parallel wire configuration lowers the detector inductance and reduces the response time well below 1ns.

Applied Physics Letters•Dec 24, 2007•124 citations

Timing jitter of cascade switch superconducting nanowire single photon detectors

Mikkel Ejrnaes, A. Casaburi, Roberto Cristiano +9 more

We investigate the timing jitter in parallel superconducting NbN-nanowire single photon detectors based on a cascade switch mechanism. The measured timing jitter is asymmetric and has an oscillatory dependence on bias current. At the highest bias current the full width at half maximum was 1.5 times larger than an on-chip reference meander NbN nanowire. A physical model of the dynamics occurring during cascade switch is developed, that quantitatively accounts for our observations as a consequence of different nanowire critical currents within the detector.

Applied Physics Letters•Sep 28, 2009•23 citations

Real-time multi-pixel readout of superconducting nanowire single-photon detectors

M. Hofherr, K. Ilin, Julia Toussaint +6 more

Nowadays detection systems based on superconducting nanowire single-photon detectors (SNSPD) are mainly with a single-pixel detector. Multi-pixel systems would extend the field of possible applications. Therefore, new concepts are required for effective readout of multi-pixel SNSPDs. We give an overview of possible concepts, conditions of operation and dedicated effort to optimize the requirements of different applications in the single-photon regime.

IEEE Workshop on Low Temperature Electronics (WOLTE)•Jul 1, 2014•0 citations
The device physics of parallel-wire superconducting nanowire single photon detectors is based on a cascade process. Using nano-optical techniques and a parallel wire device with spatially separate pixels, we explicitly demonstrate the single- and multi-photon triggering regimes. We develop a model for describing efficiency of a detector operating in the arm-trigger regime. We investigate the timing response of the detector when illuminating a single pixel and two pixels. We see a change in the active area of the detector between the two regimes and find the two-pixel trigger regime to have a faster timing response than the one-pixel regime.
Superconducting nanowire single photon detectors (SNSPDs) are a rapidly maturing detector technology that offer superior performance relative to competing infrared photon counting technologies. The original experimental work presented here explores three novel methods of improving and analysing detector characteristics, employing low-temperature piezoelectric motors at temperatures below 4 K in a closed-cycle cryostat. Utilizing the low-temperature piezoelectric nanopositioners in tandem with a miniature confocal microscope, this work specifically shows a spatially-separable parallel-wire SNSPD demonstrating one- and two-pixel photon discrimination, with the detector responding more quickly when triggering two pixels. The work demonstrates nanoantenna-coupled SNSPDs, which are simulated, designed, and tested using the same nano-optical setup. In these an increased local absorption into the nanowire is seen at the antennas' resonant wavelengths, enhancing the efficiency of the detector by up to 130 %. Finally, a modified optical setup using a distributed Bragg reflector fibre in place of the microscope to form a tunable cavity around two configurations of SNSPD is demonstrated, improving absorption of the incident light into the nanowire across the whole active area. For these, enhancement in the system detection efficiency of up to 40 % is seen.
Superconducting nanowire single photon detectors (SNSPDs) have been realized using an innovative parallel wire configuration. This configuration allows, at the same time, a large detection area and a fast response, with the additional advantage of large signal amplitudes. The detectors have been thoroughly characterized in terms of signal properties (amplitude, risetime and falltime), detector operation (latching and not latching) and quantum efficiency (at 850 nm). It has been shown that the parallel SNSPD is able to provide significantly higher maximum count rates for large area SNSPDs than meandered SNSPDs. Through a proper parallel wire configuration the increase in maximum count rate can be obtained without latching problems.
Single-photon detection is extremely important for a number of different applications such as quantum cryptography, CMOS testing and even biomedical research. Most of the applications of single-photon detector require high efficiency combined with high time resolution, high count rates and low dark counts. Superconducting nanowire single-photon detectors has emerged provides this combination unlike any other available single-photon detectors. Some of the applications of superconducting nanowire single-photon detectors (SNSPD's) require larger area SNSPD's without affecting it's performance. For this purpose, multi-pixel SNSPD's would provide a solution. To this end, prototype 4- and 16-pixel detectors have been characterised in terms of a number of performance parameters such as critical current, count rate behaviour and timing jitter. Aside from this, simulations have been performed on detection statistics and relative illumination of the individual pixels of a multi-pixel SNSPD. Results show that for 4-pixel detectors, all desired aspects have been achieved, but not yet combined in one detector. The 16-pixel detectors showed excellent critical currents and count rate behaviour but, most likely due to the fact that they were prototype chips with little to no protection, had several not functioning pixels.
We investigate the timing jitter in parallel superconducting NbN-nanowire single photon detectors based on a cascade switch mechanism. The measured timing jitter is asymmetric and has an oscillatory dependence on bias current. At the highest bias current the full width at half maximum was 1.5 times larger than an on-chip reference meander NbN nanowire. A physical model of the dynamics occurring during cascade switch is developed, that quantitatively accounts for our observations as a consequence of different nanowire critical currents within the detector.